CS Paper Radar

Multi-Reference Path Tracking Control for an Agricultural Tractor with Nonlinear Model Predictive Control

Marcel Moll, Timo Oksanen

cs.RO ·submitted 2026-09-04 05:01 UTC · v1

Abstract

Guiding a tractor along a predefined reference path is a key component of precision agriculture. This study develops a path tracking controller based on Nonlinear Model Predictive Control, which incorporates multiple segments of a piecewise-linear reference path directly into the objective function. In addition, methods for selecting viable reference segments from the full path are presented. The control system is evaluated during a field test with a tractor controlled via the Tractor Implement Management steering interface. The NMPC solver converged on average after 3.45 ms and tracked the curved reference path with a mean absolute cross-track error of 6.1 cm.

Closest papers

Nearest neighbours by meaning across the whole index.

A Novel Path-Tracking Algorithm for Automated Tractor-Trailer Forward and Backward Maneuvers

cs.RO eess.SY ·2026-09-18 ·Alexandre Lombard, Florent Perronnet, Théo Rigal, Nicolas Gaud, Abdeljalil Abbas-Turki
similarity 0.71
Abstract

Fully autonomous tractor-trailer systems are increasingly deployed in logistics, agriculture, and industrial environments, where precise and robust path-tracking capabilities are essential. However, the articulation between the tractor and the trailer introduces additional nonlinearities and significantly complicates lateral and longitudinal control, particularly during reversing maneuvers. This paper introduces a novel path-tracking algorithm specifically designed for articulated vehicles with a single trailer. The proposed method combines a lateral control law applied at the trailer level with a short-horizon predictive adjustment of the tractor steering angle, ensuring stable convergence toward the desired path in both forward and backward motion. The approach is geometry-based and requires no per-vehicle calibration or training. Simulation studies in a high-fidelity physics simulator show steady-state or final lateral errors of $0.02$--$0.05$~m on straight-line, circular, and reverse docking trajectories, which is of the same order of magnitude as, or lower than, the errors reported in the literature. Real-world experiments on a small-scale tractor--trailer robot, with the whole controller running on a low-cost microcontroller, further confirm the feasibility of the approach, with lateral errors below 13~mm during repeated reverse docking maneuvers despite a pose detection latency of about 200~ms.

0.10

Identification of the Steering and Speed Systems of a Four-Wheel-Steering Tractor for Optimal Control

eess.SY ·2026-09-04 ·Riikka Soitinaho, Timo Oksanen
similarity 0.63
Abstract

Model-based control design requires sufficiently accurate model of the system-to-be-controlled. This paper addresses the system identification of steering and speed control of a four-wheel-steering agricultural tractor for the purpose of developing path tracking control. To this end, we investigate the steering and speed control systems of the tractor. These are complex systems with digital, mechatronic, and hydraulic components challenging to model based on first principles. We take a data-driven approach to estimating the system models. The resulting model combines the kinematic model of the vehicle, actuators modelled as first-order systems, and estimated values for time constants and transport delays.

0.32

High-Speed Forward and Reverse Tractor-Trailer Driving with Learned Vehicle Dynamics

cs.RO eess.SY ·2026-11-15 ·Aaron Chen, David Shen, Taekyung Kim, Kaleb Ben Naveed, Dimitra Panagou
code/data similarity 0.56
Abstract · The first three authors contributed equally to this work. Project page: https://ds12a.github.io/drift-with-trailer/

Tractor-trailer systems are difficult to control, especially unstable during reverse motion, and their dynamics depend on difficult-to-measure factors, including road friction and suspension coefficients. We introduce a learned dynamics model for tractor-trailer control and compare it with a reduced-order dynamics model with Fiala tire forces as an analytic baseline. Specifically, we compare a model predictive path integral (MPPI) controller that uses the learned dynamics model to an MPPI controller that uses the analytic model, as well as to three additional baseline controllers. In the main closed-loop tracking experiments across four simulated environments, MPPI with learned dynamics achieves mean speeds closer to the target magnitudes and lower root-mean-square (RMS) hitch angles than MPPI with the analytic model at every tested setpoint, with higher completion rates in seven of eight reverse configurations.

0.17

Model predictive traction control system based on the Koopman operator

eess.SY ·2026-08-26 ·Josip Kir Hromatko, Šandor Ileš
publishedcode/data similarity 0.56
Abstract · 6 pages, 4 figures; associated code available at https://github.com/PVDC-project/pvdc-kmpc-traction-control

Due to their importance, traction control and anti-lock braking systems have become standard equipment in modern vehicles. However, accurate models of tire dynamics are often difficult to obtain and usually include nonlinearities, making their use in control systems challenging. This paper describes a traction control system based on model predictive control and Koopman operator theory, which aims to approximate nonlinear systems with linear ones through a state space transformation. A linear model predictive controller based on the Koopman predictor is compared to a standard nonlinear model predictive controller. Experiments in a high-fidelity vehicle dynamics simulation environment show a comparable reference tracking performance of the two controllers, with a reduced execution time for the proposed Koopman operator-based algorithm, both on a standard PC and embedded hardware.

0.78

MR-MPCC: Model Predictive Contouring Control for Robotic Manipulator Tracking under Moving Reference Frames

cs.RO ·2026-10-15 ·Chonghao Cheng, Tiancheng Li, Jonathan Woolfrey, Liang Zhao, Shoudong Huang
published similarity 0.55
Abstract · Accepted by The IEEE/RSJ International Conference on Intelligent Robots and Systems 2026 (IROS 2026)

Maintaining small path-tracking errors under moving reference frames is essential for robotic manipulation tasks with tight execution tolerances, such as machining and surgical automation. Conventional time-indexed controllers, including tracking Model Predictive Control (MPC), rely on a fixed temporal correspondence with the reference trajectory and may therefore accumulate path-relative error under abrupt reference-frame motion or timing mismatch. This paper presents MR-MPCC, a Model Predictive Contouring Control (MPCC) framework for velocity-controlled robotic manipulators with 6-DoF end-effector pose regulation under Moving-Reference disturbances. A hierarchical control architecture is adopted, in which an upper-level MPCC optimizes path progress while penalizing contouring and orientation errors, and a constrained resolved motion rate control (RMRC) layer maps the commanded Cartesian twist to feasible joint velocities under joint-level and safety constraints. MR-MPCC is implemented in a ROS2--MuJoCo pipeline and validated on a UR5e platform under moving-reference disturbances, where the path frame is perturbed and tracked by electromagnetic sensors. Compared with PI control and time-indexed tracking MPC under matched disturbance, MR-MPCC achieves lower geometric path-following error and smaller deviations in the moving path frame, demonstrating improved path-following performance under reference-frame motion.

0.44

Nonlinear Model Predictive Control for Guidance Law with Target Input Estimation

eess.SY ·2026-08-27 ·Minho Jang, Minjeong Kim, Sungsu Park
similarity 0.54
Abstract

This paper presents a look angle-based nonlinear model predictive control guidance (MPCG) method for missiles equipped with strapdown seekers. Conventional proportional navigation guidance (PNG) requires line-of-sight (LOS) rate measurements, which are not directly available in strapdown systems. MPCG instead employs look angles and their derivatives as state variables, eliminating body-rate coupling and associated parasitic feedback. The guidance problem is formulated as a continuous-time optimal control problem (OCP), discretized via the Legendre-Gauss-Radau pseudo-spectral method (LGRPM), and solved as a nonlinear program (NLP) incorporating explicit field-of-view (FOV) and acceleration constraints. Target acceleration at the first step of the prediction horizon is estimated using an adaptive extended Kalman filter (AEKF) integrated with an interacting multiple model (IMM) framework. Simulation results under single-maneuver scenarios, which include pitch and yaw plane weaving as well as barrel-roll maneuvers, demonstrate that MPCG achieves reliable interception while satisfying operational constraints, outperforming pure PNG (PPNG) in stability and resilience. This indicates that MPCG offers a practical and effective solution for modern missile guidance systems constrained by seeker measurement limitations.

0.19

An Adaptive Control Architecture for Slope and Terrain Compensation in Autonomous Navigation in Mediterranean Greenhouses

cs.RO ·2026-09-02 ·Fernando Cañadas-Aránega, Dirk Wollherr, José L. Guzmán, José C. Moreno, José L. Blanco-Claraco
similarity 0.54
Abstract

The ability to move stably over terrain with varying slopes and textures is essential for mobile agricultural robots operating in complex and dynamic environments such as greenhouses, where small terrain irregularities can lead to significant navigation errors. This article presents a novel terrain-adaptation strategy based on the carried payload, ensuring accurate and robust trajectory tracking. The proposed approach is based on: (i) the experimental characterization of the most common types of greenhouse soil, concrete, compacted sand, and gravel, and (ii) the direct measurement of terrain slope using the IMU, in order to estimate the force with which this angle affects the motor input. Based on this information, a cascade trajectory-tracking scheme has been designed, consisting of a model-based predictive controller (MPC) in the outer loop and a PI controller in the inner loop. The system incorporates an adaptive feedforward control through gain scheduling approach, capable of adjusting to disturbances caused by variations in slope and terrain type. Simulation results demonstrate that the differential-drive robot achieves a significant improvement both in error indices and in control signal efficiency, highlighting the effectiveness and robustness of the proposed approach.

0.44

A Field-Deployable GNSS-based Navigation Stack for Outdoor Mobile Robots

cs.RO eess.SY ·2026-09-24 ·Yiyuan Lin, Cole Regnier, Yu Jiang
code/data similarity 0.53
Abstract

Outdoor robots require more than an accurate receiver and a path-tracking law: the navigation system must preserve geometric consistency from geographic waypoints to actuator commands, expose measurement validity and timing, and respond to invalid or stale state information. This work presents a ROS~2 navigation stack with interchangeable single-GNSS--IMU and dual-antenna-GNSS localization front ends. Both provide a common local East--North--Up state interface for pure pursuit, virtual-point cross-track PID, finite-horizon nonlinear model predictive control (NMPC), and a segment-dependent hybrid dispatcher. The architecture specifies coordinate conventions, datum initialization, asynchronous state construction, waypoint geometry, controller equations, quality gates, command arbitration, and watchdog behavior. Independent physical field runs collected during 2025 and 2026 grape-vineyard deployments support a balanced evaluation of 800 runs, with 100 runs for each of eight controller--localization combinations on an approximately 199.6-m route. The row-hybrid mode yields the lowest run-averaged post-acquisition mean absolute cross-track error (MAE) in the evaluated dataset: 0.00952~m with single GNSS+IMU and 0.00846~m with dual GNSS. These findings characterize deviations of the recorded positions from the reference route under the evaluated conditions. The open-source navigation software and deployment instructions are available in the https://github.com/YiyuanLinXX/PPBv2/tree/main/PPBv2_Navigation.

0.33