CS Paper Radar

Stability-aware Residual Reinforcement Learning Framework for Robotic Manipulator Disturbance Compensation

Jihong Kim, Joonhyuk Kwon, Hwa Soo Kim, TaeWon Seo, Hyung-Tae Seo

cs.RO ·submitted 2026-09-18 04:35 UTC · v1

Abstract

Although conventional controllers and disturbance observers (DOBs) are the standard for precision tracking in manipulators, they suffer from parameter uncertainty, nonlinear friction, and compound disturbances. This study proposes a residual reinforcement learning DOB framework that pairs an analytical observer with an RL policy. The deterministic baseline operates within a reliable region, whereas the RL policy explicitly targets the residuals that the model cannot capture. To make this compensation disturbance-aware, an estimator network aligns the observation history with a privileged disturbance context, organizing the latent space by disturbance regime and enabling rapid adaptation across disturbance transitions. To guarantee stability, we derived and enforced a state-dependent action bound on the RL policy from an input-to-state stability (ISS) analysis such that the closed loop provably confines the tracking error to a certified envelope for arbitrary policy outputs. Experiments on a 6-DOF manipulator demonstrated consistent improvements in disturbance estimation and tracking, including a 27.8% tracking-error reduction on real hardware under zero-shot sim-to-real transfer and a 38.0% reduction under a base-vibration disturbance that was not observed during training.

Comment
14 pages, 9 figures

Closest papers

Nearest neighbours by meaning across the whole index.

Residual Deep Reinforcement Learning-Based Computed Torque Control for a Cable-Driven Lower-Limb Rehabilitation Robot under Disturbances and Parametric Uncertainties

cs.RO eess.SY ·2026-08-27 ·Mohammad-Hossein Fakouri, Ali Keymasi-Khalaji
similarity 0.70
Abstract · 32 pages, 24 figures, 13 tables. Preprint

Accurate trajectory tracking in cable-driven lower-limb rehabilitation robots is challenging because model uncertainty, external disturbances, joint constraints, and pull-only cable actuation can degrade nominal control performance. Conventional model-based controllers provide an interpretable control structure but remain sensitive to model mismatch, whereas fully learning-based control can reduce transparency and complicate constraint-aware operation. This study proposes a residual deep reinforcement learning-enhanced computed torque control framework in which computed torque control generates the nominal command and a bounded Deep Deterministic Policy Gradient policy supplies only an additional compensating torque. The approach is evaluated in simulation under nominal, uncertain, disturbed, combined, and generalization conditions, together with trajectory-tracking, joint-limit, cable-demand, workspace-feasibility, and cable-Jacobian diagnostics. Across the evaluated conditions, the residual controller improves tracking and disturbance rejection relative to computed torque control while preserving the interpretable model-based command structure and satisfying the reported feasibility checks in the representative evaluation. Broader tests indicate that tracking improvements can persist beyond the representative case while also exposing trajectory-dependent constraint limitations. These results support bounded residual learning as a practical robustness-enhancement strategy for simulation-based rehabilitation robot control and motivate further constraint-aware and experimental validation.

0.14

Reinforced Iterative Learning Control for elastic joint arms: Guaranteed cross-trajectory generalization under model uncertainties

cs.RO ·2026-10-20 ·Yuri De Santis, Michele Pierallini, Franco Angelini, Manolo Garabini
published similarity 0.69
Abstract · Accepted for publication in Control Engineering Practice, 2026. 16 pages, 10 figures

Trajectory tracking for compliant robots is challenging due to nonlinear dynamics and modeling uncertainties, often requiring learning-based methods to avoid explicit parameter identification. Iterative Learning Control (ILC) ensures theoretically high precision and preserves the passive compliance of the robot. However, traditional ILC requires a separate learning phase for each new trajectory. Conversely, Reinforcement Learning (RL) generalizes to new trajectories, but practically suffers from high sample complexity and limited tracking precision. This work proposes Reinforced Iterative Learning Control (RILC) that combines the strengths of both approaches to achieve fast adaptation and guaranteed tracking convergence across diverse trajectories. By establishing a concurrent coupling between the two controllers, RILC overcomes the high initial errors and slow adaptation of traditional ILC, enabling high-performance tracking from the very first trials. In this architecture, ILC provides high-quality samples, while RL contributes as a generalizing best-effort policy across iterations. Additionally, a theoretical proof is presented to show that the RL component preserves ILC stability and, under specific conditions, can also reduce the error bound asymptotically. The efficacy of this framework is demonstrated through simulation and experiments on an underactuated 4-degree-of-freedom serial elastic robot using different trajectories and modeling mismatches.

0.39

Residual Reinforcement Learning for Visual Servo Control with Zero-Shot Sim-to-Real Transfer

cs.RO eess.SY ·2026-11-14 ·Mahdi Nobar, Alisa Rupenyan, John Lygeros, Jürg Keller
similarity 0.69
Abstract · This manuscript is currently under review in IEEE Robotics and Automation Letters (RA-L)

We address tracking a moving object on a conveyor with a Franka Emika Panda robot arm, despite an imprecise digital twin, measurement errors, and noise. Our novel approach augments a loop-shaped inverse-Jacobian PI controller with a residual policy learned via Soft Actor-Critic in the digital twin. A delay-compensated Kalman filter fuses out-of-sequence camera measurements to provide latency-aware moving target position estimates. We compare the achieved performance to a performance bound for a class of model-based controllers derived from a frequency-domain sensitivity analysis, quantifying the minimum achievable error imposed by uncertain kinematic model mismatch. Simulation and hardware experiments indicate that our residual policy drives tracking error below the bound. Across conveyor speeds (27.9-41.8 mm/s), our method reduces mean tracking errors from 1.1-1.4 mm (baseline inverse-Jacobian PI) to 0.3-0.7 mm. These results show that learning residual corrections in a limited-fidelity simulator, combined with delay compensation, can substantially improve model-based control under modeling and measurement uncertainties while maintaining reliable sim-to-real transfer.

0.23

Learning Accurate End-Effector Trajectory Tracking with Inertial Feedback for a Quadruped Manipulator

cs.RO ·2026-11-17 ·Dohyeon Kim, Seungyong Han, Yeongtae Jung
similarity 0.67
Abstract

Accurate end-effector trajectory tracking on quadruped manipulators is challenging because uncertainties in actuators, foot-ground contact, and geometric errors are propagated through the leg-arm kinematic chain. Detecting such errors requires sensing beyond joint encoders that can capture the effects of these uncertainties on the robot's motion, since joint encoders only provide measurements at the actuated joints and cannot fully observe mechanical errors such as backlash, dimensional inaccuracies, or structural deformation. This work addresses these challenges using a reinforcement learning framework with end-effector (EE) inertial feedback, targeting local high-accuracy manipulation while maintaining a nominal body pose and support configuration without intentional body motion or foot repositioning. The learned policy uses EE inertial measurements to compensate for tracking errors induced by uncertainties throughout the leg-arm system that cannot be fully inferred from proprioception alone. Simulation and real-world experiments on continuous EE trajectory tracking show overall improvements relative to nominal and proprioception-only baselines. In real-world experiments, the proposed policy reduces the MoCap-based RMSE by 17.3% and 28.0% relative to the nominal baseline under the two in-distribution (ID) command conditions, respectively, and by an additional 12.6% and 15.9% relative to the proprioception-only baseline. Furthermore, the trajectory-wise RMSE between FK-reconstructed and motion-capture-measured end-effector positions averaged 12.61+-2.15mm (mean+-standard deviation) across 24 controller-trajectory combinations, revealing a substantial discrepancy between nominal kinematic reconstruction and measured end-effector motion.

0.18

Tackling Sim-to-Real Mismatch Through Sampling-Based Disturbance Observers: From Analytical Models to Learned World Models

cs.RO eess.SY ·2026-10-04 ·Tianqi Zhu, Jun Yang, Jianliang Mao, Cong Li, Shihua Li
similarity 0.67
Abstract · 15 pages, 14 figures, 7 tables. Project website: https://sampling-based-dob.github.io/

Robotic controllers increasingly rely on analytical models, simulators, cost-query interfaces, and learned world models. However, physical deployment can deviate from nominal assumptions, and additional disturbances may arise even when the model itself is accurate. In control systems, disturbance observers (DOB) are widely used to estimate such unmeasured effects from nominal models and measured feedback. Classical DOB formulations are generally built around explicit plant models. This paper develops the sampling-based disturbance observer (SDOB), extending the DOB principle to a broader range of models, including simulators and learned world models, through state-rollout or cost-query interfaces. SDOB separates two observable channels: state-effect disturbances, for which the feedback state differs from its prediction, and cost disturbances, for which the same query state receives different costs as the perceived environment changes. Diverse simulation and real-robot experiments across traditional and learned models demonstrate the effectiveness of SDOB in compensating for sim-to-real mismatch and improving control performance.

0.30

PolicyIK: High-Precision Inverse Kinematics for Robot Arms with Reinforcement Learning

cs.RO cs.LG ·2026-11-03 ·Yuhan Liu, Xinqi Liu, Zixuan Dong, Keith W. Ross, Shenji Wan
code/data similarity 0.67
Abstract

Inverse kinematics (IK) converts end-effector pose commands into joint motion, and many vision-language-action (VLA) policies rely on it to act on a given arm and to transfer across embodiments. Precise IK remains laborious: redundancy and singularities complicate the inverse mapping, execution depends on hand-tuned controllers, and training data on physical robots are costly to collect. We present PolicyIK, a goal-conditioned reinforcement learning policy for high-precision IK. It updates joint-position references from pose feedback and observes its accumulated reference relative to the measured joints, so it can retain the offset that the position controller needs at rest. Two-scale pose errors with an error-dependent action gain resolve millimeter residuals while preserving large motions. Progress and dwell rewards teach it to both reach the tolerance and stay within it. In simulation, a single attempt by the trained PPO policy keeps the mean errors over the final second within 1 mm and 0.2° on 93.5% of held-out tasks, and a deployment protocol raises success to 98.9%. When trained directly on a physical arm with an off-policy RL learner, PolicyIK achieves higher reaching and holding success than all four classical IK controllers under the same time budgets. In simulated pick-and-place, PolicyIK executes the end-effector commands of the $π_{0.5}$ VLA policy with 95.7% success. These results show that reinforcement learning can provide high-precision inverse kinematics for robot arms. Code is available at https://github.com/Tinaliu0123/PolicyIK.

0.24

Differentiable Iterative Learning Control for Black-Box Position-Commanded Manipulators

cs.RO eess.SY ·2026-10-31 ·Mohammed Al-Ghaili, Yakoop Qasim, Hassan Almubarak
similarity 0.66
Abstract

High-accuracy repetitive tracking is challenging for position-commanded manipulators whose low-level controllers are inaccessible, while constrained model-based iterative learning control (ILC) can require substantial manual parameter tuning. We present Differentiable Iterative Learning Control (Diff-ILC), an online bilevel framework that adapts the parameters of a constrained ILC update between physical robot executions. A closed-loop differential model is identified once from paired smooth perturbations and subsequently kept fixed. At each trial, a constrained quadratic program computes a feasible command correction, while a real-anchored next-trial prediction defines a task-level objective. Hypergradients are obtained by implicitly differentiating the locally active KKT system, enabling multiple computational parameter updates without additional robot executions. Experiments on a 6-DoF DOBOT CR3 across unseen planar and three-dimensional trajectories show substantially faster physical-trial convergence than fixed-parameter model-based ILC. Across the four primary trajectories, after only two trial-to-trial updates, Diff-ILC achieves 78.8% and 76.4% lower mean joint-vector and Cartesian RMSE, respectively, than fixed-parameter model-based ILC.

0.19

ORPA: Online Residual Policy Adaptation for Robot Manipulation Control with Human Feedback

cs.RO cs.AI ·2026-08-18 ·Muhammad A. Muttaqien, Tomohiro Motoda, Ryo Hanai, Yukiyasu Domae
similarity 0.65
Abstract

Robotic manipulation policies trained via imitation learning, such as Action Chunking with Transformers (ACT), can achieve strong performance under ideal conditions but often remain sensitive to small execution errors and distribution shifts. Correcting these failures typically requires dataset aggregation and full-policy retraining, which is computationally expensive and unsuitable for real-time deployment. In this work, we propose Online Residual Policy Adaptation (ORPA), a framework that enables immediate, feedback-driven correction of robot actions without modifying the underlying policy parameters. ORPA augments a pretrained control policy with a lightweight, feedback-conditioned module that predicts residual adjustments directly in joint space, allowing the system to adapt its behavior at runtime. We evaluate ORPA on a set of precision-sensitive manipulation tasks using the ALOHA platform, demonstrating improvements in success rate and recovery from small perturbations compared to baseline control policies and rule-based inverse kinematics corrections.

0.36