CS Paper Radar

Model-Free Current Control of Permanent Magnet Synchronous Motors via ESO-Based Disturbance Feedforward and Data-Driven H-infinity Residual Feedback

YongBo Li, Shuang Liang, HongWei Ma

eess.SY ·submitted 2026-09-22 06:53 UTC · v1

Abstract

This paper proposes a model-free current control method for permanent magnet synchronous motors (PMSMs) based on disturbance feedforward and residual feedback. An ultra-local current model incorporates motor dynamics, parameter uncertainties, cross-coupling effects, and other nonideal factors into generalized lumped disturbances. An extended state observer (ESO) estimates these lumped disturbances and compensates for them through feedforward action, transforming the original PMSM current-control problem into regulation of a simplified post-compensation residual system. A state-feedback H-infinity controller for the residual system is then learned directly from operating data using off-policy integral reinforcement learning. Owing to the simplified residual dynamics, the value function and control policies are parameterized in quadratic and linear forms, reducing the learning problem to low-dimensional parameter estimation without neural-network approximation. The proposed method requires neither prior knowledge nor online identification of PMSM electrical parameters: input-gain mismatch is incorporated into the ESO-estimated lumped dynamics, while the residual-feedback policy is obtained from operating data. Comparative simulations against deadbeat predictive current control, model-based H-infinity control, and model-free predictive current control show fast current tracking, low current distortion, and strong robustness to large parameter variations. With the learned H-infinity policy fixed and without retraining or retuning, nearly unchanged control performance is maintained when stator resistance, stator inductance, and permanent-magnet flux linkage are simultaneously varied to 20% and 200% of their nominal values.

Comment
20 pages, 14 figures

Closest papers

Nearest neighbours by meaning across the whole index.

Equivalent Flux Compensation for SPMSM Sensorless Control under Parameter Mismatch

eess.SY ·2026-09-24 ·Fobao Zhou, Jiaqiao Liang, Zhenxiao Yin, Xueyan Wang, Yang Shen +2 more
similarity 0.60
Abstract

Parameter mismatch is the main source of rotor position estimation error in sensorless control of surface-permanent magnet synchronous motors (SPMSMs). To this end, this paper proposes a simple yet efficient equivalent flux compensation (EFC) method that directly estimates the equivalent flux disturbance caused by parameter mismatches in real time. First, the equivalent flux disturbance caused by parameter mismatches is derived from a nonlinear flux observer. Second, a flux update law is proposed to minimize both magnitude and directional errors by leveraging geometric error together with the derived equivalent flux disturbance. To enhance numerical stability, a saturation function is introduced to improve gradient continuity in the update process. Additionally, Lyapunov analysis is employed to ensure the stability of the proposed update law, from which the corresponding error bounds and convergence properties are derived. Finally, experimental results validate that the proposed method fully compensates for the steady-state effects of resistance and flux mismatches, and partially mitigates the influence of inductance variation, effectively constraining the position estimation error within a relatively small range.

0.56

Parameter-Robust Sensorless Control of IPMSM Drives With Adaptive Flux Observer

eess.SY ·2026-09-30 ·Fobao Zhou, Zhenxiao Yin, Xueyan Wang, Yang Shen, Yuanfeng Qu +1 more
similarity 0.59
Abstract

To address parameter sensitivity commonly in interior permanent magnet synchronous motor (IPMSM) sensorless control, this paper proposes a parameter-robust control framework by extending the adaptive flux observer from surface-mounted PMSM to salient-pole machines. First, parameter mismatches are interpreted as an equivalent flux vector with $d$-axis and $q$-axis components. Permanent magnet flux, $d$-axis inductance, and resistance mismatches are mapped to the $d$-axis flux component, whereas $q$-axis inductance mismatch is mapped to the $q$-axis component. Then, a scalar adaptive flux update is designed to compensate the $d$-axis flux variation by tracking the equivalent flux magnitude. Since the $q$-axis component rotates the observed flux direction and cannot be eliminated by scalar adaptation, a high-frequency $q$-axis voltage injection method is introduced to identify the $q$-axis inductance. Meanwhile, stability analysis proves bounded equivalent flux magnitude tracking and identifies the residual tangential flux responsible for position error. Finally, experimental results show that the proposed method does not require precise resistance, $d$-axis inductance, or flux, while the $q$-axis inductance is provided by online identification.

0.10

Stability-aware Residual Reinforcement Learning Framework for Robotic Manipulator Disturbance Compensation

cs.RO ·2026-09-18 ·Jihong Kim, Joonhyuk Kwon, Hwa Soo Kim, TaeWon Seo, Hyung-Tae Seo
similarity 0.56
Abstract · 14 pages, 9 figures

Although conventional controllers and disturbance observers (DOBs) are the standard for precision tracking in manipulators, they suffer from parameter uncertainty, nonlinear friction, and compound disturbances. This study proposes a residual reinforcement learning DOB framework that pairs an analytical observer with an RL policy. The deterministic baseline operates within a reliable region, whereas the RL policy explicitly targets the residuals that the model cannot capture. To make this compensation disturbance-aware, an estimator network aligns the observation history with a privileged disturbance context, organizing the latent space by disturbance regime and enabling rapid adaptation across disturbance transitions. To guarantee stability, we derived and enforced a state-dependent action bound on the RL policy from an input-to-state stability (ISS) analysis such that the closed loop provably confines the tracking error to a certified envelope for arbitrary policy outputs. Experiments on a 6-DOF manipulator demonstrated consistent improvements in disturbance estimation and tracking, including a 27.8% tracking-error reduction on real hardware under zero-shot sim-to-real transfer and a 38.0% reduction under a base-vibration disturbance that was not observed during training.

0.45

Adaptive Observer of Nonlinear One-Sided Lipschitz Systems Using Estimated State Regressors With Finite Excitation

eess.SY ·2026-08-31 ·Hamid Taghavifar, Brian Delgado Aguilar
similarity 0.56
Abstract

For systems with unknown parameters, finite excitation and concurrent learning can potentially yield parameter convergence without persistent excitation but the regressor may still depend on inaccessible states, leading to regressor mismatch. In this paper, this problem is addressed for a class of nonlinear systems with one-sided Lipschitz properties and quadratically inner-bounded nonlinearities with bounded disturbances and linearly parametrized uncertainties. To this aim, an output-integral regression is utilized by using measured outputs and estimated states, and history-stack residual is explicitly bounded in terms of state-estimation error and disturbance. Furthermore, a perturbation bound between the estimated-state and true-state information matrices is derived. Additionally, an OSL-QIB LMI condition is applied for the observer design and a projected adaptive law is designed without needing exact output matching. Stability analysis's results indicate the proposed observer and parameter estimation outperform observers without history-stack learning term.

0.13

Temporal Regression-Based Model-Free Sensorless Control of Permanent Magnet Synchronous Motor

eess.SY ·2026-09-24 ·Fobao Zhou, Yang Shen, Xueyan Wang, Zhenxiao Yin, Yujia Zhang +2 more
similarity 0.54
Abstract

To address the widespread sensitivity of surface-mounted permanent magnet synchronous motor (SPMSM) sensorless control to motor parameters, this paper proposes a temporal regression-based model-free sensorless control (TFC) method. First, voltage integrals and current increments over consecutive short intervals are stacked to construct a finite window regression, in which the unknown stator inductance appears as a common scalar coefficient. Second, a projection operator constructed from the stacked current increments eliminates the inductance term, and a least-squares formulation is developed to reconstruct the rotor flux vector. Meanwhile, the analysis of the projected regression and current-flux geometry establishes a two-dimensional direction vector whose components share a common amplitude containing the stator resistance and flux linkage. This amplitude cancels during position extraction. By setting the resistance reference to zero, the proposed method estimates the position without specifying the stator resistance, inductance, or flux linkage. Finally, experimental results verify the effectiveness of the proposed TFC method.

0.32

Adaptive Stability-Constrained Neural Differential Equations for Controlled Dynamical Systems with Unknown Inputs

eess.SY ·2026-08-10 ·Syed Pouladi
similarity 0.53
Abstract

Continuous-time neural models are attractive for identifying nonlinear systems, but a small one-step error can grow rapidly when a learned vector field is rolled out under inputs that differ from those used for training. This paper develops an adaptive stability-constrained neural differential equation (AS-NDE) for systems with measured controls and unmatched, unknown perturbations. The nominal vector field and a state--input-dependent Riemannian metric are learned jointly. Positive definiteness is enforced by construction, while a sampled differential inequality penalizes violations of a prescribed contraction rate. An incremental input-to-state bound is derived: the distance between two trajectories decays exponentially up to gains determined by differences in their controls and disturbances. The statement explicitly accounts for the time derivative of an input-dependent metric, a term that is easily omitted in heuristic stability regularizers. We give a reproducible evaluation protocol for a forced Duffing oscillator and a permanent-magnet synchronous motor (PMSM) model. Because no measured data or executed training runs accompany this draft, all numerical curves and tables are clearly identified as illustrative synthetic placeholders; their PGFPlots coordinates are embedded in the source for direct replacement. The resulting manuscript is intended as a technically consistent starting point, not as evidence of empirical superiority before the prescribed experiments are run.

0.04

Real-Time Transient Response Optimization

eess.SY ·2026-08-22 ·Anahida Kanade, Djan Tanova, Steve Conner, Taner Dosluoglu
published similarity 0.53
Abstract · 6 pages, 9 figures, 1 table. Technical correspondence of original research and data that has not yet been accepted for publication in any jo…

Use of artificial intelligence in motor control applications that can be deployed within the microcontrollers need to comply with real-time demands of motor control systems. A supplementary controller approach that can be integrated within existing microcontrollers is presented. The proposed approach is implemented on a weeteq motor control integrated circuit and tested in the lab. A complete unsupervised motor control deployment solution was developed, and the real-time system response correction demonstrated under dynamic loads measured with and without the supplementary controller. The solution provides 100% coverage of real-time data at control loop sample rate and model inference period between 100usec and 1msec. The importance of latency for reduction of dynamic regulation margin during transient response is demonstrated with up to 68% reduction of the system response error. A novel key performance indicator based on principal components transform is introduced that provides a quantitative figure of merit for improvement of the transient response, in terms of the dynamic regulation margin, stability considerations and iterative improvements of consecutive regression model outputs. The significant events related to dynamic changes in the equipment and external operating conditions are detected at milliseconds resolution and recorded as highly compressed vectors representing deviation of the system response from linear steady state conditions. The resolution in time and accuracy of this vector data will enable a new level of system level optimisation that has not been possible using the time series data from IoT sensors in current equipment health monitoring solutions.

0.36

Nonadaptive Learning in Robust Nonlinear Output Regulation

eess.SY cs.AImath-phmath.OC ·2026-08-18 ·Shimin Wang, Martin Guay, Richard D. Braatz
benchmark similarity 0.52
Abstract

This paper considers robust nonadaptive regulation for general nonlinear systems in an output-feedback setting with arbitrarily high relative degree. We develop a nonadaptive design that combines an input-driven filter and a generic internal model with a recursive backstepping law, thereby recasting the regulation problem as the robust input-to-state stabilization of an augmented error system. Unlike adaptive schemes, the proposed method does not rely on linearly parameterized regressors and does not require the construction of Lyapunov functions having merely nonpositive derivatives. Under standard assumptions on the exosystem, including purely imaginary and simple eigenvalues, together with a minimum-phase input-to-state stability condition on the internal dynamics, we establish global asymptotic regulation and derive explicit, verifiable inequalities for selecting the design gains. The resulting nonadaptive framework guarantees convergence of the estimation and tracking errors even when the controlled-system dynamics are complex or only partially known. The effectiveness of the theoretical results is demonstrated using a benchmark controlled Duffing system.

0.10