CS Paper Radar

Damping Oscillations in a Spherical Pendulum Inclinometer Using Vector-Based Control

Fernando Capes, Mikael Andreas Bianchi, Roberto Gardenghi, Manuel Alò

eess.SY ·submitted 2026-08-31 16:10 UTC · v1

Abstract

This paper addresses disturbance-induced oscillations in high-precision pendulum-based inclinometers, which reduce measurement availability despite the long-term stability of gravity-referenced sensing. To actively suppress these oscillations, a contactless six-coil electromagnetic actuation system is developed, together with a control framework that generates, in real time, the planar damping force required by the controller despite the nonlinear, unilateral, and bounded nature of magnetic actuation. The proposed approach combines a control-oriented nonlinear model of the spherical pendulum, observer-based feedback control, and a constrained force-allocation scheme that maps the desired vector force into feasible coil currents. Experimental validation on a prototype demonstrates attenuation of the dominant oscillatory mode up to 31.11 dB and a marked reduction in transient duration, with the 50\% decay time decreasing from 11.10 s without control to 1.01 s at the most favorable operating point. The results also highlight a trade-off between transient speed and residual oscillation, demonstrating both the effectiveness of the proposed damping strategy and its value as a practical design framework for high-precision inclinometer systems.

Closest papers

Nearest neighbours by meaning across the whole index.

Electromagnetic Micro-Guidewire Control in Large Workspaces

eess.SY ·2026-09-14 ·Jasan Zughaibi, Elia Jaggy, Valentin Gantenbein, Denis von Arx, Cristiano Sartini +7 more
similarity 0.53
Abstract

Electromagnetic navigation requires sufficient actuation at clinically relevant distances due to limited magnetic volumes and coil currents. We combine real-time pose feedback with constrained convex optimization, dynamic feedback, and repetitive control to achieve energy-efficient micro-guidewire steering inside realistic anatomical models. Experiments with a clinically oriented, three-coil electromagnetic navigation system and a 0.6 mm-diameter tip magnet demonstrate angular tracking with root-mean-square errors below 0.25 degrees at distances up to 55 cm from the coil cover. Nullspace current redistribution maintains accurate tracking under active 45 A coil-current constraints. Compared with conventional field alignment, we demonstrate that pose-dependent torque-based allocation substantially reduces current demand, with the efficiency benefit retained at a pose-feedback rate of 15 Hz. These results demonstrate how real-time state information and optimization can extend electromagnetic guidewire control toward clinically relevant working distances.

0.23

Payload Swing Estimation and Damping Without Payload Parameters for Multirotor UAVs

eess.SY cs.RO ·2026-08-19 ·K. Taki, K. Umemoto
similarity 0.52
Abstract

Cable-suspended payload transport by multirotor UAVs is flexible but generates periodic swing disturbance that degrades tracking and risks instability. Existing anti-swing methods require additional sensors or precise identification of cable length and payload mass, limiting field deployment. We propose a swing-estimation and damping method using only the onboard IMU and throttle command, requiring no payload parameters. An extended Kalman filter extracts the periodic disturbance with the unknown pendulum frequency as an estimated state, and an active damping controller adds a correction angle to the attitude loop to dissipate pendulum energy. Flight experiments confirm robust damping across a tested range of cable-length and mass variations.

0.21

Data Driven Modeling of a Magnetic Newton's Cradle using the Optimization of a Discrete Loss

cs.CE physics.class-phphysics.comp-ph ·2026-10-29 ·Dimitris Koumoutsakos, Sergey Litvinov
similarity 0.50
Abstract · 30 pages, 19 figures, 8 tables

We investigate the dynamics of a magnetic Newton's cradle (MNC) using experiments, simulations through forward and inverse data driven models. In the MNC magnetic forces replace the instantaneous elastic collisions of the classical design. We compare point-dipole and finite-current-loop interaction models, identifying their parameters from direct measurements as well as through pendulum trajectories using the method of Optimizing a Discrete Loss (ODIL). For a synthetic three-pendulum twin, ODIL reproduces discretized trajectories to round-off accuracy and infers accurately magnet strength and damping from sparse data even when only one pendulum is observed. Model comparison shows that the point-dipole model compensates for near-field errors by underestimating the magnetic moment and produces structured residuals at each momentum transfer. The current-loop model removes this bias and, on full-precision recordings, also recovers the magnet radius. The continuous magnetic coupling reproduces the classical cradle's key behavior while enabling richer dynamics, including $N$ normal modes and a static repulsion offset. These results demonstrate that ODIL can infer physical parameters, and quantify model-form errors from sparse, noisy observations. Ultimately, this work establishes the magnetic Newton's cradle not merely as a physical curiosity, but as a rigorously quantifiable testbed for computational inverse modeling.

0.29

Total Energy Shaping of Underactuated Systems via Gravity Compensation at the Desired Equilibrium

eess.SY ·2026-11-12 ·M. Reza J. Harandi, Mehrzad Namvar
similarity 0.49
Abstract

This paper investigates total energy shaping of underactuated mechanical systems with gravity compensation evaluated at the desired equilibrium instead of throughout the online closed-loop operation. Within the interconnection and damping assignment passivity-based control (IDA-PBC) framework, sufficient conditions for local asymptotic stability are established in terms of integrability of a vector field and positive definiteness of an augmented potential energy. The approach is also combined with a reformulation of potential energy matching that replaces a nonhomogeneous partial differential equation with a homogeneous one and introduces an additional design term. Analytic constructions for the TORA system and a class of two-degree-of-freedom systems illustrate how the matching and integrability requirements can be addressed. The proposed control law avoids online evaluation of the configuration-dependent gravity term; offline controller synthesis and verification can still require knowledge of the gravity model.

0.31

Natural Swing-Up of an Underpowered Double Pendulum

cs.RO eess.SY ·2026-11-12 ·Arne Sachtler, Manuel Keppler, Florian Loeffl, Alin Albu-Schäffer
similarity 0.48
Abstract

Robots with weak motors must ride their natural dynamics rather than fight them. We swing up a direct-drive planar two-link robot, whose motors deliver only about 6\,\% of its shoulder gravity torque, along its nonlinear normal modes, two-dimensional invariant manifolds consisting of periodic orbits. On a non-strict mode, injecting energy necessarily moves the state off the manifold, so pumping and stabilization compete for the same bounded torque. We split the input torque into a power-neutral steering component and a scalar pumping input, the only component that changes the energy. The allocation then becomes a linear program in two variables: maximize pumping subject to the torque limits and one control-Lyapunov constraint. The constraint uses the model-based rate of the error, so no stabilizing feedback gain is needed. Experiments in hardware show swing-ups along both modes and compare the allocation with summing-and-clipping and with prioritized stabilization.

0.30

Magnet-Aware Control of Legged Robots

cs.RO ·2026-10-06 ·J. Playan Garai, S. B. Djuve, C. McGreavy, M. Khadiv
similarity 0.45
Abstract

Autonomous robots can increase uptime and reduce human exposure in Big Science facilities, but strong magnetic fields needed for their operation corrupt sensors and induce pose-dependent mechanical wrenches that destabilize robots and challenge conventional reactive controllers. This paper presents a control framework for modeling, estimating, and dynamically compensating for spatially varying magnetic wrenches acting on legged robots to improve robustness in these fields. We introduce a custom physics plugin for the MuJoCo simulator to model magnetic forces on rigid-body elements, alongside an inverse field-estimation framework to infer the latent magnetic field directly from quadruped dynamic responses and any number of sensor readings. Furthermore, we develop a Magnet-Aware Model Predictive Control (MPC) and Whole-Body Control (WBC) architecture that predicts and counteracts magnetic perturbations during locomotion to increase the range of magnetic fields in which the robot can operate. The effectiveness of the framework is validated through both simulation and physical hardware experiments. We show our method increases the the maximum rejectable disturbances from magnetic field in the force space by a factor of 2.5 and and between 1.6-2 times in torque space compared to a non-compensated system. Within the proposed magnetic field, this constitutes an increase in the area in which the robot can operate by 29,34% of which 10,84% would have previously caused an immediate collapse to non-compensated controllers.

0.28

Dynamic Modeling and LQR Control of a Single Coaxial Drone with 2DOF Thrust Vectoring Mechanism

cs.RO eess.SY ·2026-09-17 ·Ali Jokar, Amin Talaeizadeh, Aria Alasty
similarity 0.44
Abstract

Coaxial rotor drones have generated considerable interest because of energy efficiency and small size, but they are afflicted with inherent underactuation for roll and pitch control, although systems like swashplates have circumvented this limitation at the cost of greater mechanical complexity. This work presents a novel coaxial drone supplemented by a two-degreesof-freedom pendulum mechanism for active thrust vectoring that offers a less mechanically complicated alternative. We develop a comprehensive Lagrangian dynamic model that does not ignore the inertial contributions of all the components, including body, servo arms, and motor assembly. A Linear Quadratic Regulator(LQR) is designed based on the linearized dynamics around the hover equilibrium. High-fidelity simulations taking actuator dynamics and sensor noise into account validate the proposed architecture. An Extended Kalman Filter (EKF) blends GPS, barometer, and IMU estimates with high accuracy for state estimation. The findings verify the potential and reliability of this approach for power-saving, rapid coaxial UAVs.

0.13

Adaptive Rejection of Unknown Hybrid Sinusoidal Disturbances with Application to Humanoid Walking under Unknown Ground Motion

cs.RO ·2026-09-22 ·I-Chia Chang, Jacob Stewart, Petros A. Ioannou, Yan Gu
similarity 0.43
Abstract

Legged robot control is not yet practical in non-inertial environments, where the ground and surroundings accelerate in the inertial Earth frame, mainly because of the unknown, time-varying, persistent perturbations caused by environmental motion, compounded by the associated hybrid robotic dynamics. We formulate the problem of robot walking control as unknown-disturbance rejection for hybrid linear systems subject to hybrid sinusoidal disturbances (i.e., a linear combination of sinusoidal components with instantaneous phase jumps at discrete events). First, necessary and sufficient conditions for solvability of the disturbance rejection problem are derived and used to characterize the control input that rejects the disturbances. Second, with the Youla-Kucera parametrization, an output feedback controller capable of rejecting the disturbance is introduced. Third, an adaptive law is proposed to estimate the controller parameters that reject the disturbance in the practical case where the disturbance and its parameters are unknown. Experiments on bipedal walking during ground motion demonstrate substantially improved body-position tracking accuracy, with an average improvement of over 60% in simulations and up to 47% in real-world experiments.

0.23