CS Paper Radar

Actuator-Aware Observer Inputs for Cascade ADRC of Quadrotors Under Rotor Lag, Measurement Delay and Sensor Noise

Xuan-Quy Dao, Ngoc-Bich Le, Le-Minh Nguyen

cs.RO ·submitted 2026-10-29 01:17 UTC · v3
code/data

Abstract

In sampled cascade linear active disturbance rejection control (LADRC) of quadrotors, the extended-state observer receives the instantaneous command, although the delayed measurement reflects an earlier, rotor-filtered acceleration. This simulation and software-in-the-loop design study examines actuator-aware (AA) observer inputs: altitude and attitude observers use limited virtual inputs filtered by an assumed rotor model and aligned with the measurement delay, and horizontal observers use acceleration reconstructed from measured attitude. Fixed gains are selected on the discrete-time model under sensitivity and step-response requirements and stationary covariance ceilings on channel activity and on the noise-induced inner-loop increment of the full cascade. In paired set-point trials, PID-Budget, AA-Budget and AA-HalfGain reach mean RMSEs of 65.5, 19.2 and 16.9~mm; under a stricter common cascade ceiling, the AA designs reach 29.9 and 26.4~mm versus 72.3~mm for a PID with about twice their rotor-command increment. Ablations attribute the improvement to the rotor-lag model and the measured-attitude input; at the nominal 5-ms delay, delay alignment changes the RMSE by 0.013~mm. PX4 software-in-the-loop runs reproduce these results. Behind EKF2, a noise model fitted to the estimation errors predicts the roll/pitch and yaw increments within 5\%. After redesign for this stack, AA-Budget-E reduces the set-point RMSE from 59.1~mm (PID-E) to 44.0~mm with a lower rotor-command increment in every paired tracking run (S6: 45\% lower, 15\% after output quantization); AA-HalfGain-E beats PID-E only on the lemniscate. With fixed gains, the AA designs tolerate less unmodelled rotor lag and delay than PID in the linear sensitivity screen. The ceilings are nominal tuning constraints.

Comment
19 pages. MATLAB and PX4 SITL evaluation. Code, controller gains, random seeds, and per-seed results: https://github.com/Quang61123/actuator-aware-cascade-adrc

Closest papers

Nearest neighbours by meaning across the whole index.

How Tuning, Reference Preview, Actuator Modeling, and Fallback Policies Change Quadrotor Controller Comparisons: A Reproducible Simulation Study

cs.RO ·2026-10-26 ·Xuan-Quy Dao, Le-Minh Nguyen, Ngoc-Bich Le
similarity 0.62
Abstract · 20 pages, 5 figures, 11 tables. Reproducible simulation study of quadrotor controller benchmarking

Quadrotor controller comparisons commonly report a single tracking error, although the ranking also depends on tuning effort, reference information, actuator prediction, optimizer fallback, and command timing. We quantify these effects for cascade PID, hover LQR, boundary-layer sliding-mode control (BL-SMC), linear MPC with LQR fallback (LMPC-F), a preview-enabled LMPC-F, and a geometric $SO(3)$ controller on a common nonlinear plant with rotor gyroscopic coupling, motor lag, and saturation. A primary study (556 episodes at 50~Hz) combines matched twelve-candidate tuning, 400 paired evaluation episodes, and a 48-cell MPC factorial; a confirmation study (1462 episodes) repeats the evaluation on 50 fresh realizations with tuning budgets of 12, 24, and 48 candidates. A matched twelve-candidate tuning protocol changed the mean-RMSE ordering of the fixed baseline settings, mainly by moving BL-SMC from last to first. The ordering recurred on fresh realizations and did not change with 48 candidates, although BL-SMC's lead on the fresh set depends on a wider search range for its vertical switching gain. Reference preview reduced MPC tracking error and removed fallback activity on the figure-eight task. In single abrupt-step runs, completion depended jointly on fallback policy, predictor, and actuator authority. Command timing also changed the outcome: replaying measured command-call delays terminated three of four nominal MPC configurations on a desktop and all four on a Raspberry Pi~5, whereas capping the solver at 100 iterations removed every deadline miss in these profiles. We propose a reporting checklist that adds tuning effort, failure rates, fallback activity, applied-input variation, and command timing to tracking accuracy.

0.42

Selective Sliding Mode Control Enhances Robustness of Aerial Robots Under Disturbances

cs.RO eess.SY ·2026-10-28 ·Anoop Kiran, Thales C. Silva, Nora Ayanian
hot direction similarity 0.57
Abstract · 8 pages, 5 tables, 8 figures

Quadrotor control under disturbances such as wind gusts and payload variations remains challenging. First-order sliding mode control (SMC) and matched/unmatched uncertainty distinction are classical approaches; however, neither tells a practitioner which loops in a cascaded controller should be made robust to sustain disturbances, how to tune those loops, nor what the additional costs are on an embedded processor. Applying robust control uniformly across all axes addresses disturbances indiscriminately, adding tuning effort on axes where no disturbance acts. On inherently underactuated vehicles, disturbances along some axes cannot be opposed directly at all. We propose a principled methodology for deciding where robust control belongs in a cascaded architecture, with all control running onboard the vehicle. We recover the acting disturbance from PID hover flights under disturbance by inverting the equations of motion, use the recovered signal to identify and quantify the excited axes, and deploy robust control where it counts. Experiments on a Crazyflie 2.1 quadrotor under slung-payload and oblique-wind disturbances show tracking improvements concentrated on the axes the rule selects, and gain sweeps confirm that the switching gain reduces error on matched axes but has no effect on an excited unmatched axis, as the analysis predicts.

0.35

Estimation-Aware Control on Quadrotor State Manifolds via Anisotropic Covariance Filtering

eess.SY ·2026-11-11 ·Daniel Engelsman, Itzik Klein
similarity 0.56
Abstract · 11 Pages, 14 Figures, 2 Tables

Conventional nonlinear flight controllers operate under the implicit assumption of reliable, high-confidence state feedback. During transient sensing degradation or partial unobservability, state estimation uncertainty is frequently misinterpreted as physical tracking error, triggering aggressive and parasitic corrective inputs. To mitigate this vulnerability, we propose a generalized Estimation-Aware (EA) control framework that directly incorporates real-time estimator confidence into control execution. By mapping the posterior error covariance $\mathbf{P}_{k\mid k}$ into an uncertainty-dependent modulation operator, the EA mechanism dynamically scales feedback authority, performing anisotropic attenuation along weakly observed state directions to prevent false error corrections. Validated across six distinct control paradigms, the proposed approach demonstrates substantial performance gains across all baselines. In particular, when integrated into an Incremental Nonlinear Dynamic Inversion (INDI) architecture, the EA mechanism reduces tracking and estimation errors by 24.34% and 33.24%, respectively, at a high flight speed of 10 m/s.

0.26

Tilt-Rotor Quadcopter with Learned Residual Control and Mode-Dependent State Estimation

cs.RO ·2026-10-22 ·Ninad Joshi, Prabhat Kumar
similarity 0.54
Abstract · 5 figures

Tilt-rotor quadcopters redirect thrust for translation without banking, but complicate modeling, state estimation, and disturbance rejection. This paper presents a simulation-based flight stack for a \SI{2.00}{\kilo\gram} tilt-rotor quadcopter. The system uses a six-degree-of-freedom nonlinear model with first-order motor dynamics and two-axis rotor tilt, parameterized using a 3D CAD model. A cascaded PD controller commands forward and lateral tilt angles. A 14-state EKF fuses sensor data across hover, early-transition, and transition modes using a hysteretic (Schmitt-trigger) classifier to prevent covariance discontinuities. Because the proportional position loop leaves a steady-state offset under constant wind, a small bounded neural residual is added on top of the unmodified PD controller. It is trained by behavioral cloning from a teacher with privileged access to the true wind, while the deployed network never observes wind. In simulation, the EKF achieves a post-settling position root mean square error (RMSE) of \SI{0.226}{\metre} (horizontal) and \SI{0.03}{\metre} (vertical) and an attitude RMSE below \SI{0.8}{\degree}, and it estimates a wind velocity of $(\num{2.0}, \num{-1.2})\,\unit{\metre\per\second}$ to within \SI{0.15}{\metre\per\second} per axis. The residual reduces steady-state station-keeping error under wind by approximately \SI{49}{\percent}, from \SI{0.117}{\metre} to \SI{0.060}{\metre} at \SI{1.5}{\metre\per\second} and from \SI{0.319}{\metre} to \SI{0.162}{\metre} at an out-of-distribution \SI{3.9}{\metre\per\second}. The framework provides a basis for hardware-in-the-loop and flight-test studies.

0.29

Dynamic Modeling and LQR Control of a Single Coaxial Drone with 2DOF Thrust Vectoring Mechanism

cs.RO eess.SY ·2026-09-17 ·Ali Jokar, Amin Talaeizadeh, Aria Alasty
similarity 0.54
Abstract

Coaxial rotor drones have generated considerable interest because of energy efficiency and small size, but they are afflicted with inherent underactuation for roll and pitch control, although systems like swashplates have circumvented this limitation at the cost of greater mechanical complexity. This work presents a novel coaxial drone supplemented by a two-degreesof-freedom pendulum mechanism for active thrust vectoring that offers a less mechanically complicated alternative. We develop a comprehensive Lagrangian dynamic model that does not ignore the inertial contributions of all the components, including body, servo arms, and motor assembly. A Linear Quadratic Regulator(LQR) is designed based on the linearized dynamics around the hover equilibrium. High-fidelity simulations taking actuator dynamics and sensor noise into account validate the proposed architecture. An Extended Kalman Filter (EKF) blends GPS, barometer, and IMU estimates with high accuracy for state estimation. The findings verify the potential and reliability of this approach for power-saving, rapid coaxial UAVs.

0.13

Appointed-Time Fault-Tolerant Fast Terminal Sliding Control for UAVs with a Tracking Error-Based Disturbance Observer

cs.AI ·2026-10-31 ·Jinfa Li, Sheng Xu, Yanjie Wu, Chengyue Su
similarity 0.53
Abstract

This paper addresses the critical challenge of high-performance fault-tolerant tracking control for quadrotor UAVs under complex conditions including external disturbances, parameter uncertainties, and actuator faults. A synergistic control framework is proposed by decoupling the system into position and attitude loops, each governed by the following three innovations. First, an Appointed-Time Prescribed Performance Function (AT-PPF) is developed to strictly constrain the tracking error within a predefined funnel boundary, ensuring convergence within a fixed time regardless of initial conditions. Second, a Tracking Error-Based Fixed-Time Composite Disturbance Observer (TFxTCDO) is developed to enable fast and accurate estimation of lumped disturbances without requiring full-state information or precise system modeling. This observer directly couples disturbance estimation with the control objective, thereby enhancing robustness and convergence. Third, a Fast Second-Order Terminal Sliding Mode Controller (NFSO-TSMC) is designed to achieve faster convergence and effective chattering mitigation. Simulation results demonstrate that the proposed control strategy significantly outperforms conventional methods in terms of tracking accuracy, fault recovery speed, and robustness against uncertainties.

0.21

Onboard Wind-Preview Model Predictive Control Using Pitot-Static Sensing for Multirotor UAVs

cs.RO ·2026-09-25 ·Bas Meere, Eline Wisse, Laurens Vousten, Sander Doodeman, Elena Torta +2 more
similarity 0.52
Abstract · Submitted to ICRA 2027

Effective wind gust rejection and stable hovering are critical for the outdoor operation of autonomous drones. However, existing gust rejection methods are primarily reactive, inferring the disturbance from the resulting motion or measuring it at the airframe. Either way, the wind has already begun to act before it can be compensated. In this work, we anticipate the gust instead by measuring the wind ahead of the drone with a low-cost, low-weight pitot-static sensor mounted on a boom. The resulting wind preview is incorporated into a nonlinear model predictive controller (MPC), which optimizes the drone motion while anticipating wind disturbances. A longer boom offers more preview time but adds inertia and degrades flight performance. We characterize this trade-off in simulation and show that the optimal preview distance is not a fixed property of the platform, but shifts with the wind speed and with how quickly the drone can respond. Indoor hardware experiments confirm the trend and show that the proposed controller substantially improves hover performance against a PX4 baseline and an otherwise identical wind-unaware MPC. Outdoor experiments show that the error along the wind direction is reduced by 54 percent with respect to the baseline, demonstrating that a single wind-aligned sensor can significantly improve hovering performance.

0.21

Physics-Informed and Data-Driven Composite Disturbance Separation and Predictive Control for Airborne Electro-Optical Gimbals with Multiple Constraints

cs.RO eess.SY ·2026-10-26 ·Yaokun Lu, Yifan Li, Zhixuan Zhang, Enmei Wang, Hao Teng +1 more
similarity 0.50
Abstract · 20 pages, 8 figures. Includes supplementary derivations and proofs. Demonstration video included as an ancillary file

This paper studies the constrained pointing control problem of airborne electro-optical gimbals subjected to composite periodic and aperiodic disturbances. Under carrier vibration, input delay, and actuator constraints, achieving line-of-sight stabilization and tracking is challenging. A disturbance-separated model predictive control (MPC) scheme is proposed to compensate these heterogeneous disturbances according to their physical characteristics. An adaptive periodic observer predicts multi-harmonic vibrations over the MPC horizon using linear-regression frequency estimation. A linear observer estimates the aperiodic disturbance, and a bounded long short-term memory (LSTM) network predicts its change over the input delay. Embedding periodic predictions into the MPC model while applying aperiodic compensation outside the optimizer limits amplification of aperiodic estimation errors and improves pointing accuracy under frequency changes and parameter mismatch. On the stated headroom envelope, input-set tightening provides feasible commands within the prescribed limits, and a regional practical tracking bound is established under explicit input-sequence and predicted-state margin conditions. A UAV-mounted two-axis gimbal platform is assembled for comparative indoor hovering experiments, complemented by simulations under frequency changes and parameter mismatch. In the reported trials, the proposed method achieves yaw and pitch relative-angle root-mean-square errors (RMSEs) of 0.770 degrees and 0.350 degrees, reducing tracking errors by 25.1% and 45.9% compared with linear active disturbance rejection control.

0.39