CS Paper Radar

Equivalent Flux Compensation for SPMSM Sensorless Control under Parameter Mismatch

Fobao Zhou, Jiaqiao Liang, Zhenxiao Yin, Xueyan Wang, Yang Shen, Zhongyu Shi, Hang Zhao

eess.SY ·submitted 2026-09-24 09:47 UTC · v1

Abstract

Parameter mismatch is the main source of rotor position estimation error in sensorless control of surface-permanent magnet synchronous motors (SPMSMs). To this end, this paper proposes a simple yet efficient equivalent flux compensation (EFC) method that directly estimates the equivalent flux disturbance caused by parameter mismatches in real time. First, the equivalent flux disturbance caused by parameter mismatches is derived from a nonlinear flux observer. Second, a flux update law is proposed to minimize both magnitude and directional errors by leveraging geometric error together with the derived equivalent flux disturbance. To enhance numerical stability, a saturation function is introduced to improve gradient continuity in the update process. Additionally, Lyapunov analysis is employed to ensure the stability of the proposed update law, from which the corresponding error bounds and convergence properties are derived. Finally, experimental results validate that the proposed method fully compensates for the steady-state effects of resistance and flux mismatches, and partially mitigates the influence of inductance variation, effectively constraining the position estimation error within a relatively small range.

Closest papers

Nearest neighbours by meaning across the whole index.

Parameter-Robust Sensorless Control of IPMSM Drives With Adaptive Flux Observer

eess.SY ·2026-09-30 ·Fobao Zhou, Zhenxiao Yin, Xueyan Wang, Yang Shen, Yuanfeng Qu +1 more
similarity 0.79
Abstract

To address parameter sensitivity commonly in interior permanent magnet synchronous motor (IPMSM) sensorless control, this paper proposes a parameter-robust control framework by extending the adaptive flux observer from surface-mounted PMSM to salient-pole machines. First, parameter mismatches are interpreted as an equivalent flux vector with $d$-axis and $q$-axis components. Permanent magnet flux, $d$-axis inductance, and resistance mismatches are mapped to the $d$-axis flux component, whereas $q$-axis inductance mismatch is mapped to the $q$-axis component. Then, a scalar adaptive flux update is designed to compensate the $d$-axis flux variation by tracking the equivalent flux magnitude. Since the $q$-axis component rotates the observed flux direction and cannot be eliminated by scalar adaptation, a high-frequency $q$-axis voltage injection method is introduced to identify the $q$-axis inductance. Meanwhile, stability analysis proves bounded equivalent flux magnitude tracking and identifies the residual tangential flux responsible for position error. Finally, experimental results show that the proposed method does not require precise resistance, $d$-axis inductance, or flux, while the $q$-axis inductance is provided by online identification.

0.10

Temporal Regression-Based Model-Free Sensorless Control of Permanent Magnet Synchronous Motor

eess.SY ·2026-09-24 ·Fobao Zhou, Yang Shen, Xueyan Wang, Zhenxiao Yin, Yujia Zhang +2 more
similarity 0.68
Abstract

To address the widespread sensitivity of surface-mounted permanent magnet synchronous motor (SPMSM) sensorless control to motor parameters, this paper proposes a temporal regression-based model-free sensorless control (TFC) method. First, voltage integrals and current increments over consecutive short intervals are stacked to construct a finite window regression, in which the unknown stator inductance appears as a common scalar coefficient. Second, a projection operator constructed from the stacked current increments eliminates the inductance term, and a least-squares formulation is developed to reconstruct the rotor flux vector. Meanwhile, the analysis of the projected regression and current-flux geometry establishes a two-dimensional direction vector whose components share a common amplitude containing the stator resistance and flux linkage. This amplitude cancels during position extraction. By setting the resistance reference to zero, the proposed method estimates the position without specifying the stator resistance, inductance, or flux linkage. Finally, experimental results verify the effectiveness of the proposed TFC method.

0.32

Model-Free Current Control of Permanent Magnet Synchronous Motors via ESO-Based Disturbance Feedforward and Data-Driven H-infinity Residual Feedback

eess.SY ·2026-09-22 ·YongBo Li, Shuang Liang, HongWei Ma
similarity 0.60
Abstract · 20 pages, 14 figures

This paper proposes a model-free current control method for permanent magnet synchronous motors (PMSMs) based on disturbance feedforward and residual feedback. An ultra-local current model incorporates motor dynamics, parameter uncertainties, cross-coupling effects, and other nonideal factors into generalized lumped disturbances. An extended state observer (ESO) estimates these lumped disturbances and compensates for them through feedforward action, transforming the original PMSM current-control problem into regulation of a simplified post-compensation residual system. A state-feedback H-infinity controller for the residual system is then learned directly from operating data using off-policy integral reinforcement learning. Owing to the simplified residual dynamics, the value function and control policies are parameterized in quadratic and linear forms, reducing the learning problem to low-dimensional parameter estimation without neural-network approximation. The proposed method requires neither prior knowledge nor online identification of PMSM electrical parameters: input-gain mismatch is incorporated into the ESO-estimated lumped dynamics, while the residual-feedback policy is obtained from operating data. Comparative simulations against deadbeat predictive current control, model-based H-infinity control, and model-free predictive current control show fast current tracking, low current distortion, and strong robustness to large parameter variations. With the learned H-infinity policy fixed and without retraining or retuning, nearly unchanged control performance is maintained when stator resistance, stator inductance, and permanent-magnet flux linkage are simultaneously varied to 20% and 200% of their nominal values.

0.29

High-Performance Sensorless Control for High-Speed PMSM with Current Source Inverters

eess.SY ·2026-09-22 ·Nail Tosun, Devinda Molligoda, Xu Deng, Barrie Mecrow
publishedunusual similarity 0.53
Abstract · Accepted, and presented at ICEM 2026

Current source inverters (CSIs) are emerging as competitive alternatives to voltage source inverters (VSIs) for high-speed motor drives because they inherently suppress harmonic currents, offer output-voltage boosting, and reduce motor-side electromagnetic interference. Sensorless control of CSI-fed permanent magnet synchronous machines (PMSMs) remains less mature than VSI counterparts, primarily because conventional implementations require measurement of all circuit state variables. This paper proposes a weak-resonance-based approximation that reconstructs stator currents from inverter modulation commands and feedforward capacitor-current estimation, thereby reducing the sensing requirement to the dc-link current and two terminal voltages. The proposed observer--PLL structure is analysed for computational complexity and validated through simulations and experiments on a 100~W, 100~krpm GaN-based two-stage CSI prototype (buck + CSI). Quantitative results demonstrate accurate rotor-position tracking and high-bandwidth operation while maintaining the reduced sensor set. Proposed method performs well in simulation and experiment, achieving a position estimation error below $5^\circ$ at 100~krpm.

0.40

On sparsity and directional forgetting in adaptive control

eess.SY ·2026-09-20 ·Tochukwu E. Ogri, Trivikram Satharasi, Muzaffar Qureshi, Kyle Volle, Rushikesh Kamalapurkar
similarity 0.46
Abstract

This paper develops a sparsity-promoting memory regressor extension (MRE) adaptation law with directional forgetting for nonlinear control-affine systems with linearly parameterized uncertainty. The objective is to use directional forgetting to selectively discount obsolete information and leverage $\ell_1$ regularization to promote sparsity of the parameter estimates. While $\ell_1$ regularization has been applied to the system identification problem in an offline setting, a contribution of this paper is to develop a recursive least squares update law to implement $\ell_1$ regularization in online adaptive control. In particular, we show that $\ell_1$-regularized recursive least squares is realized via a sliding mode update law. A nonsmooth Lyapunov-based stability analysis is then used to show that the tracking and parameter estimation errors are ultimately bounded under a subspace excitation condition. Simulation results on a Van der Pol oscillator demonstrate the ability of the developed sparsity-promoting MRE controller to recover sparse dynamics while maintaining stable tracking.

0.09

Robust Model Reference Adaptive Control with Combined Adaptation under Finite Excitation Condition

eess.SY ·2026-08-23 ·Manish Patel, Arnab Maity
similarity 0.45
Abstract

In adaptive control, parametric uncertainties in linear-in-parameter form consist of unknown parameters and known regressor signals. Convergence of the unknown parameters to their ideal values requires the regressor to satisfy a persistent excitation (PE) condition, which depends on future data and is therefore infeasible to guarantee online. Memory-based parameter update laws address this by enabling ideal parameter convergence under the online-verifiable finite excitation (FE) condition. In this paper, a new algorithm is proposed to construct a memory term via the Modified Gram-Schmidt orthogonalization procedure for a class of multi-input multi-output nonlinear systems with an unknown diagonal control effectiveness matrix and bounded nonparametric uncertainties. Under the finite excitation condition, the constructed memory term yields an identity coefficient matrix in the parameter estimation error dynamics. The identity coefficient matrix eliminates the need for time-varying adaptation gains, enables an explicit ultimate bound on the parameter estimation error, and preserves the structure of the nonparametric uncertainty bound under the memory term. Building on this, a combined adaptation law is developed for controller gain estimation under FE. The closed-loop tracking and estimation errors are shown to decay exponentially to a neighborhood of the origin, characterized by an explicit ultimate bound, with a decay rate that depends solely on user-defined gains and system constants, independent of the level of regressor excitation. This removes the dependence of the convergence rate on the level of regressor excitation, a key limitation of existing approaches such as concurrent learning, memory regressor extension, and DREM.

0.24

Tilt-Rotor Quadcopter with Learned Residual Control and Mode-Dependent State Estimation

cs.RO ·2026-10-22 ·Ninad Joshi, Prabhat Kumar
similarity 0.44
Abstract · 5 figures

Tilt-rotor quadcopters redirect thrust for translation without banking, but complicate modeling, state estimation, and disturbance rejection. This paper presents a simulation-based flight stack for a \SI{2.00}{\kilo\gram} tilt-rotor quadcopter. The system uses a six-degree-of-freedom nonlinear model with first-order motor dynamics and two-axis rotor tilt, parameterized using a 3D CAD model. A cascaded PD controller commands forward and lateral tilt angles. A 14-state EKF fuses sensor data across hover, early-transition, and transition modes using a hysteretic (Schmitt-trigger) classifier to prevent covariance discontinuities. Because the proportional position loop leaves a steady-state offset under constant wind, a small bounded neural residual is added on top of the unmodified PD controller. It is trained by behavioral cloning from a teacher with privileged access to the true wind, while the deployed network never observes wind. In simulation, the EKF achieves a post-settling position root mean square error (RMSE) of \SI{0.226}{\metre} (horizontal) and \SI{0.03}{\metre} (vertical) and an attitude RMSE below \SI{0.8}{\degree}, and it estimates a wind velocity of $(\num{2.0}, \num{-1.2})\,\unit{\metre\per\second}$ to within \SI{0.15}{\metre\per\second} per axis. The residual reduces steady-state station-keeping error under wind by approximately \SI{49}{\percent}, from \SI{0.117}{\metre} to \SI{0.060}{\metre} at \SI{1.5}{\metre\per\second} and from \SI{0.319}{\metre} to \SI{0.162}{\metre} at an out-of-distribution \SI{3.9}{\metre\per\second}. The framework provides a basis for hardware-in-the-loop and flight-test studies.

0.29

Model-Based Disturbance Rejection via Sliding-Mode Control: Continuous-Time Formulation and Proper Implicit Discretization

eess.SY ·2026-10-02 ·Benedikt Andritsch, Stefan Koch, Jaime A. Moreno
theory similarity 0.43
Abstract · preprint submitted to Automatica

We propose a robust exact sliding-mode controller for reference tracking with model-based disturbance rejection, where the disturbance is generated by a linear time-invariant model driven by a bounded input and may be bidirectionally coupled with the plant. The controller embeds the internal model principle and its error dynamics mirror those of the robust exact differentiator, ensuring finite-time convergence. We develop a proper implicit discretization for sampled-data implementation that preserves stability and accuracy. In the nominal case, which contains a disturbance generated by a $p$-th order integrator chain, the method achieves a control accuracy of $T^{p+1}\bar D$, with discretization time $T$ and disturbance bound $\bar D$. This accuracy is shown to relate to the fundamental lower bound by a factor depending only on the order of the disturbance model. Simulations demonstrate the efficacy of the proposed methods.

0.45