CS Paper Radar

Multiuser Channel Estimation in FIM Systems: A Structured Block Term Decomposition Approach

Xi Han, Junqiao Chen, André L. F. de Almeida, George C. Alexandropoulos

eess.SP ·submitted 2026-10-21 16:37 UTC · v1

Abstract

Flexible intelligent metasurfaces (FIMs) create geometry-dependent array responses that provide spatial diversity but complicate multiuser channel estimation. This paper studies uplink estimation using pilot observations collected under multiple prescribed and calibrated morphing configurations. Each user contributes a matrix--vector block that couples its diagonal reference-array response with its morphing-dependent phases, while its third-mode vector is the known pilot scaled by the complex channel gain. We develop a pilot-constrained structured block term decomposition (BTD) estimator whose alternating least-squares updates exploit both the known pilot directions and the diagonal spatial factors. The undeformed configuration sets the columnwise scaling convention, and a unit first-entry normalization assigns the remaining block scale to the channel gain. Matching the recovered factors to the calibrated spatial--morphing manifold then yields the physical angles and configuration-dependent channels. We characterize the rank conditions for unique conditional least-squares updates, distinguish these conditions from global factor and physical-angle identifiability, and summarize the training, coherence-time, and computational requirements. Simulations show accurate two-dimensional angle and channel recovery in the tested settings, equal total pilot-symbol overhead in rigid-panel comparisons, improved steering-vector estimates as morphing diversity increases, and degradation as user loading or pilot correlation increases.

Closest papers

Nearest neighbours by meaning across the whole index.

Structured PARAFAC Channel Estimation for Flexible Intelligent Metasurface Receivers

eess.SP ·2026-10-20 ·Xi Han, Junqiao Chen, Yuansheng Zhang, André L. F. de Almeida, George C. Alexandropoulos
similarity 0.74
Abstract

Flexible intelligent metasurfaces (FIMs) create geometric diversity through aperture morphing, but their configuration-dependent responses complicate uplink channel estimation. This letter considers multiple users sharing a common angular response and develops a structured PARAFAC model across calibrated FIM configurations. Its known identity factor and rank-one pilot-weighted channel factor enable deterministic, noniterative algebraic factor recovery through per-element rank-one approximations, reference-state normalization, global rank-one projection, and a least-squares morphing-factor update. The recovered spatial and morphing factors are then jointly matched to the calibrated manifold to estimate the common angles, user gains, and configuration-dependent channels. Simulations demonstrate accurate recovery and show that out-of-plane morphing resolves the azimuth-sign ambiguity of an undeformed planar aperture; an angular-spread experiment quantifies the mismatch when the common-response assumption is relaxed.

0.32

Training-Efficient Channel Estimation for the Multiuser Uplink Relying on Generalized Flexible Intelligent Metasurfaces

eess.SP ·2026-10-21 ·Daniel C. Araújo, André L. F. de Almeida, Lajos Hanzo
similarity 0.72
Abstract

We consider uplink multiuser channel estimation for a generalized flexible intelligent metasurface at the base station, under narrowband far-field propagation and a twin-time-scale mechanical protocol: on the slow time-scale the panel translates rigidly over a planar grid, while on the fast time-scale the surface morphs along its normal direction. From orthogonal multiuser pilots, we show that each user's channel admits a fourth-order canonical polyadic tensor structure. We develop two complementary estimators: alternating least squares factorization followed by paired rotational-invariance wavevector extraction, and a tensor spatial-smoothing multiple signal classification estimator that preserves the multilinear array manifold. Both share a minimum description length front-end for automatic tensor-rank detection. We derive Kruskal identifiability conditions that relate the numbers of elements, morphing states and grid positions to the maximum number of recoverable multipath components, and show that the tensor model reconstructs the channel at panel configurations beyond the training grid. This prediction capability drives a configuration-selective multiuser transmit precoder that searches the entire motion grid without additional pilot overhead. Numerical results confirm the identifiability limits and show that, once the model order is resolved, the configuration search makes the same choice from estimated as from perfect channel state information. The reconfiguration gain over a fixed panel of identical aperture and training budget grows with the user load, and fast morphing proves valuable for conditioning the tensor factorization rather than as a source of beamforming gain.

0.27

Structured Channel Parameter Estimation for RIS-Assisted MIMO Systems via Kronecker and Tensor Factorizations

eess.SP ·2026-09-17 ·Melryllin G. O. Sousa, Jean C. S. Ferreira, Fazal-E Asim
publishedbenchmark similarity 0.67
Abstract

This paper proposes structured channel-parameter estimators for reconfigurable intelligent surface (RIS)-assisted multiple-input multiple-output (MIMO) systems employing uniform rectangular arrays under line-of-sight propagation. By exploiting the Kronecker and multilinear structures of the cascaded channel, we introduce the Successive Kronecker Factorization (SKF) alongside two Third-Order Tensor Parameter Estimation (TOPE) methods: TOPE-ALS and TOPE-HOSVD. These estimators recover spatial signatures from the pilot-filtered signal matrix, and then decouple the corresponding horizontal and vertical spatial frequencies. This structured formulation achieves benchmark estimation accuracy while reducing computational complexity, offering a efficient solution for RIS-aided systems.

0.25

Exact Payload-Decoupling Conditions for Pilot-Only BEM Channel Estimation With Application to OTFS

cs.IT ·2026-09-01 ·Gianmarco Romano, Francesco A. N. Palmieri, Stefano Buzzi, Giovanni Di Gennaro, Amedeo Buonanno
benchmarktheory similarity 0.65
Abstract

In high-mobility doubly dispersive links, basis expansion models (BEMs) reduce channel dimensionality, yet unknown payload symbols generally contaminate conventional matched-pilot channel estimates. This paper establishes the exact conditions under which such estimates become payload-independent and derives a pilot, guard, and data-placement rule that guarantees these conditions. We prove a necessary-and-sufficient zero pilot--data interference (ZPDI) condition under which the matched-pilot least-squares (LS) solution coincides with the maximum-likelihood (ML) estimator for the reduced pilot statistic. When ZPDI holds, estimation requires a single precomputed projection. When it does not, the estimate contains a deterministic, channel-scaled payload bias that persists at high signal-to-noise ratio. A disjoint-support rule, independent of the selected basis, realizes ZPDI through pilot, guard, and data placement. We then specialize the framework to orthogonal time--frequency space (OTFS) and examine its structural and performance consequences. With the generalized complex-exponential BEM (GCE-BEM), the ZPDI estimator remains within about $2$~dB of the perfect channel state information benchmark in bit error rate at speeds up to 500~km/h.

0.10

Simultaneous Direct and Indirect Channel Estimation for RIS-Assisted MIMO Communications

eess.SP ·2026-10-08 ·Daniel V. C. de Oliveira, Daniel C. Alcantara, Fazal. E Asim, Andre L. F. de Almeida, Gabor Fodor
publishedtheory similarity 0.65
Abstract

This paper introduces an enhanced channel estimation method for reconfigurable intelligent surface (RIS)-assisted multiple-input multiple-output (MIMO) communications. Considering the presence of both the direct link from the base station (BS) to the user equipment (UE) and the indirect link \textit{via} the RIS, we formulate a tensor-based receiver for joint direct and indirect channel estimation called the TenDICE algorithm. The proposed receiver relies on an extended parallel factor analysis (PARAFAC) tensor model for the received pilot signals, from which the involved (direct and indirect link) channels are estimated using a simple alternating least squares scheme. The proposed TenDICE method is compared with the state-of-the-art least squares (LS) method, Khatri-Rao factorization (KRF) method, enhanced trilinear alternating least squares (E-TALS), and the theoretical Cramér-Rao lower bound (CRLB) based on normalized mean square error (NMSE) and spectral efficiency (SE). The proposed TenDICE outperforms the LS and E-TALS methods and performs similarly to the KRF methods while estimating the direct channel.

0.38

Statistical Design of Multi-BD-RIS-Assisted User-Centric Cell-Free Massive MIMO

eess.SP ·2026-10-24 ·Mohammad Ezaz, Azadeh Vosoughi
theory similarity 0.64
Abstract · 6 pages, 5 figures. Submitted to IEEE ICC 2027 on Oct 16th 2026

We study the uplink of a user-centric (UC) cell-free massive MIMO system assisted by multiple beyond-diagonal reconfigurable intelligent surfaces (BD-RISs), under imperfect channel state information (CSI) and pilot reuse. The BD-RISs are modeled as reciprocal, lossless, group-connected scattering networks. We first derive the minimum mean-square error (MMSE) estimation statistics for each user's aggregate channel to its serving access points (APs). To avoid frequent CSI acquisition and RIS reconfiguration, we optimize the BD-RIS scattering matrices using long-term channel statistics, allowing their configurations to remain fixed over multiple coherence blocks. Specifically, we minimize the sum of normalized mean-square errors (NMSEs) of the MMSE aggregate channel estimators, subject to the symmetry and unitarity constraints of the group-connected architecture. We develop a product-manifold Riemannian optimization algorithm and analyze its convergence and computational complexity. To evaluate uplink spectral efficiency (SE), we separately derive a closed-form expression for the effective SINR under maximum ratio (MR) combining at the central processing unit (CPU) and establish a lower bound on the achievable ergodic SE. The SINR derivation accounts for the statistical dependence among channels associated with different APs due to shared BD-RIS-assisted propagation paths, including cross-AP second-order statistics under pilot reuse. Numerical results show that moderate group connectivity retains most of the NMSE improvements achieved by full connectivity, with larger optimization gains as BD-RIS-assisted paths strengthen relative to direct AP-user links. They also reveal that lower estimation NMSE does not necessarily lead to higher uplink SE.

0.32

Channel Estimation for Stacked Intelligent Metasurfaces with Mutual Coupling

eess.SP ·2026-10-31 ·Chandan Kumar Sheemar, Giovanni Iacovelli, Symeon Chatzinotas
similarity 0.63
Abstract

Channel estimation for stacked intelligent metasurfaces (SIMs) has relied on the cascade model, which ignores mutual coupling and inter-layer reflection. Under a coupling-consistent multiport model, we show that the pilots are linear in the unknown channel segments and derive least-squares and linear minimum-mean-square-error estimators, an identifiability condition and an exact error decomposition for the reactance training schedule, and a gradient-based schedule design. Cascade-based estimation floors above $0$~dB normalized error at practical layer spacings and collapses the sum rate below that of the bare feed, whereas the proposed estimators retain about $80\%$ of the perfect-channel-knowledge sum rate.

0.28

Two-Stage Refinement Sparse Channel Estimation for Reconfigurable Intelligent Metasurface Antenna (RIMSA) Massive MIMO

cs.IT ·2026-09-19 ·Yakun Ma, Hui-Ming Wang, Jiaping He, Qingli Yan
top venue similarity 0.63
Abstract

To meet the increasing demands for high data rates and large capacity, next generation wireless communication systems require transceivers equipped with a large number of antennas. Massive multiple-input multiple-output (MIMO) with metasurface antennas has emerged as a promising solution. In this paper, we investigate the channel estimation problem for the emerging reconfigurable intelligent metasurface antenna (RIMSA) array systems. Specifically, we develop a two-stage refinement (TSR) channel estimation method based on the compressed sensing (CS) principle. In the first stage, we exploit the antenna structure of RIMSA to receive pilots by setting identical phase response vectors across all RIMSAs. In this manner, the coherence of the measurement matrix under the CS framework is reduced and the channel estimation performance is improved. However, this special design introduces channel direction-of-arrival (DoA) estimation ambiguity and yields an ambiguous candidate DoA set. In the second stage, we optimize the phase responses of the metamaterial elements to resolve the ambiguity and accurately estimate the DoAs and channel coefficients. Overall, the estimation accuracy is improved in the first stage at the cost of ambiguity, and this ambiguity is eliminated in the second stage. We illustrate the performance advantages of the TSR method by presenting the numerical results and comparing it with the existing methods.

0.28