CS Paper Radar

Wideband Hybrid Beamforming via Programmable Unitary Mixer--TTD RF Networks

Nikola Zlatanov, Damir Salakhov, Zhen Gao

eess.SP ·submitted 2026-11-15 10:30 UTC · v1
published

Abstract

This paper proposes a wideband hybrid beamforming architecture whose analog front-end consists of fixed unitary mixers interlaced with programmable diagonal phase-shift/true-time-delay (TTD) layers. Under ideal passive-component assumptions, the analog beamformer is semi-unitary on every OFDM subcarrier, so the injected RF-chain power reaches the antenna ports without analog-network loss. We design the phase shifts and delays of the programmable diagonal phase-shift/TTD layers for OFDM sum-rate maximization. Numerical results show that increasing mixer--TTD depth improves the sum rate under ideal component assumptions and a common injected RF-power budget. With component losses included, a shallow design retains an advantage over the evaluated hybrid baselines at low-to-moderate powers, motivating deeper implementations with low accumulated loss.

Comment
Accepted
Journal ref
IEEE Wireless Communications Letters, 2026
DOI
10.1109/LWC.2026.3753452

Closest papers

Nearest neighbours by meaning across the whole index.

Exploiting Beam Squint for Near-Field Wideband Beamforming in Multi-User OFDMA Systems

eess.SP ·2026-10-17 ·Lanqing Zhi, Peilan Wang, Jun Fang
similarity 0.62
Abstract · 7 pages, 4 figures

The beam squint effect has traditionally been viewed as detrimental to near-field wideband beamforming due to the reduction of beamforming gain towards the desired direction. In this paper, we show that it can instead be harnessed as a benefit in a hardware-constrained orthogonal frequency division multiple access (OFDMA) system, where the system, equipped with a single radio-frequency (RF) chain, aims to serve multiple spatially distributed users by allocating different subcarriers to different users. By exploiting the beam squint effect, flexible frequency-dependent beamfocusing patterns are realized via parallel true-time-delay (TTD) units, enabling nearly full beamforming gain across users. In particular, we formulate a max-min rate optimization problem that jointly designs the time delays, subcarrier-user association, analog beamforming, and power allocation. To tackle the resulting nonconvex mixed-integer problem, a two-stage optimization framework is proposed. In Stage~I, subcarrier-user association and structured analog beamforming are jointly optimized. In Stage~II, power allocation is obtained via bisection search and inverse water-filling. Simulation results demonstrate that the proposed method can achieve a significant improvement by utilizing beam squint to serve multiple spatially distributed users in OFDMA systems.

0.24

Frequency-Dependent Hybrid Digital and Microwave Linear Analog Computer (MiLAC) Beamforming for Multiuser MIMO-OFDM Systems

eess.SP ·2026-10-25 ·Yiyang Peng, Zheyu Wu, Bruno Clerckx
similarity 0.58
Abstract

Microwave linear analog computing (MiLAC) has recently emerged as a promising approach for reducing the hardware and digital-processing requirements of large-scale multiple-input multiple-output (MIMO) systems. In narrowband multiuser systems, hybrid digital-MiLAC beamforming can achieve digital beamforming flexibility with only as many radio-frequency (RF) chains as data streams. However, extending this advantage to wideband systems is nontrivial because practical MiLAC circuits exhibit frequency-dependent responses. In this paper, we investigate hybrid digital-MiLAC beamforming for multiuser MISO-OFDM systems with a frequency-dependent MiLAC circuit model. We characterize the frequency dependence of MiLAC by relating the susceptance of each tunable component across subcarriers to its center-frequency value. Under this frequency coupling, we show that a single MiLAC circuit generally cannot simultaneously match the desired beamforming directions across all subcarriers, highlighting the essential role of subcarrier-dependent digital precoding. We then develop a block coordinate descent (BCD) algorithm to jointly optimize the digital and MiLAC beamformers for average sum-rate maximization. In particular, an efficient alternating direction method of multipliers (ADMM) algorithm is custom-designed to handle the frequency-coupled circuit constraints in the MiLAC beamformer subproblem. Simulation results show that the proposed hybrid digital-MiLAC design outperforms conventional hybrid digital-analog beamforming, particularly when fewer RF chains are available and the channel is more frequency-selective. With $64$ transmit antennas and $4$ data streams, it attains $96.3\%$ of the digital sum-rate using only $8$ RF chains. Furthermore, under highly frequency-selective channels and using $4$ RF chains, it provides a $48\%$ sum-rate gain over the conventional hybrid design.

0.39

Two-Layer Microwave Linear Analog Computer (MiLAC)-Aided Multi-User MIMO Networks

eess.SP ·2026-10-28 ·Xiaohua Zhou, Tianyu Fang, Matteo Nerini, Yijie Mao, Bruno Clerckx
theory similarity 0.55
Abstract

Microwave linear analog computer (MiLAC)-aided beamforming, which performs signal processing directly in the analog domain, has recently emerged as a promising alternative to fully digital and hybrid beamforming for multi-antenna systems. However, existing studies have shown that a single lossless and reciprocal MiLAC at the transmitter cannot, in general, attain the performance of fully digital beamforming in multi-user scenarios. To overcome this limitation, we propose a two-layer MiLAC-aided transmit beamforming architecture for downlink multi-user multiple-input multiple-output (MIMO) networks. Leveraging multiport microwave network theory, we first establish a general physics-compliant model of the proposed architecture, and then derive a simplified model under the assumptions of unilateral and perfectly matched amplifiers. We prove that, with lossless and reciprocal MiLACs, the two-layer MiLAC-aided transmitter can realize any fully digital transmit beamformer, while a single-layer MiLAC-aided receiver can attain the same achievable rate as a fully digital linear combiner. We then derive closed-form mappings from fully digital transmit beamformers and receive combiners to their corresponding MiLAC-aided analog implementations. Based on these equivalence results, we formulate a sum-rate maximization problem for the considered multi-user MIMO network and develop an optimization framework for jointly designing the power allocation and scattering matrices of the MiLAC-aided transceivers. Numerical results validate the theoretical analysis and show that the proposed two-layer MiLAC-aided design attains the same sum-rate performance as its fully digital counterpart.

0.21

When Every Bit Counts in Quantized Beamforming: From CSI Feedback to Low-Resolution Hardware

eess.SP ·2026-10-20 ·Yasaman Khorsandmanesh, Parisa Ramezani, Emil Bjornson
similarity 0.54
Abstract

Multiple-input multiple-output (MIMO) is a key technology in modern wireless networks, but its performance is often analyzed under ideal hardware assumptions. In practical implementations, however, quantization appears throughout the signal-processing chain, including channel state information (CSI) feedback, fronthaul signaling, beamforming coefficients, data converters, and finite-resolution phase shifters. These impairments do not act independently: they alter the channel information available for beamforming, constrain the feasible transmit signals, and can ultimately limit beamforming gain and interference suppression. This article provides a perspective on quantized beamforming by connecting its main sources, performance implications, and mitigation strategies. We discuss codebook-based CSI feedback, quantization-aware beamforming, low-resolution converter modeling, and finite-resolution hybrid beamforming, and use representative numerical examples to illustrate when quantization becomes a dominant performance bottleneck. We further highlight emerging directions in joint beamforming and quantization design, adaptive-resolution architectures, and new antenna technologies with discrete hardware constraints. The key message is that finite-resolution effects should be modeled explicitly and incorporated into the beamforming design rather than treated as an afterthought.

0.20

An Efficient SIM Beamforming Scheme Based on Physical-Empowered Projected Gradient

eess.SP ·2026-10-29 ·Yuzhi Yang, Hao Liu, Tianhao Guo, Jiancheng An, Lu Gan +2 more
similarity 0.53
Abstract · under review by ieee trans

Stacked Intelligent Metasurfaces (SIMs) have emerged as a promising technology for next-generation wireless systems. Especially in multi-input multi-output (MIMO) systems, it has the potential to realize complicated wave-domain transformations with low hardware costs and energy consumption. However, SIM-assisted MIMO systems face two major challenges in channel estimation and beamforming. As the SIM elements do not have the signal processing capability, channel estimation can only be conducted in an indirect manner, which makes it challenging. Moreover, the precoding optimization after channel estimation is non-convex and also difficult. Targeting these issues, we exploit the time-division duplex (TDD) channel reciprocity to calculate the gradient backpropagation in an over-the-air manner. Based on this structure, we propose a gradient-based optimization framework that optimizes beamforming without explicitly estimating the SIM--UE channel. The proposed method, namely the physical projected gradient descent (P2GD) method, optimizes the achievable sum rate while incorporating zero-forcing (ZF) constraints. Based on the method of incorporating the ZF restriction, we propose two variations of P2GD, namely user equipment (UE)-P2GD and base station (BS)-P2GD. We also provide a theoretical convergence analysis and projected gradient techniques to ensure physical feasibility. Simulation results show that the proposed approach can achieve suboptimal beamforming in the multi-user system within a small number of over-the-air iterations, using a per-direction signaling budget below the pilot cost of explicit SIM--UE channel estimation. The proposed method provides a low-overhead beamforming scheme for SIM systems without explicit SIM--UE channel estimation.

0.48

MiLAC-Aided Beamforming for MIMO Over-the-Air Computation

cs.IT ·2026-08-13 ·Yaru Wang, Deyou Zhang, Qingchao Li, Jun Liu, Chuang Shi
similarity 0.53
Abstract

Over-the-air computation (AirComp) enables low-latency wireless data aggregation, but its accuracy is limited by imperfect signal alignment over fading channels and receiver noise. Fully digital beamforming improves aggregation accuracy in multiple-input multiple-output (MIMO) AirComp systems but requires one radio-frequency (RF) chain per antenna. To reduce this hardware burden, we investigate microwave linear analog computer (MiLAC)-aided beamforming for MIMO AirComp. Under a lossless and reciprocal MiLAC model, we jointly optimize the transmit digital precoding matrices and the receive-side MiLAC aggregation matrix to minimize the mean squared error (MSE). An alternating optimization algorithm is developed, in which the precoding matrices are optimally updated using the Karush--Kuhn--Tucker conditions and bisection, while the resulting convex aggregation matrix subproblem is solved globally using projected gradient descent. Numerical results verify the algorithm's convergence and demonstrate that MiLAC-aided beamforming approaches the MSE performance of fully digital beamforming with substantially fewer RF chains and outperforms phase-shifter-based hybrid beamforming under the same RF-chain budget.

0.04

Ray-Tracing-Parameter-Based Lightweight Hybrid Precoding via Cascade XGBoost for Wideband Massive MIMO-OFDM Systems

eess.SP cs.IT ·2026-11-01 ·Po-Heng Chou, Wei-Chen Lin, Wan-Jen Huang, Walid Saad, Ronald Y. Chang
similarity 0.53
Abstract · 6 pages, 4 figures, 3 tables. Submitted to the IEEE International Conference on Communications (ICC) 2027

Hybrid precoding reduces the radio-frequency (RF) hardware burden in wideband massive MIMO-OFDM systems, but conventional optimization and deep neural network (DNN)-based approaches can incur high online complexity. This paper proposes XGB-SVD, a lightweight hybrid precoding framework that maps compact ray-tracing path parameters directly to analog beamforming codeword indices using cascade eXtreme Gradient Boosting (XGBoost). The cascade captures sequential beam-selection dependencies and transmit--receive propagation correlation, while the digital precoder and combiner are obtained from the reduced-dimensional equivalent channel using singular value decomposition (SVD). Evaluations over five DeepMIMO scenarios spanning sub-6-GHz and millimeter-wave bands show that XGB-SVD consistently outperforms the considered DNN baselines and approaches simultaneous orthogonal matching pursuit (SOMP) in several environments. Cross-scenario results further indicate improved transfer from propagation-diverse training environments, while XGB-SVD provides lower online computational and training costs than the DNN baselines.

0.37

uhd-rfsoc: Bringing Off-the-Shelf RFSoC Boards to Unmodified UHD Applications

cs.NI cs.AReess.SP ·2026-11-13 ·Wei Cheng, Yiming Li, Junyao Zheng, Cheng-Bin Chen, Tingjun Chen
code/data similarity 0.52
Abstract

Next-generation wireless research relies on software-defined radios (SDRs) with more channels and larger bandwidth. The USRP family is one of the most widely used SDR platforms, and much of the wireless software ecosystem is built on top of the USRP hardware driver (UHD). However, each USRP model comes with a fixed channel count, bandwidth, and streaming capability. Off-the-shelf radio frequency system-on-chip (RFSoC) boards, on the other hand, integrate up to 16 analog-to-digital converters (ADCs) and 16 digital-to-analog converters (DACs) operating at several gigasamples per second (GS/s), but existing UHD applications cannot directly use them. We present uhd-rfsoc, an open-source FPGA design and host software stack that turns these boards, including the 16-channel ZCU216 and the RFSoC 4x2, into standard UHD devices without modifying UHD. Through standard UHD calls, applications can configure the carrier frequency, channel count, the per-channel I/Q sample rate, and the wire format. uhd-rfsoc combines timestamped, flow-controlled sample transport in the FPGA with data plane development kit (DPDK) packet processing and vectorized sample conversion on x86 and Arm hosts. The built bitstreams for a number of RFSoC board configurations with varying RF data converter rates, channel counts, I/Q sample rates, and wire formats all successfully pass UHD's built-in streaming benchmarks. We further demonstrate compatibility with unmodified GNU Radio flowgraphs, a custom GPU-accelerated transceiver digital signal processing pipeline, as well as the OCUDU and Duranta 5G radio access network stacks using both software and commodity user equipment.

0.32