CS Paper Radar

Biomechanics do not predict perceptual and cognitive consequences of force augmentation

Maria Molina-Sanchez, Francesco Missiroli, Viktorija Pavalkyte, Mabel Ziman, Julien Russ, Maggie Szymanska, Noham Wolpe, Rani Moran, Lorenzo Masia, Tamar R. Makin

cs.RO ·submitted 2026-10-30 12:47 UTC · v1
code/data

Abstract

Wearable force-augmentation technologies, including exoskeletons and soft exosuits, are being developed for occupational and rehabilitation settings to enhance performance by reducing the muscular demands of movements. Yet enhanced performance also requires users to perceive the environment accurately, adapt to changing conditions, and decide whether actions are worth their physical cost. We used an elbow-assisting exosuit to investigate the physiological, perceptual and cognitive consequences of force augmentation during lifting. We assessed weight perception, adaptation in a volatile environment, and effort-based decision-making with and without assistance. While assistance reduced muscle activity, its behavioural outcomes did not simply reflect this biomechanical change. Assistance reduced perceived weight, but this effect was strongly shaped by participants' initial experience. Assistance also selectively reduced adaptation to changing environmental contingencies. Finally, reducing the muscular demands of lifting did not translate straightforwardly into how demanding the action felt or whether participants chose to perform it: differences in effort-based decisions were shaped by initial experience rather than simply tracking reductions in muscle activity or perceived fatigue. Together, we show that the perceptual and cognitive consequences of force augmentation cannot be inferred from its biomechanical benefits alone. Effective augmentation therefore requires perceptual and cognitive outcomes to be evaluated alongside physical performance.

Comment
43 pages, 3 main figures, 3 supplementary figures, 3 supplementary tables, 3 supplementary movies. Supplementary movies available at https://osf.io/ft56y/files/osfstorage

Closest papers

Nearest neighbours by meaning across the whole index.

Recursive Self-Improvement of Exoskeleton Assistance Policies through Human-in-the-Loop Feedback

cs.RO ·2026-11-01 ·Muyuan Ma, Shuo Jiang, Lijun Han, Xinpan Meng, Zhenghua Ma +3 more
hot direction similarity 0.63
Abstract

To reduce reliance on manual design and extensive parameter tuning, a framework for the autonomous evolution of exoskeleton assistance policies through human feedback is proposed. Assistance policies are autonomously generated as executable control code by an intelligent agent and evaluated in experiments with human participants. Subjective user feedback, movement performance, and muscle activation measurements are incorporated into policy assessment. Based on these assessments, policy deficiencies are autonomously identified and the control code is revised by the agent for subsequent trials. A closed loop of policy generation, human feedback, evaluation, and autonomous refinement is thereby established. The framework is evaluated using GPT, DeepSeek, GLM, and Kimi, and initial assistance performance and refinement outcomes are compared across models. Despite differences in initial performance, effective assistance is achieved with all four models after a single autonomous refinement iteration under the tested conditions. Across three tasks, biceps and triceps muscle activation levels are reduced by 29.4% and 35.2%, respectively, compared with those measured without an exoskeleton. However, limited adaptability to unexpected situations is observed, indicating that further improvements in robustness and safety are required.

0.30

A Flow-Theoretic Multimodal Control Framework Fusing Mental and Physical Engagement for Upper-Limb Rehabilitation

cs.RO ·2026-10-15 ·Jun Leng, Pengcheng Li, Hanze Wang, Shuxiang Guo, Junlin Jiang
similarity 0.60
Abstract · 10 pages

While Assist-as-Needed (AAN) control aims to maximize user participation in robot-assisted training, existing methods relying solely on physical metrics cannot distinguish muscular inability from mental disengagement, leading to suboptimal interventions. To address this ambiguity, a Flow-theoretic multimodal AAN framework is proposed, fusing EEG-based mental engagement and sEMG-based physical engagement into an adaptive impedance control strategy. A four-quadrant fuzzy decision engine translates these dual physiological metrics into continuous control policies. This enables the upper-limb exoskeleton to inject feedforward assistance during intent-execution mismatch (e.g., motor output attenuation despite mental focus) and escalate guiding stiffness to penalize mental distraction. The framework was validated with healthy participants against a state-of-practice sEMG-only AAN baseline. Kinematically and mechanically, the proposed framework reduced robotic energy expenditure by 71.9\% while maintaining precise trajectory tracking, confirming it elicited greater voluntary human effort. Physiologically, the system increased the time spent in the neuroplasticity zone (Flow State Ratio) from 4.6% to 42.8%. These results validate that decoupling and jointly regulating mental and physical states enhances the selectivity of robotic assistance, mitigating user passivity and sustaining the engagement crucial for motor learning.

0.27

Levio: Smart Actuated Back-Exoskeleton via Retrofit of a Commercial Passive Device

cs.RO ·2026-11-17 ·Ionnais Kyriazis, Mohamed Irfan Refai, Herman van der Kooij
similarity 0.57
Abstract

Passive back exoskeletons show promising benefits for reducing occupational musculoskeletal disorders. However, their assistance cannot be modulated towards the task requirements. Active exoskeletons offer opportunities for pose-specific assistance, but, developing these systems from scratch for research can be time consuming. Therefore, here, we present an accelerated design pipeline that retrofits a Commercial Off-The-Shelf (COTS) passive back exoskeleton, Laevo Flex, with COTS actuation (CubeMars AK10-9) and sensing (IMUs and load-cell) paradigms. Levio was able to provide assistance based on the user's pose. Nine participants performed stoop lifting with the original Laevo and the retrofit Levio system, in transparent and assisted modes. Compared to Laevo, Levio modulated the assistance provided between the bending and lifting phases of the stoop task. The passive assistance offered by Laevo was $25.2 \pm 4.3$ Nm and $30.6 \pm 9.5$ Nm respectively during the bending and lifting phases of the stoop tasks. Levio reduced the resistive torque during bending to $17.9 \pm 4.6$ Nm and offered increased assistance of $37.7 \pm 6.4$ Nm during lifting. Moreover, participants reported higher usability scores and lowest mean global discomfort score while using the Levio when compared to Laevo. These benefits demonstrates retrofitting passive exoskeletons is a viable direction for rapid prototyping of wearable exoskeletons for lifting.

0.25

Subject-Specific Predictive Musculoskeletal Simulations of Lower-Limb Exoskeleton Assistance: Metabolic and Biomechanical Effects of Joint Assistance Strategies

cs.RO ·2026-10-02 ·Neethan Ratnakumar, Mariya Tohfafarosh, Xianlian Zhou
similarity 0.56
Abstract

Lower-limb exoskeletons have made considerable progress in reducing energy expenditure during walking. However, designing optimal assistance strategies remains challenging, particularly given inter-individual variability in anthropometry and biomechanics. This study explores energy-optimal lower-limb joint-assistance strategies using predictive simulations with musculoskeletal models. Subject-specific models of six able-bodied subjects, with BMI-based muscle strength scaling, were used in predictive simulations to generate gait at self-selected walking speeds. Ideal actuators were incorporated to simulate various combinations of joint assistance at peak levels of 25 Nm and 50 Nm to examine the effects of assistance on gait and metabolic savings. The effects of each assistance configuration were assessed through cost of transport (COT), joint kinematics, muscle activations, assistive torques, and joint-level power metrics to characterize the biomechanical and energetic impacts of different assistance strategies. At 50 Nm, combined H+K+A (hip-knee-ankle) assistance resulted in the greatest mean COT reduction of 48.50 +/- 4.55%, with individual reductions ranging from 42.22% to 54.65% across the subjects. Among single-joint conditions, assisting the hip was most effective, reducing COT by 31.77 +/- 5.21%; the knee and ankle produced smaller, comparable reductions (19.17% and 17.02%). H+A (hip-ankle) assistance (44.60 +/- 7.08%) emerged as the most effective two-joint assistive configuration. Increasing the torque bound increased positive assistive power primarily at the hip and ankle, while knee assistance showed little sensitivity and delivered positive power near pre-swing. These results support H+A assistance as an efficient two-actuator target, while identifying the knee's atypical pre-swing power strategy as a candidate for targeted experimental validation.

0.14

Adjustment control usability and dynamic accommodation in office chairs: A comparative study of two contemporary designs

cs.HC ·2026-11-02 ·Yejin Kang, Dusan Baek, Dongwoo Park, Kitae Hwang, Woojin Park
similarity 0.56
Abstract · 21 pages, 3 figures

Adjustability is a core determinant of ergonomic fit in office chairs, but its benefits depend on users being able to operate the controls and, on the chair, continuing to support the body as posture changes during work. We compared two high-end office chairs, the T90 (Sidiz; Chair A) and the Aeron (Herman Miller; Chair B), in two experiments to explore which design features may explain differences between them. In Experiment 1, 20 participants adjusted ten controls common to both chairs and rated perceived adjustment difficulty on four items. Chair A had significantly lower overall difficulty (Wilcoxon signed-rank test, p = 0.008), with control-level advantages for headrest angle, armrest height, armrest rotation angle and lumbar support position; Chair B was easier for seat height, possibly because its side-mounted lever is more visible than Chair A's underside button. The headrest comparisons involved a third-party headrest fitted to Chair B, and control- and item-level tests were not corrected for multiple comparisons. In Experiment 2, the same participants completed a 15-minute multi-device task requiring repeated posture changes, reach and reorientation, then rated body-part discomfort, general comfort and satisfaction with five components. Discomfort and comfort did not differ; Chair A had higher satisfaction for the seat-pan and lumbar support (exploratory, uncorrected). Interviews suggested links to mechanism properties: Chair B's rear lumbar dial was often described as producing little perceptible change, and for controls without significant differences each chair appeared to leave a different aspect of the same need unmet. These findings suggest mechanical and interface properties that designers of adjustable office chairs may consider for dynamic, multi-device work.

0.35

Attribution-Gated Joint Estimation of Intention and Capability for Assist-as-Needed Upper-Limb Robots

cs.RO ·2026-10-15 ·Pengcheng Li, Shuxiang Guo, Hanze Wang, Jun Leng, Bin Wang +1 more
similarity 0.55
Abstract · 31 pages, 7 figures

Assist-as-needed (AAN) control must distinguish between changes in intended motion and changes in effective voluntary torque capability, even though both can produce similar kinematic and interaction responses. A dual-measurand multimodal MHE-MPC architecture is developed as the base framework, in which the intended trajectory and the task-dependent effective voluntary torque capability are estimated online as distinct quantities, and both estimates are used to adapt robotic assistance. Building on this architecture, the ambiguity between the two update channels is formulated as a continuous credit-assignment problem and resolved by an attribution gate. A trajectory-change indicator is obtained from persistent corrective interaction, whereas a capability-change indicator is derived from the residual between normalized muscle activation and dynamics-reconstructed voluntary torque. Nine healthy participants completed factorial target-height-load trials and a pre-post fatigue cup-transport task. Without target-height input, the gated method generated correctly ordered Low-Middle-High references under every load: target changes were preferentially assigned to trajectory adaptation, whereas added load shifted adaptation toward the capability channel. It achieved the lowest RMSE in all nine conditions (0.017 rad versus 0.041 rad for ungated dual estimation and 0.127 rad for fixed-reference error-based AAN). Post-fatigue capability estimates decreased and assistance increased at all heights, supporting functional feasibility.

0.20

Externalizing Hand Grip Pressure Through Real-Time Visual Feedback

cs.HC ·2026-10-27 ·Andrew L. Huard, Avinash Ajit Nargund, Misha Sra
hot direction similarity 0.55
Abstract

Grip pressure, including contact force and its distribution across the hand, is central to skilled grasping but is not directly visible. This makes it difficult to teach, learn, and self-correct in grip-dependent motor tasks, where verbal instruction and tactile demonstration provide only partial guidance and no real-time, spatially resolved feedback tied to the learner's own grip. Using an instrumented glove, we compare pressure feedback visualizations for such guidance, evaluating how visualization type and, secondarily, sensor-region mapping shape pressure-matching performance in novices. In a study using baseball and table tennis as representative grip tasks (N=28), we find that a continuous gradient visualization produces significantly more accurate pressure matches and lower gaze entropy than a discrete bar display, despite participants perceiving the bar as more precise for pressure magnitude. Perceived precision and objective performance therefore diverged: the encoding participants judged more precise was not the one they matched more accurately with. Grip-tailored sensor-region mappings further reduced perceived temporal demand and effort, although this subjective workload advantage did not extend to objective matching accuracy. Overall, continuous pressure feedback supported more accurate grip matching and more concentrated viewing, and we present design considerations for real-time pressure feedback in motor skill guidance.

0.26

Enhancing Balance and Posture in Material Handling Tasks with a Wearable Robotic Tail

cs.RO ·2026-11-08 ·Eisa Anwar, Sajeeva Abeywardena, Stuart C. Miller, Ildar Farkhatdinov
similarity 0.55
Abstract · 16 Pages, 5 Figures

Frequent heavy lifting is linked to musculoskeletal strain, with lower back pain affecting up to 40% of manual labourers. Inspired by animals using tails for balance, we developed a wearable robotic tail as a dynamic counterbalance. Ten participants performed an imitated shelf loading/unloading task across three conditions: active tail, passive tail, and no tail. Kinematics, centre of pressure, and muscle activation (gastrocnemius, erector spinae, tibialis anterior, biceps brachii) were measured. Compared with no tail, the active tail achieved >20 mm reduction in centre of pressure peak displacement, 4.3 degree reduction in trunk motion, and >9% and >20% reductions in erector spinae and gastrocnemius activity, respectively. The passive tail produced smaller reductions, suggesting passive counterbalancing helps while active movement augments it further. Biceps brachii activation increased with the active versus passive tail. The ankle kinematics and tibialis anterior activation were unchanged. These findings support wearable robotic tails for improving balance during material handling.

0.39