CS Paper Radar

An Analytical Review of Model Order Reduction Methodologies of Converter-Dominated Power Systems for Stability Studies

Goran Grdenić, Marco Fraccaro, Josipa-Pina Milišić

eess.SY ·submitted 2026-10-02 09:42 UTC · v1

Abstract

The rapid integration of renewable energy sources is transforming modern electric power systems into converter-dominated networks characterized by complex multi-timescale dynamics and new stability interactions over a wide frequency range. Accurate analysis of these phenomena requires high-fidelity models of transmission networks and power electronic converters, which often result in large-scale differential-algebraic systems with significant computational burden. This paper provides an analytical review of model order reduction techniques for converter-rich power systems, with particular emphasis on the key equations employed in the reduction process. Advantages and limitations of commonly used strategies, including timescale-based singular perturbation, projection-based, operator-based, data-driven, and machine-learning based methods, are discussed. The synthesis highlights key challenges related to harmonic interactions and multi-frequency dynamics, and outlines directions for the development of computationally efficient yet dynamically accurate reduced-order models for future power systems.

Comment
53 pages, 4 figures

Closest papers

Nearest neighbours by meaning across the whole index.

Impact of Reduced-Order Modelling on Sum-of-Squares Region-of-Attraction Certification for Grid-Forming and Grid-Following Converters

eess.SY math.OC ·2026-11-10 ·Chenxi Yuan, Jeremy D. Watson, Neville R. Watson
similarity 0.62
Abstract · 13 pages, 5 figures, 3 tables

With the increasing penetration of power-electronic equipment, the transient stability of grid-forming (GFM) and grid-following (GFL) converters is increasingly characterized through the region of attraction (ROA) of the post-fault equilibrium. Sum-of-squares (SOS) programming yields certified inner approximations of the ROA, yet its computational cost grows rapidly with system order. Reduced-order models are therefore widely used to reduce computational cost and, more importantly, to enable analytical investigation. However, ROA analyses based on these models often assume that reproducing the converter's transient response, or retaining more dynamics in the correct time-frame, is sufficient to preserve the ROA of the full-order system. Using time-domain ODE simulations as a reference, the SOS-based ROA of each reduced-order GFM and GFL model is assessed against both its own simulated ROA and that of the corresponding full-order model, thereby separating SOS-induced conservativeness from model-order-induced ROA distortion. The results indicate that increasing reduced-order model complexity does not necessarily improve SOS-based ROA fidelity. In the cases examined, more complex reduced-order models yield lower SOS coverage of the full-order reference ROA, despite closer ODE-boundary agreement in some regions. Model selection should therefore consider both full-order ROA fidelity and certified coverage of the practical operating range, rather than model complexity alone.

0.35

Learning Reduced-Order Dynamics with Singularity via Latent-Augmented Neural Ordinary Differential Equations

cs.LG ·2026-08-22 ·Xiaorui Wang, Yu Zhou, Wenjie Mei, Dongzhe Zheng, Yang Bai +1 more
top venue similarity 0.61
Abstract

This paper addresses the issue of self-intersecting trajectories (in phase space) in industrial reduced-order modeling and proposes the Latent-Augmented Neural Ordinary Differential Equations (LA-NODEs) framework. From the perspective of artificial intelligence, the proposed method augments conventional neural ordinary differential equations to enhance model expressiveness, enabling the representation of conflicting vector fields that may arise in reduced-order systems, thereby improving learning accuracy. Through theoretical analysis, the underlying mechanism of the framework is established, and a condition for determining the minimum required augmentation dimension is derived. From the perspective of engineering applications, the effectiveness of the proposed method is validated on the reduced-order system of two representative industrial models, namely an interior permanent magnet synchronous motor (IPMSM) drive and a distributed energy system (DES). Experimental results demonstrate that the proposed method can recover system features that are difficult to capture using conventional approaches and achieve superior performance in terms of prediction accuracy and modeling fidelity, thereby providing an effective approach for high-precision data-driven modeling of complex industrial systems.

0.47

Modular Model Order Reduction for Inverter-Based Power Systems with Stability and Accuracy Guarantees

eess.SY ·2026-10-01 ·Hanqing Zhang, Pudong Ge, Mohammad Fahim Shakib, Adrià Junyent-Ferré, Balarko Chaudhuri +3 more
similarity 0.60
Abstract · 10 pages, submitted to IEEE Transactions on Power Systems

This paper proposes a modular model order reduction framework for large-scale power grids integrated with renewable energy sources. The proposed framework has the advantage of reducing individual sub-areas independently while retaining the power grid interconnection structure. Moreover, given a user-defined accuracy specification on the overall reduced-order interconnected power grid, corresponding target specifications for the individual reduced sub-areas are determined: satisfaction of such individual specifications guarantees the overall user-defined accuracy specification, while also preserving the stability of the overall reduced-order interconnected power grid. The proposed framework is validated on a modified IEEE 118-bus system (where synchronous generators have been replaced by inverter-based resources) by assessing the accuracy specification satisfaction of the overall reduced-order interconnected power grid, in terms of frequency response, stability, active power, and sub-synchronous behaviour when injected with disturbances.

0.33

Nonlinear Participation Factor-based Power System Model Reduction Addressing Near-Resonance Conditions

eess.SY math.DS ·2026-09-27 ·Mahsa Sajjadi, Kai Sun
similarity 0.58
Abstract

This paper proposes an adaptive model reduction approach based on nonlinear participation factors (NPFs) which determines the most effective selection of unimportant generators in a power system to be linearized to accelerate time-domain simulation for the entire system. The method enables a dynamic transition between the full-order model, and a hybrid reduced model. It uses modal energies to rank system modes under contingencies, and computes NPFs for highly energized modes based on Normal Form theory. To accelerate the computation of NPFs and make it achievable online, a tensor contraction technique is introduced. The proposed approach is tested on a 48-machine, 140-bus NPCC system using both partitioned and unpartitioned strategies. It demonstrates significant simulation speedup while preserving better accuracy than a linear participation factor-based method if the nonlinear behaviors of the system cannot be ignored, especially when a near-resonance condition is presented.

0.28

RAPTOR: RAndom-projection Physics-informed Transient sOlveR

eess.SY cs.LGcs.MSmath.NA ·2026-08-31 ·Petros Ellinas, Benjamin Vilmann, Spyros Chatzivasileiadis, Johanna Vorwerk
similarity 0.57
Abstract

The complexity of time-domain simulation of modern power systems has increased significantly because converter-based resources introduce control dynamics that must be simulated alongside slower system-level and fast electromagnetic dynamics. The resulting wide range of timescales may force classical time-domain solvers to use small timesteps, complicate the solution of nonlinear equations at each timestep, and reduce solver reliability under strongly nonlinear and multi-timescale transient conditions. This paper introduces RAPTOR, a first-of-its-kind time-domain simulation framework for power system dynamic simulations. At its core, RAPTOR introduces a new integration technique that represents the unknown trajectory of hybrid differential-algebraic equations (DAEs) over a time interval using a physics-informed random-projection neural network (PIRPNN) built from fixed Gaussian radial basis functions (RBFs). A nonlinear solver, e.g., Newton-Raphson, determines how to combine the fixed RBFs so that the resulting trajectory satisfies the governing equations. By combining RBFs with broad and localized shapes, RAPTOR can represent complex multi-timescale behavior over comparatively long time intervals. This enables larger effective simulation advances, fewer overall nonlinear solver iterations, and faster integration over long time horizons. Numerical studies on stiff RMS models, IEEE 9-, 14-, 39-, 57-, and 118-bus RMS simulation benchmarks, and EMT test cases show that RAPTOR accurately finds solutions with substantially fewer sequential simulation advances while offering superior accuracy-runtime performance. With speedups of over 10x in certain cases, these results showcase RAPTOR's potential to outperform long-standing and widely used integration methods, such as the Radau method and the trapezoidal rule.

0.24

Data-driven model reduction: An identification perspective using Generalized Bases of Orthonormal Functions

eess.SY ·2026-11-17 ·Bernard Vau, Henri Bourlès
similarity 0.56
Abstract

This paper proposes a data-driven model order reduction approach based on system identification concepts. A revised equation error formulation is introduced, in which the model is parameterized using Generalized Bases of Orthonormal Transfer Functions (GBOFs). The generalized reduction problem is formulated in the Hambo frequency domain associated with the GBOF transform. The frequency-domain fit of the reduced-order model is adjusted through the selection of the basis poles. A fit indicator depending on these poles is introduced, providing valuable heuristic guidance for their selection.

0.28

Isostable-Based Nonlinear Model Reduction for Power System Oscillations

eess.SY math.DS ·2026-09-27 ·Kaiyang Huang, Dan Wilson, Kai Sun
similarity 0.55
Abstract

Power systems are often represented by high-dimensional dynamic models, making nonlinear control design computationally expensive and limiting its practical application. Oscillation analysis and damping control therefore commonly rely on linearized models, which do not capture the nonlinear oscillatory behavior induced by large disturbances. This paper proposes an isostable-based model reduction method for nonlinear modal analysis of power systems. The method constructs an invariant manifold associated with a selected oscillatory mode and uses isostable coordinates to describe the mode with only two real state variables. The isostable formulation gives linear autonomous modal dynamics, with nonlinear state reconstruction and input response computed on the modal manifold. An optimal damping control problem is then formulated directly in the reduced coordinates. Case studies on the IEEE 39-bus system demonstrate the accuracy of the proposed model in describing nonlinear oscillations and show improved damping compared with control designed using a linear reduced model.

0.38

Limitations of RMS-based Stability Assessment of Converter-based Grids: A Case Study

eess.SY ·2026-08-19 ·Pol Jane-Soneira, Ognjen Stanojev, Francisco Canales Perez, Qian Long, Mario Schweizer +1 more
similarity 0.55
Abstract

The increasing penetration of power electronic converters in industrial grids introduces stability challenges at frequencies well above the electromechanical range of traditional power systems. Commercial software tools typically perform eigenvalue-based stability analysis using root-mean-square (RMS) models that assume a quasi-stationary network, thereby neglecting electromagnetic dynamics of assets --- which is standard practice in power system analysis. This paper presents a case study of an industrial grid where the conventional RMS-based eigenvalue analysis predicts stable operation, while a detailed electromagnetic transient (EMT) simulation reveals growing oscillations, indicating instability. To bridge this gap, we introduce an alternative modeling approach that formulates the network dynamics in the rotating $dq$ reference frame, retaining the differential equations of electromagnetic dynamics. The resulting model enables eigenvalue analysis that correctly identifies the unstable modes, consistent with the EMT simulation results. Our findings highlight a fundamental limitation of RMS-based stability assessment for converter-dominated grids and demonstrate that dynamic impedance models in the dq frame provide a viable path toward accurate small-signal analysis encompassing high-frequency converter-network interactions.

0.32