CS Paper Radar

Analysis and Design of Desaturation Short-Circuit Protection for SiC MOSFET Under High Switching Voltage Transients

Ravi Teja Pogulaguntla, Arun Karuppaswamy B

eess.SY ·submitted 2026-09-19 13:03 UTC · v1

Abstract

Short-circuit protection is vital for ensuring the safe operation of high-power-density power converters using Silicon Carbide (SiC) MOSFETs. However, adapting conventional desaturation (DESAT) protection, originally designed for Silicon (Si) IGBTs, is challenging due to the significantly shorter shortcircuit withstand time of SiC devices, typically less than 3μs. Nevertheless, DESAT protection can be adapted for SiC MOSFETs through certain circuit modifications. This article provides a comprehensive analysis and design guidelines for the three architectural variants of DESAT protection circuits, specifically for adjusting the short-circuit detection time suitable for SiC MOSFETs. Further, this article establishes a quantitative framework to evaluate the noise induced into the DESAT protection circuits during turn-off dv/dt switching transients. From this analysis, a design methodology and safe operating boundary are derived for each DESAT configuration, guiding the systematic selection of component values to balance dv/dt noise margin and short-circuit detection speed for SiC MOSFETs. Experimental results are presented to validate the analysis.

Closest papers

Nearest neighbours by meaning across the whole index.

A Discrete Digital Isolator with Shielded Planar Transformer for Gate Driver Applications

eess.SY ·2026-11-17 ·Thomas A. Conway
similarity 0.54
Abstract · 5 pages, 11 figures

Galvanically isolated gate drivers are required in many power electronics applications. This paper describes an implementation of a digital isolator using discrete components with a planar coreless PCB signal transformer providing the isolation. The use of an electrostatic shield between the transformer windings is shown to provide sufficient common-mode transient immunity to support IGBT half-bridge drivers, an application subject to a severe dV/dt transient during switching. The design is verified through the experimental implementation of a prototype half bridge using two of the proposed discrete digital isolators with SiC power transistors and demonstrates common-mode transient immunity greater than 15 kV/us with very low implementation complexity.

0.30

Design of a Fast Crowbar Protection Circuit for Single Event Effect Testing

eess.SY ·2026-08-27 ·Collin Burt, Joseph D'Amico, Joseph Van Grinsven, Tommy Aldaz, Nathaniel Dodds
similarity 0.50
Abstract · 5 pages. 11 figures. Submitted to the IEEE NSREC2026 Conference

We describe the design of a custom crowbar circuit that quickly removes power when a programmable current threshold is exceeded. This protects devices from permanent damage during single event latchup/burnout tests.

0.28

Short-Circuit Current Calculation in DC Shipboard Microgrid Using Operational Admittances

eess.SY ·2026-10-30 ·Pietro Cepollini, Fabio D'Agostino, Federico Silvestro, Antonio Chiarelli
published similarity 0.48
Abstract · Accepted and presented at ESARS-ITEC 2026. Copyright 2026 IEEE. Personal use of this material is permitted. Permission from IEEE must be obt…

The increasing adoption of DC shipboard power systems is driven by the need to integrate energy storage systems seamlessly onboard. In this context, accurate calculation of short-circuit current transients is critical for sizing fast-acting protection devices. This paper proposes a methodology to calculate short-circuit current transients based on operational admittance modelling of network elements and power converters. The superposition principle is then applied to calculate current contributions and voltage time profiles. The methodology is validated with a detailed EMT model of a notional LVDC shipboard microgrid section consisting of an active front end, a bidirectional buck-boost converter and two special loads. Results demonstrate that the methodology accurately tracks nodal voltages and the fault current contributions dynamics up to the prospective fault current peak, thus providing a computationally efficient tool for fault analysis and protection coordination in LVDC microgrids.

0.38

Protection challenges and solutions on power systems towards 100% inverter-based resources and energy storage systems

eess.SY ·2026-11-02 ·Alexander Novikov, Luis A. Garcia-Reyes, Anup Joshi, Ahmar Farooque, Junaid Khalid +1 more
published similarity 0.45
Abstract · Danmarks Tekniske Universitetet, Katholieke Universiteit Leuven, Department of Electrical Engineering, Electrical Energy Computer Architectu…

The decarbonization of the energy sector, driven by the Paris Agreement and the European Green Deal, is increasing the share of renewable energy sources (RES) in power systems. Unlike traditional systems, RES-based systems rely on power electronic converters, which creates unprecedented challenges for reliability and resilience. The future power system is expected to combine a low-level AC layer with an upper-level High Voltage Direct Current (HVDC) backbone, which requires new understanding of fault protection, stability, and interaction between AC and DC components, as well as new models and simulation tools. This is especially critical in systems moving towards 100 percent converter-based generation. Protection systems detect, locate, and isolate faults to protect assets while the rest of the system keeps operating. Traditionally, they rely on the large fault currents supplied by synchronous machines. In modern systems, converter controls limit the fault current contribution to about 120 percent of rated current, so relays that distinguish faults from normal overcurrents based on current level may operate incorrectly. In addition, inverter-based resources (IBR) may not inject enough negative and zero sequence current for directional relays to work properly, and converters hold the voltage at a fixed value only within their reach, beyond which it drops quickly. As a result, existing protection schemes may not provide the expected accuracy and reliability. This report reviews the protection challenges identified in recent academic literature for power systems with high shares of converter-based resources. It covers the specific characteristics of RES, the challenges for protection with intelligent electronic devices (IED), the challenges of converter control during faults, and the main solutions proposed in research over the last decade.

0.49

Enabling Ultra-Low-Power Always-On Feedforward Leakage Suppression Logic Circuits with FDSOI

cs.ET ·2026-08-13 ·Clément Choné, Leslie Xu, Filippo Quadri, Pasquale Davide Schiavone, Alexandre Levisse +3 more
similarity 0.44
Abstract

The growing deployment of real-time applications on wearable and Internet of Things (IoT) edge devices has intensified the need for energy-efficient, high-performance systems that meet stringent timing and energy constraints. Events-driven architectures leverage the sparsity of real-time to further improve system energy efficiency by employing an always-on (AO) domain to monitor inputs and activate a high-performance (HP) domain only when relevant events occur. However, for low-duty-cycle applications, the energy bottleneck shifts toward the AO domain, where leakage power dominates overall consumption. To mitigate this issue, AO circuits are typically implemented using high voltage threshold (HVT) or ultra-high voltage threshold (UHVT) transistors, thereby avoiding sub- and near-threshold operation, which is highly sensitive to process, voltage, and temperature (PVT) variations. In this context, feedforward leakage suppression logic (FLSL) has recently emerged as a promising candidate, offering reduced leakage compared to conventional. However, previous studies report a significant degradation in FLSL leakage performance in technology nodes below 90 nm, primarily due to increased gate and junction leakage currents. FDSOI technology, with its ability to effectively suppress junction leakage, provides an opportunity to overcome this limitation and restore FLSL efficiency in advanced nodes. Therefore, we demonstrate in this work that FLSL implemented in a 22 nm FDSOI technology can significantly reduce the energy consumption of small AO circuits with low-frequency inputs compared to state-of-the-art ultra-low-power CMOS designs. Silicon measurements on an FIR filter and an AES cryptographic core show reduced operating voltage and up to 9.8 x and 1.83 x reductions in leakage power compared to equivalent HVT and UHVT CMOS implementations, respectively.

0.04

Current-Limiting Control for Fault Ride-Through of LLC-based Solid-State Transformer in Data Centers

eess.SY ·2026-08-27 ·Haoyu Wang, Chi Zhang, Mafu Zhang, Rudy Wang, Peter Barbosa
similarity 0.43
Abstract · Added IEEE submission notice

Solid-State Transformers (SSTs) are increasingly proposed as the interface between distribution grids and data centers due to flexible power flows and fast dynamic response. However, when a short-circuit fault occurs in a load branch, the SST with a voltage-source-type DC-DC stage is forced to shut down due to fault currents. Therefore, current-limiting strategies are strongly needed to prevent catastrophic equipment damage and cascading blackouts by instantly restricting massive current spikes and offering sufficient currents for protection devices to act at the faulted branch. This paper proposes a coordinated DC load fault-tolerant current-limiting and recovery strategy embedded directly in the control of the SST DC-DC stage, avoiding additional hardware cost. Specifically, the fault mechanism of an example LLC resonant converter is studied. Accordingly, a fault detection framework is implemented, a closed-loop current controller is proposed to limit the DC current to a designated value within microseconds by surging the switching frequency and adjusting the duty cycle, and a ramped recovery stage will then restore the DC bus after the fault isolation without inrush currents. Experiments on an LLC converter prototype have verified the feasibility of the proposed current-limiting strategy, enabling faster and lower-cost fault response suitable for resilient data center power architectures.

0.26

Parameter Estimation of Power Electronic Converters with Differentiable Physics Simulation

eess.SY ·2026-08-31 ·Pingjunjin Tan, Chunlin Lv, Jinjun Liu, Yang Li
similarity 0.40
Abstract

This article proposes a differentiable physics simulation (DP simulation)-based parameter estimation method for the condition monitoring of power electronic converters. In the proposed method, the time-domain simulation of converter dynamics is embedded into a differentiable computational graph, directly linking device parameters to observed voltage and current trajectories. By formulating differentiable time-stepping operators, the nonlinear dynamics of the converter across different circuit topologies are simulated in a unified, differentiable manner. A dc-dc buck converter is used as a representative case study. Using sparse transient samples from existing sensing channels, the method enables noninvasive parameter estimation without additional sensing hardware. Comprehensive simulation studies are conducted to evaluate the impacts of time-stepping schemes, regularization constraints, and various uncertainty sources on estimation accuracy and robustness. Subsequently, 30 distinct hardware configurations are experimentally tested for validation. The results show that the proposed method can effectively track the relative variations of health-related parameters across the critical components. This DP simulation framework provides a novel perspective for physics-informed machine learning in power electronic applications.

0.32

Asymmetric Transistor Aging Under Thermal Gradients

eess.SY ·2026-11-18 ·Alex Grinshpun, Firas Ramadan, Freddy Gabbay
published similarity 0.40
Abstract · Accepted for publication at ICSEE 2026

Advanced technology nodes improve performance but increase susceptibility to BTI-induced aging. Using aging- aware circuit simulations, we show that realistic on-chip thermal gradients can cause significant asymmetric transistor degradation in 16 nm FinFET circuits, leading to setup and hold time violations. These results highlight the necessity of incorporating thermal-gradient-aware aging analysis into timing signoff to ensure chip reliability.

0.32