CS Paper Radar

RIS Aided Multi-Way Communication Systems based on SIC Decoding Techniques

Lingya Wang, Harry Leib

cs.IT ·submitted 2026-10-02 19:21 UTC · v1

Abstract

This work considers reconfigurable intelligent surface (RIS) aided multi-way communication systems employing QPSK. The objectives of such system is to allow multiple users to exchange information, exploiting the full-duplex capabilities of RIS. The system under consideration comprises $K$ user terminals and an RIS with $N$ reflective elements. Each user terminal is equipped with one transmit and $M$ receive antennas. To mitigate inter-user interference caused by the full-duplex operation of the RIS, three successive interference cancellation (SIC) techniques are considered. We investigate three SIC ordering methods: $1)$ descending channel variances, $2)$ increasing mean square error, $3)$ optimization approach which maximizes the combined channel gain within the system. The bit error rate (BER) performance of these three SIC methods are evaluated using extensive Monte-Carlo simulations for different numbers of RIS elements, ranging from 4 to 64, and a varying number of transmitting users, ranging from 1 to 5. Additionally, an RIS phase shift optimization method for RIS with reflection elements of varying amplitudes is considered. In this case the previous SIC optimization technique is adapted to address phase-dependent amplitudes in RIS reflection elements. Simulation results indicate that in both ideal and varying amplitude scenarios, when the number of RIS elements is small, SIC with ordering based on increasing mean square error achieves the best BER performance. However, as the number of RIS elements increases, SIC ordering based on the optimization method achieves the best BER performance.

Closest papers

Nearest neighbours by meaning across the whole index.

A Reduced Greedy Minimum Distance Phase Shift Design for Quantized RIS-Assisted Spatial Modulation

eess.SP ·2026-10-12 ·Alexander Kelly, Mark F. Flanagan
benchmark similarity 0.59
Abstract

Reconfigurable intelligent surfaces (RISs) have emerged as a key enabler for next-generation wireless networks, offering control over the propagation environment through nearly passive reflecting elements. When combined with spatial modulation (SM), an RIS shapes a finite set of noise-free signal points at the receiver, and the error rate performance under maximum-likelihood (ML) detection is governed by the smallest pairwise Euclidean distance among these points. In this paper, we propose a low-complexity RIS phase shift design algorithm for RIS-assisted SM under practical discrete phase shift control. The proposed method targets the minimum Euclidean distance directly through a reduced greedy search over the discrete set of RIS phase shifts, in contrast to existing approaches that align RIS phase shifts to maximize the effective channel gain and therefore do not directly address the dominant error events. The search effort is controlled by a small set of integer parameters, providing a tunable trade-off between bit error rate (BER) performance and computational cost. We evaluate the proposed method against continuous and quantized phase-alignment baselines, including a complexity-matched comparison against the most directly comparable benchmark. Numerical results show that the proposed method achieves a significant SNR gain over quantized phase alignment under the same discrete hardware model, and this advantage persists under imperfect channel state information.

0.24

A Bussgang-based Latent Lifting Method: Discrete RIS Channel Estimation and Beamforming

eess.SP ·2026-11-07 ·Mintaek Oh, Namyoon Lee, Jinseok Choi
similarity 0.58
Abstract · 13 pages, 8 figures

This paper addresses the challenge of discrete phase-shift optimization in reconfigurable intelligent surface (RIS)-aided multiuser communication systems. Practical RIS hardware often utilizes low-resolution phase shifters, leading to challenging combinatorial optimization problems. To address this challenge, we propose a Bussgang-based latent lifting (BuLL) method that represents discrete phase shifts as quantized outputs of continuous latent variables. Our BuLL method calibrates the Bussgang gain and distortion covariance under a reference distribution and keeps these moments fixed during deterministic latent optimization. These fixed moments are then used to construct a distortion-aware continuous surrogate that incorporates reference-averaged discretization effects without penalty terms. For uplink channel estimation, we develop a matrix quadratic transform-based algorithm to optimize a mean-square-error surrogate. For downlink beamforming, we develop a generalized power iteration-based RIS phase-shift optimization algorithm for a spectral efficiency (SE) surrogate. Numerical results demonstrate improvements in channel estimation accuracy and sum SE over conventional benchmarks in the evaluated low-resolution RIS settings.

0.34

Exploiting Movable-Element STARS for Rate Splitting Multiple Access

eess.SP ·2026-08-17 ·Muhammad Asif, Asim Ihsan, Irfan Muhammad, Mohd Hamza Naim Shaikh, Muhammad Ayzed Mirza +2 more
benchmark similarity 0.57
Abstract · 13 pages, 10 figures

This paper investigates a movable-element simultaneously transmitting and reflecting reconfigurable intelligent surface (ME-STARS) assisted rate-splitting multiple access (RSMA) system under imperfect channel state information (CSI). Unlike conventional STARS with fixed element positions, the elements of ME-STARS can be repositioned within a predefined region, providing additional spatial degrees of freedom for improving the cascaded transmitter--STARS--user channels. To exploit this flexibility while accounting for CSI uncertainty, we formulate a robust sum-rate maximization problem that jointly optimizes the transmit beamforming, common-rate allocation, reflection and transmission coefficients, and ME-STARS element positions, subject to transmit-power, user-rate, minimum inter-element spacing, and movement-region constraints. The resulting problem is highly non-convex due to the strong coupling among the design variables and the position-dependent channels. To address this challenge, an iterative optimization framework is developed in which the transmit beamforming, STARS coefficients, and element positions are successively optimized through tractable convex reformulations. In particular, the element positions are updated sequentially using a majorization--minimization (MM) framework, where quadratic surrogate functions are constructed from the first- and second-order derivatives of the position-dependent channels while preserving the minimum inter-element spacing constraint. Simulation results demonstrate that the proposed ME-STARS design consistently outperforms the considered benchmark schemes. Moreover, the performance gains remain significant under increasing CSI uncertainty, highlighting the effectiveness of element repositioning for robust RSMA transmission.

0.49

Beamforming Design for RIS-Assisted Backscatter NOMA in Underlay Cognitive Radio

eess.SP ·2026-10-06 ·Kgomotjo Seipobi, Fambirai Takawira, Chabalala Chabalala
hot direction similarity 0.57
Abstract

This paper investigates a reconfigurable intelligent surface (RIS)-assisted backscatter non-orthogonal multiple access (NOMA) network operating as the secondary system of an underlay cognitive radio network. A multi-antenna base station serves several user clusters through the RIS, each containing a backscatter device (BD). We maximise the weighted sum rate of the secondary network by jointly optimising the transmit beamformers and the RIS reflection matrix, subject to the power budget, the interference-temperature limit and minimum rate requirements. The non-convex problem is solved by alternating optimisation, using semidefinite relaxation and sequential rank-one constraint relaxation. Interference-normalised user ordering makes the successive interference cancellation constraints redundant. A closed-form equal-rate power split is derived; it agrees closely with simulation and costs about 4.5% of the sum rate. Supporting the BDs reduces the NOMA sum rate by 8.7% relative to a no-BD design, while a larger BD reflection coefficient raises the backscatter rate with little NOMA loss.

0.29

On the Performance of RIS-Empowered Transmitters with Receive Combining Techniques

eess.SP ·2026-10-19 ·Muhammed Faruk Karabay, Oğuz Kucur, Ertugrul Basar
similarity 0.56
Abstract

Reconfigurable intelligent surface (RIS)-empowered transmitters offer a promising basis for hardware-efficient multi-antenna architectures in next-generation wireless networks. In particular, combining these transmitters with low-complexity reception techniques such as receive antenna selection (RAS) can further simplify the receiver architecture. In this paper, we investigate the impact of practical phase-shift constraint on RIS-empowered multi-antenna systems employing maximal ratio combining (MRC) and RAS. Since each RIS element can apply only a single phase-shift at a given time, the system performance degrades substantially when multiple receive antennas are active simultaneously. To quantify this effect, closed-form outage probability expressions are derived and asymptotic analyses are carried out over Rician fading channels. We show that the practical phase-shift constraint of RIS-based transmitters can degrade the diversity order of MRC and in addition, RAS outperforms MRC in the examined system models, contrary to the conventional performance ordering of these techniques.

0.15

Rate-Splitting Multiple Access for RIS-Enabled Full-Duplex Communications with User Relaying

cs.IT ·2026-10-13 ·Yuwen Cao, Hui Wang, Tomoaki Ohtsuki, Shahid Mumtaz
similarity 0.56
Abstract

Rate splitting multiple access (RSMA) has emerged as a promising non-orthogonal transmission mechanism to improve spectral- and energy efficiency, and user fairness in multi-antenna broadband channels. To further enhance its performance, in this paper we investigate a novel cooperative RSMA (C-RSMA) transmission framework assisted by reconfigurable intelligent surface (RIS) and user relaying. More specifically, we first formulate the common- and private-rate maximization problem satisfying the transmit power constraint, by jointly optimizing the transmit beamformers at the BS and the reflective beamformer at the RIS. The above formulated problem is an intractable and NP-hard problem as the optimization variables are coupled and the strong residual self-interference (SI) is involved. To conquer the challenge mentioned above, we propose a low-complexity alternative optimization approach to jointly optimize the transmit and reflective beamforming. Simulation results show that our approach is capable of enabling superior sum-rate performance than the RIS-assisted space division multiple access (SDMA), half-duplex RSMA, and SDMA without using RIS schemes.

0.10

Discrete Phase-Shift Optimization of Reconfigurable Intelligent Surfaces using Uniform Reference Directions

cs.PF cs.ITeess.SY ·2026-10-17 ·Pavithra P., Manoj Kumar Panda, Chandramani Singh
similarity 0.56
Abstract

Reconfigurable Intelligent Surfaces (RISs) enable programmable control of the wireless propagation environment through adjustable reflecting elements. A fundamental challenge in RIS-assisted communications is the optimization of discrete phase shifts to maximize the received signal power. While recently developed algorithms can obtain optimal solutions with linear complexity, their computational cost may still be excessive in applications requiring large-scale simulations, real-time adaptation, or repeated optimization over numerous channel realizations. This paper proposes a low-complexity discrete phase-shift optimization algorithm based on multiple reference directions within the feasible optimality sector. By evaluating candidate phase configurations generated from uniformly distributed reference directions, the proposed method systematically improves upon existing approximation approaches that rely on a fixed set of reference directions. The number of reference directions serves as a design parameter that enables a controllable trade-off between computational complexity and optimality. Extensive simulations demonstrate that the proposed algorithm achieves substantial computational speedups while maintaining a small optimality gap relative to the optimal solution. The results further show that increasing the number of reference directions progressively reduces the optimality gap, providing flexible operating points that can be tailored to application-specific complexity and performance requirements.

0.22

Sum Rate Maximization for Practical RIS-Enhanced Rate-Splitting Multiple Access Systems

cs.IT ·2026-10-10 ·Qian Zhang, Xuejun Cheng, Jiaming Shi, Yufei Zhao, Rugui Yao +1 more
publishedbenchmark similarity 0.56
Abstract

Reconfigurable intelligent surfaces (RIS) combined with rate-splitting multiple access (RSMA) provide a promising solution for improving the spectral efficiency (SE) of sixth-generation (6G) communication systems. However, most existing studies neglect the practical coupling between the RIS phase shift and amplitude, which may cause phase-shift mismatch and significant performance loss. In this paper, we investigate the multiuser sum-rate maximization problem for practical RIS-enhanced RSMA systems considering amplitude-phase coupling. To address the resulting non-convex problem, an effective variable separation algorithm is proposed. The proposed algorithm is compatible with RIS reflecting optimization under the continuous phase shift or any amplitude-phase coupling relationship and can also be directly extended to practical RIS-enhanced NOMA and OMA systems. Simulation results demonstrate performance gain of over 190\% compared with the ideal-RIS-based benchmark, while the proposed RSMA scheme significantly outperforms the corresponding NOMA and OMA schemes.

0.47