CS Paper Radar

Highly Scalable Selectorless Cryogenic Memory Array Using Ferroelectric Josephson Field-Effect Transistors

Saheeb Ahmad, Shamiul Alam

cs.ET ·submitted 2026-09-25 01:24 UTC · v1

Abstract

Scalable memory systems that satisfy the temperature, speed, and energy requirements of cryogenic environments are essential for the development of large-scale quantum computers. They may also benefit high-performance computing and space applications. However, existing cryogenic memory technologies often suffer from limited scalability, low operating speed, and/or high power consumption, restricting the scalability of target applications. Ferroelectric Josephson field-effect transistors (Fe-JoFETs), which combine ferroelectric polarization with the superconducting properties of Josephson junctions, offer a promising solution. The ferroelectric layer enables nonvolatile storage capability, while the Josephson junction supports high-speed, energy-efficient operations. In this work, we leverage Fe-JoFETs to develop a highly scalable, ultra-low-power, nonvolatile cryogenic memory array that does not need additional selector devices for random access. Moreover, the superconducting component of Fe-JoFET provides a binary decision during read, eliminating the need for sensing peripheral circuitry. We first develop a physics-based Verilog-A compact model for Fe-JoFETs and use it to verify the functionality of the proposed memory array. By eliminating both selector and sensing circuitry, the proposed memory architecture offers higher scalability than existing technologies. The ultra-low-power operation of this memory also makes it compatible with strict power budgets of cryogenic applications.

Comment
8 pages, 4 Figures, 1 Table

Closest papers

Nearest neighbours by meaning across the whole index.

JFS-CryoMem: A Cryogenic Memory with Voltage-Controlled Superconducting Devices and Femtojoule-Scale Write/Read Energies

cs.ET cond-mat.supr-con ·2026-09-27 ·Md Rahatul Islam Udoy, Md Mazharul Islam, Juan P. Mendez, Denis Mamaluy, Aaron J. Muhowski +5 more
similarity 0.83
Abstract

Scalable cryogenic systems require memory that combines nonvolatile storage, selective access, low thermal disturbance, and compatibility with superconducting electronics. We present a cryogenic memory architecture that integrates a voltage-controlled Josephson junction field-effect transistor (JJFET) selector with a ferroelectric superconducting quantum interference device (FeSQUID) storage element, hereafter termed JFS-CryoMem. The JJFET provides gate-controlled cell selection, whereas the FeSQUID stores information in stable remanent-polarization states. JFS-CryoMem features separate read and write path mechanisms that support nondestructive readout and independent optimization of programming and sensing conditions. The architecture is evaluated using experimentally calibrated compact models that reproduce the measured electrical characteristics of both constituent devices. We demonstrate selective programming using a half-bias scheme, nonvolatile state retention, and distinguishable readout in a $4 \times 4$ array while accounting for the selected cell and all unselected parallel branches. We then extend the analysis to arrays up to $16 \times 16$ and examine how array scaling alters current distribution, column-equivalent resistance, readout separation, required bitline current, and read energy. The results reveal the principal sensing and energy tradeoffs associated with larger arrays and identify the operating conditions required to preserve read distinguishability as the array grows. JFS-CryoMem provides a device-to-array framework for cryogenic memory in quantum, high-performance, and space-oriented computing systems.

0.16

An Emerging NVM-Based On-Chip Training Architecture with Non-Ideality Mitigation Through Bipolar Weight Distributions

cs.AR ·2026-09-01 ·Peng Dang, Youna Huang, Yintao He, Huawei Li
top venuebenchmark similarity 0.55
Abstract · 14 pages. Accepted for publication in IEEE Transactions on Very Large Scale Integration (VLSI) Systems

The rapid advancement of deep learning has presented significant energy efficiency challenges to the conventional von Neumann architecture. In-memory computing (IMC) architectures based on emerging non-volatile memory (eNVM) are widely regarded as a promising solution for accelerating neural network training due to their high parallelism and low power consumption. However, the intrinsic non-idealities of eNVM devices can cause conductance updates to deviate from target values, thereby limiting the performance of on-chip training. To address this challenge, this paper presents a Non-ideality Optimized eNVM Accelerator (NOVA) architecture for on-chip training. Specifically, we first fabricate a two-dimensional (2D) ferroelectric field-effect transistor (FeFET) and develop a conductance modulation behavioral model calibrated with experimental data. Building upon this device model, we propose, for the first time, a Non-ideality Avoidance Training (NAT) algorithm tailored for eNVM devices, which mitigates accuracy degradation by guiding weight convergence toward the most stable conductance regions of eNVM devices. Experimental results demonstrate that, even under severe device asymmetry, NAT improves the accuracy by an average of 15.1\% over the baseline methods across multiple benchmark tasks. Meanwhile, the NOVA achieves an average energy efficiency gain of approximately 33.58$\times$ compared with the peak energy efficiency of graphics processing units (GPUs).

0.69

Duplication-Aware Retiming and Cell Interface Redesign for Superconductor Circuit Minimization

cs.ET cs.AR ·2026-10-01 ·Panagiotis Papanikolaou, Alex Vanasse, Haoran Jin, Georgios Tzimpragos, Jennifer Volk
published similarity 0.53
Abstract

Superconductor electronics have increasingly shifted away from RSFQ and its variants toward logic families that eliminate explicit gate-level clocking. While this transition enables simpler circuits and more efficient architectures, it also introduces an implicit reliance on dual-rail codes, resulting in inherent gate duplication. This work presents a duplication-aware retiming methodology for Josephson junction (JJ) count minimization, co-optimizing register placement and polarity assignment. The approach applies beyond SFQ to any monotonic circuit. We further identify cell interfaces---specifically, interconnect drivers, receivers, and fanout (FO) elements---as dominant contributors to JJ count in each cell. A new amplifier design is introduced to reduce these costs, integrated within existing SFQ cells, experimentally verified, and characterized to form a new SFQ cell library. Our results demonstrate a 63-71% JJ count reduction in single-cycle implementations and 41-66% reduction in multi-cycle implementations compared to the prior state-of-the-art. The latter establishes a new Pareto frontier, achieving both shorter critical paths and lower JJ counts than the best-to-date single-cycle implementations.

0.36

Cryogenic Recharacterization of a Commercial 22 nm FD-SOI Foundry Standard-Cell Library

cs.AR quant-ph ·2026-10-18 ·Mohamed Gharib, Rami Rasheedi, Salma Abdelzaher, Henry Shi, Mike Hammer +4 more
similarity 0.53
Abstract · Submitted to the 2027 IEEE International Symposium on Circuits and Systems (ISCAS 2027)

Wiring and bandwidth bottlenecks between a quantum processor and room-temperature electronics can be reduced by placing digital control at the cryogenic stage, but commercial foundry standard-cell libraries are not specified for operation at 4 K. A cryogenic recharacterization flow is therefore developed for a commercial 22 nm FD-SOI foundry standard-cell library using commercially available cryogenic compact-device models, while retaining the original cell circuits, layouts, logic functions, and implementation semantics and remaining compatible with the commercial synthesis, place-and-route, and signoff methodology used at room temperature. Body-bias dependence is quantified over 38,640 matched slew/load points at zero, +/-0.9 V, and +/-1.8 V body bias. Relative to full bias, zero-bias operation increases the median rising and falling delays by 38.6x and 33.0x, while approximately 90% of transitions exceed the foundry-defined maximum-transition envelope. The 0.8 V-to-0.4 V level shifter is even more sensitive to body bias: its worst-case falling delay decreases from 30.6 ns at zero bias to 0.56 ns at +/-1.8 V. For the outbound 0.4 V-to-0.8 V crossing, driving the 0.8 V receiver without a level shifter dissipates 57.7 uW of static power per bit at full bias, against 0.196 nW when level-shifted. In post-route analysis of the unchanged extracted physical database of a fabricated 32-bit ALU, the register-to-register setup boundary increases from 1.3 MHz at zero bias to 37.9 MHz at +/-0.9 V and 132.9 MHz at +/-1.8 V.

0.51

Stateless Stochastic Computing for Generative AI on Superconducting Logic: A Model-Hardware Co-Design

cs.AR cs.ET ·2026-10-11 ·Mehdi Kamal, Massoud Pedram
similarity 0.52
Abstract

Thermodynamic computing lets stochastic physical dynamics carry out a computation and reads out the result as a time average. Recently, thermodynamic computing has been demonstrated on several hardware platforms, including digital CMOS circuits based on stochastic computing. Superconducting single-flux-quantum (SFQ) logic offers very high clock rates and very low switching energy, but it heavily penalizes state, memory, fan-out, and feedback, i.e., exactly the per-neuron accumulators on which such designs rely. We therefore realize thermodynamic computing in SFQ logic through a co-design of a generative model and its circuit in which the datapath holds no state at all. The model is a class-conditional flow-matching image generator, which transforms Gaussian noise into an image of the requested class along a short, deterministic path of four Euler steps; in hardware, these steps are unrolled into a feed-forward pipeline of stochastic bitstream operators, whose output is read out as a time average, as in thermodynamic computing, without any relaxation phase. Each layer of the model is a butterfly-factorized linear map built exclusively from multiplexers that operate on split-unipolar bitstreams. The ReLU activation, which in stochastic computing requires a per-neuron up/down counter (accounting for 60-70% of the JJs in a counter-based design), is replaced by a stateless AND-NOT gate whose one-clock input skew is provided at no cost by SFQ gate-level pipelining. The models are trained directly on the stream representation of the hardware, with a regularizer that bounds the stream gains. Synthesis with an SFQ design flow shows that stochastic streams tolerate relaxed path balancing, which reduces the Josephson-junction (JJ) count of a hard-wired stage by 40-47%.

0.21

Architecting Instruction Execution for Scalable Fault-Tolerant Quantum Computing

cs.ET quant-ph ·2026-10-12 ·Dmitry Filippov, Justin Hogaboam, Mathias Soeken, Raghu Gatta, Prakash Murali +1 more
published similarity 0.50
Abstract · Published in IISWC 2026

Scaling fault-tolerant quantum computing (FTQC) requires orchestrating millions of operations continuously across a tightly coupled classical-quantum control stack. A critical challenge in this orchestration is determining the optimal hardware-software boundary, i.e., the Quantum Instruction Set Architecture (QISA). We focus on cryogenic, fixed-connectivity qubit platforms, such as superconducting and topological Majorana qubits. For these, existing QISA choices either operate at too low a level, violating cryogenic thermal budgets at scale, or at too high a level, imposing unrealizable complexity on the control engine. To reason about these tradeoffs, we introduce the ARIES instruction set hierarchy, which categorizes QISAs into distinct abstraction levels. To systematically evaluate these levels, we develop an end-to-end evaluation toolflow featuring a cycle-accurate classical driver and hardware engine simulator. Using eight quantum applications across superconducting and topological qubit platforms, we measure instruction bandwidth, transceiver power dissipation, and measurement processing overheads. We demonstrate that while physical-level abstractions exceed the thermal limits of dilution refrigerators by orders of magnitude, canonical-level abstractions significantly underestimate hardware routing congestion and execution runtimes. Our Level 4 QISA (local logical operations) offers an optimal architectural balance. As quantum hardware platforms scale toward FTQC in the coming years, our findings provide concrete architectural guidance for the design of their classical control stacks and instruction interfaces.

0.24

Operation of Unshielded Kinetic-Inductance Traveling-Wave Parametric Amplifiers in Multi-Tesla Fields

eess.SY hep-ex ·2026-08-26 ·Christian Boutan, Erik Lentz, Corwin Shiu, Deniz Erdag, Stephen Jones +10 more
unusual similarity 0.49
Abstract · 10 pages, 5 figures, supplementary information included as appendix

Cryogenic parametric amplifiers are used to amplify radio-frequency signals for a range of applications in basic and applied science. Both Josephson Parametric Amplifiers and Josephson Traveling-Wave Parametric Amplifiers have been used as first-stage amplifiers enabling readout chains operating within a few quanta of the quantum limit. However, these devices are highly sensitive to magnetic fields, having critical current suppressed by the Fraunhofer effect, requiring substantial field-free zones. In a dark matter axion search experiment, axions convert to detectable microwave photons in the presence of a strong magnetic field, necessitating amplifiers that can reliably operate close to these environments. Kinetic-inductance Traveling-Wave Parametric Amplifiers (KTWPAs) may be the ideal candidate for this type of application having high critical magnetic field of the materials used throughout their construction. In this letter we demonstrate that KTWPAs can provide high gain (>20dB) over a multi-GHz bandwidth in spite of from multiple exposures to multi-Tesla fields. Further, we explore operational characteristics of these devices under harsh conditions as a function of overall field strength, device orientation within the field, applied bias current, and pump power & frequency. In so doing, we find KTWPA gain vanishes in devices oriented perpendicularly to a field of 0.02T, but gain values >10dB are achievable in fields over 1T when oriented near~parallel to the device plane, with peak gain achieved with an applied 0.25T to 0.5T field. It is our expectation that KTWPAs will expand the accessibility of quantum-limited RF measurements in the presence of Tesla-scale fields.

0.50

Stream Decoding with Confidence Scores at Room and Cryogenic Temperatures

cs.DC quant-ph ·2026-08-11 ·Maries Tahaab, Tim Chan, James Kirkman, Simon C. Benjamin
similarity 0.48
Abstract · 12+5 pages, 10+4 figures

In fault-tolerant quantum computing, fast and accurate decoding is crucial. Snowflake is a decoder for the surface code that runs in a streaming fashion. In this paper, we implement Snowflake on commercial FPGAs and validate them at room and cryogenic temperatures. Our results demonstrate high decoding throughput for small code distances that, when extrapolated, remains within acceptable limits for larger distances. Further, we incorporate the calculation of certain decoder confidence scores with negligible overhead both in terms of latency and physical resource utilisation. We note that implementing a large-scale system would require either a large FPGA beyond today's technology or clusters of FPGAs connected via a high-speed bus. Thus, we discuss an alternative architecture that exploits the locality of Snowflake by processing 2D slices of the 3D decoding window and offloading segments of the 3D structure to a high-speed memory.

0.46