CS Paper Radar

Focusing Efficiency for Large Intelligent Surfaces

Jiawang Li, Alireza Saberkari, Buon Kiong Lau, Mats Gustafsson

eess.SP ·submitted 2026-10-26 17:16 UTC · v1

Abstract

This paper studies wireless power transmission (WPT) with large intelligent surfaces (LISs) in a single-user scenario, with emphasis on power-transfer efficiency. The optimal current distribution on the LIS is derived under a total-power constraint for an arbitrary receiving antenna, providing a theoretical characterization of the maximum achievable focusing efficiency. The analysis shows that the efficiency is strongly affected by the receiving radiation pattern, antenna orientation, and transmission distance. Clear performance differences are observed among practical antenna types for specific orientations, whereas directional averaging makes their average focusing efficiencies much closer. The theoretical findings are further validated by full-wave FEKO simulations, showing good agreement with the predictions of the proposed formulation. These results provide insight into the impact of receiver characteristics and propagation geometry on LIS-enabled WPT and offer a theoretical basis for efficient single-user power-transfer design.

Closest papers

Nearest neighbours by meaning across the whole index.

Near-Field Beamforming Design for Multi-IRS Wireless Beam Routing

eess.SP ·2026-10-07 ·Tao Wang, Changsheng You, Changchuan Yin
published similarity 0.63
Abstract · 5 pages, 3 figures, accepted by IEEE Communications Letters

This letter investigates efficient near-field beamforming designs for wireless communication systems aided by multiple extremely large-scale intelligent reflecting surfaces (Multi-XL-IRSs). Previous studies have mostly assumed far-field channel conditions, based on which angle-based beamforming is adopted for the base station (BS) and IRSs. However, this approach may lead to degraded performance in practical near-field scenarios. To address this issue, we consider near-field channel modeling and formulate an optimization problem aimed at maximizing the received power at the user equipment (UE) by jointly optimizing the beamforming at the BS and IRSs. Given the intractability under the beam training (BT)-based communication framework, the problem is revisited and reformulated. Subsequently, an efficient algorithm based on alternating optimization (AO) is proposed to solve the reformulated problem. Numerical results demonstrate that, in typical setups, our AO-based beamforming designs provide over 170% and 20% received power gains over conventional angle-based beamforming and beam focusing, respectively. Furthermore, the power scaling law derived under far-field conditions no longer holds in near-field scenarios.

0.56

System-Level Gains of Dual-Band RIS: From Wireless Communication to SWIPT

eess.SP ·2026-10-01 ·Aritra Basu, Zina Mohamed, Sonia Aïssa
top venue similarity 0.58
Abstract · This work has been accepted for publication in IEEE Transactions on Communications. 2026 IEEE. Personal use of this material is permitted. P…

This paper introduces the integration of dual-band reconfigurable intelligent surfaces (DBRIS) in wireless system design, and investigates the ensuing performance gains in different application scenarios. This type of metasurfaces offers a compelling technology due to their reduced material usage, compact design, and multi-functional operation across multiple frequency bands compared to single-band RISs. Two representative use cases are considered to assess the achievable performance gains with the said integration, namely, DBRIS-assisted wireless communication, and DBRIS-assisted simultaneous wireless information and power transfer (SWIPT). For the first design, where the DBRIS is deployed as a relay, we focus on the energy efficiency (EE) maximization of the communication system. An alternating manifold method is proposed for the joint optimization of the source transmit power and the DBRIS phase shifting. For the second design, we investigate a DBRIS-assisted SWIPT system using a novel power splitting approach. An EE metric is defined, and an alternating optimization algorithm is developed to maximize it. Numerical results validate the advantages of the proposed design architectures as well as the proposed optimization framework. In particular, we highlight the energy efficiency gains enabled by the DBRIS as compared to operations with conventional single-frequency surfaces, in both application scenarios.

0.40

Power from Space: Coordinated Satellite Charging for Off-Grid Wireless Systems

eess.SP ·2026-08-26 ·Osmel M. Rosabal, Amirhossein Azarbahram, Mateen Ashraf, Mohammad Shehab, Abdul Basit Khattak +2 more
published similarity 0.57
Abstract · 7 pages, 4 figures, 2 tables, submitted to IEEE Internet of Things Magazine

Satellite-enabled wireless power transfer (WPT) may be a transformative solution for charging Internet of Things (IoT) devices in off-grid scenarios where traditional technologies struggle to efficiently meet urgent energy demands. In this article, we review the advantages and limitations of microwave-based long-distance charging for satellite-enabled WPT. We then introduce our vision of coordinated space-based WPT, where multiple satellites jointly serve networks of ground devices. Potential use cases are presented highlighting application requirements. We evaluate the average received power at the target locations using two coordination schemes and perform a statistical characterization of the power spillover on undesired locations. We also shed light on the performance of inter-satellite laser WPT for different operating distances and transmit-receive apertures of the peer satellites. Moreover, we explore the integration of metasurfaces on satellite apertures and ground networks to boost energy conversion efficiency, scalability, and beam management. Finally, we outline relevant challenges and research directions towards implementing our vision.

0.36

Secure Wireless Information Transfer and Energy Harvesting in HAPS-Based Network

cs.IT eess.SY ·2026-08-23 ·Khaled Humadi, Gunes Karabulut-Kurt, Wessam Ajib, Wei-Ping Zhu
published similarity 0.54
Abstract

High-altitude platform station (HAPS) serves as a promising enabler for wide-area connectivity of low-power wireless devices, particularly in remote and underserved regions. However, the strong line-of-sight characteristics of HAPS links increase the risk of eavesdropping, while the limited energy budget of ground devices remains a major operational constraint. In this work, we propose a secure wireless information and energy harvesting framework for HAPS-based networks in the presence of spatially distributed eavesdroppers. The proposed system integrates friendly jamming and power transfer nodes equipped with null-steering capability antennas, such that they not only degrade the reception quality at eavesdroppers but also act as additional radio-frequency energy sources for legitimate users. A time-switching wireless information and power transfer architecture is adopted at the user side. Under this framework, we derive tractable expressions for the joint rate-energy coverage and the average secrecy rate using stochastic geometry tools. Numerical and Monte Carlo results validate the developed analysis and reveal key design trade-offs among the time allocation factor, null-steering-zone radius around each user, and jammer transmit power. In particular, the results show that properly coordinated null-steering jamming can simultaneously support secure communication and adequate wireless power transfer, while an appropriate choice of system parameters, such as time allocation factor and jamming power, is required to balance harvested energy, communication reliability, and secrecy performance.

0.31

Bringing Environmental Enhancement Back to Its Physical Essence via Specular Reflecting Surfaces

cs.IT ·2026-08-15 ·Qingxiao Huang, Qianyao Ren, Yiqin Deng, Jun Huang, Yang Kun +1 more
similarity 0.54
Abstract

Intelligent control of wireless propagation environments is crucial for future network capacity and reliability. Unlike circuit-controlled reconfigurable intelligent surfaces (RIS), mechanically actuated specular reflecting surfaces (SRS) offer a simpler and potentially more cost-effective alternative. In this paper, based on the tractable ray-based cascaded channel model with power-projection correction, we investigate the fundamental operational behaviors of an ideal SRS in free space. Specifically, in the angle-aligned near field, edge reflections cause non-constructive combining, resulting in a damped oscillatory convergence of the gain to an aperture-independent constant. We further obtain the far-field behavior, unbounded-aperture asymptotics, an optimal aperture size and reflection angle, and a gain-based near/far-field boundary. For misalignment, we provide accurate approximations for small and large apertures via center-point and stationary-point analyses. We also define the SRS beam pattern, derive analytical 3-dB beamwidths, and quantify the effective region where a main lobe exists. Finally, we derive a closed-form achievable-rate for an SRS-aided communication system. Numerical results validate the proposed expressions, reveal distinct near-/far-field behaviors of specular reflection, and show that SRS can outperform RIS in the far field due to continuous aperture and angular-resolution control and stronger power projection.

0.04

Reconfigurable Intelligent Surfaces: Architectures, Models, and Applications

eess.SY ·2026-10-05 ·Mojtaba Fallahzadeh, Mohammad Hossein Koohi Ghamsari, Alireza Mallahzadeh, Amirhossein Ghasemi, Gabriele Gradoni +1 more
similarity 0.54
Abstract

Reconfigurable Intelligent Surfaces (RIS), also known as programmable metasurfaces, have emerged as a promising technology for next-generation wireless communication systems by enabling programmable control over the propagation environment. Through dynamic manipulation of the phase, amplitude, and polarization of electromagnetic waves, RIS introduces new degrees of freedom for enhancing coverage, spectral efficiency, energy efficiency, and interference management. This article reviews recent advances in RIS-enabled wireless communications, focusing on RIS architectures, emerging design and analysis techniques, and their impact on system-level performance. Key challenges related to scalability, hardware non-idealities, channel modeling, and control overhead are discussed, along with promising solutions and future research directions toward practical RIS deployment in beyond-5G and 6G networks.

0.15

Active-Element Configuration for Energy-Efficient Secure Near-Field ISAC With Hybrid RISs

eess.SP ·2026-11-14 ·Ling Zhuang, Ximing Xie, Fang Fang, Zhizhong Zhang
similarity 0.53
Abstract

Hybrid active-passive reconfigurable intelligent surfaces (HRISs) are promising for secure near-field integrated sensing and communication (ISAC) through selective signal amplification and spherical-wave beam focusing. However, fixed active-element layouts limit flexibility in exploiting element-dependent near-field channels while balancing secrecy performance, sensing accuracy, and circuit power consumption. This paper develops a joint active-element configuration and transmission design for a large-aperture HRIS-assisted system, where sensing targets act as potential eavesdroppers. The design adapts both the number and spatial distribution of active elements by exploiting near-field phase and attenuation variations. We establish a bidirectional signal and power model with full-aperture reflection and active-subset amplification for downlink signals and uplink echoes. Based on the derived three-dimensional localization Cramér-Rao bound, we formulate a mixed-integer non-convex secrecy energy efficiency (SEE) maximization problem under user-rate, localization, and power constraints. To solve this problem, we propose an alternating optimization framework combining successive convex approximation, a penalty convex-concave procedure, and full-aperture reweighted group-sparse selection. The selection method scores and ranks elements to generate binary candidate configurations without exhaustive search. After refining continuous HRIS variables for each candidate, we select the feasible configuration with the highest genuine SEE. Simulation results demonstrate higher SEE with lower base station transmit power than fixed-layout HRIS schemes and a fully passive RIS baseline.

0.14

Movable Antennas Enabled Wireless Powered Networks: Principles and Technologies

cs.NI ·2026-09-07 ·Zhendong Li, Yiran Zheng, Tianyu Li, Zhou Su, Wen Chen +1 more
similarity 0.53
Abstract

As an emerging framework, movable antenna (MA)-enabled wireless powered networks (WPNs) have attracted growing attention. WPNs integrate wireless communication and energy transfer. MA can dynamically adjust the position of antenna units by introducing additional spatial degrees of freedom, so as to make full use of channel gain, optimize the effect of energy beamforming, and further improve the performance of WPNs. In this article, we first classify the implementations of MA by driving architectures, and review the fundamental principles of WPNs. We then highlight the key advantages of MA-enabled WPNs in enhancing wireless power transfer efficiency, realizing flexible and adaptive beamforming, and improving system robustness and interference resilience. Furthermore, four representative application scenarios and three key enabling technologies are discussed. A case study is also presented to show the reduction in transmit power brought by MA for WPNs. Finally, we discuss the challenges and future directions of MA-enabled WPNs, aiming to provide reference for future research and practice.

0.27