CS Paper Radar

Non-Ionizing Radiation Analysis in Close Proximity to Antenna Tower: A Case Study in Northeast Brazil

André B. F. Diniz, Vicente A. Souza, Marcio E. C. Rodrigues, Halysson B. Mendonça, Gutembregue S. Silva, Fred S. R. Pinheiro

cs.NI ·submitted 2026-09-28 19:48 UTC · v1
publishedhighly cited

Abstract

While the amount of telecommunications services grows rapidly in the whole world, humans get potentially more exposed to Non-Ionizing Radiation (NIR) from a number of different sources. This paper has a number of goals, including monitoring radiation levels in an everyday situation, an investigation of how national and international regulations organs address NIR levels and a demonstration of scientific production trends regarding this topic. The work also presents a bibliometric study about the main scientific productions and trends related to NIR measurements, with focus on the field of Telecommunications. Another contribution is a case study in Natal, Brazil, where NIR levels were monitored in four distinct locations over a period of 24 hours each and compared to the current regulations. The result is a quantitative analysis of the amount of radiation that some populations might be exposed to in distinct moments of the day. Measurements were carried out in the proximity of an antenna spot, since it could represent a source of high NIR levels (a worst case of human exposure). This campaign differs from older studies by including a more intense usage of microwaves frequencies due to operating 4G and pre-5G systems in Brazil. Finally, a statistical study involving the measurements is conducted, concluding the analysis of how some population groups might be affected by NIR.

Journal ref
J. Microw. Optoelectron. Electromagn. Appl. 20 (1), Mar 2021
DOI
10.1590/2179-10742021v20i1833

Closest papers

Nearest neighbours by meaning across the whole index.

Human Exposure to Non-Ionizing Radiation from Indoor Distributed Antenna System: Shopping Mall Measurement Analysis

cs.NI ·2026-09-16 ·Júlia da L. A. Silva, Vicente A. de Sousa,, Marcio E. C. Rodrigues, Fred Sizenando Rossiter Pinheiro, Gutembergue Soares da Silva +6 more
publishedhighly cited similarity 0.76
Abstract

It is crucial to monitor the levels of Non-Ionizing Radiation (NIR) to which the general population may be exposed and compare them to the limits defined in the current standards, in view of the rapid rise of communication services and the prospects of a connected society. A high number of people visits shopping malls and since these locations usually have several indoor antennas close to the public, it is therefore a kind of place that must be evaluated. Thus, this work presents measurements of the electric field in a shopping mall located in Natal, Brazil. We proposed a set of six measurement points, following two criteria: places with great the flow of people and the presence of one or more Distributed Antenna System (DAS), co-sited or not with WiFi access points. Results are presented and discussed in terms of the distance to DAS (conditions: near and far) and flow density of people in the mall (scenarios: low and high number of people). The highest peaks of electric field measured were 1.96 and 3.26 V/m, respectively corresponding to 5% and 8% of the limits defined by the International Commission on Non-Ionizing Radiation Protection (ICNIRP) and the Brazilian National Telecommunication Agency (ANATEL).

0.58

Non-Ionizing Radiation Measurements for Trajectography Radars

cs.NI physics.ins-det ·2026-09-28 ·J. Marcos Leal Barbosa Filho, Millena M. de M. Campos, Daniel L. Flor, William S. Alves, Adaildo G. D'Assunção +2 more
published similarity 0.63
Abstract

This work presents a Non-Ionizing Radiation (NIR) measurement campaign and proposes a specific measurement method for trajectography radars. This kind of radar has a high gain narrow beam antenna and emits a high power signal. Power density measurements from a C-band trajectography radar are carried out using bench equipment and a directional receiving antenna, instead of the commonly used isotropic probe. The measured power density levels are assessed for compliance test via comparison with the occupational and general public exposure limit levels of both the International Commission on Non-Ionizing Radiation Protection (ICNIRP) and the Brazilian National Telecommunication Agency (Anatel). The limit for the occupational public is respected everywhere, evidencing the safe operation of the studied radar. However, the limit for the general public is exceeded at a point next to the radar's antenna, showing that preventive measures are needed.

0.44

Vertical Assessment of RF-EMF Exposure in a Building Adjacent to a Multi-Operator Shared Base Station

cs.NI ·2026-09-11 ·Ricardo Q. de F. H. Silva, Marcio E. C. Rodrigues, Fred S. R. Pinheiro, Gutembergue S. da Silva, Halysson B. Mendonça +1 more
published similarity 0.52
Abstract

This paper extends a previously published proposed approach for estimating worst-case exposure scenarios in buildings using publicly available Base Station (BS) parameters, applying it to a critical case involving a multi-operator shared site. Radiofrequency Electromagnetic Fields (RF-EMF) exposure was assessed on every floor of a 20-story building facing the site, revealing significantly higher levels near the center of the antennas' estimated vertical zone of interest, with a peak of 31.86 V/m, 23.95 times higher than the street-level peak value. However, due to uncertainties in the input parameters, measurements across all locations within the zone of interest are required to accurately identify the floor of maximum exposure. The results demonstrate the usefulness of the proposed estimation approach and highlight the need for improved methods that consider BS antenna configurations and current technical information to ensure accurate assessments of exposure to RF-EMF.

0.39

Coexistence of Direct-to-Device (D2D) Satellite Systems with 5G/6G Terrestrial Networks: Cross-Border Aggregate Interference Analysis in Saudi Arabia

eess.SP ·2026-11-09 ·Muneer M. Alzubi, Muhammad Alrabeiah, Khalid Aldubaikhy, Abdullah Alqasir, Majed Alsifaee +1 more
similarity 0.44
Abstract

Direct-to-device (D2D) satellite systems, particularly those based on 3GPP-compliant non-terrestrial networks (NTN), deliver connectivity to standard mobile phones and IoT devices using terrestrial International Mobile Telecommunications (IMT) spectrum. This raises the risk of harmful cross-border interference into incumbent terrestrial IMT networks, an issue considered under Agenda Item 1.13 of the ITU World Radiocommunication Conference 2027 (WRC-27). This paper presents an ITU-R-compliant assessment of aggregate downlink interference from two hypothetical D2D systems operating in Jordan and Iraq into terrestrial IMT user equipment (UE) in Saudi Arabia, operating in the 698-960 MHz band. Unlike prior studies that evaluate a few test points near a simplified ideal tri-border intersection, we distribute multiple victim UEs along realistic national borders within various strips at a distance of 0-40 km from the borders. We compare two satellite selection strategies: highest-elevation and random strategies. The CDF of the interference-to-noise ratio (I/N) together with the intra-system and inter-system aggregation factors are analyzed. Results show that the protection criterion is exceeded up to 88% of the time, requiring up to 27 dB of additional isolation, so coexistence is infeasible without interference mitigation. In general, random selection produces higher interference because low-elevation beams place victims closer to boresight. Two mitigation techniques are then evaluated. A border isolation zone of one cell diameter yields only a moderate improvement under both strategies, whereas a narrow-beam, deep-null phased-array pattern lowers the exceedance to about 40% irrespective of strategy, providing an important input for spectrum regulatory considerations.

0.19

Disaster Information Reachability of Medium-Wave AM Broadcasting as a Wide-Area Disaster Information Infrastructure: Lessons from the 2024 Noto Peninsula Earthquake

eess.SP physics.soc-ph ·2026-08-12 ·Eiichi Shoji
similarity 0.44
Abstract · 40 pages, 7 figures, 2 tables. Revised wording for accuracy and updated Tables 1 and 2. Submitted to Journal of Disaster Research

The 2024 Noto Peninsula Earthquake caused widespread power outages, communication failures, and road disruptions, and a tsunami warning was issued immediately after the earthquake, highlighting the importance of reliable disaster information transmission. The Noto Peninsula is surrounded by the sea on three sides and has limited transportation networks, making community isolation and securing reliable information transmission critical challenges. This study defines "Disaster Information Reachability" as the capacity to deliver necessary information to those who need it when they need it, and examines the role of medium-wave AM broadcasting from this perspective. In September 2024, the author conducted a mobile reception survey from Kanazawa to Suzu City and a fixed-point reception survey in Suzu City using commercially available radio receivers and passive radio receivers, including HOOPRA. Medium-wave stations in Niigata, Toyama, Akita, and Tokyo were clearly received, although the local NHK Kanazawa stations were affected by noise. The nationwide high-power NHK Radio 2 network, which was still operational at the time, was confirmed to provide a wide-area, multidirectional reception pathway through maritime propagation, demonstrating its critical significance as a redundant disaster information infrastructure. The fact that FM relay station damage was documented in subsequent policy materials, while medium-wave AM broadcasting received no explicit attention, suggests that its disaster information reachability remains insufficiently recognized. Medium-wave AM broadcasting, with its wide-area simultaneous broadcast capability, high-power coverage, and maritime propagation characteristics, functions effectively as a disaster information infrastructure in peninsular regions and warrants reassessment in preparation for large-scale disasters such as a Nankai Trough megaquake.

0.12

Realistic Characterization and Modeling of Vehicle-Mounted Antenna Radiation Patterns Based on Large-Scale Full-Vehicle Measurements

eess.SP ·2026-09-29 ·Guotian Ji, Tianhao Wang, Changhao Xi, Guokai Jiang, Jiaxu Feng +2 more
similarity 0.43
Abstract · Under peer-review of the IEEE Journal

Vehicle-mounted antenna radiation patterns can be significantly altered after installation due to interactions with the vehicle body. However, existing studies mainly focus on simulations or isolated antenna characterization, while large-scale experimental investigations remain limited. This paper presents a comprehensive experimental analysis of vehicle-mounted antenna radiation patterns based on full-vehicle spherical near-field measurements. A large-scale dataset covering ten commercial vehicle platforms, multiple antenna mounting locations, and various wireless functions, including 4G, 5G, V2X, and GNSS, is established under a unified measurement framework. Based on the measured results, representative case studies and statistical characterization are performed to investigate the impacts of vehicle installation on antenna radiation behavior. The results reveal substantial variations across mounting locations and wireless functions, highlighting the strong influence of vehicle integration on realistic antenna performance. Furthermore, a novel statistical model is proposed to generate realistic vehicle-mounted antenna patterns using a small set of physically interpretable parameters. The obtained dataset, characterization results, and modeling approach provide a foundation for realistic antenna evaluation and wireless system simulations in vehicular communication applications.

0.25

Passive RF Sensing for People Counting with Dense IoT Networks

eess.SP ·2026-10-21 ·Federica Fieramosca, Vittorio Rampa, Michele D'Amico
similarity 0.42
Abstract

Radio Frequency (RF) convergence, the joint use of radio signals for both communication and sensing, is gaining increasing attention in research and industry, mostly for its potential in Internet of Things (IoT) applications. By using RF signals of opportunity, such as those generate by the wireless networks, RF sensing exploits the effects of human bodies on the electromagnetic waves to detect both people presence and their movements without requiring wearable devices. In this paper, we address the problem of estimating the number of people in a monitored area covered by several RF nodes of a wireless network: to this aim, we propose a composite diffraction-based model, namely C-MAM, to capture the cumulative RF attenuation induced by multiple human bodies. Building on this model, we derive the analytical resolvability bounds that quantify the maximum number of distinguishable individuals based on the layout geometry and other physical characteristics of the wireless network. These bounds allow for the pre-deployment assessment of RF sensing performance under different scenarios.

0.27

People effects on IoT indoor wireless channel characterization

cs.NI ·2026-09-28 ·Millena Michely de Medeiros Campos, Mateus de Oliveira e Mattos, Rafael da Silva Macedo, Alvaro Augusto Machado de Medeiros, Wellerson Viana de Oliveira +1 more
publishedunusual similarity 0.42
Abstract

Wireless communication under 1 GHz is suitable for Internet of Things (IoT) applications due to larger coverage capability with less power consumption. Bearing in mind that people and elements contained in the environment can cause variations in the channel, this paper aims to evaluate the effect of the presence of people on a 900-MHz indoor narrowband wireless channel, as we characterize the small-scale phenomena. With the increase in the number of people, a greater variation in the communication channel was noticed, which is reflected in the parameters of the probability distributions used in the characterization of the random part of the signal. In addition, second-order statistics were used to analyze the data and an adherence test was applied to confirm the behavior of the signal in relation to the distributions.

0.41