CS Paper Radar

Virtualized 5G Tesbed using OpenAirInterface: Tutorial and Benchmarking Tests

M. Dória, V. Sousa, A. Campos, N. Oliveira, P. Eduardo, P. Filho, C. Lima, J. Guilherme, D. Luna, I. Rego, M. Fernandes, A. Neto

cs.NI ·submitted 2026-09-11 15:35 UTC · v1
publishedbenchmarkhighly cited

Abstract

The development of 5G and its evolutionary path to 6G brings virtualization as close as possible to the antennas. Native 3GPP systems are now software running at servers boosted by accelerator cards to cope with computationally intense signal processing. Meanwhile, the Radio Frequency (RF) front-end is still proprietary hardware, sheltering specific PHY-layer procedures like passband amplification/modulation. This approach takes advantage of the software's flexibility while keeping the complex microsecond signal processing performance from modern telecommunication systems. This paper provides tutorial material on the Core Network and Radio Access Network of OpenAirInterface (OAI) 5G stack on top of Universal Software Radio Peripheral (USRP) platforms. A set of blueprints showcases OAI's ability to provide a virtualized 5G network with different transmission capabilities and the possibility to use it with commercial mobile phones. Configuration discussions and throughput benchmark analyses follow installation and deployment instructions. Our results show that 5G prototyping using OAI and USRP frontends can lead to good reproducibility and consistent throughput.

Journal ref
Journal of Internet Services and Applications 2024, 15(1), 523-535
DOI
10.5753/jisa.2024.4454

Closest papers

Nearest neighbours by meaning across the whole index.

Open-Source 5G RAN Platforms: A Dual Perspective on Performance and Capabilities

cs.NI ·2026-08-26 ·Maria Katarine Santana Barbosa, Iasmin Gomes, Vinícius Melo, Kelvin Lopes Dias
code/data similarity 0.74
Abstract · This paper has been published in IEEE WCPNS 2025

Open-source implementations of the fifth generation (5G) Radio Access Network (RAN), such as OpenAirInterface (OAI) and srsRAN, have become increasingly relevant for industry and academic research, rapid prototyping, and low-cost private 5G deployments. The state of the art presents different evaluation scenarios for both platforms; however, these are often limited to individual testbed evaluations, end-to-end studies, or partial comparisons between them. In particular, there is a lack of evaluations considering different Software-Defined Radios (SDRs), RAN configurations, user applications, and numbers of real UEs. To address this gap, this paper presents a comparative evaluation of OAI and srsRAN. The study includes a qualitative assessment of supported features and deployment flexibility, followed by a quantitative performance analysis covering radio resource control setup procedures, compliance with theoretical data rates, and real application workloads with diverse quality of service requirements. Specifically, we consider Video on Demand (VoD) for data rate evaluation, Live Streaming (LS) and Cloud Gaming (CG) as latency-sensitive applications. These workloads provide a comprehensive view of each platform capability.

0.63

Toward Lightweight Aerial 5G gNBs: Reproducible OAI Testbed on Commodity ARM Platforms

cs.CR eess.SP ·2026-10-04 ·Marc Duboc, Ammar El Falou
similarity 0.72
Abstract

For a battery-powered UAV base station, every gram and watt devoted to RAN-compute competes with flight-duration margin. We therefore keep the 5G Core (5GC) and central unit (CU) on the ground and design the airborne unit around only the backhaul endpoint, distributed unit (DU), and radio. The key question is then a practical one: can widely available commodity ARM computers sustain a real radio OpenAirInterface (OAI) 5G DU with useful performance over heterogeneous F1? We answer it with Raspberry Pi~5 and Jetson Orin Nano as DUs, a USRP B210, a commercial handset, and Ethernet, Wi-Fi/GRE, and 5G/WireGuard backhaul. Jetson preserves 88.4% of x86 split-DU Ethernet DL throughput and 87.5-89.0% across all three bearers; 5G/WireGuard preserves 76.4-77.1% of each host's wired DL rate. The validated Jetson/B210/RM500Q-GL electronics weigh 657.4 g and draw about 28 W under sustained traffic (757.4 g with integration allowance). A controlled link adaptation intervention raises split DL from 23.4 to 99.4 Mb/s as the dominant Modulation and Coding Scheme (MCS) moves from 3 to 26. Finally, synchronized radio, F1-U, CPU, and UHD evidence narrows the remaining monolithic-split gap to split-path scheduling/timing behavior. Beyond performance, this capability serves the emergency-response use case that motivates the aerial cell: once deployed above an affected area, it can broadcast a PWS warning message. We release the OAI patch that carries the single-segment Write-Replace Warning over F1 from CU to DU, where SIB8 is scheduled to the handset. The public artifact makes the payload, performance, and emergency-broadcast baseline reproducible with laboratory-accessible hardware.

0.14

SL-RFSIM: Enabling Scalable Multi-Hop 5G NR Sidelink Mesh Networking in OpenAirInterface

cs.NI ·2026-10-01 ·Simone Pio Candido, Jin Yan, Jérôme Härri
code/data similarity 0.66
Abstract

Recent 3GPP releases have extended 5G New Radio (NR) Sidelink (SL) to support device-to-device (D2D) relay and multi-hop capabilities. This paper presents SL-RFSIM, a component-based experimentation framework extending OpenAirInterface (OAI) with scalable multi-hop NR SL capabilities. SL-RFSIM replaces the legacy OAI RF simulator with a broker-based publish/subscribe architecture enabling arbitrary peer-to-peer connectivity while preserving compatibility with the OAI protocol stack. The framework further integrates pluggable mobility, propagation, reception, and monitoring services, and supports Layer-2 mesh networking through BATMAN-adv. Experimental evaluation on the SLICES-RI research infrastructure validates the proposed architecture through representative mesh networking scenarios and identifies the current software bottlenecks limiting scalability. SL-RFSIM provides an open-source foundation for reproducible experimental research on 5G NR SL and future multi-hop cellular mesh networks.

0.28

A Ray-Traced Digital Twin for 5G NR Positioning with OpenAirInterface

cs.IT ·2026-10-09 ·Nima Chaharbaghi, Florian Kaltenberger, Bartosz Podrygajlo, Rakesh Mundlamuri, Roberto Verdone
similarity 0.60
Abstract · submitted at 22nd Wireless On-demand Network systems and Services Conference

Evaluating 5G positioning on a physical testbed ties every measurement to one propagation environment and one antenna layout, so any question about an alternative deployment requires a new field campaign. We present a ray-traced digital twin of the GEO-5G testbed at EURECOM that drives an unmodified OpenAirInterface (OAI) 5G stack with per-antenna channels computed by Sionna-RT over a 3D model of the site. The distributed gNB antennas are modelled as independent radio devices rather than as elements of a compact array, which preserves the per-antenna absolute delays on which time-difference-of-arrival (TDoA) positioning depends. With them preserved, the twin drives OAI's SRS-based UL-TDoA pipeline to metre-level accuracy consistent with that reported for the physical deployment. We then use the twin to answer a question the physical testbed cannot. Widening the carrier truncates the tail of the horizontal error distribution without improving a typical position, and leaves the vertical error untouched, because the latter is limited by the array geometry rather than by the measurement. That limit is predictable from the antenna coordinates alone, and a height-diverse layout reduces the RMS height error by a factor of four.

0.20

Real-Time Symbol-Domain OFDM Radar in an OpenAirInterface 5G Base Station With O-RAN Sensing Services

eess.SP ·2026-08-17 ·Karim Saifullin, Sajid Ahmed, Mohamed-Slim Alouini
similarity 0.57
Abstract

This paper presents a real-time orthogonal frequency-division multiplexing (OFDM) radar embedded in the OpenAirInterface (OAI) 5G base-station process. The radar removes communication symbols by regularized element-wise division and performs range-Doppler processing and ordered-statistic constant-false-alarm-rate detection online without modifying the 5G waveform. The implemented system provides 2.57 m nominal range resolution and 0.28 m/s velocity resolution. Hardware measurements identify and mitigate several implementation-specific limitations, most notably a deterministic carrier-dependent transmit-receive phase rotation on a Universal Software Radio Peripheral (USRP) X300. Selecting a tuning-grid-aligned carrier improves mean-removal clutter suppression from -16.4 dB to 38.0 dB and reduces coherent-integration loss from 19.81 dB to 0.27 dB. The measured processing gain closely agrees with its predicted value. Instrumented worker timing confirms real-time operation, with a conservative 58.4 percent utilization bound and no dropped soundings. A custom E2 service model, E2SM-RADAR, exports detections and a compact slow-time product to a near-real-time RAN Intelligent Controller. Live end-to-end operation demonstrates reliable delivery and supports controller-side tracking, micro-Doppler analysis, and classification. With a commercial user equipment connected on the same carrier, measurements show no measurable difference in downlink throughput estimate with sensing enabled, while the radar sensing bandwidth follows the scheduler allocation. Video demonstration can be found in youtube: youtu.be/GaYAcTJ8RKI

0.31

Open-source emulation-based test environment to settle O-RAN-compliant trials

cs.NI ·2026-09-16 ·Ramon Fontes, Allan Martins, Vicente Sousa, Kaio Dantas, Lucas Medeiros +9 more
published similarity 0.57
Abstract

Experimental tools are a key factor in both academic and industrial research communities to create design evaluations of new networking technologies that involve troubleshooting or changing the planning of deployed networks. Physical Software-Defined Radio (SDR) experimental platforms enable a design solution for the quick prototyping of wireless communication systems. However, SDR-based experimental platforms incur high costs, which leads to scalability limitations in the experimental settings. Having said this, network simulators, emulators, and new testbeds have attracted increasing attention. Emulation-based research prototyping can be distinguished from real communication networks and SDR-based platforms by allowing a tradeoff between cost and flexibility. This paper examines the Mininet-RAN emulation tool, which, as well as Radio Access Network (RAN) modeling, provides a way to test Open RAN Intelligent Controller (RIC) services without the need to deploy an entire RAN infrastructure. The Mininet-RAN creates virtual network elements, such as hosts, L2/L3 devices, controllers, and links, by combining some of the best emulator features, hardware testbeds, and simulators. By running the current code of standard practice Unix/Linux network applications and network stack, the Mininet-RAN enables real-world network data traffic patterns to be delivered to the RIC, regarding the most significant aspect of the dynamic generation of wireless system's KPIs. We provide the basic code of Mininet-RAN for the first two O-RAN Alliance-defined use cases involving V2X and UAV. The xApps are being implemented in O-RAN SC near-RT RIC, with Mininet-RAN which provides a closed-loop validation environment.

0.49

ONDT: A Modular and Virtualized O-RAN Digital Twin for xApp/rApp Closed-Loop Experimentatio

cs.NI ·2026-10-06 ·Miguel Catalan-Cid, Joan Josep Aleixendri, August Betzler, George Oikonomou, Lydia Ntzogani +1 more
published similarity 0.56
Abstract

Open Radio Access Network (O-RAN) architectures extend programmability in next-generation cellular networks through Near-Real-Time and Non-Real-Time RAN Intelligent Controllers (RICs), enabling AI/ML-driven xApps and rApps to optimize network behavior dynamically. However, validating automated closed-loop control algorithms in live environments presents significant operational risks and deployment costs. To address this challenge, this paper introduces the O-RAN Digital Twin (ONDT), a modular, virtualized, and cloud-native experimentation framework developed as a 6G enabler within the SNS SUNRISE-6G project. We present the ONDT architecture and its end-to-end experimentation workflows, showing how the framework automates O-RAN-compliant rApp/xApp onboarding, RAN scenario configuration and initialization, Key Performance Metric (KPM) collection, and closed-loop control validation. Experimental validation using Juniper RIC platforms and the Keysight RICtest emulation framework demonstrates ONDT ability to provide an isolated and reproducible environment for KPM monitoring, cell ON/OFF control, automated dataset generation, and rApp/xApp validation.

0.35

ISAC in 3GPP: Evolution Toward 6G

cs.NI cs.IT ·2026-08-15 ·Neeraj Varshney
similarity 0.55
Abstract · submitted for possible publication in IEEE Journal

Integrated sensing and communication (ISAC) is emerging as an important direction in the Third Generation Partnership Project (3GPP) evolution toward 6G because it allows cellular networks to provide environmental awareness in addition to connectivity. This paper surveys the current 3GPP trajectory from Release~19 feasibility studies to Release~20 radio, protocol, and architecture studies, while distinguishing established requirements, ongoing study assumptions, and possible forward directions. The survey covers service requirements, sensing topologies, channel model evolution beyond 3GPP Technical Report (TR)~38.901, Radio Access Network Working Group~1 (RAN1) physical layer design, Radio Access Network Working Groups~2 and~3 (RAN2 and RAN3) system implications, and the role of sensing-assisted communication. It also synthesizes the main unresolved issues in waveform and reference signal design, multi-node coordination, sensing data reporting, service exposure, privacy, and implementation constraints. By connecting service-level motivations to physical layer, protocol, and architecture implications, the paper provides a standards-centric reading of how 3GPP may evolve toward practical 6G ISAC support.

0.36