CS Paper Radar

Reduced-Order Model Characterization of Nonlinear Sustained Oscillations

Kaiyang Huang, Dan Wilson, Kai Sun

eess.SY math.DS ·submitted 2026-09-27 15:42 UTC · v1

Abstract

Nonlinear sustained oscillations involving inverter-based resources can happen when device and network interactions produce an attracting limit cycle around an unstable equilibrium. A damping controller must then describe nonlinear dynamics over the region between the two invariant sets, where a local equilibrium linearization can be insufficient. In this paper, a controlled phase--isostable model is first developed on a two-dimensional invariant manifold connecting the equilibrium and the limit cycle. Dynamics on this surface are represented by phase and isostable coordinates, while physical states and control inputs are related to these coordinates through nonlinear reconstruction and response functions. The required functions are computed from connecting trajectories and periodic-orbit data. A control strategy is then designed to provide extra damping while limiting phase distortion. Case studies on a two-area system and an IEEE 39-bus system demonstrate more effective oscillation damping than the compared equilibrium-linearized designs under the same conditions.

Closest papers

Nearest neighbours by meaning across the whole index.

Isostable-Based Nonlinear Model Reduction for Power System Oscillations

eess.SY math.DS ·2026-09-27 ·Kaiyang Huang, Dan Wilson, Kai Sun
similarity 0.72
Abstract

Power systems are often represented by high-dimensional dynamic models, making nonlinear control design computationally expensive and limiting its practical application. Oscillation analysis and damping control therefore commonly rely on linearized models, which do not capture the nonlinear oscillatory behavior induced by large disturbances. This paper proposes an isostable-based model reduction method for nonlinear modal analysis of power systems. The method constructs an invariant manifold associated with a selected oscillatory mode and uses isostable coordinates to describe the mode with only two real state variables. The isostable formulation gives linear autonomous modal dynamics, with nonlinear state reconstruction and input response computed on the modal manifold. An optimal damping control problem is then formulated directly in the reduced coordinates. Case studies on the IEEE 39-bus system demonstrate the accuracy of the proposed model in describing nonlinear oscillations and show improved damping compared with control designed using a linear reduced model.

0.38

Beyond Phase Reduction: Amplitude Collapse in Optimal Control of Coupled Oscillators

eess.SY math.OCmath.NA ·2026-09-15 ·Faranak Rajabi, Frédéric Gibou, Jeff Moehlis
published similarity 0.55
Abstract · 8 pages, 5 figures. Accepted to the 65th IEEE Conference on Decision and Control (CDC 2026), Honolulu, HI, December 2026

We solve the four-dimensional Hamilton-Jacobi-Bellman (HJB) equation for two diffusively coupled Stuart-Landau-like oscillators to obtain full-state optimal feedback control. A sweep over coupling strength reveals a sharp change in the numerically optimal strategy: below a threshold coupling value, the controller steers the phase difference toward anti-phase while keeping both oscillators near the limit cycle, as reduced-order models would suggest. Above this threshold, the HJB solution changes qualitatively; the controller transiently collapses one oscillator's amplitude to near zero, thereby enabling large phase repositioning near the origin before rebuilding its amplitude. Direct gradient-based and stochastic optimization do not recover this lower-cost collapse trajectory from the initializations considered, suggesting that it occupies a region of the control landscape that is difficult to access by direct search. A joint sweep over nonisochronicity and coupling shows that collapse can occur even for an isochronous oscillator: phase repositioning near the origin can favor an off-cycle strategy. Nonisochronicity provides an additional energetic benefit through a phase-velocity surplus at small amplitude, quantitatively accounting for the observed reduction in control cost. Comparisons with uncoupled and coupled phase-reduced baselines show that phase models become increasingly inaccurate and cost significantly more energy for strong coupling. Results for coupled Van der Pol oscillators further demonstrate that exploitation of off-cycle dynamics is not specific to the Stuart-Landau-like oscillators.

0.36

Stimulated Oscillations in Renewable Energy Integrated Power Systems - Part II: Methodology of Oscillation Mitigation

eess.SY ·2026-08-30 ·Peng Zhang
similarity 0.53
Abstract · 8 pages, 8 figures

As presented in Part I of this series, closely located poles can produce high-amplitude oscillations even under small perturba-tions, which are referred to as stimulated oscillations. As the second installment of this series, this paper develops a method-ology for stimulated oscillation mitigation. Firstly, the logical relationship between system stability and oscillation risk is in-vestigated, clarifying that stability is neither a necessary nor a sufficient condition for oscillation risk. Secondly, the dominant factors affecting the pole and zero position on the complex plane, as well as their effectiveness and limitations are analyzed. For feedback control systems in particular, the influence of feedback paths on the pole-zero distribution of closed-loop systems is ana-lyzed. On this basis, a methodology for stimulated oscillation mitigation is proposed. Combined with the reduced-order trans-fer function of systems with closely separated poles, the order relation and configuration of poles and zeros for the feedback path transfer function, together with the criteria for gain selec-tion, are elaborated. Finally, a parameter tuning scheme for the poles, zeros and gain of the feedback path transfer function is presented. The proposed methodology for stimulated oscillation mitigation based on feedback control is not restricted to specific devices and can serve as a methodological reference for the design of diverse oscillation suppression schemes.

0.12

Bifurcation Beyond Surface-Tangential Asymptotic Convergence in Continuous Sliding Mode Control

eess.SY ·2026-09-17 ·Fan Zhang, Jingwen Xu, Peng Li, Jun Zhou, Yaohua Guo
unusual similarity 0.53
Abstract · 13 pages, 5 figures

For second-order systems under continuous sliding mode control (SMC), the literature has long relied, largely through phase-portrait illustrations, on the implicit convention that the phase-plane trajectory approaches the equilibrium along a direction tangential to the designed sliding surface. This paper investigates this tangential convergence assumption through a rigorous phase-plane analysis of the double-integrator system subject to standard linear SMC. We reveal that the asymptotic state ratio is not unique but instead exhibits a bifurcation that depends on the control gains, the sliding surface parameter, and the initial conditions. The key finding is that the system may converge along an implicit secondary manifold rather than aligning with the designed sliding surface, implying that smooth entry is not globally guaranteed. We derive closed-form expressions for the convergence ratios and establish a classification framework that precisely characterizes when the smooth-entry assumption holds and when it fails. The analysis is further extended to classical PD control, and we show that the bifurcation threshold coincides with the critical damping boundary that separates the two convergence regimes. These findings bridge terminal geometry and convergence smoothness, providing a predictive framework for high-performance motion control design. Simulation results validate the proposed classification of convergence regimes.

0.27

New Results for Networked Control of Nonlinear Plants Subject to Transmission Delays

eess.SY ·2026-10-17 ·Ruchao Su, Xianwei Li, Shaoyuan Li
published similarity 0.52
Abstract · Accepted by IEEE CDC 2026. Copyright may be transferred without notice, after which this version might no longer be accessible

This paper studies networked control for nonlinear plants subject to several network-induced constraints, with a particular focus on transmission delays. In the context of general nonlinear networked control systems, a standard approach for guaranteeing stability is to construct a storage function, coupled with a single timer variable, to analyze the maximum allowable transmission interval (MATI) and maximum allowable transmission delay (MAD). In this paper, we propose a new approach that assigns each signal that is either \textit{in transit or most recently updated}, to an individual timer variable. This enables the individual characterization and compensation for the dynamics of each potential updating error. Subsequently, based on a novel construction of timer-coupled storage functions, the dynamics of these timer variables is designed and investigated, leading to less conservative conditions on the MATI and MAD than those by the standard approach while still ensuring closed-loop input-to-state stability with respect to external disturbances. Finally, simulation results are given to illustrate the advantages of these new results.

0.31

Feasibility of Pareto-Improving Damping Control of Forced Oscillations: The Active-Power Case

eess.SY ·2026-11-13 ·Haozong Wang, Yuru Wu, Yan Wen, Qian Liu, Jiahui Yang +3 more
benchmark similarity 0.52
Abstract

Damping control of a forced oscillation may reduce amplitudes at certain locations while increasing them elsewhere. This paper introduces Pareto improvement as a criterion for assessing such control: at least one nodal oscillation amplitude decreases, while none increases across all other nodes. The analysis considers active-power forcing sources and active-power control injections in connected swing networks with positive inertia and damping. Necessary conditions for Pareto improvement feasibility are derived from the normalized nodal responses. It is proven that for every network with a single oscillation source and a single actuator, at least one positive forcing frequency is shown to preclude Pareto improvement, regardless of the amplitude and phase of the control input. A three-node counterexample shows that this limitation does not persist with multiple actuators. PSS/E simulations of a 6-bus benchmark system and a modified IEEE 39-bus system validated the analysis. These findings suggest the value of assessing control effects across the network and further investigating multi-actuator damping control.

0.30

Linear Approximations Provide Rigorous Conditions for Phase Locking in Oscillator Networks and Power Grids

eess.SY nlin.AOmath.OCphysics.soc-ph ·2026-10-17 ·Iva Bačić, Carsten Hartmann, Philipp C. Böttcher, David Gross, Andrea Benigni +1 more
similarity 0.51
Abstract

Synchronization is a fundamental collective phenomenon in many natural and engineered networks. The stable operation of oscillator networks, such as electric power grids, requires phase locking with phase differences across edges below a given threshold. A central question is whether a given network supports such a state. In this contribution, we extend a convex optimization formulation of the nonlinear fixed point equations of the Kuramoto model, that also describe lossless power grids. Based on this formulation, we derive rigorous and tight bounds on the error introduced by an arbitrary approximation of the original model, in particular linear approximations. The bounds yield edge-wise regions of trust around the approximation, within which the true nonlinear solution must lie. They further provide sufficient and necessary conditions for phase locking under prescribed phase difference limits. Numerical experiments show that the bounds are tight over a broad range of parameters.

0.41

Harmonic Stability of Power Systems: A Control-Theoretic Definition and Assessment Criteria

eess.SY ·2026-08-20 ·N. Bhoir, A. Sarkar, J. E. Machado, J. Schiffer
similarity 0.51
Abstract

Harmonic interactions have become a defining dynamic stability phenomenon in converter-based power systems (CBPSs). However, a formalization of the notion of harmonic stability in the context of nonlinear dynamical systems is not available thus far. In this paper, we propose a definition of harmonic stability formulated as a combination of two standard stability notions, namely, bounded-input bounded-output (BIBO) and internal stability properties with respect to any nominal periodic trajectory. Moreover, we rigorously show that the local harmonic stability of any nominal periodic trajectory of nonlinear CBPSs is implied by the stability properties of its linear time-periodic (LTP) approximation. In addition, to enable computationally tractable stability assessment, we develop a framework based on harmonic state-space (HSS) representations of LTP models. In particular, we provide time-invariant linear matrix inequality (LMI) conditions to certify harmonic stability. The proposed methodology is illustrated on a grid-following converter system, where the HSS-based analysis numerically confirms harmonic stability around the periodic operating trajectory.

0.29