CS Paper Radar

Cross-Vehicle Transferability of Lateral Velocity Estimation on Production Vehicles through Input Selection and Data Augmentation

Hendrik Schäfke, Simon F. G. Ehlers, Thomas Seel, Askar Vagapov, Christoph Schweers, Ahmed Trabelsi, Daniel O. M. Weber

eess.SY cs.LG ·submitted 2026-11-18 17:06 UTC · v1

Abstract

Lateral velocity is safety-critical for vehicle-dynamics control but cannot be measured with production sensors. Model-based estimators such as Kalman filters are established, whereas data-driven estimators are more accurate within the training regime but suspected to lose accuracy beyond it. Their transfer to a structurally different vehicle has rarely been tested. We record real-world test drives of three series-production vehicles, train a neural-network estimator on production CAN signals of a compact car, and evaluate it zero-shot on an SUV and a van against a GNSS-aided inertial reference. On the unseen vehicles, the network's error exceeds that on the training vehicle by an order of magnitude, a gap not quantified on production vehicles before. A systematic comparison of input sets from ten production CAN signals identifies a five-signal set that transfers most robustly. To narrow this gap, we introduce three physically motivated augmentations of training data. Two improve generalization, namely exploiting the vehicle's left-right symmetry and emulating accelerometer bias. Combined, they reduce the error on the validation maneuvers of the SUV and van by 13% and 15%. Contrary to common expectation, on the SUV the data-driven estimator trained with both augmentations matches a model-based estimator tuned on the same training data.

Comment
14 pages, 7 figures, 6 tables. Submitted to Control Engineering Practice

Closest papers

Nearest neighbours by meaning across the whole index.

Physics-Informed Koopman Learning for Data-Efficient System Identification of Automated Vehicle Dynamics

eess.SY ·2026-10-17 ·Hangyu Li, Yiming Meng, Zhaohui Liang, Yunqing Xiao, Yuxuan Chen +5 more
code/data similarity 0.61
Abstract · 13 pages, 9 figures. The CATS-CF dataset and code are available at https://github.com/CATS-Lab/PI-Koopman

Understanding how a particular automated vehicle reacts to nearby traffic can improve motion prediction, control development, traffic simulation, and safety evaluation. However, commercial automated driving systems are proprietary, and single encounters may provide only a few seconds of noisy data. Standard physical models are interpretable but inflexible, whereas neural models are often data-hungry. We propose a physics-informed Koopman framework that combines a calibrated car-following law with a correction learned from the observations. A weak-form estimator learns this correction from velocity measurements integrated over time, avoiding noise-sensitive numerical differentiation. The resulting continuous-time model predicts the follower's response and provides interpretable measures of driving behavior. Experiments on OpenACC and CATS-CF evaluate 5-, 7-, and 11-second histories. Averaged over these histories, the constant-time-headway branch reduces speed prediction error by 16.0% and 15.4% on OpenACC and CATS-CF, respectively, relative to the best neural baselines. The PI-Koopman branches achieve the lowest mean speed and gap errors among the physical and neural comparators. Weak-form estimation reduces acceleration-field reconstruction error by 74.5% in noisy known-law simulations and noise-induced field perturbation by 91.6% in paired real-vehicle measurements. The same PI-Koopman system identification supports following-mode recognition with an approximately eleven-fold difference in median residual variance between human drivers and automated vehicles, and a single residual threshold achieves 85.4% balanced accuracy. The branch informed by the intelligent driver model takes a median 17 to 26 ms for identification and forecasting on the tested central processing units, supporting frequent target adaptation.

0.34

A Probabilistic Lateral Motion Prediction Model with Improved Response Fidelity for Vehicle-in-the-Loop Simulation

cs.RO ·2026-11-16 ·Xiangyang Ye, Chaosheng Huang, Jinwen Yang, Zhengxian Chen, Jun Li
similarity 0.60
Abstract

Vehicle-in-the-loop (VIL) simulation requires a lateral dynamics model that accurately reproduces vehicle responses and reliably generates horizontal lateral-position and heading commands through recursive integration. This paper presents a probabilistic lateral motion prediction model with improved response fidelity. A two-degree-of-freedom vehicle model provides the physical prior, while a recurrent neural network learns correlated residual corrections to lateral acceleration and yaw rate. To maintain prediction fidelity during recursive motion generation, multistep rollout training feeds corrected responses into subsequent states and histories and directly penalizes accumulated lateral-velocity error. A conditional Gaussian characterizes response uncertainty, which is propagated to lateral-response, position, and heading predictions through augmented-state linearization. Evaluation results demonstrate improved lateral-response and integrated-motion prediction. Compared with the Deep Dynamics lateral adaptation, the proposed model reduces mean lateral-position root-mean-square error (RMSE) from 0.596 m to 0.483 m, an improvement of 19.0%, while reducing mean lateral-velocity RMSE from 0.0469 m/s to 0.0441 m/s. These results demonstrate the effectiveness of combining physical priors, probabilistic residual learning, and multistep rollout training for response-faithful lateral motion prediction.

0.29

Extended Model-Based Learned Inertial Odometry

cs.RO ·2026-11-06 ·Sasanka Kuruppu Arachchige, Joni-Kristian Kämäräinen
publishedcode/data similarity 0.58
Abstract · 8 pages, Published at ICUAS 2026

Inertial odometry is a compelling approach to state estimation for agile quadrotor flight due to its affordability, low weight, and robustness to perceptual degradation. However, relying only on integrated inertial measurements is impractical, as sensor errors and time-varying biases lead to significant pose drift. Although recent advances have enabled inertial odometry for drone racing, existing approaches show limited generalization to trajectories not seen during training. This work improves generalization by adopting a body-frame representation and incorporating body-frame torque dynamics into the learning pipeline. The learned model predicts short-horizon relative displacements, which are fused with IMU measurements in an Extended Kalman Filter. Experimental results show that the proposed method outperforms the previous state-of-the-art learned inertial odometry approach for quadrotor pose estimation on unseen trajectories. An additional evaluation on four public quadrotor datasets, with whole trajectory shapes held out of training, confirms a lower velocity error on every held-out set and shows that the torque input is most informative when it is derived from the rotor signals. Code, data pipeline and trained models are publicly available.

0.48

Data-Efficient Adaptation of a Driving VLA to Class 8 Trucks

cs.RO ·2026-09-29 ·Satyajeet Das, Aaron Buxbaum, Niels Joubert, Gaurav S. Sukhatme
similarity 0.58
Abstract

Class 8 trucks differ from passenger cars in geometry, dynamics, and maneuvering requirements. As a result, vision-language-action (VLA) models trained for passenger vehicles do not readily transfer to Class 8 trucks, particularly in unstructured scenarios such as accident scenes and construction zones. Rather than training a truck-driving VLA from scratch, we propose an adapt-then-steer strategy that adapts an off-the-shelf VLA to generate trajectories for Class-8 trucks in these challenging scenarios. In the adapt stage, we use NVIDIA's Alpamayo 1.5 as the base model, fine-tuning only its action-generation stack on a few hundred real-world construction and accident-related highway scenarios. In the steer stage, we introduce Flow Velocity Steering (FVS) to further refine the model's predictions while holding the adapted VLA fixed. FVS is a compact, flow-time-conditioned residual module that adds learned corrections to the action-space flow velocity used to update the action sequence at each generation step. In open-loop evaluation on a scenario-disjoint held-out set, targeted fine-tuning more than halves single-candidate average displacement error (ADE) and final displacement error (FDE) over the entire 6.4 s horizon compared to the base model. Using the same targeted demonstrations, FVS further reduces the fine-tuned model's full-horizon ADE and FDE by 13.9% and 16.5%, respectively. At matched data budgets, targeted supervision yields 19-26% lower full-horizon ADE than general truck-driving supervision, while the targeted model remains competitive with a model fine-tuned on approximately 65 times as many general truck-driving scenarios. These results support adapt-then-steer for data-efficient vehicle-domain transfer to Class 8 trucks. Our project website is available at https://truckvla.github.io.

0.26

Differentiable Filtering for Inertial Odometry

cs.RO cs.CL ·2026-11-10 ·Yaru Gu, Ting Zou
code/data similarity 0.58
Abstract · 19 pages, 4 figures

Accurate inertial odometry is critical for autonomous systems but suffers from unbounded drift caused by the integration of sensor noise and biases. In approaches such as TLIO, neural pseudo-measurements are trained independently of their downstream filter. This paper introduces Differentiable Filtering for Inertial Odometry (DFIO), a learning framework that embeds the update stages of an error-state Kalman filter directly into a computational graph. Following standalone pre-training, DFIO jointly optimizes the displacement and covariance output heads using posterior-position supervision through differentiable measurement updates. The proposed system is validated on public pedestrian motion datasets featuring both calibrated and uncalibrated inertial measurements. Experimental results on a pedestrian dataset demonstrate that DFIO reduces mean absolute and one-second relative translation errors by 13.2% and 39.6% relative to the TLIO baseline, and by 7.7% and 17.4% relative to its pre-trained counterpart. Furthermore, evaluations on uncalibrated smartphone inertial data indicate that the proposed method effectively mitigates translational drift and maintains trajectory alignment under highly noisy sensor conditions. Source code will be made publicly available.

0.22

TriDrive: Joint Driver, Vehicle, and Road Modeling for Forecasting and Driver Monitoring

cs.RO cs.CV ·2026-09-26 ·Yuhang Wang, Jingxin Yang, Chuheng Wei, Yuechen Guo, Jinghan Xu +2 more
benchmarkcode/data similarity 0.56
Abstract · 32 pages (10-page main text plus appendices), 4 figures, 25 tables. Under review. Code, checkpoints, and demo video: https://huggingface.co/…

Predicting how drivers, vehicles, and road scenes interact and evolve together is central to driver monitoring. Prior work models in-cabin activity or traffic-conditioned driver motion in isolation, motivating joint driver, vehicle, and road modeling with real-time on-vehicle evaluation. We introduce TriDrive, to our knowledge the first unified framework that jointly forecasts driver kinematics, vehicle dynamics, and road demands through an automation-conditioned transition model. Modality-specific encoders (an anchored kinematic representation of the driver, causal CAN-bus dynamics, and frozen V-JEPA 2 road latents with structured road margins) are connected by directed residual connections through which driver and road context refine vehicle forecasts. We evaluate TriDrive on three downstream tasks. On the public AIDE benchmark, its kinematic encoder recipe sets a new full-set state of the art (SOTA) among published baselines (48.05 versus 71.47 All-MPJPE). On 197.2 hours of naturalistic BATON subset, directed connections and road margins raise assistance-engaged PR-AUC by 0.084 for steering onset and 0.286 for time-to-collision drops. For real-time use, we distill the road encoders and run TriDrive on a comma four with an external 8 GB GPU, where a lightweight current-state warning probe updates at 5 Hz with 177 ms p95 latency while the joint model forecasts concurrently. The probe is above an openpilot-based baseline on human-labeled manual-driving warnings (AUROC 0.725 versus 0.563), and in a paired on-road study 14 drivers rate its warnings as more appropriate (+1.79) and timely (+2.67) than those of openpilot's driver-monitoring system.

0.32

SSIO: Self-Supervised Inertial Odometry

cs.RO ·2026-10-19 ·Yuheng Qiu, Yutian Chen, Carlton Cort, Weison Huang, Shibo Zhao +8 more
similarity 0.56
Abstract

Learning inertial odometry for a new platform usually requires ground-truth trajectories. We show that an inertial odometry model can instead be trained from scratch by a myopic teacher that integrates the IMU over each short window independently, a scheme we call integration self-supervision. Interestingly, although supervised only by short-window velocity changes, the student learns to directly predict velocity, and does so more accurately than its integration teacher. Pose graph distillation then refines the model with sequence-consistent targets from a pose graph over many windows. Training on a new platform therefore no longer requires collecting ground-truth trajectories, but only calibrating the IMU and recording data during normal operation. Across six datasets spanning pedestrians, drones, quadrupeds, and a humanoid, the same recipe with no velocity or position labels trains models that come within 0.07~m/s average velocity error of a same-architecture supervised baseline.

0.25

IMU-Centric Moving Horizon Estimation for Lateral Dynamics Estimation Across Vehicles and Grip Conditions

eess.SY cs.RO ·2026-09-09 ·Seuffo Akouan ha Ngoune, Alessandro Toschi, Paolo Burgio, Marko Bertogna
publishedcode/data similarity 0.56
Abstract · Accepted at the 29th IEEE International Conference on Intelligent Transportation Systems (ITSC 2026). 8 pages, 6 figures

Accurate estimation of lateral vehicle dynamics near the adhesion limit is important for stability control and high-performance driving, but lateral velocity is rarely measured directly because sensors such as optical sensors are costly. This paper presents an inertial measurement unit (IMU)-centric Moving Horizon Estimation framework that reconstructs lateral velocity using standard onboard signals, without relying on exteroceptive odometry or detailed tire-parameter tuning. Experimental validation on human-driven sports cars and an autonomous open-wheel race car across tracks, maneuvers, and conditions demonstrates accurate and robust lateral velocity and lateral acceleration estimates. The proposed framework is available at https://github.com/Aseuffo/IMU-Centric-MHE

0.48