CS Paper Radar

Analog Time-Frequency Analysis and Frequency Measurement of Ultra-Wideband Microwave Signals via Dual-Comb Channelization

Taixia Shi, Wentao Ma, Fangzheng Zhang, Yang Chen

eess.SP physics.optics ·submitted 2026-08-26 05:06 UTC · v1
unusual

Abstract

Frequency-to-time mapping (FTTM)-based photonics-assisted spectrum sensing enables wideband spectrum monitoring for applications such as cognitive radio and electronic warfare. However, FTTM-based photonics-assisted spectrum sensing approaches involve trade-offs among analysis bandwidth, temporal resolution, and frequency resolution. Although channelization has been introduced to alleviate these trade-offs, the limited number of available channels in previously reported systems constrains further improvements in overall performance. Here, we propose a photonics-assisted dual-comb channelization architecture for broadband frequency measurement and time-frequency analysis. The system employs a stepped-frequency pump based on stimulated Brillouin scattering (SBS) to generate an optical filter comb and adopts a single-laser design for the pump, probe, and reference paths to enhance frequency stability while reducing system complexity. Experimental results show a 48-GHz analysis bandwidth in the 16-channel configuration and 52 GHz in the 20-channel configuration, together with microsecond-scale temporal resolution and a frequency resolution better than 80 MHz. The proposed architecture therefore offers a practical and reconfigurable solution for real-time wideband spectrum sensing.

Comment
21 pages, 12 figures

Closest papers

Nearest neighbours by meaning across the whole index.

13,000-Fold Frequency Down Conversion From 280 MHz to 21 kHz Using Mechanical Frequency Combs

eess.SP ·2026-11-05 ·Ian Anderson, Zihuan Liu, Vivek Tallavajhula, Yen-Chen Wang, Tzu-Hsuan Hsu +2 more
unusual similarity 0.46
Abstract · 4 pages, 6 figures

Optical frequency combs bridge the microwave and terahertz regimes by down-converting terahertz optical energy into microwave signals. A photodetector converts the comb's equally spaced lines, generated through optical nonlinearities, into a low-frequency tone at their spacing. Here, we present the first mechanical version of this process, using mechanical frequency combs to downconvert energy over 4 orders of magnitude, from the MHz to kHz regime. Thin-film lithium niobate (LN) is used to design an acoustic resonator with a wide range of mode frequencies. We achieve phononic comb excitation from 250 MHz to 900 MHz and compare the electrical and laser Doppler vibrometer (LDV) measurements at 277 MHz. We then show the low-frequency spectrum of the devices, highlighting mechanical motion at the comb's spacing and demonstrating energy transfer from 277 MHz to 21 kHz.

0.30

Design and Physical Constraints of Synthetic-Frequency Photonic Switching Fabrics

cs.ET physics.optics ·2026-09-01 ·Jorge Parra
unusual similarity 0.45
Abstract · Main text (12 pages + 6 figures) and supplementary information (21 pages + 10 figures)

Electro-optic frequency conversion and synthetic-frequency coupling are established functions in integrated photonic devices. Their role within a multiport switching fabric, however, depends on how simultaneous optical connections share spatial paths, frequency channels, and device controls. Here, we investigate how coherent coupling among frequency modes can be incorporated into photonic switching fabrics and identify the corresponding architectural and physical constraints. We show that synthetic-frequency coupling does not increase the number of simultaneous orthogonal frequency channels when all channels are freely accessible, but can establish connections that are otherwise blocked by fixed input frequencies, channel-continuity requirements, or unavailable output channels. Under the tested conditions, coupling over the first three frequency spacings in an $8\times8$ fabric with eight frequency channels per port achieves 96.1% of the blocking reduction obtained with unrestricted inter-mode coupling. We further show that a separate frequency-only conversion stage cannot replace missing spatial connectivity. A nominal reduction in spatial switching elements instead requires a joint element whose spatial state can be programmed independently for each frequency channel. Finally, we evaluate a thin-film lithium niobate resonator model using reported electro-optic coupling and photon-decay scales within a multistage Mach-Zehnder interferometer switching fabric. These results clarify the architectural role of synthetic-frequency coupling and the device-level requirements for incorporating it into integrated photonic switching fabrics.

0.31

A Time-Encoded Analog Photonic Interposer for Energy-EfficientIntegration of Analog Vision Sensors and Analog Accelerators

cs.AR ·2026-09-02 ·Subhradip Chakraborty, Zihan Yin, Xuming Chen, Chengwei Zhou, Gourav Datta +1 more
similarity 0.45
Abstract

This work introduces a time-encoded analog photonic interposer that enables long-distance, high-fidelity transport of analog signals between spatially separated chiplets. Unlike prior silicon-photonic links limited to digital data, the interposer preserves analog information by converting amplitudes into timing intervals using an analog-to-time converter (ATC), transmitting them over a wavelength-division-multiplexed photonic link, and reconstructing values at the receiver without an explicit high-precision ADC/DAC data-converter pipeline. The link instead embeds an implicit 6-bit time-domain quantization and uses a single wavelength per processing element independent of bit precision. Evaluated in a fully analog vision pipeline with an in-pixel computing (IPC) sensor, it achieves a 2.04x energy--delay product (EDP) improvement over an 8-bit digital electrical baseline on the 560x560 Visual Wake Words dataset, with the advantage widening with link length even against a precision-matched 6-bit baseline. The pipeline holds 89.87% and 86.15% accuracy on ResNet18 and MobileNetV2 for VWW and generalizes across CIFAR-10 and ModelNet40 within 2% of the digital baseline.

0.26

Instrument-Level Validation of Upper Sideband Syntonization Concept

eess.SP astro-ph.IM ·2026-09-09 ·Volodymyr Kudriashov, Manuel Martin-Neira
unusual similarity 0.44
Abstract · 10 pages, 9 figures

Upper Sideband Syntonization (USBS) is a two-way frequency-transfer concept proposed by the European Space Agency for distributed space radio interferometric systems. Previous investigations validated the concept primarily through frequency-stability and phase-transfer measurements. This work demonstrates the first end-to-end instrument-level validation of the USBS concept through coherent W-band cross-correlation measurements and image reconstruction. A P=2 USBS breadboard was integrated with a W-band radio interferometer developed for this test. The synchronized local oscillators (LOs) were evaluated through long-term cross-correlation measurements and coherent imaging of a point-like noise source. The results were compared with those obtained using a conventional common LO as well as two independent free-running LOs. The USBS-derived LOs maintained coherence over 500 s of cumulative effective integration time acquired over approximately five days of elapsed time and preserved inter-session phase stability over measurements spanning 40 days. The reconstructed image is nearly indistinguishable from that obtained with a common LO, whereas independent free-running LOs lead to severe coherence degradation, image distortion, and approximately 38 dB loss of peak response. The results demonstrate that USBS preserves the interferometric coherence required for W-band imaging and present the first end-to-end instrument-level validation of the USBS syntonization concept for future distributed space radio interferometric missions

0.30

Generation of entanglement statistics with a large-scale integrated photonic-electronic circuit

eess.SP quant-phphysics.optics ·2026-09-06 ·Volkan Gurses, Ali Hajimiri
similarity 0.43
Abstract · 12 pages, 3 figures

Continuous-variable quantum processors scale with the modes they can transform, and each transformation adds loss. We demonstrate optoelectronic quantum information processing, moving the mixing into radio-frequency electronics after homodyne detection. Squeezed vacuum falls on a large-scale integrated photonic-electronic circuit, a 32-channel coherent receiver array whose radio-frequency network mixes the analog photocurrents. A local-oscillator ramp reconstructs the two-mode covariance at the aperture, which is physical, and its partial transpose has smallest symplectic eigenvalue 0.99270, three standard deviations below the separability bound. Mode transformation becomes a circuit function whose scale follows integrated electronics. With electro-optic transducers in place of the photodiodes, the same receiver would transfer optical modes into superconducting circuits and back, toward a photonic-electronic quantum computer spanning the optical and microwave bands.

0.26

Super-resolution ranging using a sub-terahertz self-injection-locked frequency-modulated radar

eess.SP ·2026-08-18 ·Hossein Naghavi, Zainulabideen Khalifa, Hamad Alotaibi, Farzad Khoeini, James Gruber +7 more
similarity 0.43
Abstract

Sub-terahertz (sub-THz) and terahertz (THz) frequency-modulated continuous-wave (FMCW) radars have opened a plethora of scientific and industrial applications, especially in the imaging field. While strong candidates for sub-THz/THz FMCW radar imagers are implemented using photonic methods, there is a desire to achieve the full integration and portability that only electronics can offer. However, integrated electronic sub-THz/THz FMCW radars have significantly lower bandwidth (< 100 GHz) than photonic-based radars, restricting the radar range resolution to the millimeter scale (> 1.5 mm). In addition, the electronic FMCW radar's broad bandwidth comes with increased transmitter phase noise, consequently degrading the radar range accuracy. Here, we present a sub-THz fully-integrated autodyne frequency-modulated (AFM) radar utilizing a self-injection locking (SIL) mechanism that fundamentally overcomes the aforementioned challenges of FMCW radars. The AFM radar supports an exceptionally wide effective bandwidth extending into the terahertz sweep range by forming an intermediate frequency comb spectrum in a quadratic receiver, unlocking the path for super-resolution ranging. Furthermore, SIL significantly reduces the transmitter's phase noise, allowing high-accuracy range measurements. We theoretically describe and experimentally demonstrate the SIL operation of the AFM radar. The proposed radar experimentally achieves sub-millimeter range resolution and a range accuracy of < 0.002%, enabling the imaging of covered printed letters with micrometer features.

0.22

Giant Resonant Reflection Gain from Injection-Induced Quenching in a Tunnel Diode

eess.SY physics.app-phphysics.ins-det ·2026-09-16 ·Darmindra Arumugam, Jack Bush, Brook Feyissa
unusual similarity 0.42
Abstract

Negative-resistance microwave oscillators can simultaneously sustain autonomous oscillations and coherently scatter electromagnetic waves, enabling active reflection beyond conventional linear amplification. Here we demonstrate giant resonant reflection gain from synchronization-induced phase localization in a self-sustained tunnel diode oscillator operating near 2.96 GHz. Weak resonant RF injection drives a transition from a broadband free running state to a phase localized narrowband reflected carrier. The resulting reflected enhancement reaches 83.1dB relative to the injected signal and is accompanied by greater than order of magnitude linewidth collapse, nonlinear injection pulling, and a synchronization bandwidth of 15.84 kHz. Time resolved spectrograms directly resolve injection locking and frequency entrainment, while noisy Stuart Landau simulations reproduce the observed spectral concentration and detuning dependent gain roll off near the Hopf instability. Artificially increasing phase diffusion with broadband bias noise suppresses the reflected enhancement, confirming synchronization-induced quenching of phase fluctuations as the origin of the giant coherent reflection gain.

0.24

From power to spectrum: an off-the-shelf photodiode turned into a spectrometer by its bias alone

eess.IV physics.opticseess.SPeess.SY ·2026-11-19 ·Roi Yozevitch, Shmuel Sternklar, Ziv Glasser
unusual similarity 0.42
Abstract · 15 pages, 9 figures, 5 tables

Computational spectrometers replace dispersive optics with detectors whose spectral response can be varied, but every reported single-detector device obtains this response through dedicated fabrication: two-dimensional heterostructures, graded epitaxial junctions, organic stacks, filters or photonic circuits. We demonstrate a generic, fabrication-free alternative in which a standard commercial photodiode becomes a spectrometer through its electrical drive alone, requiring no modification of the device, no optical filter and no modulation of the light. The mechanism is bias-modulated optoelectronic chromatic dispersion (OED): light of different wavelengths is absorbed at different depths, and a sinusoidal bias changes how carriers generated at each depth are collected, so that every spectrum is encoded in the shape of the photocurrent waveform over one bias period. Applied to an unmodified InGaAs PIN photodiode at room temperature, a 10 us waveform decoded by a neural network reconstructs spectra of one to three laser lines across the 80 nm of the telecom C+L band, locating the lines to 0.3-0.4 nm, counting them in about 99% of measurements and identifying their power levels, with line shifts tracked to tens of picometres. Because OED relies on universal semiconductor transport physics, the approach is material-agnostic and applies in principle to any off-the-shelf photodiode, turning detectors already deployed as power monitors into low-cost spectral sensors.

0.30