CS Paper Radar

TapID: Rapid touch interaction in virtual reality using wearable sensing

Manuel Meier, Paul Streli, Andreas Fender, Christian Holz

cs.HC eess.SP ·submitted 2026-10-19 15:41 UTC · v1
top venuepositionhighly cited

Abstract

Current Virtual Reality systems typically use cameras to capture user input from controllers or free-hand mid-air interaction. In this paper, we argue that this is a key impediment to productivity scenarios in VR, which require continued interaction over prolonged periods of time---a requirement that controller or free-hand input in mid-air does not satisfy. To address this challenge, we bring rapid touch interaction on surfaces to Virtual Reality---the input modality that users have grown used to on phones and tablets for continued use. We present TapID, a wrist-based inertial sensing system that complements headset-tracked hand poses to trigger input in VR. TapID embeds a pair of inertial sensors in a flexible strap, one at either side of the wrist; from the combination of registered signals, TapID reliably detects surface touch events and, more importantly, identifies the finger used for touch. We evaluated TapID in a series of userstudies on event-detection accuracy (F1 = 0.997) and hand-agnostic finger-identification accuracy (within-user: F1 = 0.93; across users: F1 = 0.91 after 10 refinement taps and F1 = 0.87 without refinement) in a seated table scenario. We conclude with a series of applications that complement hand tracking with touch input and that are uniquely enabled by TapID, including UI control, rapid keyboard typing and piano playing, as well as surface gestures.

Comment
accepted to IEEE VR 2021
DOI
10.1109/VR50410.2021.00076

Closest papers

Nearest neighbours by meaning across the whole index.

Selfrionette: A Fingertip Force-Input Controller for Continuous Full-Body Avatar Manipulation and Diverse Haptic Interactions

cs.HC ·2026-11-02 ·Takeru Hashimoto, Yutaro Hirao
top venuehighly cited similarity 0.76
Abstract · 14 pages, 12 figures. Author-prepared version of the UIST 2024 paper. Both authors contributed equally

We propose Selfrionette, a controller that uses fingertip force input to drive avatar movements in virtual reality (VR). This system enables users to interact with virtual objects and walk in VR using only fingertip force, overcoming physical and spatial constraints. Additionally, by fixing users' fingers, it provides users with counterforces equivalent to the applied force, allowing for diverse and wide dynamic range haptic feedback by adjusting the relationship between force input and virtual movement. To evaluate the effectiveness of the proposed method, this paper focuses on hand interaction as a first step. In User Study 1, we measured usability and embodiment during reaching tasks under Selfrionette, body tracking, and finger tracking conditions. In User Study 2, we investigated whether users could perceive haptic properties such as weight, friction, and compliance under the same conditions as User Study 1. Selfrionette was found to be comparable to body tracking in realism of haptic interaction, enabling embodied avatar experiences even in limited spatial conditions.

0.61

Comparing Haptic Feedback Across Hand Tracking and Controllers in VR Object Interaction Tasks

cs.HC ·2026-09-18 ·Natalia Ocampo, J. Felipe Gonzalez, Robert J. Teather, Kiyoshi Kiyokawa
published similarity 0.73
Abstract

Hand tracking offers natural VR interaction but lacks controllers' inherent tactile feedback, while haptic feedback across input methods remains understudied. We conducted a participant study comparing vibration, impulse, and no feedback in hand- and controller-based VR interaction across grasp-, pinch-, and tap-like gestures assessing performance, workload, and preference. A custom glove and controller-mounted device provided both feedback types, aiming for consistency across input modalities. Controllers were faster for grasp and pinch, whereas hand tracking was more accurate for pinch and preferred overall. Haptics had limited performance effects, although impulse reduced grasp accuracy with controllers. Participants preferred vibration and impulse over no haptic feedback, favouring vibration overall. Our findings reveal a more nuanced relationship between haptic feedback, input device, and interaction context than suggested by previous work.

0.36

PalmSpace: Towards a Versatile On-Palm Interaction Space through Unified Touch Modeling

cs.HC cs.CV ·2026-10-07 ·Chentao Li, Mingze Gao, Runze Sun, Zhaoguo Wang, Jianjiang Feng +1 more
similarity 0.73
Abstract · Preprint. Initial version

As smart glasses and lightweight MR devices become increasingly practical, input remains a key challenge. The bare palm is an always-available, tactile, and proprioceptively accessible surface, but it has neither an explicit coordinate system nor embedded touch sensing. Prior on-palm systems typically expose isolated touch events, discrete regions, continuous trajectories, or task-specific gestures, limiting the palm's ability to support precise selection and gesture manipulation through a common input representation. We present PalmSpace, a wrist-worn infrared system that exposes mode-aware, body-referenced absolute input on the bare palm without per-user sensing calibration. At the interaction level, PalmSpace jointly represents contact occurrence, interaction mode, and palm-referenced absolute location; at the model level, it learns these coupled outputs through a shared real-time representation. In leave-one-participant-out evaluation with 17 participants, PalmSpace achieved 6.7 mm mean localization error, 98.9% contact detection accuracy, and 96.7% F1 for four-class interaction-state recognition. User studies further demonstrated absolute pointing and dragging, eyes-free digit input, and representative multi-finger controls including scrolling and pinch-based map manipulation. These results show that a morphologically variable bare palm can function as a transferable, mode-aware interaction surface.

0.17

Beyond Gestures: Estimating Full Hand Pose and Contact Forces from Wrist-Worn Pressure Sensor Array

cs.HC cs.RO ·2026-09-15 ·Svetoslav Kolev, Lingni Ma, Michael Goesele, Renzo De Nardi, Jakob Engel +1 more
hot direction similarity 0.71
Abstract

Capturing hand motion and interaction forces is critical for interactive computing, VR, and high-fidelity tactile demonstrations for robot learning. We introduce a wrist-worn pressure-sensing wristband that recovers continuous full-hand pose and distributed contact force on a single wearable. The system consists of flexible capacitive sensor arrays around the wrist, which require no electrical skin contact, and a recurrent network that maps the resulting pressure signal to hand state. Our key insight is that muscle contraction and tendon displacement produce pressure patterns, which correlate strongly with hand pose and interaction force. To validate this, we collect synchronized recordings of wrist pressure, optical motion-capture hand pose, and tactile-glove interaction force, covering isolated finger motion, fingertip-force stress tests, and natural hand-object manipulation. On isolated single-user motion the wristband attains $4.6^\circ$ mean finger-joint MAE, and across four users manipulating everyday objects it estimates per-finger contact force at $R^2=0.57$, which an external pose signal brings up to $0.75$. We see the wristband as one node in a constellation of everyday wearables -- e.g. paired with an egocentric camera -- adding the contact force that vision cannot observe and taking over when the hand is occluded.

0.44

RUMI: A Robotiq-Matched Universal Manipulation Interface for Robot Learning with Augmented Reality and Haptic Feedback

cs.RO cs.AI ·2026-11-11 ·Kevin Avdiu, Seongjin Bien, Yannik Blei, Philine Meister, Johannes Hechtl +4 more
similarity 0.67
Abstract

Many manipulation tasks require carefully controlled contact forces for successful execution, yet large-scale, force-aware datasets remain scarce. Handheld interfaces can help by transmitting interaction forces directly through the operator's arm, but most existing designs are tailored to simple linear grippers and do not match the nonlinear mechanics of widely used robotic grippers. We present RUMI, a handheld universal manipulation interface matched to the Robotiq 2F-85 with exchangeable fingertip sensors that preserves the target gripper geometry while enabling natural input before contact and force measurement after contact. By integrating the tracking system into a virtual reality headset, our method provides real-time augmented reality feedback about the kinematic feasibility of motion on the target robot platform. We further introduce a haptic feedback mechanism that supports force-aware teleoperation for simulated and real robots. A user study shows fewer episodes containing joint-limit violations with live robot visualization and pose initialization (3/50) than without augmented reality (16/50). We additionally train imitation policies from demonstrations, collected using two different fingertip modalities enabled by the gripper-matched hardware, and assess the haptic interface's capability for collecting force-aware teleoperation datasets in simulation.

0.05

Beyond the Mirror: Balancing Interaction Modality and Avatar Fidelity in Public 3D Virtual Try-On Systems

cs.HC ·2026-08-24 ·Yueqian Guo, Tianzhao Li, Xin Lv
similarity 0.66
Abstract

Virtual Try-On (VTON) systems deployed on large public displays face a dual barrier: the physical strain of mid-air interaction and the social inhibition caused by public self-consciousness. This paper presents a real-time 3D avatar system integrating markerless motion capture with dynamic visual fidelity control to investigate and mitigate both barriers. Through a dual-study empirical evaluation, we first decoupled physical fatigue from gesture interaction ($N=20$), demonstrating that interaction fatigue is primarily driven by visuomotor latency rather than the physical act of gesturing; our optimized low-latency gesture pipeline achieved usability comparable to touchscreens while delivering superior immersion and hygiene. Building on these insights, our second study ($N=25$) investigated the "avatar fidelity paradox" via a $2 \times 2$ factorial design manipulating interaction modality (gestures vs. touch) and visual fidelity (photorealistic MetaHuman vs. stylized mannequin). Results reveal that while high fidelity and mid-air gestures independently maximize virtual embodiment ($p < .05$), their combination elicits the highest social awkwardness. Crucially, low-fidelity avatars serve as a "psychological mask" that alleviates public embarrassment during expressive gestures, while mid-air gestures simultaneously act as a compensatory mechanism to preserve perceived try-on trust despite reduced visual realism. Finally, we propose a context-aware fidelity framework to balance privacy, immersion, and commercial trust in public spatial interactions.

0.08

Comparing Hand and Controller Avatars with Hand Tracking and Controller-Based Interaction

cs.HC ·2026-09-18 ·Natalia Ocampo, J. Felipe Gonzalez, Robert J. Teather
top venuehighly cited similarity 0.65
Abstract

Previous research suggests that the congruency between common VR input devices - such as controllers or hand tracking - and their visual representations (e.g., hand or controller avatars) influences user experience and performance. However, the specific effects of input-avatar combinations remain underexplored. We study the effects of common input devices (hand tracking and controllers) and visual representations (hand and controller avatars) on performance and perceived success in target acquisition tasks. We included both grasping and pinching gestures across 16 combinations of input, avatar, and target size. Results indicate that hand tracking benefits from any form of visual representation - even when mismatched - achieving up to 5.8% greater accuracy compared to having no avatar, likely due to its reliance on visual feedback in the absence of a physical prop. Controllers were generally preferred and offered faster task completion. However, mismatched avatars had a stronger negative effect with controllers, particularly when the virtual gesture did not align with the physical action, leading to a 5.6% drop in accuracy compared to the matched condition - suggesting that inaccurate feedback can be more disruptive than having no avatar feedback at all.

0.65

GraspPressure: Understanding Pressure Input With Busy Hands

cs.HC ·2026-10-29 ·Anand Kumar, Aditya Shekhar Nittala
published similarity 0.65
Abstract · To appear in the Proceedings of the ACM on Human-Computer Interaction (PACM HCI), presented at ACM Interactive Surfaces and Spaces (ISS 2026…

In many real-world scenarios, users interact with digital systems while their hands are partially occupied, such as when holding tools or everyday objects. Prior work on busy-hand interaction has focused on microgestures and motion-based techniques, which rely on finger articulation or relative movement. In situations where a stable grasp is required, such as handling fragile, heavy, or precision objects, such motion can be undesirable or impractical. Pressure-based input offers a complementary modality that enables interaction without changing finger pose, yet its use while holding objects has received limited empirical attention. To explore this, we conducted two within-subject experiments examining users' ability to perform controlled pressure selections and analyzing finger-specific performance across different grasps and geometries. Results indicate that participants can reliably perform pressure-based selections in these conditions, achieving high success rates (92.7% on average) with low selection times (1.74s on average). Our findings characterize the potential of pressure input as a complementary microinteraction modality under grasp-constrained, busy-hand scenarios.

0.28