CS Paper Radar

An Adaptive Control Architecture for Slope and Terrain Compensation in Autonomous Navigation in Mediterranean Greenhouses

Fernando Cañadas-Aránega, Dirk Wollherr, José L. Guzmán, José C. Moreno, José L. Blanco-Claraco

cs.RO ·submitted 2026-09-02 11:55 UTC · v1

Abstract

The ability to move stably over terrain with varying slopes and textures is essential for mobile agricultural robots operating in complex and dynamic environments such as greenhouses, where small terrain irregularities can lead to significant navigation errors. This article presents a novel terrain-adaptation strategy based on the carried payload, ensuring accurate and robust trajectory tracking. The proposed approach is based on: (i) the experimental characterization of the most common types of greenhouse soil, concrete, compacted sand, and gravel, and (ii) the direct measurement of terrain slope using the IMU, in order to estimate the force with which this angle affects the motor input. Based on this information, a cascade trajectory-tracking scheme has been designed, consisting of a model-based predictive controller (MPC) in the outer loop and a PI controller in the inner loop. The system incorporates an adaptive feedforward control through gain scheduling approach, capable of adjusting to disturbances caused by variations in slope and terrain type. Simulation results demonstrate that the differential-drive robot achieves a significant improvement both in error indices and in control signal efficiency, highlighting the effectiveness and robustness of the proposed approach.

Closest papers

Nearest neighbours by meaning across the whole index.

Moving Horizon Estimation and Constrained Model Predictive Control for Balancing a Wheel-Legged Robot Under Unknown Disturbances

eess.SY ·2026-11-03 ·Haitham El-Hussieny
similarity 0.59
Abstract

Wheel-legged robots balance on two wheels while using articulated legs to change height, absorb impacts, and cross uneven terrain. On hardware, the balance controller must rely on noisy inertial and encoder measurements, and it must reject disturbances that are not known in advance, such as payloads and wind, without exceeding motor torque limits. This paper presents a moving horizon estimator (MHE) combined with an offset-free, constrained model predictive controller (MPC) for the sagittal balance of a 9.95 kg wheel-legged robot. The estimator uses a virtual-leg model augmented with a horizontal hip force, a body pitch torque, and a gyroscope bias. Its accelerometer model removes the predicted hip acceleration, and its process noise is increased when an impact is detected. We evaluate the approach in MuJoCo with simulated sensor noise, bias, quantization, and delay, and compare it with LQR baselines that use ground-truth state, a complementary filter, or the same MHE. In a driving, squatting, reversing, and bowing sequence, MPC with MHE reduced the RMS speed error to 0.11 m/s, compared with 0.24 m/s for LQR with ground-truth state. Under an unknown 2 kg payload and a 10 N headwind, the mean position error in wind was 6 cm, compared with 81 cm for LQR with ground-truth state. Across a 3 $\times$ 4 grid of payloads and headwinds, LQR with the same estimator fell in 3 of 12 combinations, compared with 1 of 12 for MPC. These results are limited to simulation on flat ground, and experimental validation on hardware remains future work.

0.14

A Field-Deployable GNSS-based Navigation Stack for Outdoor Mobile Robots

cs.RO eess.SY ·2026-09-24 ·Yiyuan Lin, Cole Regnier, Yu Jiang
code/data similarity 0.58
Abstract

Outdoor robots require more than an accurate receiver and a path-tracking law: the navigation system must preserve geometric consistency from geographic waypoints to actuator commands, expose measurement validity and timing, and respond to invalid or stale state information. This work presents a ROS~2 navigation stack with interchangeable single-GNSS--IMU and dual-antenna-GNSS localization front ends. Both provide a common local East--North--Up state interface for pure pursuit, virtual-point cross-track PID, finite-horizon nonlinear model predictive control (NMPC), and a segment-dependent hybrid dispatcher. The architecture specifies coordinate conventions, datum initialization, asynchronous state construction, waypoint geometry, controller equations, quality gates, command arbitration, and watchdog behavior. Independent physical field runs collected during 2025 and 2026 grape-vineyard deployments support a balanced evaluation of 800 runs, with 100 runs for each of eight controller--localization combinations on an approximately 199.6-m route. The row-hybrid mode yields the lowest run-averaged post-acquisition mean absolute cross-track error (MAE) in the evaluated dataset: 0.00952~m with single GNSS+IMU and 0.00846~m with dual GNSS. These findings characterize deviations of the recorded positions from the reference route under the evaluated conditions. The open-source navigation software and deployment instructions are available in the https://github.com/YiyuanLinXX/PPBv2/tree/main/PPBv2_Navigation.

0.33

Adaptive Model Predictive Control for Ground Vehicles: Review and Demonstrative Implementation

eess.SY ·2026-08-18 ·Chetana Gadgil, Mahendra Singh Tomar
similarity 0.58
Abstract · 16 pages, 4 figures, journal

This paper reviews Adaptive Model Predictive Control (AMPC) methods for Autonomous Vehicles (AVs), focusing on control strategies that dynamically adapt to uncertainties and changing conditions in real-time. The critical role of Adaptive Model Predictive Control (AMPC) in addressing the challenges of autonomous vehicle control are discussed. For the scope of this paper, AMPC is defined as a class of Model Predictive Control (MPC) techniques that modify the system model, cost function, constraints, or prediction horizon, based on real-time data. Traditional MPC, while effective for constrained optimization, struggles with model inaccuracies, computational demands, and dynamic environments, necessitating AMPC methods. The review covers existing literature on Gain scheduled MPC, Online Model Estimation MPC, Weight Adaptive MPC, Horizon Adaptive MPC, Learning Based MPC, and Hybrid MPC that combines MPC with other control methods. In addition to the survey, a demonstrative simulation of an adaptive MPC controller is presented that illustrates practical aspects of weight and speed adaptation in trajectory tracking.

0.29

A Novel Path-Tracking Algorithm for Automated Tractor-Trailer Forward and Backward Maneuvers

cs.RO eess.SY ·2026-09-18 ·Alexandre Lombard, Florent Perronnet, Théo Rigal, Nicolas Gaud, Abdeljalil Abbas-Turki
similarity 0.57
Abstract

Fully autonomous tractor-trailer systems are increasingly deployed in logistics, agriculture, and industrial environments, where precise and robust path-tracking capabilities are essential. However, the articulation between the tractor and the trailer introduces additional nonlinearities and significantly complicates lateral and longitudinal control, particularly during reversing maneuvers. This paper introduces a novel path-tracking algorithm specifically designed for articulated vehicles with a single trailer. The proposed method combines a lateral control law applied at the trailer level with a short-horizon predictive adjustment of the tractor steering angle, ensuring stable convergence toward the desired path in both forward and backward motion. The approach is geometry-based and requires no per-vehicle calibration or training. Simulation studies in a high-fidelity physics simulator show steady-state or final lateral errors of $0.02$--$0.05$~m on straight-line, circular, and reverse docking trajectories, which is of the same order of magnitude as, or lower than, the errors reported in the literature. Real-world experiments on a small-scale tractor--trailer robot, with the whole controller running on a low-cost microcontroller, further confirm the feasibility of the approach, with lateral errors below 13~mm during repeated reverse docking maneuvers despite a pose detection latency of about 200~ms.

0.10

Adaptive-MHE : A Sampling-Based Adaptive MPC for Legged Loco-Manipulation via Moving Horizon Estimation

cs.RO ·2026-09-15 ·Hossein Keshavarz, Alejandro Ramirez-Serrano, Majid Khadiv
similarity 0.57
Abstract

Legged robots have demonstrated a remarkable ability to traverse various terrains, yet generating effective loco-manipulation behaviors remains challenging. A key difficulty is that object and terrain parameters are typically unknown to the robot, and mismatches between these parameters and their simulated counterparts introduce a sim-to-real gap that degrades control performance. Classical system identification (Sys-ID) methods often assume differentiable dynamics, an assumption that does not hold for contact-rich legged systems. Sampling-based Sys-ID avoids this restriction by directly matching simulated and recorded state trajectories through massively parallel rollouts, but existing approaches are typically applied offline and do not adapt as environmental conditions change. We present Adaptive-MHE an online sampling-based Sys-ID framework, based on moving horizon estimation (MHE), that estimates the physical parameters of objects and terrain in the environment (e.g., mass, friction) and couples this estimate with a sampling-based model predictive controller, enabling adaptive loco-manipulation in changing and uncertain environments. In simulation and hardware experiments, our framework consistently outperforms baselines and matches the performance of a controller with access to ground-truth parameters.

0.26

Learning Air-Ground Motion Control with Temporal Mode Switching and Cross-Terrain Tracking

cs.RO ·2026-09-22 ·Ruitian Pang, Mingrui Li, Xuanting Liu, Tiancheng Lai, Juncheng Chen +8 more
similarity 0.56
Abstract

Passive-wheeled terrestrial-aerial bimodal vehicles (TABVs) combine aerial mobility with energy-efficient ground locomotion. However, reliable air-ground mode switching under limited onboard perception and robust ground trajectory tracking across diverse terrains remain challenging when targeting real-world applications. In this work, we propose a learning-based air-ground motion control framework for passive-wheeled TABVs: 1) a learned mode selector for autonomous air-ground motion mode switching. The selector uses historical single-point time-of-flight (ToF) measurements and robot states together with future reference information to determine the active locomotion mode. 2) a reinforcement learning control policy for trajectory tracking. The policy combines proprioceptive observations with future reference information to anticipate trajectory changes. For ground locomotion, multi-terrain training and dynamics randomization enable robust tracking across different terrains. Simulation and real-world experiments demonstrate reliable air-ground switching under limited perception and accurate ground tracking across diverse terrain conditions. The learned selector outperforms a rule-based mode selector in challenging transitions, while the ground controller achieves lower position RMSE than PID across all tested conditions and maintains decent tracking where NMPC fails. With these capabilities integrated, the system tracks a 101m air-ground trajectory through multiple autonomous mode transitions with a position RMSE of 0.08m.

0.13

Terrain-Aware Local Path Planning with Global DEM Data Integration for Autonomous UGV Navigation

cs.RO ·2026-08-17 ·Devender Singh, Issah Nazif Suleiman, Paul Mitten, Glenn Cutler, Vinicius Prado da Fonseca +1 more
similarity 0.56
Abstract

Autonomous navigation in complex outdoor terrains presents critical challenges for unmanned ground vehicles (UGVs) due to the inherent disconnect between global mapping and real-time sensor feedback. This work proposes a hybrid framework that integrates low-resolution Digital Elevation Model (DEM) data with real-time LiDAR-based obstacle detection and terrain analysis for efficient path planning. A global path is initially computed using a preprocessed DEM-based A* algorithm. Subsequently, local sensor data drives adaptive path correction, enabling the UGV to negotiate sudden environmental changes while maintaining safety and efficiency. Simulation results in Gazebo demonstrate significant improvements over a baseline approach, achieving a 95\% obstacle avoidance rate and reducing the average encountered slope from $8^\circ$ to $2.7^\circ$ in custom terrain. This integration enhances path efficiency and terrain traversability and supports robust real-time adaptation, paving the way for more reliable autonomous navigation in dynamic outdoor environments.

0.16

Path-Following Control and Terramechanics Analysis for Planetary Rovers Under Wheel-to-Wheel Traction Asymmetry

cs.RO ·2026-09-30 ·Ryuya Matsuoka, Keisuke Takehana, Kentaro Uno, Toshinori Kuwahara, Kazuya Yoshida
published similarity 0.56
Abstract · Author's version of a manuscript accepted at the International Conference on Space Robotics 2026 (iSpaRo 2026). (c) IEEE

This paper proposes a control strategy for path following that is model-free and relies solely on deceleration for skid-steering planetary rovers navigating deformable loose terrain under continuously imposed traction asymmetry. While conventional controllers that are based on kinematics frequently cause slip-sinkage entrapment by accelerating the wheels during path correction, the proposed approach prevents this failure by setting an upper limit on the maximum commanded velocity. Heading correction is achieved solely through the selective deceleration of the outer wheels, which are located on the outside of the turn, driving them into a negative slip regime to act as a mechanical anchor. The system was evaluated using the four-wheel independent-drive rover EX1 under an asymmetric wheel configuration with different left and right grouser heights that induces significant deviations from the path. Experimental results demonstrate that this deceleration-only control successfully suppresses accumulated lateral drift across various velocity regimes up to 0.7 m/s without causing sinkage. Crucially, direct force measurements from onboard multi-axis sensors provide important empirical evidence of the underlying terramechanics, proving that the targeted deceleration establishes dynamic load equalization across the chassis and completely restores the native thrust capability of the opposite driving wheel.

0.37