CS Paper Radar

A Mixed $H_{\infty}$--Passivity Approach for Leveraging Heat-Pump-Connected District Heating Systems as Frequency Support in Electric Power Systems

Xinyi Yi, Ioannis Lestas

eess.SY ·submitted 2026-10-29 20:34 UTC · v1
code/dataunusual

Abstract

Heat-pump (HP)-connected district heating systems (DHSs) can support grid frequency by rapidly modulating HP electrical consumption while accommodating the resulting heat imbalance. Thermal-state-informed HP control improves EPS--DHS coordination, but introduces slower DHS dynamics and heat-side disturbance propagation at the electrical interface on the time scale of secondary frequency control. This paper formulates the regulated DHS as a grid-facing dynamic port and develops a mixed $H_\infty$--passivity framework for disturbance-independent temperature regulation while preserving a clean electrical response during secondary frequency control. Sufficient conditions guarantee local asymptotic stability of the EPS--HP--DHS interconnection across primary frequency control, secondary frequency control, and DHS regulation. These stability conditions are integrated with multi-channel $H_\infty$ attenuation of DHS-state-dependent electrical dynamics, heat-disturbance propagation, and DHS-regulation errors, yielding a tractable convex LMI program for controller synthesis. Cross-model validation deploys controllers synthesized on control-oriented EPS--DHS models, without retuning, on an open-source electromechanical IEEE 39-bus model coupled with four high-fidelity finite-volume DHS models retaining thermal transport, storage, and heat-loss dynamics. The resulting controller improves EPS--DHS coordination without compromising the grid-facing electrical response.

Closest papers

Nearest neighbours by meaning across the whole index.

Optimal Coordination of Heat Pump Demand Flexibility and Battery Energy Storage Considering the Operation of Distribution Networks

eess.SY ·2026-10-06 ·Gustavo L. Aschidamini, Guilherme S. Castiglio, Mariana Resener
similarity 0.53
Abstract

Electrifying space heating with heat pumps (HP) and backup electric-resistance heaters (ERH) is incentivized to support decarbonization but increases voltage and thermal issues in distribution networks. Direct load control (DLC) of smart thermostats (ST) provide grid support, yet, to the best of our knowledge, existing methods do not co-optimize this flexibility with grid-scale battery energy storage systems (BESS) and voltage-regulation devices, and do not use ERH for preheating, limiting peak demand reduction and undervoltage mitigation. We propose a mixed-integer linear programming (MILP)-based model predictive control (MPC) framework that coordinates ST setpoints for preheating and setback, grid-scale BESS, on-load tap changers, switched capacitor banks, and step voltage regulators. The framework is evaluated on 23-node and 733-node distribution networks, including a real-data-based feeder, across multiple realized days. On the 23-node feeder with 50% HP penetration and 50% DLC participation, the proposed framework reduces the feeder peak by 23.1%, and by 27.1% with the co-optimized BESS. Rolling-horizon setpoint optimization contributes 6.5 percentage points beyond a day-ahead ST schedule (16.6%), and dispatching the ERH for preheating adds 2.7 percentage points beyond backup-only operation (20.4%). On the 733-node feeder, where thermal congestion is the binding constraint, the framework reduces overloaded branches by 94% and overloaded transformers by 47%. These results demonstrate the potential of coordinated demand flexibility and voltage regulation to accommodate heating electrification.

0.12

Decentralized Continuous-Time Power Dispatch for Integrated Heat and Power Systems via Bernstein-Galerkin Equivalent Projection

eess.SY ·2026-09-29 ·Jie Deng, Zhigang Li, J. H. Zheng, Yue Chen
similarity 0.52
Abstract

Decentralized power dispatch for integrated heat and power systems (IHPSs) involves coordinating electric power systems (EPSs) and district heating networks (DHNs) while preserving privacy. The existing methods rely mainly on discretetime DHN models and constant-flow operations, limiting the ability to exploit thermal flexibility. Enabling variable-flow and variable-temperature (VF-VT) operations requires thermal-hydraulic coupling to be addressed together with continuous-time thermal dynamics. However, the simultaneous variations in mass flows and temperature lead to a nonconvex IHPS model, for which conventional decomposition methods are difficult to apply. This paper proposes a decentralized continuous-time dispatch framework using Bernstein-Galerkin equivalent projection. For a prescribed mass flow trajectory, DHN thermal dynamics are formulated in the Bernstein space and projected onto boundary variables, yielding an equivalent feasible-region model without disclosing the internal DHN topology or states. The equivalent model and DHN subproblem are derived from a unified Bernstein-Galerkin formulation, ensuring a consistent thermal state representation throughout the EPS-DHN coordination procedure. A safeguarded Anderson prediction scheme further accelerates the alternating coordination process by using historical updates and fixed-point residuals to predict the next input without additional subproblem solving steps. Numerical results show the proposed method preserves thermal state consistency, exploits VF-VT flexibility, and improves economic and computational performance.

0.14

Optimal Allocation of Grid-Forming Frequency Shaping Control

eess.SY ·2026-09-21 ·Zhaomin Lyu, Ding Zhang, Yan Jiang
similarity 0.51
Abstract

Various inverter-based control strategies have been proposed to improve frequency security for power systems with high renewable penetration. Among them, the grid-forming frequency shaping control is particularly promising due to its ability to shape the post-contingency aggregate system frequency dynamics into first-order with prescribed rate of change of frequency (RoCoF) and steady-state frequency deviation. Moreover, the shaped aggregate dynamics depends on the harmonic sum of all inverter transfer functions rather than on their distribution. In light of this, here we explore how to allocate shaping control resources to minimize the transient control effort needed to achieve ideal coherent dynamics. We formulate it as a constrained optimization problem by tackling two main difficulties. First, we make the squared $\mathcal{H}_2$ norm legitimate quantification of transient control cost under step power imbalances through a system transformation. Second, we simplify the $s$-domain constraint for Nadir elimination into a standard constraint that is easy to implement in optimization. The resulting non-convex optimization problem can be solved by existing successive convexification method. The effectiveness of the allocation has been verified on the modified Icelandic Power Network test case.

0.28

Data Center Oscillation Isolation and Grid Support: Fundamental Limits and Source-Selective Control

eess.SY math.DS ·2026-10-19 ·Cheng Feng
similarity 0.51
Abstract

The grid integration of large data centers poses a growing power-system stability challenge. Rapidly varying computing demand can induce oscillations, while the facilities must provide a prescribed response to grid disturbances. Existing controls address load fluctuations and grid support but do not establish their jointly achievable performance. This paper derives fundamental limits and develops a source-selective controller for simultaneous oscillation isolation and grid support. A coupled closed-loop model gives a condition for distinguishing disturbance sources and reveals a direct isolation-support conflict under grid-import-power feedback alone; additional electrical measurements can remove this pointwise conflict but leave a conditional cross-frequency sensitivity limit. Guided by these limits, we design a local residual-feedback storage controller through convex frequency-domain optimization with stability, isolation, and grid-response constraints across operating points. Tests on a single-generator interconnection and a modified nine-bus network show stronger oscillation isolation than equal-order optimized comparators while meeting the prescribed grid response across operating points.

0.22

Integrated Heat and Power System Scheduling with Continuous-Time Thermal Dynamics via Bernstein-Galerkin Optimization

eess.SY ·2026-08-18 ·Jie Deng, Zhigang Li, J. H. Zheng, Ye Guo
top venue similarity 0.51
Abstract

Coordinated scheduling of district heating networks (DHNs) and electric power systems can improve operational flexibility and reduce costs by exploiting thermal inertia. Most existing formulations rely on simplified discrete-time DHN models, which may inadequately represent continuous spatiotemporal thermal dynamics and can lead to biased flexibility estimation and suboptimal schedules. In this paper, an integrated heat and power system scheduling framework that explicitly incorporates the continuous-time thermal dynamics of DHNs is proposed. A Bernstein-Galerkin transform method is developed to convert the underlying partial-differential thermal-dynamics constraints into a finite set of algebraic constraints, enabling tractable optimization while retaining dynamic fidelity. The resulting model transforms the original infinite-dimensional variational problem into a finite-dimensional coefficient optimization that can be solved using optimization solvers. Compared with conventional discretization approaches, the proposed method provides a more accurate representation of thermal dynamics and yields schedules with improved economic performance and reliability.

0.57

Enhancing Grid Stability with Synchronverter-Based Control for Grid-Side Converters in Wind Power Systems

eess.SY ·2026-11-02 ·Alan Valadez, George Weiss, Chunjiang Jia, Chong Ng
published similarity 0.51
Abstract

This paper proposes a new synchronverter control strategy for wind turbine grid-side converters, aimed at bolstering grid resilience by providing essential inertial frequency support without the need for additional energy storage components. The strategy harnesses the inherent energy storage capability of the DC-link capacitor to emulate the dynamic behavior of a synchronous generator, effectively contributing to grid inertia. A dual-controller architecture is implemented, consisting of a slow PI controller to maintain DC voltage stability and a fast protection mechanism to prevent overvoltage and undervoltage excursions. Critically, the control scheme facilitates controlled reductions of up to 10% in the DC-link voltage, generating a power reserve that can be strategically deployed for inertia emulation while preserving safe operating limits. The efficacy of the proposed method is validated through simulations of a representative three-turbine wind power plant, incorporating coordinated operation via virtual friction for inter-machine damping and local-global control strategies. Results showcase the superior performance of the proposed strategy compared to conventional grid-following control, emphasizing its potential to significantly improve grid stability and address the increasing challenges posed by high renewable energy penetration.

0.62

Relative-Degree Wall Restricts Passivity-Based Stability Analysis in Inverter-Dominant Grids

eess.SY ·2026-08-30 ·Xiaoyu Peng, Zhongze Li, Xi Ru, Xinghua Chen, Feng Liu
top venue similarity 0.50
Abstract

This letter reveals a fundamental limitation of passivity-based distributed stability analysis in power systems. Under the standard formulation, passivity certification inherently imposes a relative-degree compatibility constraint that excludes many high-fidelity inverter dynamic models (e.g., those that include electromagnetic transients). Potential extensions of passivity frameworks are discussed to break this limitation.

0.43

Physics-informed neural control of heat flow rate in a counter-flow heat exchanger: modeling, identification and experimental validation

eess.SY ·2026-10-04 ·Konstantinos Skantzikas, Emmanuel Witrant, Bojan Mavkov
similarity 0.50
Abstract

The advanced operation of heat exchangers plays a critical role in the development of efficient and sustainable multivector energy systems. This paper proposes a hybrid physics-informed and data-driven framework for the analysis, identification, and regulation of transient heat transfer in counter-flow heat exchangers. A parameterized physical model combines classical heat-transfer relations with transport equations to capture convective propagation, transport-induced delays, and nonlinear effects associated with flow-rate variations. The heat-transfer coefficient is identified from experimental data, enabling the characterization of flow-dependent heat-transfer dynamics over a broad operating range. The identified model is then used to develop a hierarchical real-time control strategy. An inner loop regulates the volumetric flow rate using a high-order data-driven linear model, while an outer loop regulates the exchanged heat power using a machine-learning controller initially trained on the physical model and subsequently refined with experimental data. Experimental results demonstrate accurate reproduction of transient heat-transfer dynamics and effective heat-flow-rate regulation under varying thermal boundary conditions (identification fit above 94\% in normalized root-mean-square error and total variation of the flow rate reduced by half compared to a proportional-integral controller). The proposed framework combines physical interpretability with data-driven adaptation for the analysis and real-time operation of dynamic heat-transfer systems.

0.29