CS Paper Radar

Ghost Target Elimination in 5G Reference Signals ISAC via Multi-static Multilateration

Ali Al Khansa, Sami Mekki

eess.SP ·submitted 2026-11-04 09:42 UTC · v1
benchmark

Abstract

Integrated Sensing and Communication (ISAC) systems can reuse 5G New Radio (NR) reference signals to enable joint communication and environmental sensing. Among these signals, the Positioning Reference Signal (PRS) is particularly suitable for range and Doppler estimation. However, its comb structure introduces periodic ambiguities that generate ghost targets. Existing solutions resolve these ambiguities by combining PRS with additional signals such as the DeModulation Reference Signal (DMRS), which increases sensing overhead. This paper proposes a PRS-only sensing framework that resolves ambiguities using multi-static observations. Instead of removing ghosts locally at each receiver, the proposed method exploits spatial diversity and performs ambiguity resolution at a fusion anchor. The anchor jointly estimates target locations and ambiguity indices via multilateration across multiple sensing nodes. This approach eliminates the need for additional reference signals while maintaining low receiver complexity. Simulation results show that the proposed method reliably resolves ghost targets and achieves superior detection performance compared to benchmark methods across various scenarios, while significantly enhancing resource efficiency by enabling sensing using PRS-only transmissions.

Closest papers

Nearest neighbours by meaning across the whole index.

Ambiguity Elimination via Successive Estimation in ISAC Systems with Reference Signals

eess.SP ·2026-11-04 ·Ali Al Khansa, Sami Mekki, Giyyarpuram Madhusudan
published similarity 0.87
Abstract

Integrated sensing and communication (ISAC) systems can efficiently reuse 5G New Radio (NR) reference signals to enable joint communication and passive target detection. Among these, the Positioning Reference Signal (PRS) is widely adopted for high-performance sensing activities. However, the PRS configuration, given by the comb structure, introduces periodic ambiguities, resulting in ghost targets. Existing approaches mitigate this issue by combining PRS with additional reference signals, such as the DeModulation Reference Signal (DMRS), effectively removing ghosts but at the cost of higher complexity and sensing overhead. This paper proposes a low-complexity successive estimation strategy that initially allows ghost targets but progressively eliminates them using historical ambiguity-free estimations. The method comprises a matching process to associate current detections with historical real targets, and a pattern deviation detection mechanism to trigger a fallback to ambiguity-free estimation when the target set changes. We derive a sufficient condition that guarantees the correct matching as a function of target velocity, PRS comb size, subcarrier spacing, and sensing refresh rate. Using this condition, a parameter selection strategy is proposed to jointly improve sensing and communication performance. Numerical results demonstrate that our method achieves unambiguous detection while significantly reducing sensing resources, thus releasing more resources for communication compared to State-of-the-Art (SotA) approaches.

0.49

Joint Target-Tag Estimation in Ambient Backscatter-Based ISAC

eess.SP ·2026-10-04 ·Awadhesh Gupta, Kumar Vijay Mishra, Naveen K. D. Venkategowda, Aditya K. Jagannatham
top venuetheory similarity 0.61
Abstract

Integrated sensing and communication (ISAC) has emerged as a key paradigm for unifying radar sensing and wireless communications within a shared hardware and spectral framework. In parallel, ambient backscatter communication (AmBC) has gained attention as a low-power solution for enabling passive connectivity by modulating and reflecting existing radio-frequency signals. Motivated by these developments, this paper investigates an integrated sensing and ambient backscatter communication (ISABC) framework in which a dual-functional radar-communication (DFRC) transceiver jointly performs high-resolution target sensing and low-power tag detection in cluttered environments. Within this ISAC and AmBC setting, we develop a comprehensive system model that jointly captures the estimation of target and clutter parameters, including delay, Doppler shift, and complex reflectivity, together with the recovery of embedded AmBC tag symbols. The resulting DFRC signal model reveals strong coupling among direct-path reflections, clutter echoes, and passive backscatter signals, leading to a highly entangled estimation problem. To address this challenge, we propose a robust three-stage signal processing framework that sequentially estimates target and clutter parameters before detecting the AmBC tag message. This structured approach effectively disentangles the superimposed components, improving both sensing accuracy and communication reliability in ISAC systems. Extensive simulations, benchmarked against the Cramer-Rao lower bound (CRLB), demonstrate the superior estimation performance of the proposed DFRC-based solution. The results further highlight the fundamental trade-offs between sensing accuracy and backscatter communication efficiency in ISABC systems.

0.42

Practical Hardware-Efficient ISAC: Enabling Multi-Target Sensing With Few RF Chains

eess.SP ·2026-10-12 ·Zhenkun Zhang, Cunhua Pan, Hong Ren, Jun Tang, Dongming Wang +1 more
theory similarity 0.61
Abstract

Hybrid analog--digital arrays reduce hardware cost in integrated sensing and communications (ISAC), but spatial compression and beam-dependent scan responses complicate multi-target estimation with few radio-frequency (RF) chains. To address these challenges, this paper proposes a burst beam-scanning multiple-input multiple-output orthogonal frequency-division multiplexing (MIMO-OFDM) framework that reuses downlink reference signals for joint range, radial-velocity, elevation, and azimuth estimation. Specifically, a structured global--local dual-tensor estimator separates targets by using scanning observations and refines their parameters from selected-beam RF-chain responses, with delay--Doppler signatures maintaining cross-stage target correspondence. The recovered subarray responses yield closed-form elevation and azimuth estimates through exact sum--difference relations, avoiding small-angle approximations and fine angular grid searches. To further improve Doppler accuracy, spatial-mask-aided weighted least squares exploits the longer inter-burst temporal aperture while resolving phase ambiguity using intra-burst estimates. The joint multi-target Cramér--Rao lower bound (CRLB) and corresponding three-dimensional (3D) positioning bound are also derived to characterize estimation performance. Simulation results show that the proposed scheme achieves near-CRLB estimation accuracy at high transmit powers and centimeter- to millimeter-level 3D positioning with only four RF chains, while maintaining low computational cost.

0.12

VISTA: View-Independent micro-Doppler Reconstruction with Multistatic ISAC

cs.AR ·2026-11-11 ·Jacopo Pegoraro, Marco Canil, Aurora Peloso, Jesus O. Lacruz, Xitao Gong +3 more
published similarity 0.61
Abstract · Accepted to be presented in the IEEE ISAC 2026 conference

The micro-Doppler (uD) spectrum provides detailed characteristics of target movement, making it highly valuable for applications such as target classification and human activity recognition. However, traditional Integrated Sensing And Communication (ISAC) systems are highly view-dependent and limited by blind spots and angle dependencies. Existing approaches rely on either configuration-specific solutions or data-driven models. The former results in poor generalization when device deployments or target orientations change, while the latter requires acquiring extensive multi-view datasets, which is time-consuming and not always feasible. To address these limitations, in this work we propose VISTA, a novel method for reconstructing the uD spectrogram in an absolute coordinate frame, yielding view-independent Doppler features that are invariant to the spatial distribution of ISAC nodes. We formulate the uD estimation as a sparse reconstruction problem that jointly leverages measurements from all ISAC receivers. This is solved using a modified Orthogonal Matching Pursuit (OMP) algorithm, which iteratively alternates between jointly selecting candidate velocity vectors across all receivers (RXs) and independently estimating the complex channel gain amplitudes for each RX. Our results show that, provided sufficient spatial diversity, VISTA successfully reconstructs the targets' absolute uD spectrograms with a median error \leq 0.69 m/s for speeds \leq 15 m/s.

0.36

Delay-Doppler Sensing Performance Analysis for MIMO-OFDM ISAC Systems

eess.SP ·2026-09-01 ·Peishi Li, Rang Liu, Qian Liu, Ming Li
published similarity 0.60
Abstract · Accepted by IEEE Globecom 2026

In communication-centric integrated sensing and communication (ISAC), delay-Doppler sensing reuses data-bearing orthogonal frequency division multiplexing (OFDM) signals rather than dedicated radar probing waveforms. Consequently, the resulting range-Doppler map (RDM) is shaped not only by target parameters, but also by communication-symbol randomness and, in multi-antenna transmissions, by spatial beamforming. While existing analyses have largely focused on single-antenna OFDM-ISAC, the delay-Doppler sensing behavior of multi-antenna OFDM-ISAC remains insufficiently understood. This paper analyzes a multi-input multi-output (MIMO)-OFDM-ISAC system in which multiple data streams jointly illuminate a sensing target. We derive second-order moment expressions for the RDM under matched filtering (MF) and reciprocal filtering (RF), and use them to characterize the dynamic range (DR). The analysis reveals two key multi-stream effects. First, under MF, the random superposition of multiple beamformed streams creates an additional RDM floor beyond the modulation-dependent and receiver-noise terms; therefore, constant-modulus signaling no longer eliminates the data-induced pedestal as in single-antenna OFDM-ISAC. Second, under RF, the matched-angle data-induced floor is removed, but the noise floor is amplified according to the reciprocal-power statistics of the beamformed target illumination. These results show that the user-target angular geometry directly governs the MF/RF tradeoff: MF is more robust under weak illumination, whereas RF can achieve a higher DR when reciprocal-noise amplification is mild. Numerical results validate the analysis and demonstrate the distinct geometry-dependent behaviors of MF and RF.

0.14

Fourth-Order Co-Channel Interference-Aware OFDM-ISAC Sensing in Cluttered Environments

eess.SP ·2026-09-12 ·Tri Nhu Do, Yosefine Triwidyastuti, Gunes Karabulut Kurt
similarity 0.59
Abstract

In this paper, we develop a sensing-centric receiver for monostatic orthogonal frequency-division multiplexing integrated sensing and communication (OFDM-ISAC) in the simultaneous presence of passive clutter and a non-cooperative co-channel OFDM transmitter. We show that removing the known ISAC symbols maps target and clutter echoes to deterministic delay-Doppler components, while the non-cooperative waveform remains a random, non-Gaussian, generically full-rank residual. Guided by this distinction, we combine moving-target indication for zero-Doppler clutter with a centered diagonal fourth-order statistic for interference identification. To obtain an unbiased fourth-order estimate from phase-aligned proper snapshots, we derive additive and multiplicative finite-sample bias corrections and pair the corrected statistic with a second-order moment to separate interference from Gaussian noise. Fourth order provides identification and presence testing, whereas second order provides the diagonal disturbance-power proxy used for weighting. We further introduce diagonally loaded weights that enforce a range-Doppler aperture-efficiency floor. Simulations show that the interference estimate approaches its theoretical profile as coherent support grows and remains insensitive to deterministic echoes, that the presence test resolves interference well below the level at which weighting matters, and that loaded processing improves target detection while controlling point-spread-function degradation.

0.08

Reliable Doppler Estimation in Asynchronous Moving ISAC Devices via IMU Integration

eess.SP ·2026-09-30 ·Zaman Bhalli, Jacopo Pegoraro, Gianmaria Ventura, Paolo Casari, Michele Rossi
similarity 0.59
Abstract · 6 pages, 5 figures. Submitted to IEEE VTC2027-Spring

We present an Integrated Sensing And Communication (ISAC) framework for the joint estimation of the Doppler frequency of a passive mobile target in a bistatic scenario with clock-asynchronous nodes and where the Receiver (RX) is static but the Transmitter (TX) is mobile. In such a setup, previous geometric solutions are integrated with an Inertial Measurement Unit (IMU) device at the TX, coming up with a truly joint data fusion and estimation algorithm based on extended Kalman filtering. The approach jointly estimates the target Doppler frequency, along with the speed and direction of motion of the TX and it is robust to the unavailability of static paths between the TX and RX pair, a condition that makes previous solutions ineffective. The developed extended Kalman filter strikes a balance between the accuracy of ISAC and the IMU reliability. The proposed solution is validated via numerical simulations, obtaining a median Doppler error of 1.2% with a smartphone-grade IMU under realistic operating conditions.

0.36

Performance Evaluation of Mobile Target Sensing and Tracking Across Multiple Sensing Modes

eess.SP ·2026-10-10 ·Necati Kagan Erkek, Marco Di Renzo, Arman Shojaeifard, Kunjan Shah, Mohammad Heggo +1 more
similarity 0.59
Abstract

Moving extended-target sensing and tracking are studied in a beamformed PRS/OFDM ISAC framework. The target is modeled as a rigid cluster of scatterers whose Tx--target--Rx echoes coherently combine in a MIMO scattering channel. Delay, azimuth/elevation, and Doppler are estimated using PRS matched filtering with delay centroiding, single-cluster 2D-MUSIC, and FFT-based Doppler estimation, then used for independent localization and EKF-based tracking. The framework is evaluated in monostatic and bistatic modes under target-directed, receiver-directed, and omnidirectional beamforming. Simulation results show that EKF tracking reduces the aggregate 3D RMSE from 1.61 m to 1.38 m relative to independent localization. Target-directed beamforming substantially improves tracking accuracy, achieving 1.38 m RMSE compared with 5.91 m and 8.38 m for omnidirectional and receiver-directed beamforming, respectively. The results highlight the importance of target-aware beam management, delay-angle-Doppler fusion, and sensing geometry for mobile-target tracking in ISAC networks.

0.35