CS Paper Radar

Taming the Tilt: A Unified Pilot Control Concept for Transformational eVTOL Aircraft

Daniel Milz, Marc May, Andreas Seefried, Tobias Bellmann

eess.SY math.OC ·submitted 2026-08-20 17:38 UTC · v1
published

Abstract

Transformational electric vertical take-off and landing (eVTOL) vehicles have gained significant attention over the past decade due to their efficient wing-borne cruise capabilities and reduced reliance on ground-based infrastructure. However, control system design for these vehicles remains challenging, as they must operate across multiple flight phases, each with distinct dominant dynamics. If left unaddressed, this complexity would significantly increase pilot workload, thus motivating the development of pilot control systems for multi-phase flight operations. The Simplified Vehicle Operations concept presents a promising strategy for reducing pilot workload. This study presents the design and implementation of a novel pilot control concept for eVTOL aircraft, validated through a tandem tilt-wing aircraft simulation on a full-motion simulator equipped with an active, force-feedback side stick. The system provides pilots with tactile feedback during specific flight phases, supporting intuitive control. The proposed approach enables seamless transitions and multi-phase flight maneuvers by leveraging the available degrees of freedom. Furthermore, an optimal-control-based methodology is proposed as a metric to evaluate command-filter-induced performance penalties and inceptor activities. The results show that the proposed command filter does not significantly increase the mission duration compared to the closed-loop system, while the active side stick helps reduce inceptor activity.

Comment
Accepted for publication in "Aerospace Systems", 31 pages, 16 figures
Journal ref
Aerospace Systems (2026), 1-19
DOI
10.1007/s42401-026-00506-w

Closest papers

Nearest neighbours by meaning across the whole index.

Dynamic System Emulation: Fixed Wing Dynamics on a Multicopter

eess.SY cs.RO ·2026-09-06 ·Abdelhakim Amer, Andriy Sarabakha
similarity 0.68
Abstract · 7 pages, 6 figures

This work presents a control framework that enables a multicopter equipped with a two-axis gimbal to emulate the flight dynamics of a fixed-wing aircraft. The goal is to provide an operationally simple platform for training and simulation that avoids the aerodynamic constraints of fixed-wing vehicles, such as minimum airspeed and nonholonomic constraints. A state-input mapping between the two platforms is derived using dynamic feedback linearization. The framework is evaluated on representative fixed-wing manoeuvres. Results show high-fidelity emulation under nominal conditions. While evaluations are conducted in simulation, the approach establishes a practical path toward hardware deployment for pilot training, autonomy research, and controller benchmarking.

0.27

From Model to Prototype: Design and Motor-Flap Propulsion Control of a Twin-Wing Metamorphic UAV

cs.RO ·2026-10-06 ·Anja Bosak, Dorian Erić, Ana Milas, Stjepan Bogdan
similarity 0.60
Abstract · 8 pages, 12 figures

This paper presents the design and control strategy for MetaMorpher, a metamorphic Unmanned Aerial Vehicle (UAV), capable of both spinning-wing hover and fixed flying-wing cruise flight. Since control of the cruise configuration is comparatively well established in the literature, this paper focuses on control of the MetaMorpher in hover mode, building on the flight dynamics model and conceptual design validated in previous work. The control algorithm is implemented using one of two phase-synchronized strategies: motor propulsion, which pulses motor thrust in synchrony with the vehicle's rotation, or flap propulsion, a novel strategy that pulses the deflection of the wing-mounted elevons. We evaluate both strategies in simulation through different flight experiments. Simulation results confirm the mathematical model and show stable reference tracking, demonstrating flap propulsion as a lightweight, decoupled alternative for hover control. Experimental testing validated the vertical-dynamics propulsion model against the physical prototype, demonstrating very good steady-state agreement across different configurations.

0.22

Trajectory Inversion for a Rudderless Dual Vectored-Thrust Flying Wing

cs.RO ·2026-11-07 ·Weicheng Di, Qiqi Liu, Jinwu Xiang, Daochun Li, Zhan Tu
similarity 0.59
Abstract

A rudderless dual vectored-thrust flying wing combines vertical takeoff and landing with efficient for- ward flight in a compact tailless configuration. Without aerodynamic control surfaces, vectored thrust couples translation and pitch control. Therefore, generating dy- namically compatible trajectories remains an open chal- lenge. To address this challenge, this study proposes a trajectory generation method that jointly optimizes path geometry and timing. Trajectory inversion yields state and control histories that satisfy the coupled equations of motion. The optimization balances curvature-induced acceleration against aerodynamic support, lowering thrust- vectoring demand while retaining the defining maneuver features. Representative looping and rolling sequences are tracked in closed-loop simulations. These results provide a basis for planning autonomous aerobatic maneuvers with rudderless vectored-thrust aircraft.

0.31

Overcoming Fundamental Control Limitations in Powered Descent Flight through Robust Incremental Nonlinear Dynamic Inversion

eess.SY math.OC ·2026-11-05 ·João T. Diz, Paulo Rosa, Pedro Simplício, Paul Acquatella, Erik-Jan van Kampen +1 more
published similarity 0.57
Abstract · 28 pages, 16 figures, 5 tables. Accepted for presentation at the AIAA SciTech 2027 Forum, Orlando, FL, January 2027

This work identifies a fundamental, controller-independent limitation in reusable launch vehicle powered descent: a sudden $180^\circ$ phase transition in the open-loop transfer functions from the control inputs to the lateral drift and drift rate. The transition occurs inside the flight envelope, reverses the effective control direction, and can destabilize the closed loop system under uncertainty. An analytical condition governing this transition is derived, its physical mechanism is established, and its dependence on vehicle mass, aerodynamic properties, and geometry is characterized. An Incremental Nonlinear Dynamic Inversion (INDI)-based control architecture is then developed to inherently address this limitation and is tuned via $\mathcal{H}_\infty$ Closed Loop Shaping to provide local robustness and performance guarantees. The internal dynamics introduced by the INDI inversion are analytically derived and proven to be stable throughout the flight envelope. The proposed controller is compared against a robust gain-scheduled baseline controller through linear stability analysis and an extensive nonlinear Monte Carlo campaign. Both controllers achieve 100% success across the considered Monte Carlo campaign, though the INDI-based controller provides improved tracking performance, superior nominal and dispersed stability margins, requires fewer controller design points, and reduces controller tuning complexity.

0.45

FALCON-S: Fixed-wing ground-effect Aerodynamics Simulator and Flight Control Learning Suite

cs.RO cs.LGeess.SY ·2026-09-05 ·Matteo El Hariry, Pedro Lima, Andrej Orsula, Matthieu Geist, Miguel Olivares-Mendez
similarity 0.55
Abstract · Index Terms: Robot Learning, Flight Control, Reinforcement Learning, Autonomous Navigation, Control and Dynamics, Modeling and Simulation, W…

We present a modular, high-fidelity simulation framework for the development and benchmarking of flight control strategies in fixed-wing aerial robots operating near the ground. Unlike existing simulators that rely on simplified or hover-oriented dynamics, our framework models full 6DoF rigid-body physics, semi-empirical ground-effect aerodynamics, actuator dynamics, sensor noise, and environmental disturbances. This physical realism, combined with modular component design, enables systematic analysis of low-altitude flight behavior under realistic conditions. The simulator supports both CPU and GPU backends via Torch and NVIDIA Warp, enabling high-throughput parallel execution suitable for large-scale reinforcement learning training and optimal control rollouts. A unified interface accommodates a range of controllers (both RL and optical control algorithms) across tasks such as altitude regulation and trajectory tracking. Cross-validation with X-Plane and JSBSim is also supported to facilitate engineering integration and visual fidelity.

0.18

System Identification of an Octocopter in Hover using Full-Harmonic Orthogonal Multisine Inputs

eess.SY cs.RO ·2026-09-24 ·Justin J. Matt, George V. Altamirano
published similarity 0.54
Abstract · 31 pages, 18 figures. Presented at the AIAA AVIATION Forum 2025. Accepted for publication in the AIAA Journal of Aircraft

A new method for multi-input flight maneuver design for system identification is presented. The method consists of injecting "full-harmonic" orthogonal multisine signals into the flight control system. Orthogonality is achieved by repeating maneuvers with changing multisine polarities. The multisines can contain the same frequency content, which can simplify frequency response estimation and allow for long flight maneuvers to be split into several shorter maneuvers while maintaining the same frequency resolution and minimum frequency. An input allocation scheme is presented that augments the multisines to size the vehicle response amplitude about a specific degree of freedom. The developed approach was demonstrated through flight testing of a small octocopter in near-hover conditions. The input allocation scheme was utilized successfully to increase excitation about the yaw axis. Electrical power, motor speed, and rigid-body dynamic models were identified and are shown to predict the vehicle and motor responses accurately. The models are parameterized primarily by rotor thrust and torque coefficients, making them suitable for analysis of aircraft flight dynamics and individual rotor aerodynamics. The results demonstrate that the near-hover flight dynamics can be modeled accurately by neglecting rotor hub moments, variations in rotor coefficients, gyroscopic moments in roll and pitch, and aerodynamic interaction effects.

0.55

Neural Network-based Control Systems with Application to Flight Control, From Classical Neural Control to Reinforcement Learning

eess.SY ·2026-11-04 ·Seyyed Ali Emami, Paolo Castaldi, Mohammad Narimani, Mahdi Shahrajabian, Mostafa Ezabadi +3 more
similarity 0.54
Abstract

This book provides a comprehensive and systematic exploration of neural network-based intelligent control systems for aerospace applications, bridging foundational theory with practical implementation. It is structured into two primary parts: Part I covers model-based control design, detailing Feedback Error Learning (FEL), pseudocontrol strategies, and neural backstepping for strict-feedback systems, along with practical refinements such as learning rule modifications, composite learning, and discrete-time formulations, all grounded in rigorous Lyapunov stability analysis. Part II introduces model-free control, laying the groundwork for Reinforcement Learning and Approximate Dynamic Programming. Throughout, theoretical concepts are solidified through detailed case studies on quadrotor UAVs, fixed-wing aircraft (GTM), satellites, and hypersonic flight vehicles, complete with performance metrics, parameter sensitivity analyses, and discussions of actuator faults, input constraints, and wind disturbances, making the book an invaluable resource for students and practicing engineers seeking to design, simulate, and analyze intelligent flight control systems.

0.23

Controllability-Informed Distributed Electric Propulsion Aircraft Design Using Probabilistic Attainable Moment Sets

eess.SY math.OC ·2026-11-13 ·Umut Demir, Torbjørn Cunis, Aamir Ahmad, Walter Fichter
similarity 0.53
Abstract

Integrated aircraft design combines models of aerodynamics, propulsion, mass, and mission performance in one design loop, so that the disciplines can be traded against each other from the earliest stage. For configurations with distributed electric propulsion (DEP), part of the control authority comes from the propulsion system itself, which directly affects the required size of the tail and should therefore be known while the aircraft is being sized. This paper presents a controllability measure that is evaluated for every design in the loop and returned to it as a design signal. The attainable moment set of each candidate design is computed from the surrugate models of the loop and it is compared with a required moment set. Since the low-fidelity surrugate models are uncertain, the comparison is formulated with probabilistic attainable moment sets: the uncertainty is propagated to the boundary of the set, which yields a margin for every direction in the moment space and the probability of violating the requirement. The design loop thereby informed whether a configuration provides sufficient control authority, on which axes it falls short, and how this changes with the design variables. The approach is demonstrated on a DEP regional aircraft, where the signal is used to assess the size of the vertical tail.

0.24