CS Paper Radar

Imp-ACT: Adaptive Impedance Control and Action Chunking with Transformers to Learn Contact-Rich Manipulation from Demonstrations

Luca Zanetti, Doganay Sirintuna, Idil Ozdamar, Pietro Balatti, Heng Zhang, Arash Ajoudani

cs.RO ·submitted 2026-09-25 13:04 UTC · v1

Abstract

Contact-rich manipulation requires robots to balance accurate motion tracking with compliant interaction, yet most visual-action policies leave compliance fixed at the controller level. We present Imp-ACT, a methodologically grounded and practical approach to incorporating direction-dependent Cartesian stiffness modulation directly into demonstration collection, without manual stiffness selection or offline target reconstruction. During teleoperation, a self-tuning impedance controller adapts stiffness along the instantaneous direction of motion while maintaining compliance in orthogonal directions. The adapted stiffness is applied and recorded alongside visual observations and motion commands, capturing motion and compliance under the same dynamics. We implement this pipeline using Action Chunking with Transformer (ACT) to predict end-effector pose, gripper action, and motion-direction stiffness from visual, proprioceptive, and wrench observations. The performance of Imp-ACT is evaluated on wiping and plug insertion using both success rate and quantitative measures of contact behavior. Compared with fixed low- and high-stiffness baselines, Imp-ACT achieves comparable or higher success while maintaining low interaction forces. In wiping, it reduces contact-force vibration by approximately $29\times$ relative to the compliant baseline and $180\times$ relative to the stiff baseline. In plug insertion, it reduces forces orthogonal to the insertion direction by $43\%$ relative to the better fixed-stiffness baseline. These results highlight the benefit of maintaining sufficient stiffness along the direction needed for task execution while preserving compliance in other directions to limit contact forces and accommodate environmental constraints.

Comment
9 pages, 5 figures, submitted to IEEE International Conference on Robotics & Automation 2027, for associated video see https://youtu.be/iAu_HFeaCRg

Closest papers

Nearest neighbours by meaning across the whole index.

Wrench-ACT: Enhancing Robot Policies for Contact Rich Behavior Using Direct Wrench Control

cs.RO ·2026-09-29 ·Johannes Hechtl, Yannik Blei, Simon Ball, Reihaneh Mirjalili, Michael Krawez +3 more
similarity 0.81
Abstract

While contact-rich manipulation requires deliberate regulation of interaction forces, recent approaches to robot manipulation learning predominantly represent actions as target positions or poses. Even methods that incorporate force sensing either use it solely as an observation or, when predicting forces as part of the output, rely on a hybrid force controller. In this paper, we propose an imitation learning policy that predicts wrenches as its sole action output for direct use by a pure force controller. Our studies suggest that force-domain imitation learning depends critically on data collection, with force-feedback teleoperation improving policy performance by capturing the operator's deliberate force regulation. Using Action Chunking with Transformers (ACT) as the base architecture, we train single-task models on bilateral wrench demonstrations and evaluate them on five contact-rich manipulation tasks. The wrench policy matches or outperforms position-based baselines across all tasks, with gains varying according to the degree of deliberate force regulation each task requires. Cross-condition ablations show that the bilateral data collection interface and the wrench action space each contribute independently to performance. To support further research, we will release over 1000 wrench-action demonstrations spanning these tasks on a companion website upon publication.

0.16

M3-Tele: A Unified Multimodal Teleoperational Framework for Compliant Whole-Body Mobile Manipulation

cs.RO ·2026-09-07 ·Hengxiang Chen, Shenwen Deng, Yujian Ma, Gan Ma, Qiang Li +1 more
similarity 0.79
Abstract · 15 pages,12 figures,a under-review journal

Executing contact-rich tasks efficiently requires the seamless integration of whole-body coordination and physical compliance regulation. However, existing teleoperation and data-collection frameworks often overlook the joint consideration of multimodal perception and coordinated whole-body operation. This limitation can reduce the efficiency and quality of demonstration collection, thereby affecting the effectiveness of downstream policy learning. In this work, we present \textbf{M3-Tele}: A Unified \underline{M}ultimodal \underline{Tele}operational Framework for Compliant Whole-Body \underline{M}obile \underline{M}anipulation, enabling stable physical interaction and capturing aligned visual, tactile, force, and proprioceptive observations during task execution. Extensive experiments demonstrate that the proposed framework significantly improves contact-rich teleoperation performance. The proposed controller reduces the force tracking error from 4.132~N to 0.346~N, the contact loss from 2.46 to 0.02 events per trial and the tactile deformation error by 65\%. User studies across four mobile manipulation tasks also verify the reliability and usability of the proposed system. Furthermore, Diffusion Policy experiments highlight the value of joint tactile and force sensing.

0.22

FOMI: A Force-Feedback Manipulation Interface for Teaching Contact-Rich Manipulation

cs.RO ·2026-10-14 ·Yishu Shen, Yiming Luo, Ruilin Wang, Bowen Yang, Shuai Yang +5 more
similarity 0.78
Abstract

Robot-free collection with handheld interfaces enables scalable acquisition of human demonstrations for policy learning. However, existing handheld interfaces often provide limited intuitive force feedback, making contact-rich demonstration collection challenging for human operators. To address this, we present FOMI, a force-feedback manipulation interface with a scissor-shaped mechanism, which transmits object interaction forces directly to the operator's hands through actuation links without force sensors. This intuitive force feedback supports real-time action adjustment during robot-free collection of contact-rich demonstrations. Around FOMI, we build a demonstration collection system that integrates sensor calibration, data acquisition, and synchronization for robot-free collection. By further mapping pose changes and gripper opening of FOMI to robot end-effector poses and gripper commands, the system also supports teleoperation. Across four contact-rich tasks, FOMI improves collection efficiency by approximately 29% and 18% over the best baselines in robot-free collection and teleoperation, respectively. Demonstrations collected with FOMI in both modes enable policies to perform challenging contact-rich manipulation tasks with high success rates.

0.32

Force-Modulated Dexterity: Unified Compliance for Contact-Rich Manipulation

cs.RO cs.AI ·2026-10-12 ·Ying Yuan, David Held, Jitendra Malik, Haozhi Qi
code/data similarity 0.77
Abstract · Project page: https://yingyuan0414.github.io/fomo-dex/

Teleoperation is widely used to collect high-quality demonstrations for robot learning. Dexterous manipulation, however, requires coordinated control of motion and contact forces. Operators can specify motion, but struggle to reproduce the subtle force adjustments of human manipulation without feeling the robot's contacts. We introduce Force-Modulated Dexterity (FOMO-Dex), a unified compliance formulation for contact-rich manipulation. FOMO-Dex expresses nominal actions in coordinates defined by task geometry and contact structure. It applies force-driven motion corrections along selected directions while leaving the remaining command components unchanged. Across card picking, paper cutting, screwdriving, and nut-and-bolt assembly, FOMO-Dex reduces excessive contact forces compared with stiff control. A user study shows that operators collect more successful demonstration data per hour after brief practice. For policy learning, imitating the corrected actions improves card-picking success over imitating raw operator commands. Policies trained on FOMO-Dex demonstrations also achieve more rotation in nut-and-bolt manipulation and screwdriving than those trained on demonstrations collected with the stiff controller. Videos are shown on https://yingyuan0414.github.io/fomo-dex/ .

0.41

Impedance Cloning: Learning Equilibrium Point Parameters for Contact-Rich Manipulation

cs.RO ·2026-09-25 ·Hayato Takahashi, Ryoga Oishi, Yuki Kasuga, Toshiaki Tsuji
similarity 0.77
Abstract · 8 pages, 7 figures, 3 tables. Submitted to IEEE Robotics and Automation Letters (RA-L)

Contact-rich manipulation requires robots to regulate force against surfaces whose geometry deviates unpredictably from training conditions. Trajectory-based imitation learning, which reproduces observable outputs, breaks down under such shifts. We propose Impedance Cloning, which instead imitates the biomechanical priors that generate motion -- the stiffness and equilibrium point -- and thereby passively absorbs contact uncertainty. Because these parameters encode intent rather than outcome, they generalize across surface geometries where trajectory reproduction does not. We extract them from bilateral teleoperation demonstrations via a particle filter without force/torque sensors and evaluate the framework on two CRANE-X7 manipulators. In a wiping task with joint-space actions, the trajectory-based baseline loses contact below -6 cm, whereas the proposed method maintains a consistent 4-5 N contact force above -6 cm, with a gradual decrease below; with Cartesian-space actions, its force-height slope over 0 to +8 cm is 0.13 +/- 0.03 N/cm, versus 0.34-0.83 N/cm for fixed-impedance baselines. In a pick-and-place task with 10 diverse cups (100 trials), the proposed method succeeds in 84 trials, outperforming the fixed-impedance baseline (74/100) and performing comparably to a variable impedance control baseline (82/100) with one demonstration instead of ten. In a grasping task, the representation reduces torque tracking error with both ILBiT and Mamba backbones, confirming its generality across architectures.

0.26

Compliance for Free: Learning Identifiable Impedance via Bilateral Teleoperation

cs.RO ·2026-09-17 ·Harsha Guda, Adrià Colomé, Carme Torras
similarity 0.77
Abstract

Vision-language-action models tell a robot where to move, but not how hard to push. Contact-rich tasks depend on that second quantity, compliance, yet no widely used demonstration interface records it. The obstacle is identifiability as realized pose and measured force cannot separate the operator's intended equilibrium from their stiffness, so VR controllers, SpaceMouse and handheld grippers cannot supply compliance supervision even in principle. Prior compliance-output policies work around this with hand-specified task structure, privileged simulation contact state, or dedicated force and tactile hardware. Four-channel bilateral teleoperation removes the ambiguity directly by using the leader arm as a separate measurement of the intended equilibrium, making per-axis stiffness identifiable by regression using only the joint-torque sensing already on the manipulator. This yields per-timestep, direction-dependent compliance labels at zero annotation cost, which we use to fine-tune a VLA to emit stiffness alongside pose. On a Franka Research 3 wiping task, ours is the only policy of five whose contact force changes when the instruction asks for a firm wipe rather than a normal one (6.4N (normal) to 9.1N (firm) RMS, Cohen's d = 0.89, p = 0.023

0.22

CompVLA: A Variable Compliance Vision-Language-Action Model for Contact-rich Manipulation

cs.RO ·2026-09-20 ·Jongmin Kim, Junsu Ha, Che-Sang Park, Minchang Song, Hyeokju Jeong +3 more
hot direction similarity 0.76
Abstract · Conference on Robot Learning (CoRL) 2026

Contact-rich manipulation, requiring robots to regulate not only motion but also how they yield to external forces, has emerged as the next frontier for Vision-Language-Action (VLA) models. However, existing VLAs output purely kinematic commands, degrading performance on real-world contact-rich tasks. In this paper, we introduce CompVLA, a unified VLA framework that jointly predicts motion and a stiffness matrix from RGB and language inputs. Our approach augments the conventional architecture with a dedicated Compliance Expert, which outputs time-varying stiffness and virtual displacement profiles executed via geometric impedance control. We demonstrate that CompVLA achieves the highest average success rate across diverse contact-rich tasks, outperforming both vanilla and compliance-aware VLA baselines, with ablations confirming each component is essential.

0.47

Learning Reflexive Behavior for Contact-Rich Manipulation

cs.RO ·2026-10-02 ·Quan Nguyen, Yunho Kim, Joonho Lee
similarity 0.75
Abstract

During contact-rich manipulation, interactions between a robot and its environment carry information about local geometry: a surface prevents penetration, a bore guides a peg. A controller that exploits these interactions can comply with environmental constraints while preserving task intent. Robot-earning systems commonly use position, hybrid force-position, or Cartesian impedance control. Their prescribed tracking objectives, stiffness, or force-control directions may not match local constraints and may degrade performance. We learn a proprioceptive reflex policy in simulation on three simple interaction primitives: a spring, a plane, and a rail. The policy maps task-space commands to joint-position targets using state history, without direct force or geometrical measurements. Once trained, it serves as a frozen execution layer beneath higher-level controllers. We evaluate it in dual-arm box lifting, peg insertion, and surface following. In box lifting, the reflex kept the force below the threshold while the baseline failed. In rough-surface following it stayed below the 10 N reference, on par with tuned hybrid force-position control. In 0.02 mm peg insertion It reduced mean estimated contact force to less than half that of the baseline while increasing hardware success rates from at most 22 % to 36-58 %. By separating contact response from command generation, the reflex policy provides motion planners, learned policies, and teleoperators with robust contact-rich execution.

0.15