CS Paper Radar

Design and Evaluation of Secure Distributed Chaotic Image Encryption on ESP32-S3

Mohammed Almozaini, Fazal Noor, Sohail Alhazmi

cs.CR ·submitted 2026-11-07 09:02 UTC · v2
unusual

Abstract

The limited computational resources of Internet of Things (IoT) devices present challenges for secure image processing. This paper presents a distributed chaotic image encryption system using independent Wi-Fi-connected ESP32-S3 microcontrollers. A master-worker architecture distributes image blocks through master-coordinated chaotic sequence management, maintaining one logically continuous chaotic sequence by assigning block-specific starting states independently of worker assignments. The implemented system uses reversible chaotic substitution (SUBSTITUTE), while Elliptic Curve Digital Signature Algorithm (ECDSA)-signed discovery messages and Transport Layer Security (TLS) 1.3 with mutual authentication secure device communication. Experimental evaluation using one, two, and four workers demonstrates a reduction in execution time from 43.215 to 15.878 seconds, achieving a speed-up of 2.72 times. The encrypted image achieves a Shannon entropy of 7.999940 bits/byte and near-zero adjacent-pixel correlation. Exact image recovery is verified through matching Secure Hash Algorithm 256-bit (SHA-256) hashes and a Structural Similarity Index (SSIM) value of 1.0. Additional experiments demonstrate successful encryption and decryption using different worker counts and block sizes, automatic task reassignment following worker failure, and rejection of a mismatched private key during TLS authentication. These findings demonstrate the feasibility of secure, flexible, and distributed chaotic image processing across independent resource-constrained IoT devices.

Comment
12 pages, 10 figures, 5 tables. Corrected spelling of an author's name; research content unchanged

Closest papers

Nearest neighbours by meaning across the whole index.

Security and robustness analysis of encrypted communications for local home automation: ESPHome Native API and MQTT over TLS 1.3

cs.CR ·2026-10-12 ·Carlos Roberto Gonzalez-Escarpeta, Juan Eduardo Garcia Sanchez, José Antonio Hernandez Reyes, Ricardo Francisco Martinez-Gonzalez
published similarity 0.57
Abstract · 14 pages, 3 figures, 1 table. Systematized review. Submitted to the International Journal of Network Security & Its Applications (IJNSA)

The expansion of the Internet of Things (IoT) in residential and local automation environments has highlighted the limitations of considering the internal network as an inherently trusted domain. Man-in-the-middle (MitM) attacks, such as ARP spoofing, can allow traffic interception or manipulation when communications lack appropriate confidentiality, integrity, and authentication mechanisms. This paper presents a systematized review of the security mechanisms used by two communication alternatives between ESP-family microcontrollers and the Home Assistant platform: MQTT protected through TLS 1.3 and the ESPHome Native API, whose encryption is based on the Noise Protocol Framework using the Noise_NNpsk0_25519_ChaChaPoly_SHA256 pattern. The analysis considers four dimensions: cryptographic robustness, attack surface, implementation complexity, and resource consumption. The review identifies significant differences resulting from the architecture and cryptographic model of each alternative. TLS 1.3 provides a standardized framework compatible with public-key infrastructure and formal identity management, though it introduces greater configuration complexity and computational overhead during session establishment. The ESPHome Native API employs a more specialized scheme with lower operational complexity, eliminates dynamic algorithm negotiation, and uses ChaCha20-Poly1305. The resource-consumption analysis relies on measurements published by the projects and manufacturers themselves, not on an experimental test bench, and this limitation is explicitly acknowledged. The results identify the conditions under which each mechanism is appropriate for local home-automation architectures and provide a basis for designing IoT systems that balance security, interoperability, and resource constraints.

0.36

Syntax Element Encryption for H.265/HEVC Using Chaotic Map-Based Coefficient Scrambling Scheme

cs.CR ·2026-08-23 ·Liang-Wei Li, Chung-Nan Lee, Kishu Gupta, Huei-Fang Yang, Ashutosh Kumar Singh
publishedunusualhighly cited similarity 0.54
Abstract

In today's digital landscape, high-efficiency video coding (H.265/HEVC) has emerged as the most widely used video coding standard, employing selective encryption schemes to protect the privacy of video content while maintaining efficient compression performance. However, existing coefficient scrambling methods impose a significant computational load, leading to increased bit rate overhead due to encryption, longer execution times, and insufficient safety measures. To address these issues, a new coefficient scrambling scheme based on \textit{chaotic maps} is proposed. This approach leverages the pseudorandomness, ergodicity, and sensitivity to initial conditions inherent in chaotic maps to generate highly unpredictable coefficient distributions, thereby strengthening security while preserving low complexity. Unlike conventional scrambling, chaotic maps ensure minimal correlation between encrypted coefficients, enhancing resistance against statistical and differential attacks. Additionally, the scrambling conditions are specifically designed to minimize the impact on the bit rate overhead. Furthermore, when combined with syntax element encryption (SEC), which includes motion vector difference (MVD), quantized transform coefficients (QTC), and luma intraprediction mode (Luma IPM), this method effectively distorts video content. The proposed scheme operates synchronously with slices, ensuring that the decryption of video content remains intact even if some slices are lost. Additionally, a random sequence generated by AES-CTR is incorporated with the H.265 encoded stream to protect against chosen-plaintext attacks.

0.63

Post-Quantum Authentication Protocol for Internet of Medical Things

cs.CR ·2026-10-03 ·Kartick Sutradhar, Ranjitha Venkatesh
position similarity 0.50
Abstract

IoMT communication systems should provide origin authentication and ensure integrity protection for the messages produced by patients' devices for transmission to gateways and further processing by other hospital services. With regard to IoMT, this paper discusses tampering, impersonation, and replay attacks on messages provided as medical reports. Long-term security of the communication system is also addressed considering potential quantum attacks. For this purpose, we design a protocol that meets requirements of practical implementation and employs an ISIS like lattice-based construction combined with concepts of the blockchain technology. Patients' devices generate a canonical JSON format medical report containing a timestamp and critical information. Using a nonce, the patients create a cryptographic signature of the message with a challenge generated from hash of a message. The gateway verifies signatures utilizing the public key of a trusted ledger associated with a particular patient and ensures freshness of the transmitted message. To optimize the performance in case when many devices interact with a gateway at once, the gateway performs batch signature validation using vectorized modular linear equations. The trusted ledger uses tamper-resistant REGISTER and TRUST UPDATE entries, maintaining a trust score of each registered patient and updating the value after each ACCEPT/REJECT operation. Our prototype application demonstrates registration procedure of a new patient, signing and verifying medical reports, auditing of the ledger, and performance assessment. Based on our experiments in the prototype, we argue that, when applied to large-scale systems, batch verification is superior to simple signature validation approach.

0.24

Secure Aggregate Encryption with Identity-Based Authentication for Multi-Vendor FPGA Cloud Deployment

cs.CR ·2026-10-08 ·Mukta Debnath, Krishnendu Guha, Debasri Saha, Amlan Chakrabarti, Susmita Sur-Kolay
similarity 0.48
Abstract

Secure deployment of FPGA bitstreams in heterogeneous multi-vendor cloud infrastructures requires scalable authorization, authenticated device access, and bitstream protection throughout the deployment lifecycle. Existing approaches typically address these functions through separate mechanisms, increasing coordination and key management requirements. This paper presents SAEID, a secure FPGA deployment framework that integrates aggregate authorization, certificate-free identity-based device authentication, and identity bound bitstream verification within a pairing based cryptographic framework, with symmetric cryptography used for session binding and AES 256 GCM based bitstream protection. Building on AgEID, an aggregate encryption scheme that enables individual decryption for authorized FPGA devices, SAEID extends the underlying framework to heterogeneous multi vendor deployments by supporting multiple FPGA vendors and IP providers, capability-aware authorization, and dynamic device membership. SAEID provides protection against unauthorized access to future deployments after device revocation and to prior deployments by newly enrolled devices, while retaining constant-size aggregate ciphertexts within each vendor domain and individual decryption. Experimental results demonstrate the practical performance of SAEID, with identity-based device authentication completing in approximately 4.35 ms and device membership updates requiring 4.95 to 5.09 micro seconds for device addition. The aggregate-encryption component exhibits scalable behavior with increasing device-set size. The complete SAEID software decryption path was also validated on a physical ZC702 Cortex A9 platform, requiring 191.126 ms. These results demonstrate scalable aggregate authorization with bounded authentication and dynamic-membership overhead for secure multi-vendor FPGA deployment.

0.25

Lossless Reversible Watermarking for AIGC with Applications in Authentication

cs.CR cs.CV ·2026-11-17 ·Yupeng Qiu, Han Fang, Ee-Chien Chang
hot direction similarity 0.47
Abstract

AIGC watermarking is commonly used for tracing, but it can also support applications such as authentication and tampering detection. We study lossless reversible watermarking, which enables exact recovery of the original watermarked image after permissible distortions. By exploiting the relatively low entropy of the information required for image generation, together with robust latent-space watermarking, we design a framework that preserves sufficient information for lossless recovery. We then apply the framework to AIGC authentication, which generally faces two key challenges. First, the authentication mechanism must resist adaptive adversaries. Second, the content relevant to authentication, such as visual designs or expressed messages, may depend on application requirements that are not known at generation time. To solve these difficulties, we incorporate cryptographic message authentication to provide unforgeability against adaptive attacks. Lossless recovery provides the original image as reference evidence, after which a suitable analyzer can be selected to make the authentication decision. Experiments on Stable Diffusion demonstrate exact recovery under a wide range of distortions.

0.34

Bit-Level Triangular Content-Aware Permutation for Fragile Image Watermarking: Zero False Positive Rate, Single-Bit Sensitivity, and Arbitrary Dimension Support

cs.CR cs.CV ·2026-08-14 ·Zahra Ghoraeian, Mohammad-Reza Sadeghi, Samaneh Mashhadi
similarity 0.47
Abstract · 19 pages, 4 figures, 8 tables

With the growth of digital document exchange, protecting image integrity against attacks such as Vector Quantization (VQ) and collage has become critical. Existing methods are vulnerable to these attacks and limited to fixed image dimensions. This paper presents a novel, dimension-agnostic, fragile watermarking algorithm that enhances security and tamper localization by replacing conventional hash functions with Triangular Content-Aware Permutation (TCA). The image is combined with key-based global noise and divided into blocks. The core innovation is applying content-dependent permutation with intrinsic avalanche effect (TCA) at the bit-plane level, generating a unique content-dependent watermark. For color images, a vertical sandwich transformation merges channels, preserving inter-channel dependency with only 1.62x time increase. The "remainder merging" strategy eliminates padding constraints. Experiments on 50 grayscale and 10 color images under 18 attacks show FPR=0% and FNR=0% for 17 attacks. Salt-and-pepper noise yields negligible FNR of 0.27% (grayscale) and 0.14% (color). Average PSNR is 51.14 dB (8-bit), 75.25 dB (12-bit), and 99.33 dB (16-bit). Embedding and extraction times are 1.61 s and 1.63 s, respectively. The algorithm achieves 100% accuracy against collage, VQ, copy-move, JPEG (quality 5-95), and geometric attacks, providing a secure solution for digital forensics, medical imaging, and legal document authentication.

0.10

A Non-Invasive Cloud-Based Migration Strategy for Post-Quantum Cybersecurity in Smart HVAC Systems: Architecture, Implementation, and Empirical Evaluation

cs.CR cs.AIeess.SY ·2026-08-19 ·Mahedee Zaman Moon, Kaysarul Anas Apurba, Md Hasibul Hasan, Sk Md Mizanur Rahman
similarity 0.46
Abstract · 27 pages, 12 figures (3 architecture diagrams, 9 experimental plots), 6 tables. Preprint; work in progress. Presents a non-invasive post-qua…

Legacy smart HVAC controllers rely on vendor-cloud TLS secured by ECDH and RSA, both broken by Shor's algorithm, and typical 10-15 year lifespans mean today's devices remain in service through the quantum-threat era. Direct on-device post-quantum cryptography is infeasible: an ESP32-S3, representative of capable HVAC hardware, has only 339 KB free heap against the 900 KB ML-KEM-768 requires, and even classical ECDH-P256 keygen (111.93 ms) dwarfs hardware AES-128 (0.032 ms). We propose a non-invasive PQC proxy, requiring no device, firmware, or vendor-cloud changes, performing ML-KEM-768 encapsulation and ML-DSA-65 authentication (NIST FIPS 203/204) with AES-256-GCM session keys via HKDF, implemented with Open Quantum Safe liboqs on a Raspberry Pi 4B gateway. Over 500 runs, the post-quantum handshake (Steps 1-6) completes in 2.48 ms, 0.38 ms slower than classical baseline, with PQC computation around 8% of handshake time at 20 ms simulated round-trip network latency. The gateway sustains 443 sessions/second, 100% success under 32 concurrent connections, extrapolating to 3546 sessions/second on a 32-core cloud instance. Five side-channel tests, including verified in-place session-key zeroization and a fixed-vs-random TVLA timing analysis, found no exploitable timing leakage or susceptibility to man-in-the-middle attacks. The architecture is vendor-agnostic and becomes unnecessary once vendors adopt NIST PQC natively.

0.16

CESBench: Benchmarking Large Language Models on Cryptographic Engineering Security for IoT Devices

cs.CR cs.AI ·2026-09-18 ·Wenquan Zhou, An Wang, Jing Liang, Peien Feng, Jingqi Zhang +2 more
benchmark similarity 0.46
Abstract

For Internet of Things (IoT) devices, a secure algorithm alone is not enough: an attacker with physical access can attack the implementation directly, and its flaws are hard to fix once deployed. Large language models (LLMs) are now used to build and analyze such implementations. LLM benchmarks exist for cryptography and general cybersecurity, but none covers cryptographic engineering. In this paper, we present CESBench, 380 expert-written items across six sub-domains of cryptographic engineering security for IoT devices: side-channel, fault injection, implementation, countermeasures, evaluation, and integration. Four task types target different competences: 209 multiple-choice items test recall, 67 judgment items require a security verdict and its justification, 63 scenario items require an engineering diagnosis, and 41 code tasks are graded by 572 test cases. To validate the benchmark, 11 open-weight and proprietary LLMs answer every item. Multiple-choice and code responses are scored automatically, and judgment and scenario responses by an LLM judge, whose scores are checked against a second judge from another model family and human re-scoring. Composite scores range from 54.4% to 83.6%. The top score on each task type is 98.6% for multiple choice, 95.1% for code, and 88.4% for scenario diagnosis, but only 58.8% for judgment. Across models, 88.5% of verdicts are correct, yet their justifications earn only 53.4% of the rubric marks. Multiple choice is near its ceiling for the strongest models and most code tasks are solved, whereas justifying a security verdict remains the weakest competence. The benchmark, prompts, and per-item results are public.

0.20