CS Paper Radar

Locally homogeneous PID gain-scheduling for motion control systems

Andrey Polyakov, Michael Ruderman

eess.SY ·submitted 2026-11-16 12:38 UTC · v1
unusual

Abstract

A method for upgrading linear PID controller to a locally homogeneous PID regulator is developed. The homogeneous PID shares the gains with linear PID while the tuning of local homogeneity degrees could allow better regulation quality comparing with the linear algorithm. The homogeneous algorithm is obtained by means of the scaling the gains of the linear controller dependently of the current value of the output and its derivative. The linear algorithm can be recovered from the homogeneous one by assigning zero homogeneity degree. The tuning scheme for the homogeneous controller is suggested and illustrated experimentally in comparison with a standard PID control, which is robustly designed by the loop-shaping around the critical frequency range. The experiments are accomplished on a linear-motion stage system with voice-coil-motor and noisy contactless output measurements.

Closest papers

Nearest neighbours by meaning across the whole index.

On Global Regulatability of Robot Manipulators by Classical PID

cs.RO eess.SY ·2026-09-01 ·Cheng Zhao, Jingru Zhu, Lei Guo
similarity 0.51
Abstract

A long-standing open problem in robot manipulator control is whether global regulation can be achieved by classical PID control. This paper provides an answer to this question for classical PID controllers with triple parameters (k_p,k_i,k_d) in R^3. We find and prove that for one-degree-of-freedom manipulators, the classical PID control guarantees global stability and asymptotic regulation under standard structural assumptions, and further derive explicit quantitative design conditions for the PID gains. However, for multi-degree-of-freedom cases, we can construct a robot manipulator satisfying the same structural assumptions for which no choice of PID gains (k_p,k_i,k_d) can achieve global asymptotic regulation. These results provide a fundamental understanding of the abovementioned open problem, revealing both the fundamental capability and intrinsic limitation of the classical PID control for robot manipulator dynamics.

0.26

Model-Free PID Tuning by Step-Response Inspection

eess.SY eess.SP ·2026-09-14 ·Daniel Pachner, Pavel Otta, Jiří Dostál, Vladimír Havlena
unusual similarity 0.50
Abstract · 12 pages, 4 figures, ready for submission

Industrial PID loops are still tuned by hand: step the setpoint, look at the response, change a gain. This paper turns that procedure into an algorithm, SPIN, for Step-response Phase-portrait INspection. From a single closed-loop step response we form three phase portraits of the control deviation and count how many times each trajectory winds around its settling point. The counts are dimensionless and independent of the step size and of the clock. They show which channel is under-damped: integral, proportional, or derivative. A triangular rule reads the three counts, cutting the gain of the one band whose fault is certain and raising that of every band the same test shows to be within its limit. No model is identified and no optimization is solved. The iteration is deterministic and its gains stay inside a fixed box. Because a ringing count is itself the evidence that the loop is in the regime where cutting that band's gain reduces the count, the iteration settles into a cycle at the edge of the well-damped set. It needs no excitation beyond a routine setpoint step, so it can run on a process in operation, and it may start from arbitrary gains, including destabilizing ones. SPIN assumes a stable, self-regulating process whose gain and phase both fall with frequency, which covers the lag-plus-dead-time models common in process control, and a controller from the nested family $\mathrm{I} \subset \mathrm{PI} \subset \mathrm{PID}$ with integral action present. We validate it on a battery of process-typical plants with one fixed step size and one set of dimensionless constants throughout. Every decision is visible: the operator sees what the algorithm sees. A reference implementation and an interactive demonstration are public.

0.28

Multi-Period Repetitive Control Design in a Time Delay Framework with Application to an Active Vibration Isolation System

eess.SY ·2026-09-21 ·Xiaoran Han, Sil Spanjer, Wouter B. J. Hakvoort
theoryunusual similarity 0.49
Abstract

Multi-period Repetitive Control (MPRC) can lead to amplification at non-repetitive frequencies due to the multiplication of multi-period repetitive control in their closed-loop sensitivity functions, which leads to closed-to imaginary poles. We propose a MPRC structure that eliminates such interaction. The scheme can be equivalently converted into a disturbance observer to improve robustness to frequency uncertainties. We derive an upper bound on the sensitivity function that can be optimized at either repetitive or non-repetitive frequencies. Experimental results on an active vibration isolation system show superior performance over existing robust MPRC schemes, and the capability to suppress unknown time-varying periodic disturbances.

0.25

Design of Adaptive PID Controller Based On Asynchronous Advantage Actor Critic Learning Method for QuadCopter Control

cs.RO eess.SY ·2026-09-17 ·Ali Jokar, Aria Alasty
similarity 0.49
Abstract

Quadcopters offer great utility in many applications, but their nonlinear nature and disturbance sensitivity present great control challenges. Basic PID controllers are generally not sophisticated enough to cope with these complexities. This paper suggests a control system that integrates the Asynchronous Advantage Actor-Critic (A3C) algorithm with a PID controller for quadcopter attitude and trajectory tracking. The A3C controller uses parallel agents to optimize PID parameters dynamically using a neural network. A system identification module for the complementary system makes predictions about system states for optimal control policy. The proposed framework was compared with a standard actor-critic (A2C) model. Simulation results verify that they both track accurately. However, the A3C-based controller converges much more for the loss function, as evidenced by reward figures and loss curves, demonstrating better parameter optimization. This shows that A3C-based approach results in improved performance for the control of quadcopter, effectively integrating reinforcement learning and traditional control to achieve higher adaptability.

0.26

A Modular State-Machine Based Event PID Controller

eess.SY ·2026-09-30 ·Sandesh Thapa, Zhen Qi
benchmark similarity 0.49
Abstract · pid control, time-trigged control, robust control, discrete events , state machine

In this paper, we present a modular proportional-integral-derivative (PID) controller whose computation and mode logic are executed by a higher-level state machine. Inspired by real-time safety-critical applications where computational load, actuator chattering, sensing error and noise are design challenges, the proposed algorithm wraps a standard PID inside a finite state machine with three states (pidInit, ErrorOutRange, ErrorInRange). The goal is to regulate a desired reference within a safe region of operation while reducing actuator chattering and creating a sizable hold band over the range of operation. This design is modular and can be easily integrated into a higher-level state machine with multiple low-level loops and states. The algorithm also has low computational complexity and is suitable for embedded hardware deployment. We demonstrate the effectiveness of the algorithm in simulation on the two test benches of a published event-based PID benchmark. The algorithm computes the control updates significantly less often than the time-triggered PID and less often than both dominant event-driven controllers, while keeping a fairly equivalent control performance profile. Furthermore, we also present some experimental results of the designed algorithm for a real-time flow control.

0.25

From PID to Reinforcement Learning in Building HVAC Control: A Control-Architecture Review of Tuning Strategies, Formulations, and Deployment Trade-offs

cs.LG ·2026-11-02 ·Erfan Haghighat Damavandi, Davide Papurello, Mahdi Alibeigi, Armin Keshavarz
similarity 0.49
Abstract · 52 pages, 6 Figs

This paper reviews control architectures for building heating, ventilation and air-conditioning (HVAC) systems, addressing the tension among energy demand, occupant comfort and equipment operability, and situating proportional-integral-derivative (PID) regulation within a layered control stack that also includes rule-based and model-based supervisory control and data-driven reinforcement learning (RL). It examines the thermostat-PID layer from two-position and scheduled setpoint control through proportional, PI and PID regulation and their tuning, then formulates RL for building control as a Markov decision process. Its central contribution is a taxonomy of where RL meets PID: RL as a gain tuner for an existing loop, as a direct replacement for the regulatory controller, as a hybrid with model predictive control, and as supervisory setpoint and schedule generation. Across these classes, the review establishes that the physical loop remains invariant while the intervention point changes, and that the classes differ in their requirements for actuation authority, state information, modelling, commissioning and constraint handling. It further establishes that PID is inexpensive and well codified but limited by nonlinearity, time variation, discrete mode switching, loop interaction and slow plant dynamics, while RL's admissible position must be argued rather than assumed. The paper concludes that these architectures are not competing philosophies of control but nested points of attachment on one HVAC plant, with hybrid implementations possible, and that deployment trade-offs must be assessed according to the specific control interface and scaffolding required.

0.25

Implicit discretization of PID-like sliding-mode control with third-order output accuracy

eess.SY ·2026-11-13 ·Martin Zapf, Benedikt Andritsch, Leonid Fridman, Martin Horn
code/data similarity 0.49
Abstract · Extended version of a paper submitted to Automatica. 20 pages, 3 figures, 2 tables. Code and verification records: https://github.com/Martin…

A digital PID-like sliding-mode controller is proposed for a double integrator with a Lipschitz matched disturbance. A proper implicit discretization, matched to the exact sampled dynamics of the plant, attains the accuracy of the continuous-time controller without discretization chattering. Global finite-step convergence to a discrete-time sliding mode is established for two gain designs and every sampling time, using an implicit Lyapunov function and a computer-assisted certificate in exact arithmetic. The resulting controller provides third-order output accuracy, second-order accuracy for its derivative, and exact finite-time rejection of constant matched disturbances. These accuracy orders are proved to be optimal among deterministic causal controllers using the same sampled information.

0.25

Exact PID and PI Gain Regions for Uncertain Non-Affine MIMO Systems

eess.SY math.OC ·2026-09-10 ·Cheng Zhao
similarity 0.48
Abstract · Submitted to IEEE Transactions on Automatic Control

Characterizing all PID gains that guarantee uniform exponential regulation of uncertain nonlinear systems remains a fundamental problem. Most existing results provide only sufficient conditions derived from a particular Lyapunov construction. This paper gives exact gain regions, defined directly by uniform regulation over the entire uncertainty class, for two classes of nonaffine MIMO systems with $m\ge2$ controlled coordinates and input channels. For systems of second order under PID control, we independently characterize a common quadratic inner region and an outer region based on a linear subclass. The two regions coincide and therefore characterize the PID gain region exactly at the system level. For systems of first order under PI control, a lossless reduction to a linear family on the uncertainty boundary, combined with a common quadratic certificate, yields the exact PI region. Both regions strictly enlarge existing sufficient regions, and the PID result also provides a sequential tuning rule. A compact linear family with one uncertain parameter shows that common quadratic certification is not generally lossless. These results establish endpoint coincidence and boundary family equivalence as two routes to exact gain regions and motivate the broader question of which nonlinear uncertainty classes admit such characterizations.

0.26