CS Paper Radar

An Ultra-Compact Differential V-Band Power Amplifier Using EDMOS Transistors With 18.1 dBm P1dB and 21% PAE in 22nm FD-SOI CMOS

Han Zhou, Torgil Kjellberg, Haojie Chang, Christian Fager

eess.SP eess.SY ·submitted 2026-08-25 15:15 UTC · v1
unusual

Abstract

This paper presents a compact, fully differential, two-stage millimeter-wave (mm-wave) cascode power amplifier (PA) designed and implemented in a 22nm FD-SOI CMOS process (22FDX+). The PA employs the newly introduced extended-drain MOS (EDMOS) device in 22FDX+, together with a carefully engineered device core and transformer baluns. At 50 GHz, the prototype achieves 18.8 dBm saturated output power (PSAT), 18.1 dBm 1-dB compression output power P1dB, and 21% power-added efficiency (PAE) at P1dB. To the best of our knowledge, this work achieves the highest reported power density of 2.6 W/mm2 among single-way, two-stage CMOS cascode PAs.

Closest papers

Nearest neighbours by meaning across the whole index.

An Efficient W-/D-Band Power Amplifier in a 130 nm SiGe BiCMOS Process

eess.SP eess.SY ·2026-08-25 ·Han Zhou, Yu Yan, Haojie Chang, Herbert Zirath
unusual similarity 0.58
Abstract

This paper presents a wideband power amplifier (PA) designed and implemented in Infineon Technologies' 130-nm SiGe BiCMOS process for upper W-band and lower D-band applications. A complete load-pull simulation methodology is carried out, and a band pass filter (BPF)-based matching strategy is employed for the design of the output and inter-stage matching networks. The fabricated PA prototype achieves a small-signal gain 3-dB bandwidth of 71-133 GHz. Moreover, it maintains a relatively flat gain of approximately 15.7 dB over 75-128 GHz, with less than 1-dB fluctuation. The measured saturated output power is 8.8-11.7 dBm, while the measured peak power-added efficiency (PAE) is 7.2-11.1%. These results demonstrate the potential of SiGe BiCMOS technology for wideband and integrated transmitter front ends operating across the W-/D-band frequency range.

0.35

A 188-260 GHz Distributed Frequency Multiplier Achieving 4 dBm Saturated Output Power in 65 nm CMOS

eess.SP ·2026-10-03 ·Ahmet Yelboğa, Shuhei Amakawa, Korkut Kaan Tokgöz
similarity 0.51
Abstract · Latin America Microwave Conferance 2026

Sub-terahertz (sub-THz) low-phase-noise signal sources commonly employ frequency multiplier chains to extend the operating frequency of lower-frequency oscillators. This paper presents the design and simulations of a wideband, high-output-power frequency multiplier implemented in TSMC 65 nm CMOS technology. The proposed design is based on a distributed frequency multiplier with a quarter-wave transmission line termination at the drain side, where the reflected and forward-traveling waves are constructively combined to enhance the output power. The proposed frequency doubler achieves a minimum conversion loss of 12 dB at an input frequency of 115 GHz with an input power of 12 dBm, resulting in an output power of 0 dBm and 12.6 dB fundamental suppression. For the same input power, the output power remains within 3 dB of its peak value over the 188-260 GHz output frequency range. At 230 GHz, the proposed design achieves a saturated output power of 4 dBm while occupying an area of 0.149 mm^2.

0.25

Edge-Combining Subharmonic Mixer-First Receiver

eess.SP ·2026-11-17 ·Eric Danson, Jeffrey S. Walling
unusual similarity 0.50
Abstract · 4 pages, 10 figures, 1 Table

A 1-10 GHz subharmonic mixer-first receiver using edge combining to drive N-path switches from 50% duty-cycle clocks at half the local oscillator (LO) frequency avoids the gain penalty of harmonic mixing. Inverter-based differential baseband amplifiers with back-gate feedback linearization set their gain by process-defined capacitance ratios, using no additional components and consuming no additional power. A 22 nm fully depleted silicon on insulator (FD-SOI) prototype receiver achieves a conversion gain of 12.8-18.1 dB and a noise figure of 5.7-11 dB across the band. It achieves up to 15.4 dBm out-of-band IIP3 while consuming 16.7-22.3 mW.

0.31

SCALE-X: A Systematic Complexity-Aware Low-Precision Approach for Digital Predistortion

eess.SP ·2026-09-08 ·Anees Rehman, Mohd Tasleem Khan, George Goussetis, Yuan Ding, Jaiyu Hou +1 more
similarity 0.44
Abstract

This letter presents SCALE-X, a systematic, complexity-aware, low-precision, model-based digital predistortion (DPD) technique for power amplifiers with enhanced capabilities. The proposed approach employs a novel complexity-aware coefficient pruning method, which, when combined with optimized fixed-point modeling, enables more accurate capture of quantization effects and supports better informed decisions for implementation. Targeted configuration of model order, memory depth, and coefficient bitwidth delivers dramatic cuts in computational overhead without much sacrificing accuracy. Field-programmable gate array implementation demonstrates practical trade-offs with improved overall efficiency.

0.25

Breaking the Myth of Four-Tier Stacked Transistors for Logic: an Investigation from Process to Device and Block-Level PPA

cs.ET cond-mat.mes-hall ·2026-11-18 ·Jianxiang Jin, Haoran Lu, Yihan Luo, Yanbang Chu, Yibo Zhang +11 more
similarity 0.42
Abstract · 4 pages,17 figures,conference

For the first time, this work evaluated whether 4-tier stacked transistors can translate the straightforward density gains into realistic chip-level scaling benefits. A practical dual-sided 4-tier transistor-stacking CFFET (Flipped CFET-to-CFET) process was proposed, on which a DTCO framework spanning standard-cell design, local interconnects, RO analysis, and physical implementation was built under 2A node design rules. The CFFET was also benchmarked with its 2-tier transistor-stacking counterparts FFET. Among CFFET configurations, the best-performing Symmetric Power still lags FFET by 11.2% in RO frequency due to the complex MOL parasitics. At the block level, CFFET reduces the Ibex RISC-V core area by only 12.8% (far below the 40% nominal cell-height reduction), while running 10.9% slower at iso-power. We further introduced a novel Tetris-like cell stitching to minimize the area overhead, which allows non-rectangular cell design and recovers 7.4% area in a 1-bit ALU design. An optimized NanoStack CFFET was finally proposed, inspired by previous work. This work indicates that straightforward vertical 4-tier stacking proves insufficient to guarantee enough PPA benefits, though the resulting design insights may guide future advanced architectures.

0.23

A Study on THz Plasmonics in a CMOS Continuum Transistor Array

eess.SY ·2026-08-21 ·Hossein Naghavi, Shruti Chakraborty, Zainulabideen Khalifa, James Gruber, Aditya Varma Muppala +4 more
similarity 0.40
Abstract

This work addresses the limitations of CMOS at terahertz (THz) frequencies, where charge transit time and parasitic capacitances restrict the maximum operating frequency, fmax. As transistor dimensions shrink, reduced current handling capabilities further challenge CMOS, necessitating novel circuit design approaches for the THz domain. By leveraging the plasma characteristics of electron channels in CMOS transistors, this study explores a potential solution for THz signal amplification. Key mechanisms in plasma wave amplification within a continuum transistor array (CTA) formed by 28 nm fully depleted silicon-on-insulator (FD-SOI) CMOS transistors are investigated. A hydrodynamic transport model combined with Pierce's theory is presented to describe plasma wave propagation along the CTA. Simulations of gated amplifiers demonstrate the potential for THz signal amplification in advanced fabrication nodes. Finally, a proof-of-concept plasma wave amplifier operating at 700 GHz has been designed and fabricated, exhibiting amplification along the plasma wave propagation path.

0.23

StreamingDPD: A 1.28-GSa/s Instantaneous-Power-Gated Depthwise TCN Accelerator for Real-Time 320-MHz Digital Predistortion

eess.SP cs.AR ·2026-11-17 ·Yizhuo Wu, Xinling Wang, Chang Gao
similarity 0.39
Abstract

State feedback between successive samples limits the streaming throughput of recurrent neural networks for digital predistortion (DPD). We present StreamingDPD, an accelerator that processes 320-MHz signals at 1.28 GSa/s. Its 207-parameter instantaneous-power-gated depthwise temporal convolutional network (IPG-DWTCN) uses $|x[n]|^2$ to gate feature channels and causal dilated depthwise convolutions to model power amplifier memory. The network maps to a spatially unrolled fixed-point pipeline with shift-based quadratic activations and layer-wise mixed precision, sustaining one complex sample per cycle per lane. Its algorithmic cost is 554 floating-point operations per complex sample, 30.1% fewer than the recurrent baseline with the best linearization performance. In RF playback measurements on three power amplifiers driven by 40- to 320-MHz Wi-Fi 6/7 and 5G NR waveforms, IPG-DWTCN achieves the lowest mean adjacent-channel power ratio (ACPR) and ranks first or ties for first in mean error vector magnitude (EVM) against five neural baselines of comparable size. Four-lane FPGA hardware-in-the-loop tests on a 320-MHz 4096-QAM Wi-Fi 7 waveform achieve -45.82 dBc ACPR and -42.94 dB EVM at 1.28 GSa/s. At the same sample rate, post-layout evaluation of a single-lane 12-nm FinFET ASIC yields a 0.10 mm$^2$ core, a 52-cycle (40.63 ns) latency, and an estimated typical-corner power of 142.21 mW (111.10 pJ/sample). Relative to the prior 22-nm recurrent DPD ASIC, the design provides 5.1 times the throughput at about one-seventh the energy per sample.

0.25

Comparative Analysis and Behavioral Modelling of Power Amplifiers in FR3

eess.SP ·2026-10-14 ·Cel Thys, Rodney Martinez Alonso, Ali H Alsarraf, Zhuangzhuang Cui, Dominique Schreurs +1 more
publishedcode/data similarity 0.38
Abstract · Accepted at 2026 IEEE 1st Annual Integrated Sensing and Communication Conference (ISAC)

Power amplifier (PA) nonlinearity is a critical transmitter impairment in the upper mid-band (7 GHz to 24 GHz), designated as Frequency Range 3 (FR3) in emerging 6G standardisation. The 3GPP PA model baseline, TR 38.803 Annex A, was derived from 2.1 GHz and 28 GHz measurements and has not been revisited yet for FR3 standards work. This paper addresses that gap with characterisation measurements of multiple PA devices-under-test (DUTs), driven into gain compression in the 7 GHz and 15 GHz bands with 100 MHz and 200 MHz bandwidth. Memoryless polynomial and Generalized Memory Polynomial (GMP) behavioral models are extracted by least-squares regression and compared with 3GPP models spanning FR1 and FR2. The GaN PA DUT is modelled best at a higher nonlinear order and shows markedly stronger phase distortion than the wideband PA. The memory terms of the GMP model measurably improve the Normalized Mean Square Error (NMSE) at all operating points. An orthogonal frequency-division multiplexing (OFDM) ambiguity function analysis from the Integrated Sensing and Communication (ISAC) literature, using the extracted models, illustrates how PA compression raises the sidelobe floor of the sensing response. These results provide a reference for PA impairment modelling in FR3, directly applicable to ISAC system design. All model coefficients and measurement data are publicly available [1].

0.40