CS Paper Radar

RUN-O-RAN: An O-RAN-Native Architecture Enabling Cooperative Uplink Localization

Viola Bernazzoli, Alberto Ceresoli, Ilario Filippini

cs.NI ·submitted 2026-09-17 16:23 UTC · v1

Abstract

Accurate positioning is increasingly required in indoor and dense urban environments; nonetheless, satellite-based systems are not always available, and standardized 5G localization solutions remain difficult to deploy with commercial devices. This paper presents RUN-O-RAN, an O-RAN-native framework that enables network-centric uplink localization using standard Sounding Reference Signal (SRS) transmissions from commercial 5G devices. RUN-O-RAN xApp coordinates serving and neighboring base stations, enabling non-serving base stations to retrieve SRS-based uplink timing measurements that would be unavailable in conventional RAN deployments, without modifying the UE or existing 3GPP signaling procedures. The framework combines cooperative SRS collection, first-path time-of-arrival estimation, timing-advance tracking, clock-drift compensation, and multi-anchor position estimation into a complete network-side localization service. Experimental evaluation over $150,000$ SRS transmissions validates the proposed framework, achieving meter-level localization under diverse propagation conditions while revealing the impact of anchor geometry and multipath on positioning accuracy. These findings demonstrate that cooperative SRS-based localization can be realized within the O-RAN ecosystem without modifying commercial UEs, providing a practical foundation for future network-native ISAC positioning services.

Comment
14 pages, 13 figures

Closest papers

Nearest neighbours by meaning across the whole index.

UE-Side Location Privacy for 5G NR Uplink Positioning: Mechanisms and Trade-offs

eess.SP ·2026-09-22 ·Giulia Focarelli, Alireza Pourafzal, Henk Wymeersch, Stefania Bartoletti
published similarity 0.65
Abstract · 6 pages, 4 figures, 1 table. Accepted for publication at the 2026 IEEE 1st Annual Integrated Sensing and Communication Conference (ISAC)

Future 5G-Advanced and 6G networks increasingly reuse uplink communication waveforms for positioning and sensing. This raises privacy concerns, as user equipments (UEs) may unintentionally reveal precise timing information even when positioning services are not explicitly requested. While prior works show generic orthogonal frequency division multiplexing (OFDM) pilots can be manipulated to degrade time-of-arrival (ToA) estimation without compromising data links, this paper extends these concepts to a realistic 5G new radio (NR) up-link framework including Sounding Reference Signal (SRS), Demodulation Reference Signal (DMRS), Physical Uplink Shared Channel (PUSCH), and standardized 3GPP channel models. We investigate several UE-side privacy mechanisms: optimized pilot distortion, artificial noise, artificial multipath, and delay spoofing. Through 3GPP-compliant sample-level simulations, we assess their impact via localization, communication, and consistency-based detection metrics. The resulting analysis highlights the trade-offs among privacy, communication reliability, and detectability, providing key insights into waveform-level obfuscation for future integrated sensing and communication (ISAC) systems.

0.26

Scalable BLE Channel Sounding Localization with Ranging-Assisted PDoA

eess.SP cs.NI ·2026-11-06 ·Jorg Wieme, Eli De Poorter, Jeroen Hoebeke
code/data similarity 0.64
Abstract · 14 pages, 5 figures, 7 tables, Appendix, For reproducibility code available at https://gitlab.ilabt.imec.be/iwine/ra-pdoa-simulator

Bluetooth Channel Sounding (CS) enables accurate phase-based ranging, but multi-anchor localization requires sequential ranging exchanges that limit scalability and increase measurement latency. This paper proposes Ranging-Assisted Phase Difference of Arrival (RA-PDoA), a scalable BLE localization architecture combining one active anchor performing a standard two-way CS exchange with multiple passive receive-only anchors observing the same transmissions. A channel-recovery framework is derived that enables passive anchors to reconstruct a channel response suitable for super-resolution delay estimation, allowing multipath-robust ranging without participating in a two-way exchange. Coarse arrival-time information is further used to bound the position estimate and reject inconsistent range solutions. A comprehensive evaluation characterizes the impact of multipath propagation, body shadowing, synchronization requirements, oscillator impairments, anchor placement, and deployment inaccuracies, thereby quantifying the practical infrastructure requirements for scalable BLE localization. Simulation results in modeled indoor environments show that RA-PDoA reduces the 90th-percentile localization error from 175.3 cm to 95.5 cm under body shadowing while maintaining an airtime requirement independent of the number of anchors. The results demonstrate that a single active ranging link enables scalable and multipath-robust BLE Channel Sounding localization.

0.30

Map-Free Single-Anchor Position Localization Using Multipath Uncertainty at Upper Mid-Band

eess.SP ·2026-09-08 ·Xingchen Liu, Mingjun Ying, Xinquan Wang, Dipankar Shakya, Homa Nikbakht +2 more
published similarity 0.64
Abstract · 6 pages, 5 figures. Accepted for presentation at the 2026 IEEE Global Communications Conference (GLOBECOM), Macao, China, December 2026

Future 5G-Advanced and 6G systems will exploit directional wideband channels for path-based localization, yet map-free indoor positioning remains challenging because extracted multipath components (MPCs) vary widely in localization reliability. This paper presents an uncertainty-aware map-free single-anchor localization framework using 16.95~GHz indoor directional channel measurements collected at NYU WIRELESS in Brooklyn, New York. Per-MPC angular covariance is estimated from the local consistency of neighboring pattern-de-embedded power delay profile (PDP) observations and propagated into geometric localization through weighted fusion of point-type and line-type constraints. Measurements across 20 links with TX--RX separations from 11~m to 97~m show that the proposed covariance-weighted method achieves a mean localization error of 3.86~m, a median of 2.66~m, and 70\% of links within 5~m using five retained MPCs. It outperforms the power-weighted and unweighted variants under identical point/line constraints, as well as the literature baselines. These results indicate that local directional consistency provides reliability information beyond received power alone and demonstrate a practical map-free approach for future indoor directional systems.

0.50

Evolution Toward Sensing-Enabled RAN: Practical Bistatic Sensing via Uplink

eess.SP ·2026-10-14 ·Kenan Turbic, Khanh-Toan Pham, Slawomir Stanczak
publishedcode/data similarity 0.63
Abstract · Accepted for presentation at IEEE ISAC 2026

This paper considers uplink channel state information (CSI)-based sensing as an opportunistic approach to enabling sensing in cellular networks, with minimum required modifications to the infrastructure. A practical sensing signal processing procedure is presented, combining 5G positioning function with multi-antenna array processing for passive target localization. The approach is validated through simulation and practical experiments with a software-defined radio-based setup, utilizing open-source software frameworks and commercially available hardware components. Results demonstrate feasibility of the uplink CSI-based sensing for detection, localization and tracking of moving targets over local areas.

0.47

mmWave UE Positioning Under Blockage: Limits for ISAC-Assisted Handover

cs.NI eess.SP ·2026-10-30 ·Seyed Bagher Hashemi Natanzi, Bo Tang
similarity 0.63
Abstract

Proactive handover can save a millimeter-wave (mmWave) link before a passing body blocks it, but only if the network knows where the user is. We ask whether the radio units that serve a user can localize it accurately enough from its uplink sounding reference signals. We derive position error bounds that include synchronization and array calibration errors, with and without reflected paths known from a digital twin, and test two estimators in a ray-traced street canyon on held-out scenarios. Three findings stand out. First, with line of sight to both radio units, array calibration, not bandwidth, limits the bound. Second, blockage degrades the line-of-sight-only bound sharply, whereas known reflections keep the map-aided bound low. Third, a simple dominant-path estimator fails where it matters most: its errors grow sharply around blockage, and proactive handover becomes worse than the 3GPP baseline. A map-aided multipath tracker cuts the median error from 12 to 3.7 cm and removes this significant penalty at link margins of 15 dB and above, but does not yet beat the baseline.

0.35

HF Single-Station Localization via Multimode Ray Tracing and Time-Frequency Information Fusion

eess.SP ·2026-10-09 ·Qinglin Li, Wen Liu, Yun Ning, Zhongxin Deng, Junkang He +2 more
similarity 0.61
Abstract · 12 pages, 4 figures, 7 tables

High-frequency (HF) single-station localization estimates an emitter location from measured directions of arrival (DOAs) and an ionospheric propagation model. When the propagation mode composition cannot be identified from conventional direction-finding (DF) measurements, the same DF observation may produce multiple physically valid ground landing points under different propagation modes, making the location inversion ambiguous. This paper proposes a multimode time-frequency information fusion localization method (MTFIF-L).Rather than assuming a propagation mode a priori, MTFIF-L retains valid landing points generated under different propagation modes and uses repeated observations across time windows and, when available, multiple operating frequencies to progressively constrain the resulting candidate locations. Experiments on four measured HF links examine the respective roles of multimode candidate retention, cross-window processing, and cross-frequency processing. All four links yield unique location decisions. Links A--C achieve relative errors of $1.40\%$, $0.78\%$, and $3.41\%$, respectively.Link D, the only single-frequency case, also yields a unique decision from repeated temporal observations, although its post- localization error is substantially larger. Propagation-path analysis further reveals link-dependent differences in reflection layer, hop count, magnetoionic mode, and elevation angle among the ray-tracing paths associated with the measured links.Overall, the results show that repeated temporal observations can support localization within an individual frequency, while multifrequency information provides additional robustness against unreliable frequency-specific outcomes, enabling HF single-station localization under unknown and potentially coexisting propagation modes while retaining interpretable propagation information for post-localization analysis.

0.26

Enhancing 5G NTN VSAT RACH in GNSS-Denied environments

eess.SP ·2026-09-24 ·Francesco Menzione, Alejandro Gonzalez-Garrido, Flavien Ronteix-Jacquet, Ottavio M. Picchi
published similarity 0.61
Abstract

The 3GPP 5G non-terrestrial networks (NTN) technology fundamentally relies on a global navigation satellite system (GNSS) fix at the user equipment (UE) to pre-compensate for user-link delay and Doppler shifts prior to any transmission, including the random-access procedure for initial access. In GNSS-denied or interfered environments, this dependency triggers preamble collisions and connection dropouts, undermining satellite-based global connectivity. To address this vulnerability, this paper introduces a novel single-satellite positioning framework designed for higher-frequency (Ku- or Ka-band) 5G NTN very small aperture terminals (VSATs) equipped with a phased-array antenna. The multi-step scheme derives an initial coarse position from angle of arrival (AoA) observables, extracts frequency of arrival (FoA) and time of arrival (ToA) measurements from low Earth orbit (LEO) downlink reference signals, and hybridizes them within a Levenberg-Marquardt navigation filter. Systematic evaluations across static grids and realistic dynamic urban trajectories detail the incremental gains of transitioning from single-epoch AoA error minimization to multi-epoch angular tracking, followed by the integration of Doppler and ranging observables. Grounded in a realistic error budget, the proposed framework reduces initial positioning uncertainty from tens of kilometres down to a few kilometres. This level of positioning accuracy, combined with the GNSS-resilient features introduced in 3GPP Release 20 NR NTN specifications, enables robust initial access in compromised operational environments with minimal relaxation of 3GPP standards.

0.32

A Ray-Traced Digital Twin for 5G NR Positioning with OpenAirInterface

cs.IT ·2026-10-09 ·Nima Chaharbaghi, Florian Kaltenberger, Bartosz Podrygajlo, Rakesh Mundlamuri, Roberto Verdone
similarity 0.59
Abstract · submitted at 22nd Wireless On-demand Network systems and Services Conference

Evaluating 5G positioning on a physical testbed ties every measurement to one propagation environment and one antenna layout, so any question about an alternative deployment requires a new field campaign. We present a ray-traced digital twin of the GEO-5G testbed at EURECOM that drives an unmodified OpenAirInterface (OAI) 5G stack with per-antenna channels computed by Sionna-RT over a 3D model of the site. The distributed gNB antennas are modelled as independent radio devices rather than as elements of a compact array, which preserves the per-antenna absolute delays on which time-difference-of-arrival (TDoA) positioning depends. With them preserved, the twin drives OAI's SRS-based UL-TDoA pipeline to metre-level accuracy consistent with that reported for the physical deployment. We then use the twin to answer a question the physical testbed cannot. Widening the carrier truncates the tail of the horizontal error distribution without improving a typical position, and leaves the vertical error untouched, because the latter is limited by the array geometry rather than by the measurement. That limit is predictable from the antenna coordinates alone, and a height-diverse layout reduces the RMS height error by a factor of four.

0.20