CS Paper Radar

What Does an RF Fingerprint Identify? A Cross-Corpus Evaluation of Hardware-Family-Associated and Unit-Level Signal

Hyojung Han

cs.CR cs.LG ·submitted 2026-11-10 23:35 UTC · v1
benchmark

Abstract

RF fingerprinting benchmarks report how well a classifier separates transmitters, not whether that separability reflects the individual unit or its hardware family. We compare a benchmark's real hardware grouping with size-matched random groupings of the same devices, using calibrated, unclipped variational lower bounds under label-blind, device-level cross-fitting on devices never seen in training. On WiSig (OFDM Wi-Fi), the generation grouping exceeded all 999 matched random groupings (permutation p = 0.001, the resolution floor), although no grouping attained a positive certified bound, and the direction survives removing channel equalization. A preregistered replication on a LoRa corpus (chirp spread spectrum, three hardware models), with a front-end frozen on synthetic data, again exceeded all 999 (p = 0.001), and two sensitivity analyses judged by a reversal rule fixed in advance did not reverse the direction. This is a directional replication only: the excess magnitude reflects a miscalibrated null, the chain-rule decomposition leaves a residual of +0.296 bits, and capture order is undocumented. In a same-model corpus of 122 ESP32 radios, a temperature-calibrated held-out bound of +3.338 bits (label entropy 6.931 bits) indicates substantial device-specific identity, not separable from per-device capture-session effects; relying on the calibrated bound was decided after the uncalibrated bound changed sign. On synthetic transmitters a high-capacity convolutional decoder reaches 98.5% of a known 6-bit ceiling, and the audit protocol leaves chain-rule residuals of +0.072 bits (synthetic, fixed physical features) and +0.060 bits (WiSig, audit features). Two further corpora were excluded by preregistered ingest gates. Across WiSig and LoRa, hardware-family groupings consistently produced stronger identity-associated signal than size-matched random groupings.

Comment
20 pages, 4 tables, no figures

Closest papers

Nearest neighbours by meaning across the whole index.

Calibrated RF-Fingerprinting Under Interference With Heterogeneous Transmission Protocols

cs.LG ·2026-09-17 ·Tariq Abdul-Quddoos, Xiangfang Li, Lijun Qian
publishedtheory similarity 0.63
Abstract

Radio Frequency(RF)-Fingerprinting is a spectrum monitoring technique that identifies specific transmitters based on hardware impairments imprinted within the emitted signal. Although widely researched, studies almost exclusively consider scenarios where only one transmitter is emitting at a time, limiting real world applicability. In this work, we further the study of RF-Fingerprinting by considering co-channel interference, with multiple emitted signals interfering with each other, overlapping in time and frequency. Specifically, we formulate this problem as a multi-label classification problem and employ a 1D convolutional neural network (CNN). Furthermore, the models are calibrated such that the confidence thresholds for the label probabilities are derived, with guarantees on the upper bound on the average number of False Negatives, providing a degree of confidence in not missing a true spectrum policy violation. The proposed method is validated using real world data from the POWDER 5G testbed on devices transmitting 802.11a(Wi-Fi), 4G LTE, and 5G NR waveforms. The results show accuracy as high as 97% and as low as 73% after calibration depending on channel conditions. Also calibrating for various average false negatives upper bounds achieves micro recall scores of approximately (1 - calibrated false negatives) with the calibration robust to out-of-distribution interference, demonstrating the potential of the proposed method in a realistic high contention wireless environment

0.38

Supervised Device Charting with CSI Measurements from Commercial 5G NR User Equipments

eess.SP cs.IT ·2026-09-21 ·Mischa Vasylyev, Frederik Zumegen, Reinhard Wiesmayr, Christoph Studer
similarity 0.62
Abstract · This work has been submitted to the 2027 IEEE International Conference on Acoustics, Speech, and Signal Processing (ICASSP)

Radio frequency fingerprint identification (RFFI) is a promising approach to distinguish physical wireless devices using hardware-induced signal imperfections. Conventional RFFI methods only provide discrete device labels and no human-interpretable representation of the relations among received signals. We propose supervised device charting, which maps location-insensitive channel-state information (CSI) fingerprints to a low-dimensional chart that visualizes cluster compactness, overlap, and outliers. We evaluate the method with real-world 5G New Radio (5G NR) measurements from six commercial smartphones and introduce the neighbor label error rate (NLER) to quantify class-separation accuracy. Our results demonstrate that two- and three-dimensional device charts provide an interpretable visualization of the learned RFFI representation. For three-dimensional device charts, the NLER is 0.22% for same-day measurements and 7.38% for measurements from the next day. The device charts reveal a cross-day distribution shift and map the held-out device close to the known device of the same model. Increasing the device chart dimensions further improves cluster separation at the expense of interpretability.

0.21

C$^2$T-OpenMax: A Novel Open-Set WiFi RF Fingerprinting Method via Center Constrained Learning and Confidence-Guided Tail Modeling

cs.CR ·2026-09-02 ·Yuanyu Zhang, Junjie Yang, Ji He, Shuangrui Zhao, Lele Zheng +1 more
similarity 0.59
Abstract

Radio frequency fingerprinting (RFF) enables device authentication from transmitter-specific hardware imperfections, but practical deployment requires cross-environment open-set recognition. Data augmentation improves environmental generalization, yet may yield dispersed, low-confidence known-class representations that distort the class statistics used by OpenMax. To address this problem, we propose C$^2$T-OpenMax, an enhanced OpenMax framework combining center-constrained learning with confidence-guided tail modeling. The former improves intra-class compactness, making class-wise representations more suitable for distance-based modeling. The latter retains only correctly classified, high-confidence logits for mean activation vector estimation and Weibull fitting, reducing bias from ambiguous boundary samples. Together, the two modules refine representation geometry and OpenMax construction while preserving augmentation benefits. Experiments on a public WiFi CSI dataset show that C$^2$T-OpenMax achieves the highest open-set accuracy in seven of eight location groups and outperforms all baselines in area under the receiver operating characteristic curve (AUROC) and open-set classification rate (OSCR) across every tested openness level. Under the largest-openness setting, it improves accuracy by 12.31%, AUROC by 0.0887, and OSCR by 0.0856 over the augmented OpenMax baseline.

0.26

RFCheck: Synthetic RF Sensing Data Can Fail Measurement Consistency

eess.SP ·2026-08-10 ·Di Zhang, Yuanhao Cui, Tony Xiao Han, Xiaojun Jing
similarity 0.58
Abstract

Synthetic radio-frequency (RF) sensing data are widely used to augment wireless sensing tasks, yet their measurement consistency with real data is rarely evaluated under matched acquisition conditions. This paper identifies a measurement-consistency failure mode: synthetic samples may pass task-facing checks while deviating from the measurement behavior of real samples collected and processed by the same sensing pipeline, potentially introducing synthetic shortcuts and biasing downstream model selection. We propose RFCheck, a calibrated measurement audit that uses held-out real data from the same acquisition and preprocessing pipeline as the reference. RFCheck calibrates representation-specific tests on real samples and flags synthetic samples whose responses exceed the calibrated real-data range. We use the audit for candidate screening and residual repair. We validate RFCheck primarily on Wi-Fi channel state information (CSI), where the audit examines delay-domain and local frequency-domain structures. Experiments show that aggregate statistics and label-based screening can miss measurement failures detected by RFCheck. Under the same label acceptance rule, low-risk and high-risk synthetic candidates exhibit different downstream behavior. A repair reference reduces the flagged ratio to 10.83% while preserving mean task performance. In a held-out proposal study, correction followed by calibrated selection produces a class-balanced set with no flagged samples under a fixed training budget. We further apply the same calibration principle to frequency-modulated continuous-wave (FMCW) millimeter-wave radar gesture sensing. The results show that synthetic RF sensing data can violate measurement consistency even when conventional task checks are satisfied, motivating measurement-aware diagnosis and mitigation before augmentation.

0.04

Interpretable Feature Learning for RF Fingerprinting via Polar MKANs

eess.SP cs.LG ·2026-08-20 ·Mikhail Krasnov, Ljupcho Milosheski, Carolina Fortuna
benchmark similarity 0.58
Abstract · 5 pages, 5 figures, 3 tables

Radio frequency (RF) fingerprinting authenticates wireless devices from hardware-induced I/Q impairments, typically with deep learning feature extractors that are accurate but opaque, limiting their use in security critical settings. We propose Polar Monotonic Kolmogorov-Arnold Networks (Polar MKAN), a block partitioned monotonic encoder on polar inputs in which each latent dimension depends exclusively on magnitude or phase, yielding channel separation and monotone responses by construction. On a synthetic gain and carrier frequency offset (CFO) benchmark, Polar MKAN reaches 57.2 percent DCI Disentanglement versus at most 12.9 percent for unpartitioned baselines. We further evaluate the detection accuracy trade off on real data and the sensitivity to blind CFO compensation.

0.36

Pluggable Subband-Decoupled Fusion and Unlabeled Capture Prototype Calibration: Bridging High-SNR Null-Subcarrier Regrowth and Low-SNR Coherent Preambles for Cross-Domain IoT RF Fingerprinting

cs.AI cs.ITeess.ASeess.SP ·2026-11-17 ·Fengchong Yao, Jianbing Li, Qing Liu, Kefeng Song, Haitao Li +2 more
benchmark similarity 0.57
Abstract

Zero-overhead physical-layer authentication at edge wireless access points (APs) is vital for securing resource-constrained Internet of Things (IoT) transceivers against credential cloning, yet cross-domain IEEE 802.11a/g radio frequency fingerprint identification (RFFI) faces an acute signal-to-noise ratio (SNR) crossover. Power-amplifier spectral regrowth on unpopulated null subcarriers resists indoor multipath at high SNR but decays quadratically below the thermal noise floor, whereas populated active in-band preambles survive low SNR yet degrade under severe multipath, causing static fusion to lose up to 44.7 percentage points (pp). To our knowledge, we propose the first RFFI framework that dynamically modulates active in-band waveforms and unpopulated null-subcarrier regrowth via a blind physical SNR gate: Pluggable Gated Subband-Decoupled Fusion with Unlabeled Capture-Aware Prototype Calibration (GSDF-CAPC). Avoiding the 20-35 dB subband gradient imbalance of joint training, GSDF pairs any frozen pretrained host backbone with a 46.3K null-subcarrier plug-in encoder (NS-Branch), fusing scale-standardized logits and gate-warped spherical embeddings under a source-calibrated lag-64 thermal-SNR gate with exact low-SNR fallback. Over unlabeled target AP captures, forward-only unbalanced optimal-transport calibration (UOT-CAPC) aligns shifted prototypes under packet-arrival skew and recovers parameter-free balanced Sinkhorn (U-CAPC) at equipartition. Across DataPort-WiFi, WiSig, and ORBIT MobRFFI, zero-retrain GSDF wins all 72/72 paired runs across eight backbones with 0.00 pp low-SNR loss, while edge IB-Host + GSDF (92.6K-93.3K active parameters, 1.82 ms single-core CPU latency) and timing-synchronized GSDF-STO / GSDF-Tri reach 57.50%-65.05% three-benchmark Macro-F1 (89.04%-100.00% over 5-10-packet IoT bursts).

0.27

SFPF: Spatio-Frequency Polarization Fingerprint for Anomalous Wireless Device Detection

cs.CR ·2026-09-18 ·Xiaoxuan Huang, Jinlong Xu, Daoyuan Shen, Meng Zhang, Dong Wei
similarity 0.57
Abstract

Periodic inspection of deployed wireless devices is necessary because unauthorized hardware replacement may preserve communication functions, credentials, and logical identity, making anomalous devices difficult to detect. Such inspections are conducted under controlled measurement conditions to verify that each device remains consistent with its enrolled hardware state. Conventional radio-frequency fingerprint (RFF) may provide insufficient separation when replacement hardware closely resembles legitimate hardware, while a polarization fingerprint (PF) constructed at one observation direction may miss spatially nonuniform polarization changes. This paper proposes the spatio-frequency polarization fingerprint (SFPF), which jointly represents complex polarization responses over multiple frequencies and observation directions; conventional PF is its fixed-direction slice. We derive SFPF formation from hardware-dependent modal excitation, directional far-field radiation, and polarization projection. A first-order sensitivity analysis shows that the response to the same hardware change varies with both frequency and direction, motivating joint spatio-frequency acquisition. Electromagnetic simulations confirm the nonuniform spatio-frequency sensitivity and show that, under the same observation budget, SFPF improves normalized distance, Fisher score, and the inter-/intra-class ratio over PF by 17.7%, 45.8%, and 11.3%, respectively. Experiments show that SFPF consistently outperforms RFF and PF over 0--20~dB. At 15--20~dB, SFPF achieves anomalous-device F1 scores of 87.3--90.4% and AUROC values of 85.4--95.5%.

0.29

From Identification to Authentication for Micro-CSI RF Fingerprinting in OFDM Systems

eess.SP ·2026-08-30 ·Matteo Varotto, Stefano Tomasin
similarity 0.55
Abstract

We consider a scenario where a legitimate user (Alice) authenticates itself to an authenticator (Bob) by transmitting orthogonal frequency division multiplexing (OFDM) pilots, from which the authenticator extracts the Micro-CSI (M-CSI) fingerprint and compares it against a stored reference via a likelihood test (LT)-based test. We introduce a new spoofing attack, where two adversarial devices collude to first jointly estimate the M-CSI fingerprints of Alice and Bob and then construct a forged signal able to break the authentication mechanism with high probability, limited only by noise effects on the estimates. We derive approximate closed-form distributions of the authentication test statistic under both the legitimate and spoofing hypotheses, enabling the derivation of false alarm and misdetection probabilities in closed-form. We then validate our analytical results against M-CSI fingerprints extracted from experimental data. The results reveal that, given sufficient pilot observations or an equivalent noise statistic between Bob and the attackers, the latter can always drive the test statistics to a random classifier, vanishing the security of M-CSI-based authentication.

0.25