CS Paper Radar

Compute Before You Digitize: ADC-less Mixed-Signal Processing for Scalable Cryogenic Qubit Readout

Qirui Zhang, Ben Toby, He Wang, Benjamin Lienhard, David Blaauw, Dennis Sylvester

cs.AR quant-phcs.ETeess.SP ·submitted 2026-11-17 19:52 UTC · v1

Abstract

We introduce DIRAC, an ADC-less in-cryostat qubit readout architecture that uses analog computing to redraw the analog-digital boundary. Directly operating on the front-end's analog output, passive complex mixers perform the equivalent of digital demodulation, ping-pong active-RC integrators average their outputs into down-sampled per-qubit traces, and a time-domain stage digitizes them, eliminating Nyquist-rate ADCs. A TX-RX co-design derives the mixers' local oscillators from the readout transmitter's baseband rather than per-tone PLLs. A per-line calibration flow trains the matched filter jointly with the neural network, improving fidelity and enabling low-bit-width, low-voltage digital processing. Designed in 22 nm FD-SOI and evaluated at 4 K on 1.12M experimental shots, DIRAC matches the fidelity of a floating-point (FP32) digital pipeline for readout windows down to 750 ns, at 31.6$\times$ and 238$\times$ lower energy than the fixed-point (FxP) and FP32 pipelines. It cuts the total 4 K power per physical qubit by 50.4% and 68.6% relative to FxP and room-temperature flex cables, respectively. At a fixed logical-qubit count and 4 K budget, this yields, against FxP, a code distance larger by 2 to 6 and a 1.6-7.3$\times$ (Willow) and 4.9-204$\times$ (SI1000, $p = 10^{-3}$) lower logical error rate.

Closest papers

Nearest neighbours by meaning across the whole index.

Adaptive carrier signal synthesis for frequency-division multiplexed cryogenic detector readout

eess.SP physics.ins-det ·2026-11-12 ·Timo Muscheid, Benedikt Keppner, Daniel Crovo, Robert Gartmann, Marvin Fuchs +3 more
unusual similarity 0.59
Abstract · TWEPP26 Proceedings

Frequency-domain multiplexing is a fundamental technology for readout of cryogenic detector arrays on a single transmission line. Synthesizing a large number of static carrier tones for resonator stimulation eventually drives the cryogenic low-noise amplifier beyond its P1dB, introducing detector signal distortion. Scaling array sizes to O(10^6) detector pixels therefore demands minimizing the total power on the transmission line by continuous tracking of the resonances, which requires the readout electronics to be capable of updating the carrier tones dynamically. This work presents an scalable FPGA-based implementation for carrier signal synthesis based on a numerically controlled oscillator and a polyphase filter bank, enabling real-time frequency adaptivity as well as frequency resolution of 4 mHz to precisely tune the operating point, while simultaneously reducing resource usage compared to the current memory-based implementation.

0.25

A Hybrid Digital/Analog Polyphase Filtering Approach for High-Speed RF-DACs

eess.SP ·2026-11-06 ·Behdad Jamadi, Jungmin Lee, Tarun Cousik, Rohit Rangaraj, Jeffrey S. Walling
similarity 0.56
Abstract · 11 pages, 5 figures, 5 tables

This paper proposes a hybrid polyphase interpolation for RF-DACs that removes the need for full-rate digital commutation by using passive combining on the RF-DAC itself. A P-branch polyphase FIR filter is factored into M streams, each formed by a (P/M)-way digital commutator at fRF/M and driving a dedicated RF-DAC slice, giving either partial digital (1<M<P) or fully analog (M=P) recombination. We show that the slice array acts as a single full-rate DAC with an M-times longer zero-order hold, derive yield laws for slice gain, timing and unit-capacitor mismatch, and find that with retiming the binding requirement is sub-picosecond matching of the fRF clock arrival, so the best choice is the smallest M that closes digital timing. Two 28-nm digital macros, designed for a 12.8GSps output rate and verified by post-layout simulation, illustrate a 4-phase variant that closes timing up to 14.4GSps with its digital logic at fRF/4 and an 8-phase variant that closes timing up to 16GSps with its digital logic at fRF/8. The analog recombination is evaluated with a behavioral model of the slice array. The architectures target wideband software defined radio (SDR) platforms, including cognitive radio, electronic warfare, and satellite communications.

0.30

uhd-rfsoc: Bringing Off-the-Shelf RFSoC Boards to Unmodified UHD Applications

cs.NI cs.AReess.SP ·2026-11-13 ·Wei Cheng, Yiming Li, Junyao Zheng, Cheng-Bin Chen, Tingjun Chen
code/data similarity 0.56
Abstract

Next-generation wireless research relies on software-defined radios (SDRs) with more channels and larger bandwidth. The USRP family is one of the most widely used SDR platforms, and much of the wireless software ecosystem is built on top of the USRP hardware driver (UHD). However, each USRP model comes with a fixed channel count, bandwidth, and streaming capability. Off-the-shelf radio frequency system-on-chip (RFSoC) boards, on the other hand, integrate up to 16 analog-to-digital converters (ADCs) and 16 digital-to-analog converters (DACs) operating at several gigasamples per second (GS/s), but existing UHD applications cannot directly use them. We present uhd-rfsoc, an open-source FPGA design and host software stack that turns these boards, including the 16-channel ZCU216 and the RFSoC 4x2, into standard UHD devices without modifying UHD. Through standard UHD calls, applications can configure the carrier frequency, channel count, the per-channel I/Q sample rate, and the wire format. uhd-rfsoc combines timestamped, flow-controlled sample transport in the FPGA with data plane development kit (DPDK) packet processing and vectorized sample conversion on x86 and Arm hosts. The built bitstreams for a number of RFSoC board configurations with varying RF data converter rates, channel counts, I/Q sample rates, and wire formats all successfully pass UHD's built-in streaming benchmarks. We further demonstrate compatibility with unmodified GNU Radio flowgraphs, a custom GPU-accelerated transceiver digital signal processing pipeline, as well as the OCUDU and Duranta 5G radio access network stacks using both software and commodity user equipment.

0.35

A Reconfigurable Pipelined-SAR ADC with Embedded Compression for Temporal Compressed-Sensing Ultrasound Imaging

eess.SP physics.med-ph ·2026-08-28 ·Reza Pakdaman Zangabad, Xitie Zhang, Levent Degertekin, Shaolan Li
similarity 0.54
Abstract · 15 pages, 11 figures, Journal

Compact ultrasound imaging systems are increasingly constrained by receiver-side sampling, conversion, memory, and data-transfer requirements. This work presents a compressed-sensing pipelined successive-approximation-register analog-to-digital converter (CS-SAR ADC) for acquisition-side temporal compression of pre-beamformed medical ultrasound radio-frequency (RF) data. Pseudo-random polarity modulation and charge-domain accumulation are embedded in the SAR sampling network so that multiple consecutive RF samples are encoded into one measurement before quantization, supporting temporal compression ratios of $N_{cT}=1$, 2, and 4. The compressed outputs are recovered off chip using a probe-specific pulse-dictionary RF model and then processed with conventional ultrasound beamforming. A 65-nm CMOS prototype was measured with a 1.2-V supply and 50-MHz master clock. In the non-compressed mode, it operates at 10 MS/s, consumes 964.49~$μ$W, and achieves 44.12-dB SNDR and 56.40-dB SFDR for a 7.7-kHz input. The ADC output rates decrease to 5 MS/s and 2.5 MS/s for $N_{cT}=2$ and 4. Across all evaluated RF traces, median NCC values were 0.981 and 0.932, with median NRMSE values of 0.36 and 0.56, respectively. Wire-phantom localization error remained below 0.04 mm with no appreciable FWHM degradation. In the speckle-rich cyst phantom, SSIM remained 0.94 and 0.87, while CNR decreased from 3.534 in the reference to 2.047 and 1.379. These results demonstrate a hardware-realistic tradeoff in which temporal compression substantially reduces ADC conversion count and output data rate while preserving point-target geometry, whereas low-contrast cyst conspicuity is more compression-sensitive.

0.28

You Only Charge Once 2.0 : A End-to-End Analog Computing-in-Memory Architecture with Reconfigurable Switched Capacitors

cs.AR ·2026-08-11 ·Zihao Xuan, Yewen Li, Jia Chen, Wei Xuan, Xiao Huo +1 more
similarity 0.54
Abstract · 13 pages, 19 figures

Analog Computing-in-Memory (ACiM) accelerates deep neural networks by keeping weights inside memory arrays and executing dot products in the analog domain. However, modern ACiM accelerators are often limited by the "ADC wall": analog-to-digital converters consume a large fraction of energy and area, while bit-sliced execution repeatedly invokes these converters. Existing designs reduce this cost with low-resolution readout or time multiplexing, but they either lose output fidelity or introduce serialization overhead. Charge-CIM addresses this bottleneck by using switched-capacitor charge redistribution as a unified computing and conversion substrate. The same capacitor fabric performs input conversion, analog MAC, weighted shift-and-add, and readout quantization, reducing both standalone converter overhead and intermediate ADC invocations. A differential readout path further combines paired partial sums during ADC quantization, providing a highly compact and energy-efficient solution for array integration. With dataflow architecture support, we evaluated Charge-CIM on a suite of DNN benchmarks, from CNNs to Transformer models, and experimental results show that Charge-CIM reduces ADC energy by 91.7% under our evaluation setup and improves energy efficiency by 2.7x and throughput by 2.0x compared to the state-of-the-art charge-domain CIM accelerator.

0.10

A Timing-Robust Frequency-Interleaved ADC with Embedded Analog Fourier Transform

eess.SP ·2026-10-02 ·Xingchen Chao, Yunqiang Xu, Qiang Yu, Christian Adam, Qiang Li
similarity 0.53
Abstract

Timing errors represent a fundamental challenge in high-speed analog-to-digital converters (ADCs). This paper presents a frequency-interleaved architecture with inherent robustness to timing errors. The frequency interleaving is achieved by an embedded analog Fourier transform (AFT), allowing accurate channel spacing. The charge-based passive AFT is able to share the capacitor array with the capacitive DAC of the subsequent data conversion. A circuit implementation for the complex-valued irrational coefficients in the AFT matrix is proposed, which eliminates the device-ratio-induced systematic errors. Measured at 10b 13GS/s, the calibration-free ADC achieves 45.8-dB SNDR and 56.1-dB SFDR at Nyquist. The ADC consumes 26.4mA from a single 1V supply, resulting in a Walden FoM of 12.7 fJ/conv.-step.

0.25

Precision and resource scaling of real-time flux distortion compensation for superconducting quantum control

cs.AR quant-ph ·2026-09-23 ·Qi Zhou, Zi-Hao Mei, Peng Duan, Peng Wang, Liang-Liang Guo +5 more
similarity 0.52
Abstract · 17 pages, 9 figures

Real-time waveform generation supports dynamic quantum circuits without pre-storing complete waveforms for every execution path. However, long-lived distortions in flux-control lines degrade gate fidelity, requiring compensation to account for the actual pulse history. A frequency-domain inversion and time-domain fitting method is proposed for resource-efficient real-time flux distortion compensation. The method fits the reconstructed compensation impulse response with a compact hybrid infinite impulse response (IIR) and finite impulse response (FIR) filter. Look-ahead parallelization enables this filter to process synthesized waveforms at 1.2GSa/s on a field-programmable gate array (FPGA). Two-qubit cross-entropy benchmarking shows that real-time IIR filtering achieves a median controlled-Z Pauli fidelity close to the software-reference value of 99.57%. Numerical analysis and FPGA synthesis indicate approximately logarithmic growth in hardware resource use with compensation timescale. Extending compensation from microsecond to hundred-microsecond timescales increases look-up table (LUT) and digital signal processing (DSP) resource use by only about 14% and 4%, respectively, while maintaining a relative arithmetic error below $10^{-4}$. This work provides a scalable hardware foundation for high-fidelity flux control in dynamic superconducting quantum circuits.

0.26

SMART-AIMC: Sensitivity-Aware Mixed ADC Resolution with Fine-Grained Tunability for Analog In-Memory Computing

cs.AR cs.AI ·2026-11-01 ·Yung-Chin Chen, Ourania Stouraiti, Naveen Verma
similarity 0.52
Abstract

Analog In-Memory Computing (IMC) is a promising paradigm for accelerating GEMM-based AI workloads by executing computations directly within the memory array in the analog domain. While IMC delivers substantial energy and throughput improvements, it can suffer from significant task accuracy degradation due to analog-to-digital converter (ADC) quantization noise, which occurs at the GEMM output and is thus different from weight/activation quantization, which occurs at the GEMM input. Mixed ADC resolution allows IMC modules to choose between high- and low-resolution ADC modes with different energy costs, offering a compelling accuracy-energy trade-off. However, selecting ADC resolutions across IMC units while respecting hardware granularity constraints remains challenging. In this paper, we propose SMART-AIMC, a Sensitivity-aware Mixed ADC Resolution framework with fine-grained Tunability for Analog In-Memory Computing. SMART-AIMC correlates the algorithmic task loss to hardware ADC quantization noise in the form of an ADC Channel Sensitivity (ACS) metric. Using this metric, SMART-AIMC systematically, and in a disciplined manner, allocates ADC resources to critical computations. Furthermore, we introduce a sensitivity-based channel reordering scheme that overcomes the hardware granularity constraints with no runtime overhead and approaches the optimal ADC quantization possible for the model. Evaluated across diverse workloads, SMART-AIMC unlocks a superior accuracy-energy Pareto frontier, providing (1) higher task accuracy at matched energy budgets and (2) fine-grained tuning across efficiency targets, from aggressive energy savings to near-digital inference accuracy. At the latter operating point, SMART-AIMC achieves $6.99\times$ higher modeled system-level energy efficiency for linear projections than the INT8 digital baseline with negligible accuracy degradation.

0.23