CS Paper Radar

State-Dependent Delay Modeling of Wind-Farm Wake Dynamics

Sengiyumva Kisole, Jungbae Chun, Peter Seiler, Matthew M. Peet

eess.SY ·submitted 2026-10-27 23:15 UTC · v1

Abstract

Turbines convert wind to electrical power. In the wake of a turbine, wind speed is reduced in proportion to the amount of power extracted. In a wind farm, downstream turbines may be located in wake of an upstream turbine, requiring coordination to yield maximum power generation. This paper creates a state-dependent delay model for a two turbine wind farm. The upstream turbine creates a wake that diminishes the wind speed at the downstream turbine. Changing the upstream turbine operation will affect the downstream turbine after a delay that depends on the wind-propagation time between them. This delay depends on the upstream power extraction and it can destabilize the combined dynamics. Conventional models of this effect rely on nonlinear partial differential equations (PDEs). Control design and analysis with such models is difficult with established methods. We first show that the PDE model can be represented by an Abel-type state-dependent delay differential equation. The equation has an implicit solution. To obtain an explicit representation, we then introduce a simplified state-dependent delay model. Both models predict destabilizing interactions between the two turbines. Numerical examples illustrate delay-induced oscillations using the simplified model and verify their effectiveness in simulation.

Closest papers

Nearest neighbours by meaning across the whole index.

Distributed Model-Free Turbine Repositioning for Wake Overlap Minimization in Floating Offshore Wind Farms

eess.SY math.DS ·2026-10-06 ·Zekai Chen, Ryozo Nagamune
similarity 0.63
Abstract · This paper has been submitted to the American Control Conference (ACC) 2027

This paper presents a model-free method for turbine repositioning control in floating offshore wind farms. The method uses a distributed online optimization framework to mitigate the wake effect. Conventional approaches rely on centralized, model-based control architectures, which suffer from poor practical feasibility. To overcome this limitation and address nonconvexity and inaccessible gradient information, we incorporate physics-informed knowledge of wake dynamics into the control system design. We demonstrate the effectiveness of the proposed method by comparing it with a centralized, model-based baseline in mid-fidelity simulations. Results indicate that the proposed method achieves slightly better performance while significantly reducing computational cost.

0.23

EndoWake: Modeling Wind by Linear Programming for Wind Farm Layout Optimization

cs.CE math.OC ·2026-09-30 ·Martina Fischetti, Matteo Fischetti
similarity 0.56
Abstract · 30 pages + 12 pages of supplementary material (appended after the references). Replication package: https://doi.org/10.5281/zenodo.22017424

The Wind Farm Layout Optimization problem consists of placing a given number of turbines within a given area so as to maximize energy production. One of its main challenges is the wake effect between turbines, which can strongly affect production and is a cumbersome function to evaluate and to embed in an optimization framework. In this paper we introduce a new endogenous wake model (EndoWake), based on the idea of treating the wind speed at every grid point as a decision variable, linked to its upwind neighbors through linear propagation constraints. This makes it possible to incorporate the wake equations directly into a Mixed-Integer Linear Programming (MILP) model. We then develop such a MILP model and, in particular, introduce a new class of valid "band" inequalities, showing that they substantially strengthen the root bound. Building on this, we design a branch-and-check scheme: the master problem retains only the site variables together with one hypograph variable per cell and scenario, integer solutions are evaluated by an exact linear-time oracle, and the optimality cuts are problem-specific "upwind cuts". Computational results are reported on a ladder of square grids under a four-sector axial wind rose, demonstrating the effectiveness of the proposed improvements.

0.58

Model Predictive Control of Wind Turbines: A Model-Oriented Review of Prediction Models, Control Objectives, and Nonlinear Aerodynamic Formulations

eess.SY math.DSmath.OC ·2026-10-22 ·Roya Khalili-Amirabadi, Mohsen Jalaeian-Farimani, Mahdi Ghane
published similarity 0.52
Abstract · Khalili-Amirabadi, R., Jalaeian-Farimani, M., & Ghane, M. (2026). Model Predictive Control of Wind Turbines: A Model-Oriented Review of Pred…

Model predictive control (MPC) has been applied to wind-turbine regulation with markedly different internal prediction models, ranging from linearized low-order turbine models to nonlinear, aeroelastic, floating, and data-driven predictors. This review organizes the literature primarily by the model propagated by the controller and treats model order, predictor representation, MPC formulation, control objective, and validation plant as separate descriptors. Primary studies show that low-order linear or piecewise-affine predictors are attractive for constrained power and speed regulation, whereas flexible drivetrain, structural, and floating models are needed when drivetrain twist, tower motion, blade loads, or platform dynamics are explicit control quantities. Nonlinear and economic MPC studies further demonstrate coordinated pitch/torque control across broad operating regions, while preview, repetitive, and data-driven formulations address wind prediction, periodic loads, and model mismatch. Particular attention is given to aerodynamic pitch dependence: variable-pitch turbine dynamics can be non-affine with respect to applied pitch, and the term NMPC alone does not prove that the original nonlinear pitch map is retained inside the optimizer. The review therefore adopts a conservative, equation-based classification for direct nonlinear applied-pitch propagation. Here, direct nonlinear applied-pitch propagation means that the applied pitch at each prediction step is evaluated inside the original nonlinear aerodynamic map, rather than replacing that dependence by a linearized, scheduled, piecewise-affine, or learned surrogate. The literature supports a remaining integration challenge at the intersection of flexible drivetrain prediction, nonlinear aerodynamic pitch treatment, explicit constraints and load objectives, and validated adaptive or learned model correction.

0.35

Offline Reinforcement Learning for Wind Farm Control: A Wind Tunnel Study under Dynamic Wind Directions

cs.LG ·2026-09-11 ·Yuhan Su, Hongyang Dong, Simone Tamaro, Filippo Campagnolo, Carlo L. Bottasso +1 more
benchmark similarity 0.52
Abstract

This paper addresses the wind farm power maximization problem in the presence of wind direction changes. Specifically, a model-free Modified Twin Delayed Deep Deterministic Policy Gradient with Behavior Cloning (MTD3-BC) algorithm is proposed to tackle this task through yaw control under varying wind direction conditions. MTD3-BC is an offline reinforcement learning (RL) algorithm that aims to infer good behavior from only a precollected offline dataset. Additionally, to ensure smooth and moderate yaw adjustments, a new action consistency term is introduced into the policy optimization objective. Unlike online RL methods, MTD3-BC does not require extensive interactions with a wind farm simulator during training, significantly reducing computational costs and training time. A wind tunnel experiment is conducted to validate the effectiveness of the algorithm under varying wind directions. The results demonstrate that MTD3-BC successfully mitigates wake effects, delivering farm-level power gains of approximately 10\% over the baseline greedy strategy and performance on par with a data-calibrated model-based wake-steering benchmark, while requiring no wake model and only a small fraction of the training cost of online RL. To our knowledge, this is the first time an offline RL wind farm control policy has been validated and demonstrated experimentally.

0.30

Stochastic Sequential Feedback Optimization for Wind Farm Control under Time-Varying Inflow

eess.SY math.OC ·2026-10-02 ·Shijie Huang, Sergio Grammatico
benchmark similarity 0.50
Abstract

We consider steady-state optimization of nonlinear dynamical systems under time-varying stochastic operating conditions, where the objective is an expected-value function over the current operating-condition distribution, so that changes in the distribution induce a moving stochastic optimum. To address this problem, we propose stochastic sequential feedback optimization (S2FO), which combines projected feedback-gradient updates with sequential sensitivity estimates obtained by linearizing the plant at realized stochastic operating conditions. We analyze the closed-loop performance of S2FO through expected dynamic regret, instantaneous tracking in expectation, and almost-sure convergence under diminishing step sizes. We then apply the method to wind farm power maximization under time-varying stochastic inflow. Simulations on a benchmark layout and on a realistic offshore wind farm show that S2FO improves average power generation when persistent wake interactions are present, and that its advantage decreases as wind-direction variability increases.

0.15

Noise Steering: Exploiting Wake Steering and Acoustic Directivity for Noise-Constrained Wind Farm Control via Reinforcement Learning

cs.AI eess.SYphysics.ao-phphysics.flu-dyn ·2026-10-27 ·Martín de Frutos, Baptiste Corban, Claire Bizon Monroc, Ana Bušić, Donatien Dubuc +2 more
similarity 0.48
Abstract · 17 pages, 11 figures

Existing noise mitigation strategies for wind farms usually consist in reducing turbines power output, without accounting for the wake interactions between them and the noise emission directivity. This leads to over-conservative policies and unexploited wind power. Yet, turbine yaw can simultaneously affect wake interactions and the direction of noise emission, offering an additional degree of freedom for farm-level noise control. We therefore propose Noise Steering, a model-free reinforcement learning (RL) strategy that jointly controls turbine yaw angles and power setpoints to maximise farm power while satisfying a local noise constraint in a defined region. To enable training at a reduced computational cost, a low-fidelity acoustic model is coupled with the steady-state FLORIS simulator. The RL agent effectively learns how to redirect wakes and noise directivity away from the protected region while redistributing power across the farm. On a six-turbine test farm, the policy satisfies the 40 dB noise constraint throughout the full range of turbulent winds, with an average power deficit of only 2% relative to greedy unimpeded control, and up to 7.7% at high wind speeds. In comparison, the industry-standard noise-reduced operation (NRO) baseline here generates an average power loss of 17%. When deployed in the higher-fidelity FASTFarm simulator, the policy largely retains its performance under steady and turbulent inflow, despite differences in simulation fidelity. These results demonstrate the potential of combining yaw control and power derating through RL to improve the power-noise trade-off in wind farm operation.

0.20

Passivity Control for Synchronous Machine Systems using Battery, Field Current and Governor Actuation

eess.SY ·2026-11-17 ·Maryam Khodabakhshloo, Elizabeth L. Ratnam, Ian R. Petersen
similarity 0.47
Abstract

The passivity of synchronous machines enables power system stability to be established from local conditions. A recent state-feedback design enforces robust passivity using battery actuation at the machine terminal bus. This paper extends that design to a model that includes the field winding and the dynamics of a steam turbine and its governor. The extended model provides two additional actuator signals: the exciter input and the governor input. The nonlinear terms in the model depend on speed and field current deviations, and are represented as bounded uncertainties. Robust positive real conditions are derived in terms of a single algebraic Riccati equation. From its solution, a state-feedback controller is designed in closed form. Numerical results show that, unlike the design with battery actuation alone, the proposed controller leads to passivity at all loading levels when the damping is low.

0.09

Fast-varying Natural Frequencies and Damping Ratio Identification for Linear Time-Varying System

cs.LG ·2026-09-17 ·Melisa Bozaci, Alice Cicirello
unusual similarity 0.47
Abstract · Preprint submitted to Mechanical Systems and Signal Processing

This work proposes a physics-enhanced machine learning approach for the system identification of Linear Time-Varying (LTV) systems under time-varying operating conditions in terms of fast-varying natural frequencies and damping ratios by combining a long short-term memory network with an Extended Kalman Filter (EKF). The proposed approach uses vibration data (displacement and velocity measurements), domain knowledge of modal damping ratios, and a physics-based model that can yield an approximate natural frequencies time-dependency model. The approach is validated using synthetic data generated from a finite element model of a 2-blade offshore wind turbine under realistic environmental and operating conditions. This system displays fast time-varying frequencies due to operating conditions, whose identification is particularly challenging because of the wind and wave loading. The robustness of the proposed approach is assessed under assumed incorrect system information (e.g. damping ratio). The proposed approach is evaluated across different environmental and operating conditions to show its applicability to different operating regimes. The results show the approach can accurately identify the selected fast-varying natural frequency, 1st Fore-Aft (FA-1) mode, with a maximum root mean square error of 0.0012 Hz. The results demonstrate that the model trained on EKF estimates depends on accurate damping values, whereas the model trained on physics-based data exhibits robustness to incorrect damping assumptions. The approach is extended to damping ratio identification for the selected mode by estimating the root mean square error between models trained on EKF estimates and physics-based data. The results show that the approach can yield a good approximation of the FA-1 mode damping ratio using grid search, offering an improvement over covariance-driven stochastic subspace identification.

0.30