CS Paper Radar

Controllability-Informed Distributed Electric Propulsion Aircraft Design Using Probabilistic Attainable Moment Sets

Umut Demir, Torbjørn Cunis, Aamir Ahmad, Walter Fichter

eess.SY math.OC ·submitted 2026-11-13 12:20 UTC · v1

Abstract

Integrated aircraft design combines models of aerodynamics, propulsion, mass, and mission performance in one design loop, so that the disciplines can be traded against each other from the earliest stage. For configurations with distributed electric propulsion (DEP), part of the control authority comes from the propulsion system itself, which directly affects the required size of the tail and should therefore be known while the aircraft is being sized. This paper presents a controllability measure that is evaluated for every design in the loop and returned to it as a design signal. The attainable moment set of each candidate design is computed from the surrugate models of the loop and it is compared with a required moment set. Since the low-fidelity surrugate models are uncertain, the comparison is formulated with probabilistic attainable moment sets: the uncertainty is propagated to the boundary of the set, which yields a margin for every direction in the moment space and the probability of violating the requirement. The design loop thereby informed whether a configuration provides sufficient control authority, on which axes it falls short, and how this changes with the design variables. The approach is demonstrated on a DEP regional aircraft, where the signal is used to assess the size of the vertical tail.

Closest papers

Nearest neighbours by meaning across the whole index.

Overcoming Fundamental Control Limitations in Powered Descent Flight through Robust Incremental Nonlinear Dynamic Inversion

eess.SY math.OC ·2026-11-05 ·João T. Diz, Paulo Rosa, Pedro Simplício, Paul Acquatella, Erik-Jan van Kampen +1 more
published similarity 0.54
Abstract · 28 pages, 16 figures, 5 tables. Accepted for presentation at the AIAA SciTech 2027 Forum, Orlando, FL, January 2027

This work identifies a fundamental, controller-independent limitation in reusable launch vehicle powered descent: a sudden $180^\circ$ phase transition in the open-loop transfer functions from the control inputs to the lateral drift and drift rate. The transition occurs inside the flight envelope, reverses the effective control direction, and can destabilize the closed loop system under uncertainty. An analytical condition governing this transition is derived, its physical mechanism is established, and its dependence on vehicle mass, aerodynamic properties, and geometry is characterized. An Incremental Nonlinear Dynamic Inversion (INDI)-based control architecture is then developed to inherently address this limitation and is tuned via $\mathcal{H}_\infty$ Closed Loop Shaping to provide local robustness and performance guarantees. The internal dynamics introduced by the INDI inversion are analytically derived and proven to be stable throughout the flight envelope. The proposed controller is compared against a robust gain-scheduled baseline controller through linear stability analysis and an extensive nonlinear Monte Carlo campaign. Both controllers achieve 100% success across the considered Monte Carlo campaign, though the INDI-based controller provides improved tracking performance, superior nominal and dispersed stability margins, requires fewer controller design points, and reduces controller tuning complexity.

0.45

Taming the Tilt: A Unified Pilot Control Concept for Transformational eVTOL Aircraft

eess.SY math.OC ·2026-08-20 ·Daniel Milz, Marc May, Andreas Seefried, Tobias Bellmann
published similarity 0.53
Abstract · Accepted for publication in "Aerospace Systems", 31 pages, 16 figures

Transformational electric vertical take-off and landing (eVTOL) vehicles have gained significant attention over the past decade due to their efficient wing-borne cruise capabilities and reduced reliance on ground-based infrastructure. However, control system design for these vehicles remains challenging, as they must operate across multiple flight phases, each with distinct dominant dynamics. If left unaddressed, this complexity would significantly increase pilot workload, thus motivating the development of pilot control systems for multi-phase flight operations. The Simplified Vehicle Operations concept presents a promising strategy for reducing pilot workload. This study presents the design and implementation of a novel pilot control concept for eVTOL aircraft, validated through a tandem tilt-wing aircraft simulation on a full-motion simulator equipped with an active, force-feedback side stick. The system provides pilots with tactile feedback during specific flight phases, supporting intuitive control. The proposed approach enables seamless transitions and multi-phase flight maneuvers by leveraging the available degrees of freedom. Furthermore, an optimal-control-based methodology is proposed as a metric to evaluate command-filter-induced performance penalties and inceptor activities. The results show that the proposed command filter does not significantly increase the mission duration compared to the closed-loop system, while the active side stick helps reduce inceptor activity.

0.40

Control Allocation with Adaptive Augmentation for Aerodynamic Optimization of Trailing Edge Morphing Aircraft

eess.SY math.OC ·2026-10-01 ·Mark Spiller, Lennart Kracke, Johannes Autenrieb
similarity 0.52
Abstract · Submitted to American Control Conference (ACC) 2027

This paper presents a control allocation framework with adaptive augmentation for a trailing edge morphing aircraft, providing stability guarantees under uncertainty while exploiting the available morphing degrees of freedom to optimize aerodynamic efficiency. A baseline controller is designed using the nominal aircraft model to establish the desired closed-loop reference dynamics. For the aerodynamics, the wing shape is optimized dependent on the flight state to achieve a target elliptical lift distribution corresponding to minimum induced drag. The adaptive augmentation is tailored to the control allocation problem to account for the uncertain system dynamics and stabilize the aircraft around the reference dynamics. The resulting stabilization condition is formulated as hard constraint in the allocation problem while minimizing deviations from the corresponding state-dependent aerodynamically optimal wing shape. Numerical results demonstrate that the adaptive augmentation compensates for matched uncertainties while the control allocation optimizes the wing shape with respect to the reference elliptical lift distribution.

0.18

Trajectory Inversion for a Rudderless Dual Vectored-Thrust Flying Wing

cs.RO ·2026-11-07 ·Weicheng Di, Qiqi Liu, Jinwu Xiang, Daochun Li, Zhan Tu
similarity 0.50
Abstract

A rudderless dual vectored-thrust flying wing combines vertical takeoff and landing with efficient for- ward flight in a compact tailless configuration. Without aerodynamic control surfaces, vectored thrust couples translation and pitch control. Therefore, generating dy- namically compatible trajectories remains an open chal- lenge. To address this challenge, this study proposes a trajectory generation method that jointly optimizes path geometry and timing. Trajectory inversion yields state and control histories that satisfy the coupled equations of motion. The optimization balances curvature-induced acceleration against aerodynamic support, lowering thrust- vectoring demand while retaining the defining maneuver features. Representative looping and rolling sequences are tracked in closed-loop simulations. These results provide a basis for planning autonomous aerobatic maneuvers with rudderless vectored-thrust aircraft.

0.31

Optimal TRACON Descent Procedures under Wind Uncertainty and Fuel Savings Factors

eess.SY ·2026-08-23 ·Yutian Pang, John-Paul Clarke
similarity 0.49
Abstract

A terminal-area descent procedure need to perform across the wind climatology rather than a single wind condition. Although flight demonstrations of the delayed deceleration approach (DDA) showed substantial fuel savings, DDA combined late deceleration with a steeper $3.77^\circ$ final descent, obscuring the contribution of each design choice. In this work, we propose the continuous-descent delayed deceleration approach (CDDA), which applies delayed deceleration to a continuous descent approach (CDA) profile without a level segment before glideslope intercept. A simulation-based stochastic optimization selects flap deployment trigger speeds and glideslope-capture distance to minimize expected fuel under wind uncertainty subject to a given stabilized-approach probability. An optimal control reduction limits the design space to a few hundred candidates, enabling exact expectation over a weighted wind grid using six-degree-of-freedom fast-time simulations. CDA and CDDA are optimized at matched final angles of $3.00^\circ$, $3.50^\circ$, and $3.77^\circ$ for the A319, B737-800, B767-400, and A340-300. Results show that deceleration architecture is the weakest factor, yielding 0.3--3.9\% savings at $3.50^\circ$ and becoming material only for the B767-400 at $3.77^\circ$. Glideslope angle dominates fuel saving. At the $3.50^\circ$ Category D design maximum, optimized CDDA reduces expected fuel by 11-21\% relative to optimized $3^\circ$ CDA, while flap-schedule optimization adds 2-17\%. The DDA level segment acts primarily as a tailwind-robustness buffer, and the $3.77^\circ$ final exceeds the 1,000 ft/min stabilized-approach sink-rate element, limiting its near-term operational applicability.

0.45

Aeroelastically Constrained Optimal Path Planning of a Fixed-Wing Airborne Wind Energy System

eess.SY ·2026-11-10 ·Omid Heydarnia, Jolan Wauters, Tom Lefebvre, Joris Degroote, Guillaume Crevecoeur
published similarity 0.49
Abstract

Multi-megawatt fixed-wing airborne wind energy systems (AWES) use an aircraft with large, slender wings that deform over the pumping cycle. To harvest maximum energy, the cycle is usually designed by means of dedicated reference trajectory optimization routines. It is well known that such routines rely heavily on the system model and that close alignment between the model and the physical system is required for the results to hold in practice. Nevertheless, the wing is usually treated as rigid and structural limits are respected indirectly through upper bounding of states and inputs. In this work, we directly enforce bounds on the elastic deflection and twist of the wing in the power-maximizing periodic optimal control problem. To that end, we model the wing by root-clamped modes, loaded by strip-theory aerodynamics and by the gravitational and inertial loads of the manoeuvring aircraft. To keep the problem tractable, the modal dynamics are replaced by their quasi-static equilibrium, which enters every discretization interval as algebraic constraints. For a multi-megawatt reference aircraft, the elastic twist near the wing tips reaches $1.03^\circ$ along the optimal rigid-wing trajectory. With a twist limit of $0.6^\circ$, the optimal trajectory delivers $31\,\%$ less mean power than the rigid-wing one, mainly through a lower tether tension during reel-out. Rigid-wing trajectory optimization can thus overestimate the power that the wing limits permit. Forward simulations that retain the modal dynamics demonstrate that the quasi-static deflection and twist deviate from the dynamic ones by less than $2\,\%$ of their limits. This work shows that elastic deformation can be accounted for in the trajectory optimization and that, depending on the wing limits, it can strongly reduce the achievable power.

0.32

Dynamic System Emulation: Fixed Wing Dynamics on a Multicopter

eess.SY cs.RO ·2026-09-06 ·Abdelhakim Amer, Andriy Sarabakha
similarity 0.49
Abstract · 7 pages, 6 figures

This work presents a control framework that enables a multicopter equipped with a two-axis gimbal to emulate the flight dynamics of a fixed-wing aircraft. The goal is to provide an operationally simple platform for training and simulation that avoids the aerodynamic constraints of fixed-wing vehicles, such as minimum airspeed and nonholonomic constraints. A state-input mapping between the two platforms is derived using dynamic feedback linearization. The framework is evaluated on representative fixed-wing manoeuvres. Results show high-fidelity emulation under nominal conditions. While evaluations are conducted in simulation, the approach establishes a practical path toward hardware deployment for pilot training, autonomy research, and controller benchmarking.

0.27

Certifiable Explicit Model Predictive Control for Spacecraft Rendezvous under Bounded Disturbances

eess.SY ·2026-08-23 ·Diogo Silva, Daniel Silvestre
similarity 0.49
Abstract · 12 pages, 5 figures, 2 tables. Submitted to IEEE Transactions on Control Systems Technology

Two properties of optimization-based controllers such as model predictive control (MPC) limit their use in space flight. The online computing time varies and can exceed the sampling period, and the closed-loop behavior carries no formal guarantee. Explicit MPC, where a parametric solution of the optimization problem is computed, replaces the on-board optimization with a lookup table of piecewise-affine functions with a fixed execution time. However, it has been regarded as only applicable to small horizons, since the number of regions bounds the memory the table occupies and admits only an exponential bound in the horizon. This paper builds on recent developments in parametric solutions of quadratic programs and nonconvex reachability analysis to provide an entire pipeline for spacecraft rendezvous controllers under the Clohessy-Wiltshire dynamics. For this application, efficient data structures can be constructed to encode the control law, both from a computing time and a memory standpoint. In addition, the controller can be verified offline with a guaranteed closed-loop stability certificate by resorting to reachability analysis with hybrid zonotopes. At a 51-step horizon the rendezvous law occupies 10.5 MB and is evaluated in under 300 ns. The occupied memory would fit for instance the CubeSat flight computer ARM9-class AT91RM9200 meaning that the horizon limitation does not hold when the partition is built with the parametric solvers and data structures shown in this paper.

0.16