CS Paper Radar

Instrument-Level Validation of Upper Sideband Syntonization Concept

Volodymyr Kudriashov, Manuel Martin-Neira

eess.SP astro-ph.IM ·submitted 2026-09-09 20:19 UTC · v1
unusual

Abstract

Upper Sideband Syntonization (USBS) is a two-way frequency-transfer concept proposed by the European Space Agency for distributed space radio interferometric systems. Previous investigations validated the concept primarily through frequency-stability and phase-transfer measurements. This work demonstrates the first end-to-end instrument-level validation of the USBS concept through coherent W-band cross-correlation measurements and image reconstruction. A P=2 USBS breadboard was integrated with a W-band radio interferometer developed for this test. The synchronized local oscillators (LOs) were evaluated through long-term cross-correlation measurements and coherent imaging of a point-like noise source. The results were compared with those obtained using a conventional common LO as well as two independent free-running LOs. The USBS-derived LOs maintained coherence over 500 s of cumulative effective integration time acquired over approximately five days of elapsed time and preserved inter-session phase stability over measurements spanning 40 days. The reconstructed image is nearly indistinguishable from that obtained with a common LO, whereas independent free-running LOs lead to severe coherence degradation, image distortion, and approximately 38 dB loss of peak response. The results demonstrate that USBS preserves the interferometric coherence required for W-band imaging and present the first end-to-end instrument-level validation of the USBS syntonization concept for future distributed space radio interferometric missions

Comment
10 pages, 9 figures

Closest papers

Nearest neighbours by meaning across the whole index.

Fourier Domain Synthesis Imaging Using A Wirelessly Coordinated Distributed Antenna Array

eess.SP ·2026-09-17 ·Sherwin K. Shiran, Jason M. Merlo, Shivanshu Ojha, Jorge R. Colon-Berrios, John B. Lancaster +1 more
similarity 0.51
Abstract

In this work we present an experimental demonstration of one-dimensional Fourier-domain imaging using a fully-digital wirelessly coordinated coherent distributed antenna array (CDA) receiver. The nodes consist of two software-defined radios (SDRs) operating with independent system clocks performing wireless time, frequency, and phase coordination without a shared reference such as the global navigation satellite system (GNSS). Two spatially separated noise sources transmit independent noise waveforms with a bandwidth of 25 MHz and a carrier frequency of 915 MHz. Two sources were positioned at angles of $-6.28°$ and $12.95°$ off broadside and imaging was performed. The two sources are clearly resolved to within $3°$ of their expected locations in both the individual and combined source measurements and demonstrating the Fourier-domain image reconstruction principle using a fully-digitally coordinated distributed antenna array.

0.23

Imaging-Communication Trade-off in VLEO ISAC-SAR Using CP-OFDM

eess.SP ·2026-09-16 ·In-Hyeok Lee, Kawon Han
similarity 0.48
Abstract · 13 pages, 13 figures

This paper investigates the imaging--communication trade-off in very-low-Earth-orbit (VLEO) integrated sensing and communication synthetic aperture radar (ISAC-SAR) using cyclic-prefix orthogonal frequency-division multiplexing (CP-OFDM) as the shared waveform. We develop a unified analytical framework that jointly accounts for random communication payloads, range-dependent CP deficit across the swath, and slow-time-varying platform Doppler over the synthetic aperture. The resulting signal model separates the coherently retained component from inter-carrier interference (ICI) and inter-symbol interference (ISI) through common subcarrier-coupling coefficients. By propagating these effects through receive filtering, range compression, and azimuth focusing, we derive image-domain statistics for matched- and reciprocal-filter receivers. Based on the derived statistics, an effective noise-equivalent sigma zero (ENESZ) is formulated to characterize data-dependent sidelobes, ICI/ISI, and noise enhancement on a common backscatter-equivalent scale. The analysis reveals that the CP duration acts as a system-level design parameter bringing scalable trade-off. Increasing the CP improves coherent retention and suppresses range-dependent interference, but simultaneously reduces coherent processing gain and communication payload throughput. Accordingly, the sufficient-CP duration does not generally coincide with the imaging-optimal CP duration. End-to-end simulations for a representative VLEO scenario validate the derived image-domain statistics and demonstrate the resulting trade-off between ENESZ and communication throughput as a function of CP duration.

0.18

Continuous Phase-Coherent Readout of a Magneto-Mechanical Resonator Using a Phase-Locked Loop

eess.SY ·2026-11-16 ·Frauke H. Niebel, Jan-Philipp Scheel, David Conrad, Hossein Shabanalinezhad, Matthias Graeser
similarity 0.48
Abstract · 2 pages, 2 figures, Sensor and Measurement Science International Conference (SMSI) 2027 conference

Magneto-mechanical resonators are wireless sensors that encode a measurand in their natural frequency. Existing systems estimate this frequency from repeated cycles of excitation and ring-down, which limits the precision and bandwidth range. Here, we introduce a continuous, phase-coherent readout based on a phase-locked loop. In a benchtop setup, one record stayed within 4 % of the precision-bandwidth limit over more than three decades of bandwidth, while conventional readouts remained about a factor of 4 above it.

0.26

Communication-Oriented Channel Characteristics of Holographic Curvature-Reconfigurable Apertures

eess.SP ·2026-09-29 ·Hang Lin, Shu Sun, Hangsong Yan, Qiuming Zhu
published similarity 0.48
Abstract

This letter investigates the joint impact of array curvature and mutual coupling (MC) on holographic curvature-reconfigurable apertures. An analytical framework is developed to characterize spatial correlation, coupling-aware reference directivity, and spectral efficiency. Under the small-curvature regime, we establish a relation linking inter-element distances to coupling perturbations and spatial-mode eigenvalues. Simulation results reveal asymmetric spectral-efficiency variations between transmit- and receive-side array curvature with MC, while their no-MC difference is consistent with zero under hemispherical isotropic scattering. Results based on the 3rd Generation Partnership Project clustered delay line-B channel angular/power profile, together with colored-noise sensitivity analysis, further show that the effects of curvature and receive-side coupling depend on the propagation angular distribution and receiver-noise covariance. These findings highlight the importance of jointly accounting for array geometry, mutual coupling, and receiver noise when evaluating curved holographic multiple-input multiple-output links.

0.57

Impact of Synchronization Offsets and CSI Feedback Delays on Coherent Joint Transmission in Distributed MIMO-OFDM

eess.SP ·2026-10-23 ·Kumar Sai Bondada, Daniel J. Jakubisin, R. Michael Buehrer
similarity 0.46
Abstract

This paper studies the impact of synchronization offsets and CSI feedback delay on coherent joint transmission (CJT) in distributed MIMO-OFDM systems. Unlike conventional co-located MIMO, distributed CJT is highly sensitive to transmitter-dependent synchronization impairments because coherent combining requires phase, frequency, and timing alignment across geographically separated transmitters. Received signal models are derived for residual timing offsets, carrier frequency offsets (CFOs), sampling clock offsets (SCOs), phase noise, and channel variations accumulated during channel state information (CSI) feedback delay. The corresponding spectral efficiency (SE) expressions quantify the degradation in capacity due to loss in coherent-combining gain caused by residual phase rotations, inter-carrier interference (ICI), and precoder misalignment. The SE expressions are numerically evaluated to determine synchronization requirements for maintaining negligible SE degradation, yielding the following findings: a Gaussian-distributed start-time jitter with a standard deviation below 10\% of the sampling period results in negligible SE degradation, with the SE loss decreasing from 0.68\% at an SNR of 0 dB to 0.17\% at 40 dB. A normalized CFO standard deviation of 0.001 also results in negligible ICI-induced degradation, with the SE loss increasing from 0.05\% at an SNR of 0 dB to 2\% at 40 dB. At an SNR of 26 dB, limiting the SE loss to 5\% yields feasible operating points with clock-error standard deviations up to 50 ppb, Doppler-delay products up to 0.1, and phase-tracking error standard deviations up to $40^{\circ}$ at carrier frequency of 3.5 GHz with 30 kHz sub-carrier spacing with 15.36 MHz sampling rate.

0.23

Hardware-friendly Baseband Design and Performance Analysis for LEO Broadband LoS-MIMO Systems

eess.SP ·2026-10-14 ·Peixin Zhang, Fengkui Gong, Guo Li, Tony Q. S. Quek
similarity 0.46
Abstract · 6 pages, 5 figures

High-frequency and broadband line-of-sight multiple-input multiple-output (LoS-MIMO) is a key solution for massive space-to-Earth data downlinks. However, in low Earth orbit (LEO) scenarios, it faces spatial rank deficiency from time-frequency coupling correlation and clock deviations from distributed oscillators. This paper establishes a dynamic effective channel throughput (ECT) framework incorporating waterfall characteristics of forward error correction. A hardware-friendly OFDM-based transceiver architecture with subband-adaptive truncation and dynamic timing recovery to achieve robust spatial decoupling is proposed. Through rigorous closed-form derivations, the equivalent signal-to-interference-plus-noise ratio (SINR) under joint errors is quantified, and an optimal scheduling algorithm combining truncation with variable coding and modulation is proposed to maximize ECT. Simulations confirm that the design circumvents outages caused by spatial notches with low complexity, stably enhancing the potential average throughput of a single dual-polarized beam to over 100 Gbps, providing a reliable theoretical foundation and baseband solution for next-generation high-throughput satellites.

0.23

HF Single-Station Localization via Multimode Ray Tracing and Time-Frequency Information Fusion

eess.SP ·2026-10-09 ·Qinglin Li, Wen Liu, Yun Ning, Zhongxin Deng, Junkang He +2 more
similarity 0.45
Abstract · 12 pages, 4 figures, 7 tables

High-frequency (HF) single-station localization estimates an emitter location from measured directions of arrival (DOAs) and an ionospheric propagation model. When the propagation mode composition cannot be identified from conventional direction-finding (DF) measurements, the same DF observation may produce multiple physically valid ground landing points under different propagation modes, making the location inversion ambiguous. This paper proposes a multimode time-frequency information fusion localization method (MTFIF-L).Rather than assuming a propagation mode a priori, MTFIF-L retains valid landing points generated under different propagation modes and uses repeated observations across time windows and, when available, multiple operating frequencies to progressively constrain the resulting candidate locations. Experiments on four measured HF links examine the respective roles of multimode candidate retention, cross-window processing, and cross-frequency processing. All four links yield unique location decisions. Links A--C achieve relative errors of $1.40\%$, $0.78\%$, and $3.41\%$, respectively.Link D, the only single-frequency case, also yields a unique decision from repeated temporal observations, although its post- localization error is substantially larger. Propagation-path analysis further reveals link-dependent differences in reflection layer, hop count, magnetoionic mode, and elevation angle among the ray-tracing paths associated with the measured links.Overall, the results show that repeated temporal observations can support localization within an individual frequency, while multifrequency information provides additional robustness against unreliable frequency-specific outcomes, enabling HF single-station localization under unknown and potentially coexisting propagation modes while retaining interpretable propagation information for post-localization analysis.

0.26

Phase-Compensated Frequency-Scan Measurement of Harmonic Transfer Function Impedance

eess.SY ·2026-10-28 ·Yiyang Liao, Yitong Li, Jinjun Liu
similarity 0.45
Abstract

Impedance models obtained through frequency scanning provides terminal characterization for small-signal stability analysis without requiring detailed knowledge of internal converter parameters. When unbalanced steady-state components introduce cross-frequency coupling, conventional $2\times2$ impedance scan methods must be extended to identify harmonic transfer function (HTF) impedance. However, the measured phases of frequency-coupling terms depend on the starting time of the fast Fourier transform (FFT) window, potentially introducing phase errors when different time references are used. This paper presents a $dq$-domain measurement method of HTF impedance that explicitly accounts for this time dependence. Phase compensation aligns the measured Fourier coefficients to a common electrical phase reference, correcting the resulting phase discrepancies and enabling consistent impedance reconstruction. Comparisons with analytical models under balanced and unbalanced conditions verify the measurement method, recovering the conventional $2\times2$ impedance and the dominant coupling blocks of a $6\times6$ HTF representation, respectively.

0.34