CS Paper Radar

Appointed-Time Fault-Tolerant Fast Terminal Sliding Control for UAVs with a Tracking Error-Based Disturbance Observer

Jinfa Li, Sheng Xu, Yanjie Wu, Chengyue Su

cs.AI ·submitted 2026-10-31 15:57 UTC · v1

Abstract

This paper addresses the critical challenge of high-performance fault-tolerant tracking control for quadrotor UAVs under complex conditions including external disturbances, parameter uncertainties, and actuator faults. A synergistic control framework is proposed by decoupling the system into position and attitude loops, each governed by the following three innovations. First, an Appointed-Time Prescribed Performance Function (AT-PPF) is developed to strictly constrain the tracking error within a predefined funnel boundary, ensuring convergence within a fixed time regardless of initial conditions. Second, a Tracking Error-Based Fixed-Time Composite Disturbance Observer (TFxTCDO) is developed to enable fast and accurate estimation of lumped disturbances without requiring full-state information or precise system modeling. This observer directly couples disturbance estimation with the control objective, thereby enhancing robustness and convergence. Third, a Fast Second-Order Terminal Sliding Mode Controller (NFSO-TSMC) is designed to achieve faster convergence and effective chattering mitigation. Simulation results demonstrate that the proposed control strategy significantly outperforms conventional methods in terms of tracking accuracy, fault recovery speed, and robustness against uncertainties.

Closest papers

Nearest neighbours by meaning across the whole index.

Learning-Oriented Fault-Tolerant Control for UAVs with Time-Varying Fault Estimation

eess.SY ·2026-10-22 ·Moh Kamalul Wafi
published similarity 0.70
Abstract · This is an extended version of the paper published in the proceedings of IEEE CoDIT

The increasing deployment of unmanned aerial vehicles (UAVs) in safety-critical applications has created a growing demand for control strategies that remain reliable in the presence of actuator and sensor faults. This paper presents a fault-tolerant control framework that combines constructive mathematical modeling, proportional--integral (PI) fault estimation, and learning-oriented control. A nonlinear quadcopter model is first developed using both the Newton--Euler and Euler--Lagrange formulations, from which a discrete-time linear model is derived for observer and controller design. A PI observer is then proposed to estimate actuator and sensor faults, with exponential estimation-error convergence established for constant faults in the absence of disturbances and ultimate boundedness established for slowly time-varying faults under bounded disturbances. The estimated fault signals are incorporated into an active fault-tolerant control architecture together with a Deep Deterministic Policy Gradient (DDPG) controller, which is trained using only the yaw channel and subsequently applied to improve closed-loop tracking performance. Numerical simulations illustrate the observer's estimation performance under constant and slowly time-varying faults, including bounded disturbances, and the tracking performance of the integrated controller under multiple actuator and sensor fault scenarios. The proposed framework combines model-based fault estimation with learning-based control to improve fault accommodation and tracking performance in UAV systems.

0.49

Observer-Based Robust Control for an Aerial Manipulator System under Unknown External Disturbances

eess.SY ·2026-09-07 ·Mayank Pandey, Sneha Gajbhiye
similarity 0.61
Abstract

This paper addresses the mathematical modeling and control of an aerial manipulator system comprising a quadrotor as the uncrewed aerial vehicle and a robotic arm as the manipulator. The dynamic model is established by identifying the overall center-of-mass velocity and the system's orientation as constraints, yielding a simplified, two-decoupled subsystems: a locked (overall translation) subsystem and a shape-space (actuation or overall rotation) subsystem, both subjected to external disturbances. Since the system is mechanically coupled, a critical challenge arises where constant bounded disturbances in the first subsystem manifest as time-varying, state-dependent disturbances in the second subsystem. Given that the quadrotor is inherently unstable, the movement of the robotic manipulator (RM) during flight can further jeopardize the stability of the entire QRM system if these disturbances and coupling effects are not effectively managed. To address this, we present a continuous nonlinear disturbance observer-based feedback control law, which enables the independent control of each subsystem while systematically eliminating cross-coupling effects. The efficacy of the proposed controller is validated through multiple simulations emulating practical operating conditions, thereby substantiating its real-world applicability and highlighting the core contributions of this work.

0.11

Quasi-Static Fault-Tolerant Feedback Control of a Quadrotor Carrying a Slung Payload under Rotor Failure

eess.SY ·2026-11-11 ·Mohamed Al Lawati, Adeel Akhtar
code/data similarity 0.61
Abstract · 8 pages, 8 figures

This paper presents a nonlinear control law for a slung payload system (SPS) consisting of a quadrotor unmanned aerial vehicle (UAV) carrying a slung payload. We propose a fault-tolerant control (FTC) design for the case of a complete single-rotor failure, i.e., only three functioning propellers. The failure is not modeled as a disturbance to be handled by estimation. Rather, we model the faulty SPS in control-affine form and design a quasi-static feedback law directly for the faulty dynamics. The controller achieves local exponential convergence of the payload position to a geometric path in space, rather than tracking a timed reference trajectory. Moreover, the transverse dynamics are exponentially stable, and the path-following manifold is rendered controlled invariant by feedback. Controlled invariance allows motion along the path to be prescribed independently through a tangential command while the state stays on the path-following manifold. The UAV body angular velocity remains bounded under bounded applied torque despite the failure. To validate the control design, numerical simulations apply the controller derived from the faulty SPS model in coordinates to the coordinate-free SPS model. Code and animations are available at https://gradslab.github.io/qs-sl/.

0.17

Selective Sliding Mode Control Enhances Robustness of Aerial Robots Under Disturbances

cs.RO eess.SY ·2026-10-28 ·Anoop Kiran, Thales C. Silva, Nora Ayanian
hot direction similarity 0.60
Abstract · 8 pages, 5 tables, 8 figures

Quadrotor control under disturbances such as wind gusts and payload variations remains challenging. First-order sliding mode control (SMC) and matched/unmatched uncertainty distinction are classical approaches; however, neither tells a practitioner which loops in a cascaded controller should be made robust to sustain disturbances, how to tune those loops, nor what the additional costs are on an embedded processor. Applying robust control uniformly across all axes addresses disturbances indiscriminately, adding tuning effort on axes where no disturbance acts. On inherently underactuated vehicles, disturbances along some axes cannot be opposed directly at all. We propose a principled methodology for deciding where robust control belongs in a cascaded architecture, with all control running onboard the vehicle. We recover the acting disturbance from PID hover flights under disturbance by inverting the equations of motion, use the recovered signal to identify and quantify the excited axes, and deploy robust control where it counts. Experiments on a Crazyflie 2.1 quadrotor under slung-payload and oblique-wind disturbances show tracking improvements concentrated on the axes the rule selects, and gain sweeps confirm that the switching gain reduces error on matched axes but has no effect on an excited unmatched axis, as the analysis predicts.

0.35

Model-Based Disturbance Rejection via Sliding-Mode Control: Continuous-Time Formulation and Proper Implicit Discretization

eess.SY ·2026-10-02 ·Benedikt Andritsch, Stefan Koch, Jaime A. Moreno
theory similarity 0.56
Abstract · preprint submitted to Automatica

We propose a robust exact sliding-mode controller for reference tracking with model-based disturbance rejection, where the disturbance is generated by a linear time-invariant model driven by a bounded input and may be bidirectionally coupled with the plant. The controller embeds the internal model principle and its error dynamics mirror those of the robust exact differentiator, ensuring finite-time convergence. We develop a proper implicit discretization for sampled-data implementation that preserves stability and accuracy. In the nominal case, which contains a disturbance generated by a $p$-th order integrator chain, the method achieves a control accuracy of $T^{p+1}\bar D$, with discretization time $T$ and disturbance bound $\bar D$. This accuracy is shown to relate to the fundamental lower bound by a factor depending only on the order of the disturbance model. Simulations demonstrate the efficacy of the proposed methods.

0.46

Estimation-Aware Control on Quadrotor State Manifolds via Anisotropic Covariance Filtering

eess.SY ·2026-11-11 ·Daniel Engelsman, Itzik Klein
similarity 0.55
Abstract · 11 Pages, 14 Figures, 2 Tables

Conventional nonlinear flight controllers operate under the implicit assumption of reliable, high-confidence state feedback. During transient sensing degradation or partial unobservability, state estimation uncertainty is frequently misinterpreted as physical tracking error, triggering aggressive and parasitic corrective inputs. To mitigate this vulnerability, we propose a generalized Estimation-Aware (EA) control framework that directly incorporates real-time estimator confidence into control execution. By mapping the posterior error covariance $\mathbf{P}_{k\mid k}$ into an uncertainty-dependent modulation operator, the EA mechanism dynamically scales feedback authority, performing anisotropic attenuation along weakly observed state directions to prevent false error corrections. Validated across six distinct control paradigms, the proposed approach demonstrates substantial performance gains across all baselines. In particular, when integrated into an Incremental Nonlinear Dynamic Inversion (INDI) architecture, the EA mechanism reduces tracking and estimation errors by 24.34% and 33.24%, respectively, at a high flight speed of 10 m/s.

0.20

Practical Complete Tracking Through Gimbaled Unidirectional Actuation with Application to Multirotor UAVs

eess.SY ·2026-10-22 ·Ian Willebeek-LeMair, Craig Woolsey
similarity 0.55
Abstract · 16 pages, 10 figures

This paper addresses the problem of practical tracking control for robotic vehicles with gimbaled unidirectional actuators, with special application to multirotor unmanned aerial vehicles. A widely recognized obstacle to tracking control for multirotors is the free-fall singularity --- when a multirotor is commanded to free fall, the vehicle's target attitude becomes undefined. This singularity is a pathology pertinent to all robotic vehicles with gimbaled unidirectional actuators. This paper considers the general theoretical problem for vehicles with gimbaled actuators. Starting from a baseline robust controller that assumes unconstrained inputs, we redesign the control law to be compatible with the gimbaled actuator. This is accomplished by driving the output of the gimbaled actuator to a ball centered at the target input value. The baseline controller's tracking guarantees are recovered in a practical sense. We apply our results to synthesize a global practical complete position tracking controller for multirotor unmanned aerial vehicles. The theory is demonstrated in simulation.

0.23

Physics-Informed and Data-Driven Composite Disturbance Separation and Predictive Control for Airborne Electro-Optical Gimbals with Multiple Constraints

cs.RO eess.SY ·2026-10-26 ·Yaokun Lu, Yifan Li, Zhixuan Zhang, Enmei Wang, Hao Teng +1 more
similarity 0.54
Abstract · 20 pages, 8 figures. Includes supplementary derivations and proofs. Demonstration video included as an ancillary file

This paper studies the constrained pointing control problem of airborne electro-optical gimbals subjected to composite periodic and aperiodic disturbances. Under carrier vibration, input delay, and actuator constraints, achieving line-of-sight stabilization and tracking is challenging. A disturbance-separated model predictive control (MPC) scheme is proposed to compensate these heterogeneous disturbances according to their physical characteristics. An adaptive periodic observer predicts multi-harmonic vibrations over the MPC horizon using linear-regression frequency estimation. A linear observer estimates the aperiodic disturbance, and a bounded long short-term memory (LSTM) network predicts its change over the input delay. Embedding periodic predictions into the MPC model while applying aperiodic compensation outside the optimizer limits amplification of aperiodic estimation errors and improves pointing accuracy under frequency changes and parameter mismatch. On the stated headroom envelope, input-set tightening provides feasible commands within the prescribed limits, and a regional practical tracking bound is established under explicit input-sequence and predicted-state margin conditions. A UAV-mounted two-axis gimbal platform is assembled for comparative indoor hovering experiments, complemented by simulations under frequency changes and parameter mismatch. In the reported trials, the proposed method achieves yaw and pitch relative-angle root-mean-square errors (RMSEs) of 0.770 degrees and 0.350 degrees, reducing tracking errors by 25.1% and 45.9% compared with linear active disturbance rejection control.

0.39