CS Paper Radar

Gain-Dependent Entropy Characterization of a Zener Avalanche Noise TRNG via Dual NIST Standards: Toward Low-Cost Hardware Entropy for ICS Deployments

Rishabh Das

cs.CR cs.AR ·submitted 2026-11-05 22:51 UTC · v1
unusual

Abstract

True random number generators based on Zener avalanche noise offer a low-cost entropy source for industrial control system and IoT edge devices, yet the relationship between amplifier gain, coupling capacitance, and entropy quality remains uncharacterized under current NIST standards. This paper presents a comprehensive entropy assessment of an op-amp-based Zener avalanche noise generator across five gain configurations and two coupling capacitor values, evaluated against the NIST SP 800-22 statistical test suite and the SP~800-90B entropy source assessment using 1.44 billion raw bits per configuration. We identify a three-phase autocorrelation structure, attributed to comparator saturation-recovery dynamics, consistent across all gain settings. A direct-current substitution experiment, replacing the Zener diode with a stable voltage source at the same bias point, reduces switching activity by approximately 97%, confirming that Zener avalanche noise, rather than amplifier self-excitation, is the necessary entropy source. The coupling capacitor is further shown to govern comparator overdrive and entropy quality independent of this source mechanism, with the smaller capacitance improving entropy, throughput, and bias. The combined results identify an optimal gain configuration achieving a perfect statistical test score, NIST-compliant min-entropy, and peak entropy throughput at a bill-of-materials cost under five dollars, offering practical design guidance for low-cost entropy sources in industrial and embedded deployments.

Closest papers

Nearest neighbours by meaning across the whole index.

Self-Referenced Diagnosis of SPAD Dark-Count-Rate Switching for Quantum Communication Receivers

cs.ET ·2026-10-27 ·Yu Luo, Lina Pu, Yaroslav Koshka, Chun-Hung Liu, Junming Diao
unusual similarity 0.49
Abstract · 13 pages, 12 figures

Single-photon avalanche diodes (SPADs) are essential components of quantum communication receivers. In practical systems, some SPADs exhibit intrinsic step-like changes in dark-count rate (DCR), commonly referred to as random telegraph signal (RTS) noise. Similar RTS-like variations, however, can also arise from stray light, temperature-dependent threshold crossings, cable disturbances, electrical interference, and other readout artifacts. Distinguishing intrinsic RTS from these artifacts is important because they originate from different mechanisms and require different corrective actions. We present a self-referenced diagnostic that primarily uses the low-to-high afterpulse-yield ratio R, together with complementary checks based on DCR-state reproducibility, cross-channel behavior, and event timing. Four commercial SPAD modules were monitored in darkness for more than 920 h. Three exhibited intrinsic DCR switching of 44.59%, 19.33%, and 2.77%, with corresponding R values of $0.9996\pm0.0027$, $1.0050\pm0.0023$, and $1.0027\pm0.0043$, all consistent with unity. Controlled experiments reproduced temperature-related threshold crossings, light leakage, cable-contact artifacts, and artificial electrical injection. These artifacts produced distinct correlation and timing signatures: temperature-related threshold crossings gave intermediate pair-survival responses, cable disturbances and electrical injection generated sub-dead-time events, while light leakage produced simultaneous cross-channel switching and nonreproducible DCR levels. Combining R with orthogonal timing and DCR-based checks provides a practical self-referenced diagnostic framework for distinguishing intrinsic RTS from non-intrinsic artifacts using primarily time-tagged dark-count data.

0.30

Implementation and Validation of Mismatch-Tolerant High-Gain OTA with a Calibrated Negative Conductance Load

eess.SP ·2026-10-29 ·Mayank Aggarwal, Naveen Kadayinti
similarity 0.44
Abstract · 6 pages, 13 figures

This paper presents the circuit-level implementation of a mismatch-tolerant high-gain operational transconductance amplifier (OTA) using automatic negative-conductance calibration in 65-nm CMOS. The technique enhances OTA gain by compensating for its finite output conductance using a cross-coupled transistor pair, with an on-chip calibration loop that eliminates the need for a replica circuit or external tuning. The calibration routine increases the gain by driving the steady state error of the OTA in a unity gain feedback loop toward zero. The implementation addresses practical challenges involving comparator offset, DAC design, and subtractor gain and offset. A 6-bit capacitive DAC (CDAC)-based comparator offset calibration scheme enables reliable detection of the sub-millivolt steady state error required for high OTA gain. Post-layout Monte Carlo simulations show that the comparator offset standard deviation is reduced from 4.11 mV to 132 $μ$V, with a maximum observed post-calibration offset of 625 $μ$V. The complete calibration circuitry is implemented and evaluated through post-layout simulations.

0.32

Neuromorphic Pseudo-Random Number Generators with a Low Power Hardware Implementation

cs.NE q-bio.NC ·2026-09-30 ·Jafar Shamsi, Navid Akbari, Sonia Sennik, Aaron Gruber, Wilten Nicola
similarity 0.44
Abstract · 33 pages, 3 figures

Pseudo-random number generation often requires trade-offs among quality, power consumption, and bandwidth to produce unpredictable sequences of numbers. The brain, on the other hand, efficiently generates unpredictable output complex network dynamics occurring in a high-dimensional state. This state, which is hypothesized to be chaotic, relies on the balance between excitation and inhibition. Here, we investigated if computational models of these chaotic balanced states can be harnessed for Neuromorphic Pseudo-Random Number Generators (NPRNGs) in low power hardware. We successfully constructed a balanced spiking neural network model consisting of leaky-integrate-and-fire neurons that could be readily implemented in low power FPGAs and used as a NPRNG. The prototyped NPRNG consumed 3.24 mW during operation and produced pseudo-random numbers at 120kbps. In both hardware and software instantiations, NPRNGs produce high-quality random numbers as validated by standard metrics for testing RNG quality.

0.21

NOVA-CIM: Noise- and Correlation-Tolerant Stochastic Interfaces for Analog Compute-in-Memory

cs.AR ·2026-09-07 ·Jiachen Ren, Wenshuai Yao, Haobo Liu, Xincheng Feng, Chenxi Hu +4 more
similarity 0.43
Abstract

Analog compute-in-memory (CIM) enables energy-efficient model acceleration, but its reliance on ADC-based readout, which directly quantizes noisy column currents, makes inference accuracy highly sensitive to analog read noise, active-row scaling, and ADC precision. In this paper, we present NOVA-CIM, a noise- and correlation-tolerant stochastic interface for analog CIM by replacing multi-bit ADC readout with random-reference 1-bit sensing and reconstructing results through lightweight counting. By converting column currents into comparison probabilities, this probability-domain readout averages zero-mean dynamic read noise over stochastic samples while reducing dependence on high-resolution ADCs. We provide a unified robustness analysis showing that dynamic read noise is suppressed through temporal averaging and that spatial input-bitstream correlation increases instantaneous current variance rather than introducing first-order MAC bias. MAC-level experiments and end-to-end evaluation on ViT-Base validate the analysis: under read noise, Top-1 accuracy remains 84.48% near the 84.51% bfloat16 (BF16) baseline; under stochastic number generator (SNG) reuse, MAC bias stays near zero while root-mean-square error (RMSE) and stochastic cross-correlation (SCC) grow as predicted.

0.17

Event-triggered Implicit Perturbation for Zeroth-Order Fine-Tuning of Spiking Transformers

cs.AR cs.LGcs.NE ·2026-08-21 ·Tengteng Lei, Prabodh Katti, Rashi Dutt, Houssem Sifaou, Tan Peng +3 more
similarity 0.42
Abstract

Zeroth-order (ZO) optimization estimates gradients using only forward-pass evaluations, making it suitable for fine-tuning non-differentiable, event-driven spiking neural networks (SNNs). However, its deployment on in-memory computing (IMC) accelerators is constrained by the repeated read-modify-write (RMW) operations arising from explicit weight perturbation and the prohibitive hardware footprint of random number generators (RNGs) for statistically independent per-weight perturbations. To address these challenges, we propose an implicit-perturbation ZO (IPZO) architecture in which perturbation sums computed by an event-triggered perturbation generation unit (PGU) are combined with the weighted sums produced by the IMC array, eliminating perturbation-induced RMW operations while preserving weight-stationary execution of IMC. By exploiting spike sparsity, the PGU generates and accumulates perturbation contributions only for spike-activated weight rows, reducing the required row dimension of the RNG array. An address-driven XOR recombination scheme (PGU-XOR) is further introduced to mitigate the spatial correlations caused by direct RNG reuse (PGU-Reuse). The results show that (1) PGU-XOR matches software RNGs in accuracy on Spikingformer/CIFAR-10 (76.41% vs. 76.53%) and perplexity (PPL) on SpikeGPT/WikiText-2 (54.20 vs. 53.23), whereas PGU-Reuse degrades accuracy by 9.56 percentage points and increases PPL by 11.8; (2) implemented in a TSMC 16-nm CMOS technology, PGU-XOR incurs 40.3%-46.0% area and 15.2%-48.9% energy overhead per matrix-vector multiplication relative to PGU-Reuse, yet its faster convergence reduces the total perturbation energy to 0.51x that of PGU-Reuse at iso-accuracy; (3) IPZO reduces the perturbation energy to 0.46x-0.83x that of conventional explicit weight perturbation for a batch size of B=64 and T=4 time steps, with the advantage growing as BT decreases.

0.14

Toward Partitioned Reference Readout for Four-Level IGZO Memory: Device Statistics, Confusion Matrices, and INT4 Error Propagation

cs.ET ·2026-10-12 ·Huiyun Li
similarity 0.41
Abstract · 10 pages, 6 figures

Four-level indium-gallium-zinc oxide (IGZO) 2T0C memory needs reliable state formation, sensing references, and a path from cell errors to digital weights. We analyze 107 measured DC transfer curves from 37 isolated IGZO transistors (W/L = 3/0.5 micrometers). Four gate-bias operating points inferred from the first sweep are evaluated on later sweeps of 35 devices. Device-resolved operating points reduce second-sweep across-device current standard deviation by 49.4-52.4%, yet retaining initial thresholds increases misclassified points from 37/140 to 55/140. Leave-one-device-out reference estimation gives 0/140 on the second sweep; freezing second-sweep thresholds yields 6/140 on the third. Sampling eight reference transistors on the third sweep gives a mean held-out error fraction of 0.15% over 2,000 selections, versus 4.33% with frozen thresholds on matched held-out devices. We present conditional confusion matrices, a counterfactual common-gain sensitivity, and an INT4 error-propagation proxy. A simultaneous four-state bank with eight reference cells per state requires at least 32 physical reference cells, 12.5% of a proposed 256-cell data bank before peripheral overhead. A charge-conservation model and a partitioned hierarchical error model specify the pulse, retention, and array measurements needed to test transfer from DC device statistics to pulsed 2T0C operation.

0.30

Burst-mode timing recovery based on fourth-power phase detector for passive optical networks

cs.NI ·2026-09-14 ·Ji Zhou, Haide Wang, Xiaofeng Zhang, Zhiyang Liu, Miao Yu +3 more
publishedunusual similarity 0.41
Abstract

Driven by the ever-increasing capacity demands, 50G passive optical network (50G-PON) is ready for practical application. It is highly challenging to realize 50GHz burst-mode analog components; therefore, based on 25GHz burst-mode analog devices, burst-mode digital signal processing (DSP) is introduced to achieve the reception and processing of 50Gb/s on-off keying burst signals. To optimize the power consumption and area of the DSP chip, a one-sample-per-symbol (1-SPS) analog-to-digital converter has been applied in 50G-PON. One of the main challenges is implementing burst-mode timing recovery (BM-TR) for the 1-SPS burst signal in 50G-PON. In this paper, we first propose a BM-TR based on the fourth-power phase detector (4PPD) for 50G-PON. We mathematically verify that 4PPD can directly compute the timing phase offset (TPO) from the 1-SPS signal without using training sequences, allowing for immediate BM-TR initialization within 20 cycles to prevent long convergence times. After the initialization, the feedback loop structure tracks the TPO changes based on the sign of 4PPD, the loop filter, and the numerically controlled oscillator. In conclusion, training-sequence-free 4PPD-based BM-TR achieves low burst overhead via fast convergence and is particularly effective for handling burst signals in 50G-PON.

0.37

S-ALSA: Co-Design of Adiabatic Logic-based Sensing and Balanced Bit-Cells for Secure and Energy-Efficient MRAM

cs.AR ·2026-09-27 ·Wu Yang, Amit Degada, Himanshu Thapliyal
similarity 0.40
Abstract · 6 pages; 2026 IEEE Computer Society Annual Symposium on VLSI, July 2026

Magnetoresistive Random Access Memory (MRAM) technologies such as Spin-Transfer Torque (STT-MRAM) and Spin-Orbit Torque assisted (SOT-STT-MRAM) offer nonvolatility and low leakage, making them attractive for IoT systems. However, conventional MRAM read circuits face two fundamental challenges: high dynamic energy consumption and vulnerability to side-channel attacks caused by data-dependent current variations in Magnetic Tunnel Junctions (MTJs). This paper presents a Secured Adiabatic Logic Sense Amplifier (SALSA) that addresses both challenges simultaneously through circuit-device co-design. S-ALSA combines structural current balancing via a 4T-2MTJ bit cell, which eliminates read current asymmetry at the storage level, with dynamic power equalization via adiabatic charge recovery in the sensing circuit. The proposed architecture supports both STT-MRAM and SOT-STT-MRAM. Case studies using 4x4 MRAM macros shows up to 80% energy savings over conventional Pre-Charge Sense Amplifiers (PCSA) across IoT frequencies. Correlation Power Analysis (CPA) attacks on PRESENT-80 encryption confirm complete suppression of key leakage when S-ALSA is combined with a balanced bit cell. This work establishes a unified framework where energy efficiency and hardware security are achieved simultaneously, enabling secure and low-power IoT memory design.

0.26