CS Paper Radar

Dynamic Traffic Modeling using Equivalent Circuit Models

Joseph Moyalan, Ricardo de Castro, Iman Ebrahimi, Xuchang Tang, Xinfan Lin

eess.SY ·submitted 2026-11-06 21:32 UTC · v1

Abstract

This paper presents an equivalent circuit model (ECM) for dynamic traffic modeling by exploiting analogies between electrical and transportation variables. Vehicle concentration is represented by capacitor voltage, while traffic flow is modeled using controllable current sources. The proposed formulation is shown to preserve the conservation and sending/receiving relationships of the spatially discretized Lighthill Whitham Richards traffic model. The framework is extended to restricted inflow, traffic signals, and two road merging and diverging scenarios. Validation against microscopic Simulation of Urban MObility (SUMO) simulations, involving traffic signals, two-road merging, and single-road diverging scenarios, demonstrates that the proposed ECM successfully reproduces the principal macroscopic traffic dynamics, including queue formation, backward congestion propagation, vehicle accumulation, saturation, and subsequent traffic recovery.

Closest papers

Nearest neighbours by meaning across the whole index.

MIXSim: A multiclass first order traffic model with composition-dependent dynamics for mixed-autonomy urban networks

eess.SY math-ph ·2026-10-16 ·Muhammad Haris, Claudio Roncoli
similarity 0.63
Abstract

This paper presents a novel multiclass first order macroscopic traffic model for mixed-autonomy in signalized urban networks, called MIXSim. Human driven vehicles (HDVs) and Connected and Automated Vehicles (CAVs) are represented as separate classes while origin-destination information is retained through commodity specific states. The local vehicle class composition and class specific driving behaviour characteristics determine the parameters of a composition-dependent triangular fundamental diagram. At signalized intersections, the composition of movement demand additionally determines the saturation flow rate, while the realized movement flow is constrained by demand, effective green time, and downstream receiving capacity. Numerical experiments investigate different CAV penetration levels and CAV time gaps, together with alternative signal control strategies. The numerical experiments illustrate how changes in CAV penetration and CAV time gap affect network performance under the tested conditions, and demonstrate the use of MIXSim for comparing signal control strategies across different mixed traffic regimes.

0.21

Beyond corridor averages: Lane-level validation of microscopic freeway simulation with empirically parameterized arrivals

cs.CE ·2026-11-18 ·Korede R. Bishi, Casey Bowman, John A. Miller
similarity 0.57
Abstract

Traffic flow modeling is an essential part of civil planning around the world, and traffic simulation is an important component of the analyses that city planners must perform to ensure safe and efficient road networks for their citizens. This work advances microscopic traffic simulation through lane-level validation of speed and flow dynamics, addressing a critical gap in conventional macro-aggregated approaches. We systematically evaluate the trade-offs between numerical integration methods and vehicle arrival processes when reproducing empirical trajectory data from California's freeway network. Results demonstrate that numerical-integrator choice has negligible impact on simulation accuracy, with less than one percent variation across eight methods, while vehicle arrival-process modeling substantially affects fidelity. The shifted Erlang-2 distribution reduces flow-prediction error by approximately 28% compared to Poisson processes by enforcing a realistic minimum headway. Lane-level validation across five detector stations reveals lane-specific dynamics that aggregated metrics often obscure.

0.32

Stochastic Shockwave Dynamics in First-Order Traffic Flow

eess.SY physics.soc-phmath.APmath.PR ·2026-10-16 ·Yanlin Zhang, Alireza Talebpour
unusual similarity 0.57
Abstract

Moving congestion fronts vary across realizations even when the traffic-flow law is fixed. This paper develops a generator-based formulation of the Lighthill--Whitham--Richards (LWR) model with random initial density and a deterministic fundamental diagram. Randomness enters through the initial spatial density field; every realization follows the same conservation law. For a smooth strictly concave fundamental diagram, we adapt established one-sided spatial Markov closure to traffic variables under the stated spatial-process and regularity assumptions, and derive a kinetic balance for physically normalized front intensities. Evolving the spatial generator provides density laws and congestion-front statistics without solving a road-grid problem for every realization. The formulation is continuous in physical space and time, while its numerical implementation approximates density state and integrates physical time. Four experiments distinguish deterministic consistency from stochastic comparison. Riemann and signal examples recover independently constructed exact LWR solutions. Smooth strictly concave approximations approach the deterministic triangular-diagram signal solution over the tested finite horizons; this does not establish stochastic closure at contacts or the capacity kink. A matched Monte Carlo Godunov ensemble evaluates front counts, sizes, mergers, and density distributions. The evolved generator also yields an instantaneous travel-time distribution for a frozen density field, compared with the same functional of the matched Godunov profiles. This quantity is not experienced travel time through evolving traffic. Resolution checks identify remaining normalization and small-front-loss effects. The contribution is direct evolution and interpretation of traffic-state and front distributions under a fixed first-order traffic law.

0.23

Integrating Traffic Noise Emission Modelling into Variable Speed Limit Control

cs.RO ·2026-09-01 ·Jiawen Meng, John Pravin Arockiasamy, Alexey Vinel
published similarity 0.56
Abstract · Accepted for publication at the IEEE Intelligent Transportation Systems Conference (ITSC), 2026

Road traffic noise remains a major environmental challenge, yet most speed management strategies are static and do not respond to short-term variations in traffic noise emissions. Although variable speed limit (VSL) systems are widely deployed for safety and congestion mitigation, traffic noise is rarely treated as an explicit operational control objective. This paper proposes a noise-aware VSL framework that integrates aggregated traffic-state estimation with a simplified CNOSSOS-EU-based emission indicator. A stage-based controller with time-varying reference thresholds dynamically adjusts discrete speed-limit levels in response to estimated emission conditions. The framework is evaluated using microscopic traffic simulation calibrated with empirical motorway data and replicated across multiple stochastic realisations. Over a 24-hour evaluation period, the adaptive strategy reduces the receiver-based equivalent sound level by 2.9 dB(A) relative to unrestricted traffic conditions, while maintaining an average vehicle speed approximately 11.3 km/h higher than a permanently imposed low-speed regime. Period-wise analysis shows that speed reductions are activated selectively when emission levels approach calibrated targets, rather than enforcing a constant intermediate limit. Traffic stability indicators reveal moderate increases in speed variability compared with unrestricted operation, but substantially lower braking intensity than under uniform low-speed enforcement. These results demonstrate the feasibility of integrating environmental performance indicators into operational speed control, providing a practical complement to conventional infrastructure-based noise mitigation measures.

0.27

A Collision-Aware Predictive Rerouting Framework for Connected and Automated Vehicles

eess.SY ·2026-10-13 ·Tony Kinchen, Ting Bai, Andreas A. Malikopoulos
benchmark similarity 0.54
Abstract · 15 pages

In this paper, we investigate the problem of mitigating non-recurrent congestion in urban transportation networks through predictive and adaptive routing for connected and automated vehicles (CAVs). We propose a collision-aware predictive rerouting framework that integrates microscopic SUMO simulation, DCRNN-based spatiotemporal traffic-state forecasting, collision-window lookahead, and multi-objective route scoring. The routing controller uses predicted congestion, live emission information, route-length penalties, and incident-window constraints to decide when CAVs deviate from their current routes. The completed simulation campaign across three urban network scenarios, five CAV penetration levels, three random seeds, and multiple benchmark rerouting strategies shows that the proposed full framework does not dominate all baselines in aggregate travel time, distance, or emissions. Instead, its principal advantage is operational stability: it maintains comparable network-level efficiency while substantially reducing rerouting frequency relative to active rerouting baselines. These results demonstrate both the promise and the tradeoffs of embedding graph-based prediction and collision awareness into real-time CAV rerouting, and they motivate further work on forecast calibration, uncertainty-aware prediction, and system-level fairness between CAV and non-CAV traffic.

0.11

Traffic State Prediction and Control Using a Koopman Operator Framework with Polynomial Observables

eess.SY ·2026-10-14 ·Shakib Mustavee, Arvind Singh, Shaurya Agarwal
similarity 0.54
Abstract

In this paper, we develop a Koopman operator framework for modeling and control of traffic flow governed by the Lighthill--Whitham--Richards (LWR) conservation law. We show that the nonlinear dynamics induced by the Greenshields flow--density relation naturally motivate a dictionary of polynomial observables, while the controlled dynamics become bilinear in the lifted Koopman coordinates. A reduced-order Koopman model is identified from spatio-temporal traffic-density snapshots and used as the prediction model in a model predictive control (MPC) framework for ramp metering. The resulting Koopman-MPC is compared with two predictive control baselines that use, respectively, a fixed linearized LWR model and the nonlinear finite-volume LWR model. In a one-hour freeway experiment, the Koopman-based controller maintains the traffic density below the critical Greenshields value and closely reproduces the behavior of the nonlinear PDE-based MPC, with a maximum-density difference below 1%. The Koopman predictor also reduces the mean online model-evaluation cost by approximately one order of magnitude relative to the nonlinear PDE predictor. In contrast, the linearized LWR predictor is computationally cheaper but exhibits substantially larger prediction errors and yields a more conservative metering policy. These results demonstrate that the analytical structure of the nonlinear traffic conservation law can be exploited to construct an interpretable data-driven surrogate for efficient traffic prediction and control

0.24

Ramp Metering Control via Hybrid State Deep Reinforcement Learning in Partially Observable Connected Vehicle Environments

cs.LG cs.AImath.OC ·2026-10-05 ·Youcef Mehamlia, Nadir Farhi, Meriem Bouali
code/data similarity 0.53
Abstract

Freeway on-ramp merges are major sources of congestion, causing significant economic and environmental costs. While Deep Reinforcement Learning (DRL) offers a promising solution for ramp metering, existing approaches rely primarily on aggregated macroscopic data. Connected vehicles (CVs) provide vehicle-level observations that can complement aggregate traffic measurements, but their limited penetration produces incomplete microscopic information. This paper proposes a hybrid observation representation combining macroscopic traffic measurements with a two-channel grid encoding observed CV presence and speed. A Dueling Double Deep Q-Network processes these inputs to select ramp-metering green durations. The controller is trained under varying traffic demands and CV penetration rates and evaluated against ALINEA and macroscopic-only DRL variants in SUMO. Across 50 matched evaluation scenarios, the hybrid controller under partial CV visibility reduces the reported total travel time by 11.4 % and mean spillback duration by 84.9 % relative to ALINEA. Evaluating the same trained policy with full CV visibility yields a further travel-time reduction of approximately 1.6 %. Analysis across penetration rates suggests that the performance gap decreases as microscopic observations become more complete. These results support the use of complementary macroscopic and sparse microscopic observations for learning-based ramp metering. The source code implementation of the model is available at: https://github.com/youcefMehamlia/Multimodal-DRL-RMC

0.28

Balancing Mobility Efficiency and Environmental Exposure During Mega Events: A Multi-agent Routing Framework

cs.MA cs.CY ·2026-10-26 ·Xinyue Liu, Qiumeng Li, Suhong Zhou, Junwen Lu, Jiali Zhou +1 more
similarity 0.52
Abstract

Mega events can generate concentrated travel demand, intensifying congestion around venues and increasing travelers' environmental exposure. Existing traffic management strategies focus on travel efficiency, with limited attention to exposure risks. Taking mega-event travel as a short-term high-demand scenario, this study develops an exposure-aware multi-agent routing framework integrating road-network conditions, event-induced demand, background traffic, and environmental data within a unified simulation environment. Motorized travelers optimize travel efficiency, whereas micro-mobility travelers consider travel time and dynamic exposure to traffic-related PM2.5 and noise. We compare the framework with shortest-distance, congestion-aware, and exposure-aware routing baselines. Results show that, under high demand, the SARSA-based framework reduces vehicle travel time by 34.59% and cumulative environmental exposure by 58.65%, while micro-mobility travel time remains nearly unchanged. Exposure reduction is jointly driven by vehicle-side congestion mitigation and low-exposure routing. The framework provides quantitative support for vehicle diversion, low-exposure route guidance, and health-oriented traffic management in short-term high-demand scenarios.

0.21