CS Paper Radar

Camera Calibration Using Inaccurate and Asynchronous Discrete GPS Trajectory from Drones

R. Yang, Y. Bar-Shalom, H. A. J. Huang

eess.SY cs.CV ·submitted 2026-08-27 02:39 UTC · v1
theory

Abstract

This paper considers a stationary camera calibration problem, which estimates the camera orientation angles yaw, pitch and roll, using a drone trajectory recorded by a GPS. There are three challenges in using a GPS trajectory as ground truth for camera calibration. One, the altitude of GPS data is inaccurate with an unknown bias. Two, the GPS receiver and camera are not time synchronized, and there is an unknown time offset between the two systems. Three, the GPS trajectory is time-discrete and accurate interpolation is needed. This is actually an estimation problem since velocity is also needed. To address the first two challenges, we formulate the problem as a parameter estimation problem to estimate a vector consisting of the GPS altitude bias and time offset in addition to the camera yaw, pitch and roll biases. We then develop a special maximum likelihood estimator using the Iterated Least Squares algorithm which can work with a non-synchronized time-discrete GPS trajectory for the third challenge. Since the camera measurement errors are usually small, this requires a high calibration accuracy so that the residual bias error following the calibration should not be significant compared to the measurement error standard deviation. The calibration accuracy depends highly on the drone trajectory. This paper also recommends an appropriate drone trajectory which can yield a good calibration accuracy, namely, 14\% of the measurement error standard deviation. Simulation tests are conducted to demonstrate the algorithm performance. The estimation results meet the Cramer-Rao Lower Bound (CRLB) since the Normalized Estimation Error Squared w.r.t.\ the CRLB is statistically acceptable.

Comment
11 pages, 12 figs, published on JAIF

Closest papers

Nearest neighbours by meaning across the whole index.

Towards Agile Vision-Based Multi-UAV Flight: Revisiting State Estimation

cs.RO ·2026-09-30 ·Michal Pliska, Matouš Vrba, Ondřej Víta, Martin Jiroušek, Viktor Walter +1 more
publishedbenchmark similarity 0.62
Abstract · This work has been accepted to the IEEE for possible publication (IROS 2026)

Agile multi-UAV flight requires accurate and low-latency onboard estimation of the kinematic states of neighboring UAVs for collision avoidance, motion coordination, etc. Most vision-based approaches rely on position-only measurements, inferring velocity and acceleration indirectly from displacement. We show that this introduces a fixed structural delay in the estimation of higher-order states, which limits the achievable agility. To address this, we propose to integrate tilt measurements, provided by a state-of-the-art visual detector, which inform about the thrust direction of co-planar multirotor UAVs. We benchmark four position-only and five pose-aware estimators, including a novel formulation of a linear thrust-constraining Kalman filter, on two real-world and one high-fidelity photorealistic simulated dataset over different levels of agility (3-21 m/s^2). In our setup, pose-aware estimation consistently reduces the average velocity and acceleration estimation errors by 40% and 57% across the three datasets with the proposed KF formulation outperforming the other estimators. Position-only filters exhibit a constant ~300 ms delay in acceleration step response independent of agility, whereas the tilt-constrained estimators operate near the physical response limit given by the camera frame-rate by observing the change in thrust direction before the displacement accumulates. In a closed-loop leader-follower simulated experiment with NMPC control, position-only estimation of the leader's state fails to facilitate stable hovering of the follower, while the proposed estimator enables tracking of lateral maneuvers exceeding 2g of acceleration.

0.26

On-the-Fly Homographies Calibration for Multi-Camera Tracking

cs.CV cs.AI ·2026-09-16 ·David Voihanski, Mor Sinai, Ben Zion Bobrovsky
similarity 0.61
Abstract

Precise multi-camera tracking traditionally relies on rigorous 3D site calibration, yet this requirement is often operationally impossible in large-scale deployments. Privacy regulations frequently prohibit recording video for offline calibration; limited bandwidth precludes synchronizing high-resolution streams from hundreds of cameras; and covering immense physical sites with calibration targets is logistically infeasible. We present a multi-camera homography calibration system designed to overcome these barriers through "on-the-fly" geometric refinement. Starting from coarse manual homographies, we introduce a centroid-based projection optimization (PO) that continuously aligns the ground-plane geometry using live detection streams. Because PO operates asynchronously on already-transmitted, lightweight metadata, it adds zero computational latency to the real-time tracker. This allows the system to adapt automatically to camera movements or environmental changes without human intervention. This optimized geometry feeds a multi-camera bird's-eye-view (BEV) tracker that fuses detections and unifies trajectories across zones. Crucially, by operating strictly on live anonymous metadata, our solution ensures a privacy-safe, zero-overhead, and resilient tracking pipeline that maintains global consistency in dynamic environments where static, recorded-video calibration is impossible.

0.31

A Height-Constrained 2-Point Minimal Solver for Pose Estimation from Active LED Markers with Event Cameras

cs.CV cs.RO ·2026-08-10 ·Runze Yuan, Alexander Kappler, Jun Zhang, Kuangyi Chen, Fabio Morbidi +3 more
published similarity 0.61
Abstract · 8 pages, 6 figures, accepted by IEEE/RSJ International Conference on INTELLIGENT ROBOTS & SYSTEMS (IROS) 2026

In many autonomous applications requiring real-time localization, active marker-based systems are preferred due to their low latency and ease of deployment compared to computationally demanding feature-based methods. Event~\mbox{cameras} offer high temporal resolution and minimal delay and are commonly used with active LED markers for robust real-time localization. Existing methods typically rely on Perspective-n-Point (PnP) solvers for pose estimation. However, structured marker layouts can be challenging to deploy in space-constrained scenarios, while partial self-motion information (e.g., gravity direction and altitude) is readily available from onboard sensors. We derive a robust and accurate minimal solver that estimates camera pose from only two LED markers by incorporating known tilt angle and camera height measured by an onboard sensor, such as an IMU or an altimeter. The proposed formulation uniquely determines the camera pose through both a closed-form and a linear least-squares solution. We further analyze degenerate configurations and characterize the conditions under which height information does not contribute to rotation estimation. For evaluation, we developed an event-based active marker system to collect real-world data with ground truth from a motion capture system. Experiments on both synthetic and real data demonstrate improved accuracy over the state-of-the-art P2P solver and competitive performance relative to P3P.

0.33

Metric Scale for Insta360 Structure-from-Motion from the Camera's Embedded IMU

cs.CV ·2026-10-26 ·Davide Cuttini, Diego Di Tommaso, Alessio Antoniacomi, Luca Simonetti
benchmarkcode/data similarity 0.60
Abstract · 17 pages, 9 figures, 4 tables. Dataset: https://huggingface.co/datasets/OverTheReality/OverMaps360_50

Structure-from-motion (SfM) from the dual-fisheye video of a consumer 360-degree camera recovers geometry only up to a similarity transform; in the pipeline considered here, metric scale is obtained from smartphone ARKit or ARCore poses captured alongside the camera. This paper evaluates a self-contained alternative: the IMU embedded in the Insta360 X5 and X6, recorded at 1 kHz. The sensor is characterised (noise density, camera-IMU synchronisation, accelerometer scale factor, bias stability), the camera-IMU rotation and frame timing are estimated from the data, and the scale is recovered by a linear visual-inertial alignment over the SfM poses of a whole survey. The standard formulation, with gravity and accelerometer bias shared across the survey, overestimates the scale by 3.4% on average; estimating each contiguous segment independently and averaging removes the bias. On nine surveys with a co-mounted LiDAR scanner the inertial scale deviates from the LiDAR by 0.81% in mean absolute error, against 1.94% for the smartphone scale; on printed fiducial markers both agree within the 1% uncertainty of the target. On the reference trajectories of thirty sequences of a public benchmark, brought to scales of 1/40, 1 and 40, the estimator recovers the metric scale with a mean error of -0.07% and a standard deviation of 1.28%. On fifty production surveys where the smartphone is the only reference, the two scales agree to a standard deviation of 2.3%, the inertial scale being 0.3% lower on average; the difference is uncorrelated with run length, grows with the extent of the smartphone anchor, and cannot be attributed to either reference. An ablation over window construction and a comparison with monocular metric-depth networks complete the study.

0.34

Visual-Inertial Odometry for Ground Robots with Dynamic Camera-IMU Extrinsic Calibration

cs.RO ·2026-10-18 ·Bo Dong
similarity 0.60
Abstract

Visual-inertial odometry systems are often constrained by the assumption that sensors are rigidly mounted, which limits their adaptability in practical scenarios involving structural motion. To address this limitation, this paper investigates time-varying camera-IMU extrinsic calibration. First, a dynamic camera-IMU extrinsic calibration method based on the Denavit-Hartenberg convention is proposed by incorporating the robot kinematic model. Second, a two-step initialization strategy is developed to efficiently estimate the initial joint angles, providing a reliable starting point for subsequent extrinsic parameter optimization and enabling online estimation of timevarying camera-IMU extrinsic parameters. Simulation experiments demonstrate that the proposed framework can effectively accommodate variations in camera-IMU extrinsic parameters while maintaining competitive localization accuracy.

0.14

Human-in-the-Loop Geospatial Annotation for Rapid Dataset Construction in Field-Deployed UAV Systems

cs.RO ·2026-09-23 ·Morgan Masters, Adam Korycki, Nikolaas Bender, T. Luca Altaffer, Nick Kuipers +2 more
similarity 0.60
Abstract · 30 pages, 10 figures (plus 2 in appendix)

Real-world perception systems must adapt to changing environments, but manual image annotation cannot scale to field data volumes. We present BirdsEye, which shifts expert annotation from images to the field: an operator records target locations in world coordinates using RTK positioning and calibrated projective geometry propagates each observation to all frames where the target is visible. To quantify how well physical annotations align with image observations, we derive a first-order mapping from camera-pose uncertainty to pixel uncertainty and validate it against Monte Carlo simulation. This mapping is linear in the six per-axis pose variances, so it inverts into a sensor design tool: we give a sufficient condition converting an annotation tolerance into a convex set of admissible pose-noise budgets, a closed-form largest admissible scaling of a deployed sensor suite, and a unique per-axis pose specification under an equal-budget-share allocation. We also analyze the planar-surface approximation underlying the projection, which holds up to 10 degrees of terrain slope. By direct measurement, we show that system projection accuracy is sub-decimeter (sub-30 pixel) at AGL altitudes of 10-20m under conditions excluding sustained yawing. During an in-field case study across three agricultural sites, two field workers produced 12,524 annotated frames carrying 55,600 labels in roughly 12 hours (25.5x per-worker rate increase over manual labeling). Detectors trained on imagery collected by this workflow recovered 56-89% of in-view surveyed targets at a geographically distinct farm, at pre-registered operating points; human review of the leading configuration estimates detection precision at 83-87%, spanning three tie-break conventions for clusters carrying contradictory human verdicts.

0.23

PATH: Continuous Target Sensing among Autonomous Cooperative Drones

cs.RO ·2026-09-11 ·Heegyeong Kim, Alice James, Avishkar Seth, Endrowednes Kuantama, Jane Williamson +2 more
similarity 0.59
Abstract

Continuous target sensing by uncrewed aerial vehicles (UAVs) is constrained by limited flight endurance, motivating the transfer of tracking responsibility between cooperating UAVs. Such a handoff requires the receiver to identify the same physical target currently tracked by the sender despite differences in viewpoint, scale, and target appearance. Existing approaches based on global target localization or appearance-based cross-view association are limited by positioning uncertainty or ambiguous visual features. This paper presents Perspective Alignment \& Tracking Handoff (\textbf{PATH}), a platform-agnostic, geometry-assisted sensing and verification framework for target handoff between two moving UAVs. The sender reconstructs the tracked target as a metric 3D point using RGB-D sensing, while the receiver estimates its relative pose from a fiducial observation and projects the transmitted target point into its own image as a spatial prior for target acquisition. The receiver-generated candidate is then returned to the sender and verified through a cross-view Mutual Agreement Handshake before tracking responsibility is transferred. Real-world UAV experiments show mean relative-position and target-position errors of 0.047~m and 0.030~m, respectively. Under visually ambiguous conditions, PATH achieves 96.0\% frame-level receiver-side target acquisition accuracy, with 2.0\% false-positive and 2.0\% false-negative rates. A sensor-error sensitivity analysis shows that relative-pose uncertainty is the dominant contributor to receiver-view projection error. The implementation operates at video rate with compact inter-UAV communication below 16~kB/s at 60~Hz, demonstrating the feasibility of lightweight geometry-assisted target handoff on resource-constrained UAV platforms.

0.38

Belief-Adaptive Online Autonomy for Quadrotor UAV Navigation under GNSS Degradation in Urban Environments

cs.RO eess.SY ·2026-09-13 ·Deepak Kumar Panda, Weisi Guo
similarity 0.58
Abstract

Reliable online autonomy is critical for quadrotor operation in urban airspaces, where global navigation satellite systems (GNSS) measurements suffer from multipath, blockage, and latency issues, introducing non-stationary, temporally correlated errors that degrade conventional GNSS-IMU fusion. This paper presents a belief-adaptive online autonomy framework that augments an extended Kalman filter (EKF) with explicit GNSS trust modelling, second-order online belief adaptation, and latency-aware out-of-sequence measurement handling. GNSS trust is represented as a latent belief state that modulates measurement weighting and multipath bias uncertainty, and is updated online using EKF consistency signals. Unlike reactive covariance tuning, the proposed approach enables proactive and stable sensor trust adaptation without prior environmental knowledge or offline training. Evaluation in simulated urban air mobility scenarios with correlated multipath, stochastic latency, and obstacle constraints demonstrates improved belief convergence, smoother trajectories, and reduced estimation and tracking errors compared to naive, adaptive, and first-order baselines. The framework preserves classical GNSS-IMU fusion structure and can be integrated directly into existing flight control pipelines, supporting robust online autonomy in GNSS degraded environments.

0.16