CS Paper Radar

Design and Physical Constraints of Synthetic-Frequency Photonic Switching Fabrics

Jorge Parra

cs.ET physics.optics ·submitted 2026-09-01 12:06 UTC · v1
unusual

Abstract

Electro-optic frequency conversion and synthetic-frequency coupling are established functions in integrated photonic devices. Their role within a multiport switching fabric, however, depends on how simultaneous optical connections share spatial paths, frequency channels, and device controls. Here, we investigate how coherent coupling among frequency modes can be incorporated into photonic switching fabrics and identify the corresponding architectural and physical constraints. We show that synthetic-frequency coupling does not increase the number of simultaneous orthogonal frequency channels when all channels are freely accessible, but can establish connections that are otherwise blocked by fixed input frequencies, channel-continuity requirements, or unavailable output channels. Under the tested conditions, coupling over the first three frequency spacings in an $8\times8$ fabric with eight frequency channels per port achieves 96.1% of the blocking reduction obtained with unrestricted inter-mode coupling. We further show that a separate frequency-only conversion stage cannot replace missing spatial connectivity. A nominal reduction in spatial switching elements instead requires a joint element whose spatial state can be programmed independently for each frequency channel. Finally, we evaluate a thin-film lithium niobate resonator model using reported electro-optic coupling and photon-decay scales within a multistage Mach-Zehnder interferometer switching fabric. These results clarify the architectural role of synthetic-frequency coupling and the device-level requirements for incorporating it into integrated photonic switching fabrics.

Comment
Main text (12 pages + 6 figures) and supplementary information (21 pages + 10 figures)

Closest papers

Nearest neighbours by meaning across the whole index.

13,000-Fold Frequency Down Conversion From 280 MHz to 21 kHz Using Mechanical Frequency Combs

eess.SP ·2026-11-05 ·Ian Anderson, Zihuan Liu, Vivek Tallavajhula, Yen-Chen Wang, Tzu-Hsuan Hsu +2 more
unusual similarity 0.49
Abstract · 4 pages, 6 figures

Optical frequency combs bridge the microwave and terahertz regimes by down-converting terahertz optical energy into microwave signals. A photodetector converts the comb's equally spaced lines, generated through optical nonlinearities, into a low-frequency tone at their spacing. Here, we present the first mechanical version of this process, using mechanical frequency combs to downconvert energy over 4 orders of magnitude, from the MHz to kHz regime. Thin-film lithium niobate (LN) is used to design an acoustic resonator with a wide range of mode frequencies. We achieve phononic comb excitation from 250 MHz to 900 MHz and compare the electrical and laser Doppler vibrometer (LDV) measurements at 277 MHz. We then show the low-frequency spectrum of the devices, highlighting mechanical motion at the comb's spacing and demonstrating energy transfer from 277 MHz to 21 kHz.

0.30

Generation of entanglement statistics with a large-scale integrated photonic-electronic circuit

eess.SP quant-phphysics.optics ·2026-09-06 ·Volkan Gurses, Ali Hajimiri
similarity 0.48
Abstract · 12 pages, 3 figures

Continuous-variable quantum processors scale with the modes they can transform, and each transformation adds loss. We demonstrate optoelectronic quantum information processing, moving the mixing into radio-frequency electronics after homodyne detection. Squeezed vacuum falls on a large-scale integrated photonic-electronic circuit, a 32-channel coherent receiver array whose radio-frequency network mixes the analog photocurrents. A local-oscillator ramp reconstructs the two-mode covariance at the aperture, which is physical, and its partial transpose has smallest symplectic eigenvalue 0.99270, three standard deviations below the separability bound. Mode transformation becomes a circuit function whose scale follows integrated electronics. With electro-optic transducers in place of the photodiodes, the same receiver would transfer optical modes into superconducting circuits and back, toward a photonic-electronic quantum computer spanning the optical and microwave bands.

0.26

Tetris: Circuit Scheduling for Rearrangeably Non-Blocking Photonic Interconnects

cs.NI ·2026-09-21 ·Eliezer Amponsah, Deeksha P Rao, Vamsi Addanki
similarity 0.46
Abstract

Reconfigurable photonic interconnects are emerging as a promising communication architecture for next-generation distributed computing. Yet, most circuit schedulers are designed around an idealized view of the interconnect as either blocking or strictly non-blocking. Practical scalable designs are often rearrangeably non-blocking (RNB), with connections routed through networks of internal $2\times2$ switches. This changes the scheduling problem fundamentally: establishing a new connection can force existing connections to be rerouted, trigger state changes across multiple internal switches, and impose reconfiguration delay on otherwise unrelated traffic. We present Tetris, a circuit scheduling algorithm for RNB photonic interconnects. Tetris builds on two observations. First, All-to-All demands are often not doubly stochastic, leaving a small number of endpoints as communication bottlenecks. Second, reconfiguration delay can be large enough to change which connection should be scheduled next. Tetris prioritizes bottleneck endpoints using their remaining communication and reconfiguration work, while selecting and routing matchings to preserve ongoing connections whenever possible. Matchings ensure progress, but connections are scheduled independently, allowing completed connections to be replaced without matching-wide barriers and incurring delay only at switches whose states change. Our simulation and hardware-emulation results show that Tetris reduces All-to-All demand completion time by up to $6.6$x over Birkhoff--von Neumann-based scheduling and by $30$% over Sunflow. More broadly, RNB interconnects raise new questions in multi-tenant scheduling and routing for partial reconfiguration, which we discuss at the end of the paper.

0.16

Analog Time-Frequency Analysis and Frequency Measurement of Ultra-Wideband Microwave Signals via Dual-Comb Channelization

eess.SP physics.optics ·2026-08-26 ·Taixia Shi, Wentao Ma, Fangzheng Zhang, Yang Chen
unusual similarity 0.45
Abstract · 21 pages, 12 figures

Frequency-to-time mapping (FTTM)-based photonics-assisted spectrum sensing enables wideband spectrum monitoring for applications such as cognitive radio and electronic warfare. However, FTTM-based photonics-assisted spectrum sensing approaches involve trade-offs among analysis bandwidth, temporal resolution, and frequency resolution. Although channelization has been introduced to alleviate these trade-offs, the limited number of available channels in previously reported systems constrains further improvements in overall performance. Here, we propose a photonics-assisted dual-comb channelization architecture for broadband frequency measurement and time-frequency analysis. The system employs a stepped-frequency pump based on stimulated Brillouin scattering (SBS) to generate an optical filter comb and adopts a single-laser design for the pump, probe, and reference paths to enhance frequency stability while reducing system complexity. Experimental results show a 48-GHz analysis bandwidth in the 16-channel configuration and 52 GHz in the 20-channel configuration, together with microsecond-scale temporal resolution and a frequency resolution better than 80 MHz. The proposed architecture therefore offers a practical and reconfigurable solution for real-time wideband spectrum sensing.

0.30

A Wavelength Borrowing Architecture for Optical Data Center Networks - Extended Version

cs.NI ·2026-09-04 ·Andrea Detti, Chiara Lodovisi, Silvello Betti
similarity 0.45
Abstract

The growth of east-west traffic, along with the cost and power consumption of electronic switching, is motivating the integration of a low-power, high-rate, all-optical layer within the data center network. This paper presents a spine-leaf all-optical architecture in which the default wavelength configuration, one wavelength per source--destination leaf pair, can be reconfigured to accommodate unbalanced traffic demand: wavelengths that are unused or lightly loaded at one leaf are borrowed by another leaf with higher demand. This topology-engineering capability is combined with a traffic-engineering scheme, based on two-hop detouring, enabling the control of wavelength load while limiting the amount of detoured traffic. A key feature of the architecture is that its degree of wavelength reconfigurability is set by a single tunable parameter, the borrowing degree $B$, ranging from none to full; performance evaluation shows that performance nearly equal to that of a fully reconfigurable architecture is achieved well below the maximum $B$, saving the complexity of a fully reconfigurable solutions. The optical fabric relies on mature, data-center-grade components, namely AWGs, AWGRs, colorless OXCs, and combiners. The reconfiguration speed and the adopted dynamic control policy make the architecture suitable for network tiers where the traffic varies on timescales of tens of minutes or more, e.g., among groups of racks (pods).

0.27

Phase-aware Inverse Design for Silicon Photonic Logic Gates

eess.SP physics.optics ·2026-09-04 ·Ary Portes, Narges Dalvand, Felipe M. F. Teixeira, Omar P Vilela Neto, Julian L. Pita Ruiz +2 more
similarity 0.44
Abstract · 19 pages, 3 figures

Inverse design has emerged as a powerful strategy for realizing compact photonic devices; however, its application to logic operations remains constrained by challenges in physical interpretability, architectural generality, and experimental validation. This work introduces an experimentally validated, unified, and physics-driven inverse design framework that implements all fundamental Boolean logic gates within a single silicon photonic architecture. Devices are fabricated within a 2 x 2 um^2 design region on a silicon-on-insulator platform, representing one of the smallest areas reported for photonic logic elements. By integrating amplitude, phase, and energy conservation into a composite figure of merit, the proposed approach enables direct control over constructive and destructive interference. Consequently, all logic functions, including XOR and three-input NAND/NOR operations, are achieved using a standardized configuration with two logical inputs and a bias port. Experimental results exhibit good agreement with numerical simulations across the C-band, confirming both the predictive accuracy and fabrication robustness of the method. Performance benchmarking reveals competitive contrast ratios compared to previous implementations, while providing a unified and scalable design strategy. These findings establish a physically interpretable and experimentally validated paradigm for inverse-designed photonic logic, advancing the development of compact, integrated optical computing systems.

0.29

VortexChat: An agentic framework for autonomous multi-objective integrated photonic design

cs.AI physics.optics ·2026-08-21 ·Faqian Chong, Yulun Wu, Shilong Li, Andrew Forbes, Hongsheng Chen +1 more
benchmark similarity 0.42
Abstract

The advancement of modern integrated photonics is frequently bottlenecked by device design workflows that rely heavily on manual simulation and expert intuition. While inverse design offers an alternative, it remains constrained by expert supervision and a lack of end-to-end automation. To address these issues, we present VortexChat, an agentic framework for the autonomous, end-to-end inverse design of integrated photonic devices directly from natural language specifications. VortexChat couples a large language model (LLM) decision agent with topology generation, gradient-based refinement, and full-wave electromagnetic simulation. This closed-loop architecture enables the system to iteratively decompose design objectives, orchestrate computational tools, and update strategies based on feedback with minimal human intervention. Constrained by the absolute metrics of the Vortex100 Benchmark, VortexChat autonomously generates devices that strictly meet all predefined performance thresholds without any human-in-the-loop. As an experimental demonstration, we fabricated a broadband terahertz perfect vortex beam multiplexer, autonomously designed by VortexChat, with measurements confirming high-efficiency operation, high mode purity and low inter-channel crosstalk in agreement with full-wave simulations. These results demonstrate that an LLM agent can assume key aspects of expert decision-making in photonic inverse design while maintaining physical fidelity and fabrication feasibility, providing a scalable route towards autonomous design of complex integrated photonic systems.

0.25

Functional Superoscillations in a Wave Processor

cs.NE physics.opticsphysics.app-ph ·2026-10-25 ·Yuntian Wang, Md Sadman Sakib Rahman, Aydogan Ozcan
similarity 0.42
Abstract · 31 Pages, 7 Figures

Physical wave processors are constrained by diffraction, but the bandwidth of the mathematical functions they implement need not be set by it. Here, we demonstrate continuous and multiplexed optical processing of superoscillatory functions, in which a scalar argument is encoded onto a wavefront and a fixed diffractive wave processor synthesizes optical responses that approximate the corresponding function outputs in parallel. Unlike conventional superoscillatory optics that generates predetermined fields, superoscillation here is expressed in the input-output dependence on the encoded argument. Its frequencies are therefore distinct from the transverse spatial frequencies of propagating light and are not subject to the same diffraction-imposed cutoff. We demonstrate complex-valued superoscillatory function synthesis and introduce a multiplexed architecture that simultaneously evaluates distinct target superoscillatory functions whose harmonic content exceeds that of the optical input encoding. Visible-light experiments further validate this beyond-encoding superoscillatory regime. Together, these results establish functional superoscillation as a design principle for wave-based computation and show how interference, diffractive depth and spatial channel allocation extend the functional reach of passive wave processors. More broadly, these analyses establish a separation between functional bandwidth and physical wave bandwidth in analog optical computation.

0.27