CS Paper Radar

Slower but Faster: When Self-Organized Traffic Flows Beat Traffic Signal Control

Damian Dailisan, Meisam Akbarzadeh, Dirk Helbing

eess.SY ·submitted 2026-11-16 15:24 UTC · v1

Abstract

Urban traffic flow networks are complex adaptive systems, whose variability challenges centralized, top-down control. We study decentralized alternatives in which order emerges from local interactions, comparing the network-wide performance of roundabouts in SUMO against fixed-time and actuated control as well as self-organizing signals on a 4$\times$4 grid and a rewired, irregular variant of it, across demand levels and periodic surge amplitudes. In our computer simulations of the regular grid, converting the single most central intersection already lowers delays by 2 to 3\% relative to actuated control; each additional conversion lowers them further, and full conversion outperforms every signalized alternative under all conditions studied. In the irregular traffic flow network with full conversion of all intersections into roundabouts, this holds only up to a critical load, where traffic flow breaks down sharply, when the time-averaged demand reaches about 3.1 times the base load. Beyond that point, the self-organizing traffic signals show the lowest delay of any network-wide strategy and is nearly insensitive to surges. Interestingly, roundabouts are favorable solutions even at lower speed limits: in the regular grid, compared to the mean speed under actuated control at a speed limit of 50\,km/h, roundabouts match that speed at a speed limit of about 40\,km/h. Compared to traffic signal control, this establishes a slower-is-faster effect. Furthermore, travel times in self-organized traffic flows are more predictable than in networks with conventional signals.

Comment
submitted to IEEE T-ITS

Closest papers

Nearest neighbours by meaning across the whole index.

Towards Mode-Balanced Intersection Control: Hierarchical Coordination of Signal Timings, AV Trajectories, and Cyclist Speed Advice

eess.SY ·2026-11-10 ·Wies Siffels, Giray Önür, Azita Dabiri
similarity 0.60
Abstract

Connected and automated vehicles (AVs) enable traffic signals and vehicle trajectories to be optimised jointly, but existing co-optimisation frameworks overlook cyclists, even though they share the same intersections. We propose a hierarchical framework that optimises traffic signal timings, AV trajectories, and cyclist speed advice to reduce travel times for both motorised vehicles and cyclists. The upper level jointly optimises signal timings and cyclist speed advice, while the lower level optimises AV trajectories and also updates cyclist speed advice obtained from the higher level at a higher frequency based on the resulting signal plan. The framework is evaluated in simulation under multiple demand profiles and optimisation parameter settings. Compared with optimized vehicle trajectories with fixed-time signal control, the proposed framework reduces mean travel times by 13.6\% for AVs and 12.3\% for cyclists. Adding cyclist speed advice further reduces mean cyclist waiting time by about 80\% relative to the same framework without speed advice. These results demonstrate substantial benefits for both modes of transport.

0.27

Joint Dynamic Lane Reversal and Variable Speed Limit Control: A Graphormer-Based Approach

eess.SY cs.AIcs.LG ·2026-10-26 ·Hamed Araab, Abbas Ahmadi, Mohammad Hossein Basiri
similarity 0.59
Abstract · 21 pages, 10 figures, 3 tables, 1 algorithm

Connected and automated vehicles could allow reassigning lane directions and speed limits on every road frequently, but the benefit hinges on how traffic reroutes, and one-way roads can isolate junctions. We formulate network-wide dynamic lane allocation and directional speed limit control with one-way roads, lane clearing before each reversal, and a navigable graph kept strongly connected at all times. An action-resolution algorithm grounded in graph orientation theory admits a proposal closing a direction only if the network stays strongly connected and otherwise relaxes or reverts it, keeping all junctions mutually reachable within the model, even during clearing. All road controllers share one transformer whose attention, Global Endpoint Relation-Aware Spatio-Temporal Self-Attention (GERASTSA), spans all road-time tokens, biased by the endpoint relations between roads. It is pretrained on action-conditioned traffic forecasting and fine-tuned with per-road proximal policy optimization under a mixed reward that also credits neighboring roads and the network. On a 6 x 6 grid with commuter rush hours, the learned policy makes about two thirds of roads one-way in the peak direction and cuts daily delay by 90% against the initial configuration held fixed and by 85% against a tuned two-way load balancer. Restricted to two-way roads at test time, it gains only about as much as this balancer, whereas its learned speed limits add delay. Pretraining roughly halves the updates needed to surpass the fixed configuration. Of the ablations, only removing the relational bias or the spatial embedding clearly matters, multiplying delay about fivefold.

0.17

Timing Sensitivity in Actuated Traffic Signal Control: A simulation study on one urban network

eess.SY ·2026-09-29 ·Nitai Aharoni
code/data similarity 0.57
Abstract · 13 pages, 1 figure, 12 tables. Code, network and experiment configurations at https://github.com/nitaiaharoni1/traffic-simulator

A comparison between adaptive and fixed-time traffic signals can change when only their timing settings change. We examine this sensitivity in 240 simulation runs on one OpenStreetMap-derived urban network, using eight configurations, three arrival rates and ten paired demand seeds. The experiment varies the maximum green of presence-based actuation, retimes the fixed baseline, and includes a discharge-based phase-termination rule. The endpoint is finite-window time spent per offered trip, including entry waiting and penalties for removed or abandoned trips. At the highest tested load, actuation with a maximum green of twice the planned split has a mean endpoint 57.4 per cent above the original fixed plan. Reducing that multiplier to 1.25 puts it 70.7 per cent below the same plan. Against the best of three tested fixed plans, discharge-based termination reduces the mean endpoint by 14.8, 15.8 and 18.3 per cent across the three loads. Both timing sweeps favour their shortest tested setting, so neither identifies an optimum. This exploratory study uses synthetic demand, negligible start-up lost time and physical removal of persistently stationary vehicles. The results support testing timing sensitivity before attributing performance to a controller family; they do not establish a setting for real-world deployment.

0.41

MIXSim: A multiclass first order traffic model with composition-dependent dynamics for mixed-autonomy urban networks

eess.SY math-ph ·2026-10-16 ·Muhammad Haris, Claudio Roncoli
similarity 0.57
Abstract

This paper presents a novel multiclass first order macroscopic traffic model for mixed-autonomy in signalized urban networks, called MIXSim. Human driven vehicles (HDVs) and Connected and Automated Vehicles (CAVs) are represented as separate classes while origin-destination information is retained through commodity specific states. The local vehicle class composition and class specific driving behaviour characteristics determine the parameters of a composition-dependent triangular fundamental diagram. At signalized intersections, the composition of movement demand additionally determines the saturation flow rate, while the realized movement flow is constrained by demand, effective green time, and downstream receiving capacity. Numerical experiments investigate different CAV penetration levels and CAV time gaps, together with alternative signal control strategies. The numerical experiments illustrate how changes in CAV penetration and CAV time gap affect network performance under the tested conditions, and demonstrate the use of MIXSim for comparing signal control strategies across different mixed traffic regimes.

0.21

Maneuver Coordination Using V2I to Improve Traffic Efficiency at Intersections

cs.NI ·2026-10-09 ·Lorenzo Farina, Marco Rapelli, Barbara Mavì Masini, Claudio Casetti, Alessandro Bazzi
publishedbenchmarkhighly cited similarity 0.56
Abstract · 8 pages, 8 figures, accepted at IEEE VNC 2024

Traffic efficiency and air pollutants are major issues in urban transport systems, as they are critical points for traffic flows and people living in urban areas, respectively. In response to this challenge, connected and autonomous vehicles (CAVs) have garnered increasing attention, with the potential to address the above challenges through cooperative maneuvering and real-time communication. In this paper, we consider an intersection served by a multi-access edge computing (MEC) where CAVs communicate with a controller to pass the intersection without the need of signals and without stopping unless in presence of heavy congestion. For this purpose, we propose a first-in-first-scheduled (FIFS) algorithm, and we specify the communication protocol for its practical implementation. The solution is validated through simulations with varying traffic densities, showing that it provides significant gains in travel time and emissions compared to both uncontrolled intersections, with or without traffic lights, and a benchmark solution derived from the literature.

0.72

Human Driver Temperament and the Safety Impact of a C-V2X Denial-of-Service Flooding Attack in Mixed-Autonomy Traffic

cs.HC ·2026-09-18 ·Rasheed Bello, Gurcan Comert, Varghese Vaidyan, Akinbobola Jegede, Vijay Bendigeri +1 more
similarity 0.56
Abstract · 12 pages, 6 figures, Submitted to AHFE Hawaii International Conference

Cooperative and connected automated vehicles (CAVs) rely on Signal Phase and Timing (SPaT) messages to cross signalized intersections; a denial-of-service (DoS) flood that blocks SPaT forces CAVs into a fail-safe mode. Because human-driven vehicles share the intersection, the safety consequence depends not only on the attack and the CAV fail-safe policy, but on how the surrounding human drivers behave. We investigate this human-factors dimension with a coupled OMNeT++/INET (5G NR-V2X) and SUMO microsimulation of a signalized corridor, sweeping CAV market penetration (10-90%), four calibrated driver temperaments (cautious to aggressive) and two standards-based fail-safe policies, a minimal-risk maneuver (MRM) and an adaptive cruise control (ACC) keep-driving fallback, with each attack arm differenced against its policy-matched no-attack baseline. Temperament's effect on the attack is specific and modest rather than a blanket amplification. Aggressive surroundings worsen one metric, the hard-braking a keep-driving fail-safe forces on nearby drivers (p = 0.03), rising from near zero to +8 episodes/1000 veh-s. They appear to dampen rear-end conflicts, but only because the flood clears the queues aggressive drivers build, so the gain is in flow, not safety. On the attack's primary signatures, CAV red-light running and crossing conflicts, temperament has no detectable effect. It instead dominates baseline risk, producing a 13- to 18-fold cautious-to-aggressive gradient far larger than the attack itself, which acts through a channel already congested by CAV adoption. Human driver populations determine how dangerous the intersection is but do not systematically amplify this attack, so fail-safe design cannot assume a cautious test population bounds the risk.

0.19

Information-Region MPC: Non-Iterative Distributed Control of Urban Traffic Signals

eess.SY math.OC ·2026-11-19 ·Qiongdan Hu, Menglin Yang, Meng Wang, Chaopeng Tan
similarity 0.56
Abstract · Submitted to the 2027 European Control Conference

Centralized model predictive control (MPC) exploits network-wide traffic information to obtain the optimal solution of the network-level control problem, but its computational burden grows rapidly with network size. Iterative distributed MPC reduces the size of local optimization problems, but requires repeated information exchange and coordination within each control update. To address these limitations, this paper proposes information-region MPC (IR-MPC), which approximates the first control input of centralized MPC using limited real-time data without iterative coordination. Based on historical traffic data, we quantify how perturbations at other intersections affect the centralized first control input of each intersection and use these couplings to construct a compact information region for every intersection. At each control update, each intersection then solves a local IR-MPC problem once using current data only from its information region. SUMO simulations on a real 28-intersection network show that IR-MPC with one processor per intersection computes its control inputs 9 times faster than centralized MPC and 15 times faster than a representative iterative decomposition-based distributed MPC method. IR-MPC reproduces 85% of the centralized control inputs exactly at the implemented one-second resolution, keeps 99.3% within 2s, and increases mean delay by only 0.03%.

0.32

Hardware-in-the-Loop Demo of a Cooperative Intersection where Cars don't Stop

cs.AR ·2026-10-09 ·Lorenzo Farina, Matteo Piccoli, Salvatore Iandolo, Antonio Solida, Carlo Augusto Grazia +4 more
published similarity 0.54
Abstract · 3 pages, 3 figures, accepted at IEEE CSCN 2025

The road transportation sector is undergoing a radical transformation, working for a future where all vehicles will be autonomous and connected. A key challenge in this vision concerns intersections, which will no longer rely on traffic lights or traditional right-of-way rules. Instead, algorithms and communication protocols will be employed to optimize traffic flow. In this context, we are developing a testbed where cars equipped with wireless connectivity exchange information with a remote controller and coordinate their maneuvers. As the vehicles navigate through different types of intersections with various routes, they communicate with the controller, adjusting their speed to pass through intersections without stopping. This demo specifically showcases a hardware-in-the-loop (HiL) implementation of such intelligent intersection, using the SUMO traffic simulator to emulate vehicle positions. Real hardware and software components, which are designed for use in vehicles and roadside infrastructure, are employed to enable real-time data exchange of contextual and control information, running the cooperative coordination algorithm.

0.36