CS Paper Radar

Nested Power Models for Multirotor Propulsion: From Aerodynamic Drag to Electrical Losses

Antonio Franchi, Aaron Saini, Ahmed Ali, Chiara Gabellieri

cs.RO eess.SY ·submitted 2026-10-06 11:29 UTC · v1
unusual

Abstract

Speed-only aerodynamic power models for multirotor propulsion cannot represent acceleration-dependent effects. This work develops a nested sequence of propulsion-power models that starts from aerodynamic power dissipation and progressively introduces a reversible kinetic-energy rate, torque-dependent electromechanical dissipation, and lumped speed-proportional dissipation. The models are identified using one subset of experiments and validated using the other on a motor-drive-propeller unit. Independent estimates of rotational inertia and aerodynamic drag complement predictive validation by assessing whether the models correctly attribute the measured power to reversible kinetic-energy exchange and irreversible dissipation and, within the latter, to aerodynamic and electromechanical losses. The results show that the reversible kinetic-energy rate is necessary but insufficient for accurate dynamic power prediction. Dissipation proportional to the squared motor torque provides the main additional improvement, while speed-proportional dissipation further prevents irreversible losses from being attributed to reversible kinetic-energy exchange. The resulting methodology provides a reusable and experimentally verifiable basis for developing and selecting dynamic propulsion-power models for multirotor systems.

Closest papers

Nearest neighbours by meaning across the whole index.

Mass Scaling Laws for Energy-Optimal Horizontal Multirotor Flight

cs.RO eess.SY ·2026-11-03 ·Ayush Patnaik, Nicolas Michel, Leonard Baursfeld, Davide Scaramuzza, Xinfan Lin
top venue similarity 0.57
Abstract · Accepted to IEEE Robotics and Automation Letters, October 2026

Multicopters are a type of aerial robot seeing extensive real-world applications but with range and endurance as critical bottlenecks. Optimization of its energy efficiency through energy-aware flight planning (e.g. cruise speed-scheduling) has hence been an important topic. The mass of the multicopter is an important factor to consider, as it has a significant impact on efficiency, and many common applications are subject to frequent mass variation due to payload change. This work derives closed-form scaling relationships between the energy-optimal steady horizontal flight behavior of a multicopter and its vehicle mass, and validates them experimentally on two multirotor platforms. Specifically, for mass-only variation, i.e., when payload changes the vehicle mass while the airframe geometry, aerodynamic characteristics, and rotor configuration remain unchanged, we show through a combination of numerical simulation, theoretical derivation, and experimental validation that (1) the energy-optimal velocity is proportional to the square root of vehicle mass; (2) the energy-optimal pitch angle is constant with respect to mass; and (3) the optimal energy per meter is proportional to mass. The analysis shows that these three relationships arise from a common mass-similarity property of the steady-state flight and rotor-aerodynamic equations. Furthermore, the obtained scaling relationships enable simple yet effective cruise-speed planning to optimize energy efficiency and extend the range and endurance of the multicopter.

0.45

Model Predictive Control of Wind Turbines: A Model-Oriented Review of Prediction Models, Control Objectives, and Nonlinear Aerodynamic Formulations

eess.SY math.DSmath.OC ·2026-10-22 ·Roya Khalili-Amirabadi, Mohsen Jalaeian-Farimani, Mahdi Ghane
published similarity 0.53
Abstract · Khalili-Amirabadi, R., Jalaeian-Farimani, M., & Ghane, M. (2026). Model Predictive Control of Wind Turbines: A Model-Oriented Review of Pred…

Model predictive control (MPC) has been applied to wind-turbine regulation with markedly different internal prediction models, ranging from linearized low-order turbine models to nonlinear, aeroelastic, floating, and data-driven predictors. This review organizes the literature primarily by the model propagated by the controller and treats model order, predictor representation, MPC formulation, control objective, and validation plant as separate descriptors. Primary studies show that low-order linear or piecewise-affine predictors are attractive for constrained power and speed regulation, whereas flexible drivetrain, structural, and floating models are needed when drivetrain twist, tower motion, blade loads, or platform dynamics are explicit control quantities. Nonlinear and economic MPC studies further demonstrate coordinated pitch/torque control across broad operating regions, while preview, repetitive, and data-driven formulations address wind prediction, periodic loads, and model mismatch. Particular attention is given to aerodynamic pitch dependence: variable-pitch turbine dynamics can be non-affine with respect to applied pitch, and the term NMPC alone does not prove that the original nonlinear pitch map is retained inside the optimizer. The review therefore adopts a conservative, equation-based classification for direct nonlinear applied-pitch propagation. Here, direct nonlinear applied-pitch propagation means that the applied pitch at each prediction step is evaluated inside the original nonlinear aerodynamic map, rather than replacing that dependence by a linearized, scheduled, piecewise-affine, or learned surrogate. The literature supports a remaining integration challenge at the intersection of flexible drivetrain prediction, nonlinear aerodynamic pitch treatment, explicit constraints and load objectives, and validated adaptive or learned model correction.

0.35

Spinning Quadrotor: Hover Thrust Augmentation with Passive Lifting Surfaces

cs.RO ·2026-08-24 ·Aniketh Parkala, Harikumar Kandath
published similarity 0.52
Abstract · 8 pages

Conventional multirotor aerial vehicles actively suppress yaw rotation during hover, expending power to maintain a fixed heading despite the fact that yaw regulation is not required for force balance or altitude control. This paper challenges that paradigm by proposing a spinning quadrotor architecture that intentionally operates at a sustained yaw rate, converting power traditionally spent on yaw regulation into useful aerodynamic effects. A dynamic model of the spinning quadrotor is developed, analysis for low Re range is conducted to choose an airfoil for lifting surfaces. Preliminary hardware tests show a 22% reduction in thrust required. These findings suggest that intentional yaw rotation, rather than being suppressed, can be exploited as a design mechanism for efficient and robust multirotor flight.

0.33

Learning to Exploit Passive Dynamics for Energy-Efficient Target Hopping of a Spring-Legged Quadcopter

cs.RO cs.LG ·2026-09-14 ·Ruigang Chen, Qi Zhang, Zhicheng Zhong, Zhuorui Yun, Yizhar Or +1 more
similarity 0.49
Abstract · 8 pages, 10 figures

Combining aerial thrust with spring-loaded hopping makes monopedal quadcopters promising for locomotion over complex terrain, but heuristic proportional-integral-derivative (PID) tuning limits coordination between active thrust and passive contact dynamics. We present a direct estimated-state-to-motor Proximal Policy Optimization (PPO) policy that commands four motors without an explicit hopping state machine or low-level attitude PID. Its reward combines Energy-Manifold Shaping for mass-normalized vertical-energy tracking and apex-state anchoring with Efficiency Shaping, which uses a history-aware power estimator to penalize general power use, impose an additional airborne-power cost, and penalize airborne near-stationarity. In representative hardware runs, the PPO-based control stack reduced cycle-averaged measured electrical power by 30.7% and mean total normalized thrust by 49.8% relative to the tuned PID-based control stack, while retaining repeatable commanded-height hopping and more concentrated landings. These observations are consistent with improved use of passive dynamics and reduced measured electrical demand.

0.29

Piezoelectric Energy Harvesting from a Pitch-Plunge Aerofoil in Compressible Flow, the Euler Full-Order Model, Strip Theory and the Reduced Models Compared

cs.CE ·2026-09-16 ·Nikolaos D. Tantaroudas, Ilias Karachalios, Andrew J. McCracken
similarity 0.47
Abstract · 15 pages, 4 figures

A piezoelectric transducer embedded in a pitch-plunge aerofoil with a finite-mass trailingedge flap converts the limit-cycle oscillation that follows flutter into electrical power. The design findings for such a harvester have so far been obtained with incompressible strip theory, whose aerodynamic state is a handful of lag variables. Here the same section, the same transducer and the same test cases are coupled instead to the two-dimensional compressible Euler equations, giving a full-order model of twelve thousand states, and the two aerodynamic models are placed side by side on the flutter boundary, on the limit cycle and on the harvested power, with the strip-theory results compared against higher fidelity aerodynamic modelling provided by CFD. The degree of freedom carrying the transducer remains the first-order design variable, and the ranking of the mountings and the position of the optimum in the coupling and load-resistance plane are unchanged, while strip theory is found to underpredict the harvested power of the compressible section and to overstate the effect of the transducer on stability where the electrical time constant meets the flutter frequency. A nonlinear reduced model of four states, built on eigenvectors of the coupled Jacobian at the velocity of interest, reproduces the frequency of the cycle, its pitch amplitude, the transducer voltage and the mean power, and misstates the proportion of plunge to pitch in the orbit and its phase. That error is shown to be independent of the amplitude of the cycle and to survive enlargement of the basis, which places it in the retained subspace rather than in the order of the expansion, and suggests that such models should be judged on the shape of the orbit rather than on a single amplitude.

0.37

Differentiable Hydrodynamics for Whole-Body MPC of Underwater Robots

cs.RO ·2026-11-19 ·Hefan Wang, Yvan Petillot, Carlos Mastalli
similarity 0.46
Abstract

Underwater vehicle-manipulator systems distribute actuation across thrusters and joint motors. Whole-body model predictive control (MPC), rather than separate vehicle and arm controllers, can coordinate both to extend the workspace and exploit the system's full kinematic capability. Doing so, however, requires a hydrodynamic model and derivatives throughout the prediction horizon. Computational fluid dynamics (CFD) captures geometry-dependent forces and moments for such a model, but is too expensive to evaluate online. We present a differentiable analytical hydrodynamic model combining smooth spherical-harmonic force and moment fields with a coupled added-inertia matrix identified from CFD. It compactly represents velocity and acceleration-dependent loads and provides their derivatives in closed form. These derivatives are propagated through free-floating vehicle--manipulator dynamics for whole-body trajectory optimization and receding-horizon control, jointly optimizing thruster forces and joint torques for reaching and continuous tracking. Held-out CFD tests validate the principal translational-force and rotational-moment fields and the added-inertia response. The analytical Jacobians evaluate faster and avoid the step-size sensitivity of central finite differences. Closed-loop Stonefish experiments demonstrate whole-body MPC in an independent marine simulator. By making geometry-dependent hydrodynamics directly available to gradient-based control, the model incorporates water forces and their sensitivities into motion allocation between the vehicle and arm, rather than treating them only as disturbances.

0.40

Dual-Actuation Emulation of Scaled Relative Orbital Dynamics on a Free-Flyer

cs.RO ·2026-11-18 ·Elias Krantz, Pedro Roque, Gunnar Tibert, Huina Mao, Christer Fuglesang
publishedcode/data similarity 0.45
Abstract · 7 pages, 4 figures. Presented at the 2026 IEEE International Conference on Space Robotics (iSpaRo); to appear in IEEE Xplore

Ground-based free-flyer testbeds reproduce the planar motion of a free-floating spacecraft using air bearings, but not the relative dynamics of spacecraft in orbit. We present a dual-actuation architecture that physically emulates Clohessy-Wiltshire dynamics on an open-source free-flyer. Two model predictive controllers run in parallel: one drives the solenoid thrusters with an orbital dynamics model, representing the spacecraft under test; the other drives bidirectional propellers that physically apply the orbital accelerations, continuously updating its reference to account for thruster-induced velocity changes. A dynamic similitude maps the orbital scenario onto the limited floor area and actuation rates of the testbed, letting the spacecraft controller run directly at orbital scale. We validate the architecture on hardware and against a high-fidelity orbital simulation, where the orbital accelerations instead arise naturally, both driven by the identical spacecraft controller. Their agreement indicates that the testbed reproduces the relative orbital motion the controller would encounter in flight.

0.50

Dynamic Modeling and LQR Control of a Single Coaxial Drone with 2DOF Thrust Vectoring Mechanism

cs.RO eess.SY ·2026-09-17 ·Ali Jokar, Amin Talaeizadeh, Aria Alasty
similarity 0.45
Abstract

Coaxial rotor drones have generated considerable interest because of energy efficiency and small size, but they are afflicted with inherent underactuation for roll and pitch control, although systems like swashplates have circumvented this limitation at the cost of greater mechanical complexity. This work presents a novel coaxial drone supplemented by a two-degreesof-freedom pendulum mechanism for active thrust vectoring that offers a less mechanically complicated alternative. We develop a comprehensive Lagrangian dynamic model that does not ignore the inertial contributions of all the components, including body, servo arms, and motor assembly. A Linear Quadratic Regulator(LQR) is designed based on the linearized dynamics around the hover equilibrium. High-fidelity simulations taking actuator dynamics and sensor noise into account validate the proposed architecture. An Extended Kalman Filter (EKF) blends GPS, barometer, and IMU estimates with high accuracy for state estimation. The findings verify the potential and reliability of this approach for power-saving, rapid coaxial UAVs.

0.13