CS Paper Radar

Residual Reinforcement Learning for Visual Servo Control with Zero-Shot Sim-to-Real Transfer

Mahdi Nobar, Alisa Rupenyan, John Lygeros, Jürg Keller

cs.RO eess.SY ·submitted 2026-11-14 10:25 UTC · v1

Abstract

We address tracking a moving object on a conveyor with a Franka Emika Panda robot arm, despite an imprecise digital twin, measurement errors, and noise. Our novel approach augments a loop-shaped inverse-Jacobian PI controller with a residual policy learned via Soft Actor-Critic in the digital twin. A delay-compensated Kalman filter fuses out-of-sequence camera measurements to provide latency-aware moving target position estimates. We compare the achieved performance to a performance bound for a class of model-based controllers derived from a frequency-domain sensitivity analysis, quantifying the minimum achievable error imposed by uncertain kinematic model mismatch. Simulation and hardware experiments indicate that our residual policy drives tracking error below the bound. Across conveyor speeds (27.9-41.8 mm/s), our method reduces mean tracking errors from 1.1-1.4 mm (baseline inverse-Jacobian PI) to 0.3-0.7 mm. These results show that learning residual corrections in a limited-fidelity simulator, combined with delay compensation, can substantially improve model-based control under modeling and measurement uncertainties while maintaining reliable sim-to-real transfer.

Comment
This manuscript is currently under review in IEEE Robotics and Automation Letters (RA-L)

Closest papers

Nearest neighbours by meaning across the whole index.

PolicyIK: High-Precision Inverse Kinematics for Robot Arms with Reinforcement Learning

cs.RO cs.LG ·2026-11-03 ·Yuhan Liu, Xinqi Liu, Zixuan Dong, Keith W. Ross, Shenji Wan
code/data similarity 0.69
Abstract

Inverse kinematics (IK) converts end-effector pose commands into joint motion, and many vision-language-action (VLA) policies rely on it to act on a given arm and to transfer across embodiments. Precise IK remains laborious: redundancy and singularities complicate the inverse mapping, execution depends on hand-tuned controllers, and training data on physical robots are costly to collect. We present PolicyIK, a goal-conditioned reinforcement learning policy for high-precision IK. It updates joint-position references from pose feedback and observes its accumulated reference relative to the measured joints, so it can retain the offset that the position controller needs at rest. Two-scale pose errors with an error-dependent action gain resolve millimeter residuals while preserving large motions. Progress and dwell rewards teach it to both reach the tolerance and stay within it. In simulation, a single attempt by the trained PPO policy keeps the mean errors over the final second within 1 mm and 0.2° on 93.5% of held-out tasks, and a deployment protocol raises success to 98.9%. When trained directly on a physical arm with an off-policy RL learner, PolicyIK achieves higher reaching and holding success than all four classical IK controllers under the same time budgets. In simulated pick-and-place, PolicyIK executes the end-effector commands of the $π_{0.5}$ VLA policy with 95.7% success. These results show that reinforcement learning can provide high-precision inverse kinematics for robot arms. Code is available at https://github.com/Tinaliu0123/PolicyIK.

0.24

Stability-aware Residual Reinforcement Learning Framework for Robotic Manipulator Disturbance Compensation

cs.RO ·2026-09-18 ·Jihong Kim, Joonhyuk Kwon, Hwa Soo Kim, TaeWon Seo, Hyung-Tae Seo
similarity 0.69
Abstract · 14 pages, 9 figures

Although conventional controllers and disturbance observers (DOBs) are the standard for precision tracking in manipulators, they suffer from parameter uncertainty, nonlinear friction, and compound disturbances. This study proposes a residual reinforcement learning DOB framework that pairs an analytical observer with an RL policy. The deterministic baseline operates within a reliable region, whereas the RL policy explicitly targets the residuals that the model cannot capture. To make this compensation disturbance-aware, an estimator network aligns the observation history with a privileged disturbance context, organizing the latent space by disturbance regime and enabling rapid adaptation across disturbance transitions. To guarantee stability, we derived and enforced a state-dependent action bound on the RL policy from an input-to-state stability (ISS) analysis such that the closed loop provably confines the tracking error to a certified envelope for arbitrary policy outputs. Experiments on a 6-DOF manipulator demonstrated consistent improvements in disturbance estimation and tracking, including a 27.8% tracking-error reduction on real hardware under zero-shot sim-to-real transfer and a 38.0% reduction under a base-vibration disturbance that was not observed during training.

0.45

Differentiable Iterative Learning Control for Black-Box Position-Commanded Manipulators

cs.RO eess.SY ·2026-10-31 ·Mohammed Al-Ghaili, Yakoop Qasim, Hassan Almubarak
similarity 0.63
Abstract

High-accuracy repetitive tracking is challenging for position-commanded manipulators whose low-level controllers are inaccessible, while constrained model-based iterative learning control (ILC) can require substantial manual parameter tuning. We present Differentiable Iterative Learning Control (Diff-ILC), an online bilevel framework that adapts the parameters of a constrained ILC update between physical robot executions. A closed-loop differential model is identified once from paired smooth perturbations and subsequently kept fixed. At each trial, a constrained quadratic program computes a feasible command correction, while a real-anchored next-trial prediction defines a task-level objective. Hypergradients are obtained by implicitly differentiating the locally active KKT system, enabling multiple computational parameter updates without additional robot executions. Experiments on a 6-DoF DOBOT CR3 across unseen planar and three-dimensional trajectories show substantially faster physical-trial convergence than fixed-parameter model-based ILC. Across the four primary trajectories, after only two trial-to-trial updates, Diff-ILC achieves 78.8% and 76.4% lower mean joint-vector and Cartesian RMSE, respectively, than fixed-parameter model-based ILC.

0.19

ORPA: Online Residual Policy Adaptation for Robot Manipulation Control with Human Feedback

cs.RO cs.AI ·2026-08-18 ·Muhammad A. Muttaqien, Tomohiro Motoda, Ryo Hanai, Yukiyasu Domae
similarity 0.63
Abstract

Robotic manipulation policies trained via imitation learning, such as Action Chunking with Transformers (ACT), can achieve strong performance under ideal conditions but often remain sensitive to small execution errors and distribution shifts. Correcting these failures typically requires dataset aggregation and full-policy retraining, which is computationally expensive and unsuitable for real-time deployment. In this work, we propose Online Residual Policy Adaptation (ORPA), a framework that enables immediate, feedback-driven correction of robot actions without modifying the underlying policy parameters. ORPA augments a pretrained control policy with a lightweight, feedback-conditioned module that predicts residual adjustments directly in joint space, allowing the system to adapt its behavior at runtime. We evaluate ORPA on a set of precision-sensitive manipulation tasks using the ALOHA platform, demonstrating improvements in success rate and recovery from small perturbations compared to baseline control policies and rule-based inverse kinematics corrections.

0.36

Residual Compliant Policy: Learning Compliant Policies from Few Demonstrations

cs.RO ·2026-10-01 ·Chunyu Jiang, Yichen Cai, Shuai Li, Wenbin Sun, João Carvalho +4 more
similarity 0.63
Abstract · 9 pages, 6 figures. Project website: https://residual-compliant-policy.github.io

Contact-rich manipulation requires a robot to be precise in free space to establish the intended contacts, and compliant once in contact to avoid excessive forces. Imitation learning has proven effective for simpler manipulation tasks, but the compliance underlying a demonstration is not directly observable and is therefore difficult to infer from demonstration data alone. We present a framework that makes compliance explicit at every stage. During data collection, the operator teleoperates the real robot while a synchronized digital twin visualizes the error between the commanded reference and the achieved pose, making the current compliance visible, and selects between two discrete compliance modes. To generalize across object poses, we combine Laplacian editing, which retargets trajectories efficiently but is not physics-consistent during contact, with simulation-based trajectory optimization, which enforces physical plausibility but offers no manual guidance. Finally, a residual reinforcement learning policy refines the interaction forces by adjusting the reference pose of the underlying admittance controller. We evaluate on three flipping and pushing tasks on a Franka FR3 based on a total of 7 demonstrations across tasks. Our method is successful on all 40 out-of-distribution trials, compared to 33/40 and 24/40 for two baselines, with our base policy alone reaching 35/40.

0.27

Reinforced Iterative Learning Control for elastic joint arms: Guaranteed cross-trajectory generalization under model uncertainties

cs.RO ·2026-10-20 ·Yuri De Santis, Michele Pierallini, Franco Angelini, Manolo Garabini
published similarity 0.62
Abstract · Accepted for publication in Control Engineering Practice, 2026. 16 pages, 10 figures

Trajectory tracking for compliant robots is challenging due to nonlinear dynamics and modeling uncertainties, often requiring learning-based methods to avoid explicit parameter identification. Iterative Learning Control (ILC) ensures theoretically high precision and preserves the passive compliance of the robot. However, traditional ILC requires a separate learning phase for each new trajectory. Conversely, Reinforcement Learning (RL) generalizes to new trajectories, but practically suffers from high sample complexity and limited tracking precision. This work proposes Reinforced Iterative Learning Control (RILC) that combines the strengths of both approaches to achieve fast adaptation and guaranteed tracking convergence across diverse trajectories. By establishing a concurrent coupling between the two controllers, RILC overcomes the high initial errors and slow adaptation of traditional ILC, enabling high-performance tracking from the very first trials. In this architecture, ILC provides high-quality samples, while RL contributes as a generalizing best-effort policy across iterations. Additionally, a theoretical proof is presented to show that the RL component preserves ILC stability and, under specific conditions, can also reduce the error bound asymptotically. The efficacy of this framework is demonstrated through simulation and experiments on an underactuated 4-degree-of-freedom serial elastic robot using different trajectories and modeling mismatches.

0.39

An Empirical Study of Reinforcement Learning for Keypoint Positioning of Deformable Linear Objects

cs.RO ·2026-11-05 ·Vinay Rodrigues, Sara Zeynalpour, Gokhan Solak, Sebastian Hjorth, Arash Ajoudani
similarity 0.62
Abstract

Deformable linear object (DLO) manipulation is challenging because high-dimensional configurations, nonlinear contact dynamics, and diverse material and geometric properties produce a broad range of object responses that are both difficult to model and data-intensive to learn. This work studies reinforcement learning for planar manipulation of a one-end-grasped DLO, focusing on training efficiency, observation design, robustness, and zero-shot sim-to-real transfer. We compare three Proximal Policy Optimization training stacks and find that the GPU-parallel MuJoCo Playground stack enables faster convergence and more consistent performance than CPU-based alternatives under the same wall-clock budget. Relative keypoint observations and an asymmetric actor-critic formulation further improve learning efficiency. Policies trained with observation noise, delay, domain randomization, and disturbances achieve simulation success rates of 96.4% for single-point tracking, 98.0% for disturbance recovery, and 88.8% for two-point tracking. Using markerless RGB-D keypoint estimation, the policies transfer without real-world fine-tuning, succeeding in 9/10, 10/10, and 8/10 physical trials, respectively.

0.09

OATH: Object-Agnostic Tracking for Dexterous Hands, Enabling Rapid Physics-based Retargeting

cs.RO ·2026-10-09 ·Solvin Sigurdson, Prasanna Sriganesh, Juan Borbon, Joel Burdick, Dingqi Zhang +1 more
code/data similarity 0.62
Abstract · 8 pages, 7 figures, 3 tables. Project page: https://multiplylabs.github.io/oath/

Retargeting human demonstrations into dynamically feasible dexterous hand trajectories requires resolving complex contact physics, yet current methods either omit physical constraints or rely on computationally expensive sampling-based optimization in simulation. Reinforcement learning has previously been used to achieve planning and control through contact dynamics; however, standard policies require object-specific training and fail to generalize across arbitrary geometries. This work reframes physics-based retargeting as a residual learning problem, where we demonstrate that zero-shot generalization across objects relies on structured state representations. Specifically, formulating the observation space to include a localized contact-error signal guiding each robot link to its target coordinate on the object surface enables a single, unified residual policy to successfully grasp novel, unseen object geometries. Rolling out this policy in simulation on a kinematic reference trajectory yields a physics-based retargeter, OATH. Operating at 0.4 seconds of compute per second of reference, OATH achieves 2.4x faster-than-real-time performance and a 60-350x reduction in computational cost compared to sampling-based methods. The system recovers 58% of held-out and 54% of unseen-object DexYCB trajectories while maintaining a sub-2 cm tracking error.

0.29