CS Paper Radar

Collision Avoidance and Collision Detection Strategies to Counteract Large-Scale FMCW Automotive Radar Interference

Francesco Miccoli, Vittorio Todisco, Fabrizio Cuccoli, Matteo Passeri, Vincent Martinez, Alessandro Bazzi

cs.NI ·submitted 2026-11-09 20:36 UTC · v1
published

Abstract

Automotive radars operating in dense traffic environments may experience significant mutual interference, potentially degrading sensing reliability for advanced driver assistance systems (ADAS). This issue motivates the development of techniques to mitigate interference among multiple radar-equipped vehicles sharing the same spectrum. This paper investigates interference mitigation strategies for uncoordinated radar networks through system-level simulation. Two approaches are considered: frame-by-frame collision avoidance (FbF-CA), which exploits idle intervals to measure the perceived interference and possibly adapt the operating frequency, and frame-by-frame collision detection (FbF-CD), which estimates interference during transmission based on observed chirp collisions. An event-driven radar network simulator is used to model realistic highway traffic and radar interactions. Results show that collision avoidance provides higher robustness when a larger bandwidth is available, while collision detection is more effective under bandwidth-limited conditions. The analysis highlights the trade-off between collision avoidance and collision detection mitigation strategies and provides design insights for scalable automotive radar deployments.

Comment
7 pages, 10 figures, 1 table. Accepted at IEEE VTC-Fall 2026, Boston

Closest papers

Nearest neighbours by meaning across the whole index.

RadarCom: Unlocking Simultaneous Communication and Sensing on Commodity Automotive mmWave Radars

cs.NI ·2026-10-27 ·Yi Wei, Yue Zhang, Peijun Hou, Qiuyu Liao, Nan Cen
published similarity 0.65
Abstract · Accepted to ACM SenSys 2027. 14 pages

Vehicle-to-vehicle (V2V) communication can improve road safety and traffic efficiency, yet its deployment remains limited by the need for dedicated communication hardware and supporting infrastructure. Meanwhile, production vehicles are already widely equipped with millimeter-wave radars for sensing. To unlock their communication potential, this paper presents RadarCom, a software-defined system that enables direct radar-to-radar communication on unmodified commercial off-the-shelf (COTS) automotive mmWave radars while preserving their native sensing functionality. The key insight is that mutual inter-radar interference, traditionally viewed as harmful, can be repurposed as a communication carrier. Based on this insight, RadarCom introduces slope-mismatch-based discovery, adaptive chirp synchronization, differential coding on range-FFT, and sensing-aware interference suppression to enable simultaneous communication and sensing without hardware modification, waveform redesign, or infrastructure support. We implement RadarCom on TI AWR2243 automotive radars and evaluate it under static, dynamic, and challenging real-world conditions. Results show an average effective data rate of 5.55 kbps with symbol error rates below 1.5%, while maintaining sensing F1 scores of up to 80.5% during concurrent communication. These results demonstrate the feasibility of transforming commodity automotive radars into dual-purpose communication and sensing devices.

0.41

A Systematic Evaluation of Infrastructure-Based Radar System for Highway Traffic Monitoring

cs.CV ·2026-09-22 ·Tianheng Zhu, Woei-chyi Chang, Alamss Riaz, Sogand Hasanzadeh, Yiheng Feng
publishedcode/data similarity 0.59
Abstract · Accepted by IEEE ITSC 2026. Compared with the accepted version, this version includes an expanded trajectory tracking analysis with addition…

Infrastructure-based radar systems offer robust and long-range solutions for traffic monitoring, yet their detection and tracking performance under real-world conditions remains insufficiently evaluated. This study introduces DRaT (Drone and Radar Trajectories), a dual-modality dataset of naturalistic vehicle trajectories collected at a highway merging segment in Fort Worth, Texas, to systematically assess radar sensing performance against drone-derived ground truth. The performance is evaluated at three levels: individual vehicle detection, trajectory tracking, and macroscopic traffic parameter estimation. For individual vehicle detection, the radar achieves an overall precision of 78% and a recall of 57%, with degraded performance under congested traffic conditions and at longer distances. At the trajectory level, the radar demonstrates reasonably strong tracking performance (IDF1 = 0.699), maintaining reliable vehicle identities when tracks are successfully established. For macroscopic traffic flow metrics, the radar accurately estimates space-mean speed (MAPE < 4%) but underestimates density and volume by approximately 23% due to missed detections. The paper also discusses practical deployment considerations and potential downstream applications of roadside radar sensing systems. To support reproducible research on infrastructure-based sensing systems, we have open-sourced the DRaT dataset on Zenodo: https://zenodo.org/records/20171110.

0.66

Physics-Based Plausibility Assessment of AI-Predicted Vehicle Parameters for Automotive Radar in Pre-Crash Scenarios

cs.RO ·2026-11-03 ·Rainer Engert, Patrick Zaumseil, Thomas Brandmeier
similarity 0.55
Abstract

Automotive radar is a key sensing modality for safety-critical vehicle functions due to its robustness under adverse weather and lighting conditions. Recent advances in AI-based radar perception enable the direct estimation of object parameters from a single radar measurement cycle. However, the internal decision process of data-driven models is typically not explicitly linked to the underlying radar sensing physics. Consequently, object estimates may achieve high statistical accuracy while remaining physically inconsistent with the measured radar signature, particularly in previously unseen scenarios. Such inconsistencies are especially critical for heading estimation, as they directly affect trajectory prediction and collision assessment in pre-crash scenarios. This paper presents a physics-based consistency assessment framework for validating AI-derived vehicle hypotheses in automotive radar perception. The proposed approach generates an expected radar signature from AI-estimated object parameters using a physics-based reference model that incorporates occlusion-dependent edge visibility, aspect- and angle-dependent RCS modeling, and characteristic wheel-induced MD signatures. The expected signature is compared with the observed radar point cloud using a Wasserstein-distance-based consistency metric computed from three complementary features: the spatial distribution of detections along object edges, the local detection count, and the radar reflection intensity. In this way, physically implausible object hypotheses can be identified and corrected independently of the underlying neural network architecture and without model retraining or architectural modifications. The proposed consistency module is integrated as a cascaded post-processing stage for vehicle heading estimation.

0.23

Highly Detailed Simulation for Connected Automated Vehicle Cooperative Driving

cs.NI ·2026-09-01 ·Andrei Fizulin, Ilia Dolgov, Andrei Karpukhin
published similarity 0.53
Abstract · 6 pages, 5 figures. Published in the 2026 International Russian Smart Industry Conference (SmartIndustryCon)

End-to-end simulation of connected and automated vehicles requires consistent fidelity across mobility, environment modeling, V2X radio propagation, and decision-making/control modules. However, 2D representations of complex road infrastructure often fail to capture critical signal propagation dynamics, leading to overly optimistic connectivity assumptions. This paper presents a unified workflow within CAVISE that integrates map-based scene preparation with microscopic mobility simulation. The proposed framework incorporates a comparative analysis of trace-driven propagation in 3D versus a simplified 2D baseline, and a modular interface for integrating Autonomous Intersection Management (AIM) models. Collectively, these capabilities enable high-fidelity Cooperative Driving Automation (CDA) experiments. Leveraging ray tracing using Sionna RT at 5.9 GHz with the same radio and solver configuration for both geometry variants, we show that planar reduction in multi-level road infrastructure can remove physically present occlusions and substantially distort signal-loss dynamics. In a bridge overpass case study, the 2D baseline eliminates an occlusion interval observed in 3D, changing the outage behavior from intermittent to consistently connected and yielding an average signal-loss shift on the order of 10 dB. These propagation-induced biases highlight the inability of planar models to capture vertical occlusions, necessitating 3D-aware communication modeling to ensure the validity of cooperative driving automation and intersection control evaluations.

0.43

Multi-Observer Vehicle Localization Case Study with Roadside Radar and Connected Vehicle Sensing

cs.CV cs.RO ·2026-08-17 ·Aleksi Pippuri, Nilusha Jayawickrama, Risto Ojala
datasetcode/data similarity 0.52
Abstract · 12 pages, 7 figures and 8 tables

In modern intelligent transportation systems, it is essential to accurately estimate vehicle positions, especially in mixed traffic conditions where both connected and conventional vehicles coexist. Roadside infrastructure and connected vehicles can provide complementary observations of the same traffic scene, but real-world evidence on decision-level fusion between these sources remains limited. This paper proposes a multi-observer vehicle localization framework that fuses compact object-level detections from a static roadside radar and a dynamic LiDAR-equipped connected vehicle. We evaluate the framework with real-world data collected at an urban intersection in Helsinki, Finland, with a separately instrumented target vehicle used as the reference trajectory. Two extended Kalman filter based strategies for the localization task were benchmarked. The performance of the radar and LiDAR sensors were evaluated separately, and the two fusion strategies were explored under nominal sensing conditions, reduced LiDAR update rates, simulated LiDAR occlusions, and different target-vehicle motion states. The results show that, under full LiDAR availability, fusion performance is dominated by the LiDAR observations, while the less accurate and less consistent radar observations provide only limited additional improvement. Nevertheless, AEKF achieves small gains over the LiDAR-only baseline, and object-level connected vehicle observations remain useful when shared at reduced update rates. These findings indicate that decision-level fusion provides scenario-dependent benefits rather than automatic improvement over a strong single-sensor baseline. We release the dataset and implementation on Github to support further research: https://github.com/AppuriAalto/multi-observer-vehicle-tracking

0.45

A Collision-Aware Predictive Rerouting Framework for Connected and Automated Vehicles

eess.SY ·2026-10-13 ·Tony Kinchen, Ting Bai, Andreas A. Malikopoulos
benchmark similarity 0.52
Abstract · 15 pages

In this paper, we investigate the problem of mitigating non-recurrent congestion in urban transportation networks through predictive and adaptive routing for connected and automated vehicles (CAVs). We propose a collision-aware predictive rerouting framework that integrates microscopic SUMO simulation, DCRNN-based spatiotemporal traffic-state forecasting, collision-window lookahead, and multi-objective route scoring. The routing controller uses predicted congestion, live emission information, route-length penalties, and incident-window constraints to decide when CAVs deviate from their current routes. The completed simulation campaign across three urban network scenarios, five CAV penetration levels, three random seeds, and multiple benchmark rerouting strategies shows that the proposed full framework does not dominate all baselines in aggregate travel time, distance, or emissions. Instead, its principal advantage is operational stability: it maintains comparable network-level efficiency while substantially reducing rerouting frequency relative to active rerouting baselines. These results demonstrate both the promise and the tradeoffs of embedding graph-based prediction and collision awareness into real-time CAV rerouting, and they motivate further work on forecast calibration, uncertainty-aware prediction, and system-level fairness between CAV and non-CAV traffic.

0.11

RIS-Assisted Radar-Communication Coexistence: Detection Analysis with Channel Uncertainties

eess.SP ·2026-08-24 ·Rawan Derbas, Shimaa Naser, Hamad Yahya, Sanjeev Gurugopinath, Paschalis C. Sofotasios +1 more
similarity 0.52
Abstract · Submitted for publication in IEEE journals

Reconfigurable intelligent surfaces (RISs) have emerged as a promising technology for improving communication reliability in radar-communication coexistence (RCC) scenarios, particularly for communication users (CUs) located inside radar exclusion zones, where only the radar is permitted to operate and the two systems remain uncoordinated. In such settings, CUs may suffer from strong radar interference whose phase is random and difficult to track while also facing difficulty in obtaining accurate CSI from the base station. These challenges become even more critical in the presence of RIS phase errors, which limit the applicability of conventional coherent detection methods. Motivated by these practical limitations, this paper develops an RIS-assisted RCC framework for a CU operating in an uncoordinated RCC setting. Within this framework, we derive two practical maximum-likelihood (ML)-based detectors, both of which avoid tracking the radar interference phase: 1) a non-coherent detector that does not require instantaneous CSI and incorporates RIS phase uncertainty, and 2) a mismatched coherent detector that relies on imperfect CSI. For the non-coherent case, we derive an exact likelihood expression and a closed-form detector in the low to moderate SINR regime. For the imperfect CSI case, we derive the corresponding closed-form detector in the low-to-moderate SINR regime, and analyze performance through pairwise error probability (PEP), yielding a tractable approximation based on Gauss-Chebyshev quadrature. Numerical and analytical results show that the proposed non-coherent detector closely matches the optimal ML detector, validating its practical usefulness.

0.25

Vehicle Speed-Aware Jammer-Resilient Receiver for Multi-User MIMO V2X Systems

eess.SP ·2026-11-02 ·Hanyoung Park, Yongjae Jang, Ji-Woong Choi
published similarity 0.52
Abstract · Presented at the 17th International Conference on Ubiquitous and Future Networks (ICUFN 2026)

Vehicle-to-everything (V2X) communication plays a crucial role in enabling connected and autonomous driving by supporting the reliable exchange of safety-critical information among vehicles and infrastructure. However, due to the open nature of wireless channels, V2X systems are vulnerable to various physical-layer attacks, among which jamming is one of the most intuitive and severe threats. In this paper, we propose a vehicle speed-aware jammer-resilient reception framework for multi-user multiple-input multiple-output (MIMO) V2X systems. The proposed method exploits the fundamental difference in Doppler characteristics between stationary jammers and moving vehicles. By transforming the received signal into the Doppler domain, the receiver identifies low-Doppler components associated with static interference and suppresses them through Doppler-domain filtering. Notably, the proposed approach does not require prior knowledge of the jammer channel or its spatial direction, making it suitable for practical V2X environments. Simulation results demonstrate that the proposed framework effectively mitigates strong jamming signals and significantly improves the achievable sum-rate compared with conventional receivers.

0.39