CS Paper Radar

Dynamic System Emulation: Fixed Wing Dynamics on a Multicopter

Abdelhakim Amer, Andriy Sarabakha

eess.SY cs.RO ·submitted 2026-09-06 10:37 UTC · v1

Abstract

This work presents a control framework that enables a multicopter equipped with a two-axis gimbal to emulate the flight dynamics of a fixed-wing aircraft. The goal is to provide an operationally simple platform for training and simulation that avoids the aerodynamic constraints of fixed-wing vehicles, such as minimum airspeed and nonholonomic constraints. A state-input mapping between the two platforms is derived using dynamic feedback linearization. The framework is evaluated on representative fixed-wing manoeuvres. Results show high-fidelity emulation under nominal conditions. While evaluations are conducted in simulation, the approach establishes a practical path toward hardware deployment for pilot training, autonomy research, and controller benchmarking.

Comment
7 pages, 6 figures

Closest papers

Nearest neighbours by meaning across the whole index.

Taming the Tilt: A Unified Pilot Control Concept for Transformational eVTOL Aircraft

eess.SY math.OC ·2026-08-20 ·Daniel Milz, Marc May, Andreas Seefried, Tobias Bellmann
published similarity 0.68
Abstract · Accepted for publication in "Aerospace Systems", 31 pages, 16 figures

Transformational electric vertical take-off and landing (eVTOL) vehicles have gained significant attention over the past decade due to their efficient wing-borne cruise capabilities and reduced reliance on ground-based infrastructure. However, control system design for these vehicles remains challenging, as they must operate across multiple flight phases, each with distinct dominant dynamics. If left unaddressed, this complexity would significantly increase pilot workload, thus motivating the development of pilot control systems for multi-phase flight operations. The Simplified Vehicle Operations concept presents a promising strategy for reducing pilot workload. This study presents the design and implementation of a novel pilot control concept for eVTOL aircraft, validated through a tandem tilt-wing aircraft simulation on a full-motion simulator equipped with an active, force-feedback side stick. The system provides pilots with tactile feedback during specific flight phases, supporting intuitive control. The proposed approach enables seamless transitions and multi-phase flight maneuvers by leveraging the available degrees of freedom. Furthermore, an optimal-control-based methodology is proposed as a metric to evaluate command-filter-induced performance penalties and inceptor activities. The results show that the proposed command filter does not significantly increase the mission duration compared to the closed-loop system, while the active side stick helps reduce inceptor activity.

0.40

FALCON-S: Fixed-wing ground-effect Aerodynamics Simulator and Flight Control Learning Suite

cs.RO cs.LGeess.SY ·2026-09-05 ·Matteo El Hariry, Pedro Lima, Andrej Orsula, Matthieu Geist, Miguel Olivares-Mendez
similarity 0.63
Abstract · Index Terms: Robot Learning, Flight Control, Reinforcement Learning, Autonomous Navigation, Control and Dynamics, Modeling and Simulation, W…

We present a modular, high-fidelity simulation framework for the development and benchmarking of flight control strategies in fixed-wing aerial robots operating near the ground. Unlike existing simulators that rely on simplified or hover-oriented dynamics, our framework models full 6DoF rigid-body physics, semi-empirical ground-effect aerodynamics, actuator dynamics, sensor noise, and environmental disturbances. This physical realism, combined with modular component design, enables systematic analysis of low-altitude flight behavior under realistic conditions. The simulator supports both CPU and GPU backends via Torch and NVIDIA Warp, enabling high-throughput parallel execution suitable for large-scale reinforcement learning training and optimal control rollouts. A unified interface accommodates a range of controllers (both RL and optical control algorithms) across tasks such as altitude regulation and trajectory tracking. Cross-validation with X-Plane and JSBSim is also supported to facilitate engineering integration and visual fidelity.

0.18

Neural Network-based Control Systems with Application to Flight Control, From Classical Neural Control to Reinforcement Learning

eess.SY ·2026-11-04 ·Seyyed Ali Emami, Paolo Castaldi, Mohammad Narimani, Mahdi Shahrajabian, Mostafa Ezabadi +3 more
similarity 0.61
Abstract

This book provides a comprehensive and systematic exploration of neural network-based intelligent control systems for aerospace applications, bridging foundational theory with practical implementation. It is structured into two primary parts: Part I covers model-based control design, detailing Feedback Error Learning (FEL), pseudocontrol strategies, and neural backstepping for strict-feedback systems, along with practical refinements such as learning rule modifications, composite learning, and discrete-time formulations, all grounded in rigorous Lyapunov stability analysis. Part II introduces model-free control, laying the groundwork for Reinforcement Learning and Approximate Dynamic Programming. Throughout, theoretical concepts are solidified through detailed case studies on quadrotor UAVs, fixed-wing aircraft (GTM), satellites, and hypersonic flight vehicles, complete with performance metrics, parameter sensitivity analyses, and discussions of actuator faults, input constraints, and wind disturbances, making the book an invaluable resource for students and practicing engineers seeking to design, simulate, and analyze intelligent flight control systems.

0.23

System Identification of an Octocopter in Hover using Full-Harmonic Orthogonal Multisine Inputs

eess.SY cs.RO ·2026-09-24 ·Justin J. Matt, George V. Altamirano
published similarity 0.61
Abstract · 31 pages, 18 figures. Presented at the AIAA AVIATION Forum 2025. Accepted for publication in the AIAA Journal of Aircraft

A new method for multi-input flight maneuver design for system identification is presented. The method consists of injecting "full-harmonic" orthogonal multisine signals into the flight control system. Orthogonality is achieved by repeating maneuvers with changing multisine polarities. The multisines can contain the same frequency content, which can simplify frequency response estimation and allow for long flight maneuvers to be split into several shorter maneuvers while maintaining the same frequency resolution and minimum frequency. An input allocation scheme is presented that augments the multisines to size the vehicle response amplitude about a specific degree of freedom. The developed approach was demonstrated through flight testing of a small octocopter in near-hover conditions. The input allocation scheme was utilized successfully to increase excitation about the yaw axis. Electrical power, motor speed, and rigid-body dynamic models were identified and are shown to predict the vehicle and motor responses accurately. The models are parameterized primarily by rotor thrust and torque coefficients, making them suitable for analysis of aircraft flight dynamics and individual rotor aerodynamics. The results demonstrate that the near-hover flight dynamics can be modeled accurately by neglecting rotor hub moments, variations in rotor coefficients, gyroscopic moments in roll and pitch, and aerodynamic interaction effects.

0.55

Cybflight: An Embedded Rust Autopilot for Aerial Robotics Research

cs.RO ·2026-09-25 ·Yifan Lin, Chao Qin, H S Helson Go, Hugh H. -T. Liu
code/data similarity 0.60
Abstract

Bringing an aerial robotics method from simulation to flight should not require rebuilding a mature autopilot or adding a companion computer. Cybflight is an open-source embedded Rust research autopilot whose typed, replaceable interfaces connect hardware access, perception, state estimation, trajectory planning, and control. This modular development and compile-time optimization workflow is demonstrated with replaceable Rust implementations of model predictive contour-tracking control (MPCTC) and incremental nonlinear dynamic inversion (INDI) running on one STM32H743 without a companion computer. Using this configuration, the vehicle reaches 12.38 m/s during indoor flight, while an outdoor flight using global navigation satellite system (GNSS) position updates reaches 31.4 m/s. These flights show that running demanding estimation and nonlinear control entirely on a flight-controller microcontroller need not come at the expense of a modular autopilot structure.

0.65

From Model to Prototype: Design and Motor-Flap Propulsion Control of a Twin-Wing Metamorphic UAV

cs.RO ·2026-10-06 ·Anja Bosak, Dorian Erić, Ana Milas, Stjepan Bogdan
similarity 0.60
Abstract · 8 pages, 12 figures

This paper presents the design and control strategy for MetaMorpher, a metamorphic Unmanned Aerial Vehicle (UAV), capable of both spinning-wing hover and fixed flying-wing cruise flight. Since control of the cruise configuration is comparatively well established in the literature, this paper focuses on control of the MetaMorpher in hover mode, building on the flight dynamics model and conceptual design validated in previous work. The control algorithm is implemented using one of two phase-synchronized strategies: motor propulsion, which pulses motor thrust in synchrony with the vehicle's rotation, or flap propulsion, a novel strategy that pulses the deflection of the wing-mounted elevons. We evaluate both strategies in simulation through different flight experiments. Simulation results confirm the mathematical model and show stable reference tracking, demonstrating flap propulsion as a lightweight, decoupled alternative for hover control. Experimental testing validated the vertical-dynamics propulsion model against the physical prototype, demonstrating very good steady-state agreement across different configurations.

0.22

AM-Bench: A Modular Simulation Suite and Benchmark for Aerial Manipulation Policy Learning

cs.RO ·2026-09-01 ·Yutong Wang, Dongjae Lee, Xiaofeng Guo, Yuanzhu Zhan, Yufei Jiang +7 more
benchmarkhighly cited similarity 0.59
Abstract · 28 pages, 7 figures, 15 tables

Standardized benchmarks have played a central role in advancing robot manipulation learning, yet most focus on ground-supported manipulation systems, which limits their applicability to dynamics-critical domains such as aerial manipulation (AM). AM presents distinct system-level challenges, including environmental disturbances, coupled dynamics between the manipulator and floating base, and constrained degrees of freedom. Consequently, task performance depends jointly on robot embodiment, low-level control, and high-level policy design. We introduce AM-Bench, a modular simulation suite and benchmark for multirotor-based AM policy learning. AM-Bench includes representative embodiments spanning underactuated, fully actuated, and overactuated systems, 12 tasks across contact, transport, and constrained interaction, configurable aerodynamic disturbances and actuator saturation, standard low-level controllers, and baseline policy-learning algorithms. Unlike prior manipulation benchmarks that primarily emphasize end-to-end policy performance, AM-Bench enables system-level evaluation of how embodiment, control, disturbances, and policy choices interact. We demonstrate its diagnostic value through three simulation studies spanning high-level policies, policy--control interfaces, and embodiments, together with real-world validation of modeled effects and a hardware test of the learning pipeline.

0.47

Autonomous fixed-wing interception using reinforcement learning

cs.RO cs.AIcs.NEeess.SY ·2026-10-27 ·Daan van Hamersveld, Ewoud Smeur, Iurii Kriachko
similarity 0.59
Abstract · MSc thesis, Faculty of Aerospace Engineering, Delft University of Technology, 2026. 24 pages, 29 figures, 4 tables

Medium altitude, long endurance unmanned aerial systems such as Shahed-type strike drones are an unanswered threat in modern conflicts. Conventional air defense systems are too expensive to provide a feasible large-scale solution. Quadcopter interceptors are a cheap, battle-proven alternative, but their extremely limited flight time restricts them to low altitude targets at short range, whereas fixed-wing platforms have the endurance to reach higher altitude targets from longer distances. However, such interceptors are still operated manually. Recent developments in learning-based controllers show potential for automation. In this work, a fixed-wing interceptor is presented that is controlled by a neural network that maps filtered monocular vision observations directly to actuator commands. The policy was trained in a custom Python environment using reinforcement learning and proximal policy optimization. The policy was then deployed on a fixed-wing platform and tested in real interception scenarios. As a baseline, two classical guidance controllers were also developed and tested in simulation. The policy is able to intercept targets both in simulation and in real flight. In simulation, the policy outperforms the classical controllers under most conditions. The interceptor was ultimately successfully validated in real flight by intercepting maneuvering fixed-wing targets. This novel system shows the potential of artificial intelligence for autonomous control of fixed-wing interceptor drones.

0.31